Forearc structures and tectonics in the southern Peru—northern Chile Continental Margin

SeaMARC II side-scan images, bathymetry, and single-channel seismic reflection data along the southern Peru—northern Chile forearc area between 16° and 23° S reveal a complex region of morpho-structural, submarine drainage and depression patterns. In the subducting plate area, the NW—SE trending primary normal fault system represented by trench-paralleled scarps was incipiently formed as the Nazca Plate was bent in the outer edge and further intensified as the plate approached the trench. The NE—SW trending secondary normal fault system that consists of discontinuous and smaller faults, usually intersect the primary trench-paralleled fault system. Similar to the Nazca Plate, the overriding continental plate also shows two major NW—SE and NE—SW trending fault systems represented by fault scarps or narrow elongated depressions.The submarine drainage systems represented by a series of canyon and channel courses appear to be partly controlled by the faults and exhibit a pattern similar to the onshore drainage which flows into the central region of the coastal area. Two large depressions occurring along the middle—upper slope areas of the continental margin are recognized as collapse and slump that perhaps are a major result of increased slope gradient. The subsidence of the forearc area in the southern Peru—northern Chile Continental Margin is indicated by: a) drainage systems flowing into the central region, b) the slope collapse and slumps heading to the central region, c) the deepening of the trench and inclining of the lower slope terrace to the central region, and d) submerging of the upper-slope ridge and the Peru—Chile Coast Range off the Arica Bight area.The subsidence of the forearc area in the southern Perunorthern Chile margin is probably attributed to a subduction erosion which causes wearing away and removal of the rock and sedimentary masses of the overriding plate as the Nazca Plate subducts under the South American Plate.     

对虾养殖生态系中有机碳的初步研究本研究由

对于围隔养殖对虾生态系中有机碳的变动进行了研究 ,结果表明 :溶解有机碳 (DOC)含量波动在 5 .2 99～ 13.39mg/ L之间 ,平均为 8.5 3mg/ L± 2 .2 5 mg/ L;颗粒有机碳 (POC)含量波动在0 .6 5～ 6 .6 3mg/ L之间 ,平均为 3.2 5 mg/ L± 1.76 mg/ L;总有机碳 (TOC)含量波动在 6 .92～ 2 0 .0 2mg/ L之间 ,平均为 11.78mg/ L± 3.82 mg/ L ;其中 DOC∶ POC∶ TOC为 0 .72∶ 0 .2 8∶ 1。各种有机碳组分的含量明显高于自然海水中各种有机碳的含量 ;各种有机碳组分的含量在养殖期间总体上呈上升的趋势 ;其变化与 DCOD的变化呈显著线性正相关的关系。     

九龙江河口区水体中的226Ra和228Ra

用ＭｎＯ２－纤维富集大体积水样中的Ｒａ同位素，并用直接射气法测定２２６Ｒａ和２２８Ａｃ的β计数法测定２２８Ｒａ的方法，研究了九龙江河口区２２６Ｒａ，２２８Ｒａ的行为，结果表明：在该河口区２２６Ｒａ，２２８Ｒａ均呈非保守行为，２２６Ｒａ，２２８Ｒａ的最高值分别在盐度为１９和９处测得。２２８Ｒａ／２２６Ｒａ）Ａ．Ｒ．值在盐度小于１９的区域约为３左右。与世界其他河口区相比，九龙江河口区的２２６Ｒａ，２２     

台湾海峡中北部上升流区各种形态磷的化学特性

根据１９８８年７月调查资料讨论了台湾海峡中北部海域夏季上升流区各种形态磷的分布特征。结果表明，上升流中心区（即海坛岛东侧一带水域）具有低温、高盐、低溶解氧；ＤＩｐ，ＴＤＰ，ＰＰ，ＴＰ较高；ＤＯＰ较低（０．２７）；及ＤＩＰ／ＤＯＰ比值（约为１）较高的特性。ＤＯＰ是该海域磷的主要形态（占ＴＰ的４９．２％），其含量分布及其形态转化与生物活动直接相关，是该海域生物生产力高的体现。     

点带石斑鱼人工育苗技术

通过58批次的人工育苗试验，总结点带石斑鱼人工育苗技术；阐述了育苗池、育苗的环境条件、鱼苗不同生长阶段的饵料及投喂方法、育苗水质管理及生产中的操作方法等；讨论了如何解决开口饵料问题和出现3个危险期的原因等。     

黄海表面水温场的准周期变化分析

本文用能谱方法分析了黄海的海表面水温(SST)场的准周期变化。由分析结果清楚地看出,SST具有高频准周期变化:黄海北部以2.6—3.2,1.4—1.7,3.6—3.8和6.7个月的准周期为主;3.3—3.6,5,1.3—2.3及6.7个月在黄海南部占优势。同时,两个海域都有6.7和3.3年的明显的准周期变化。     

牙鲆种群动态及其资源管理

本文根据1980—1986年间鱼类生物学参数测定,结合体长分布资料的模拟分析,研究黄、渤海区牙鲆种群年龄结构、死亡动态以及在不同年龄和死亡率条件下世代资源生物量变化的规律。模型分析结果表明,当F=1.0和t_c=6.0a时,单位补充量最大群体产量为1492g。由此认为,现阶段牙鲆资源利用的最佳策略是通过增殖放流,增加资源补充;同时应适当控制捕捞压力,减少渔具对幼鱼资源的破坏并增设繁殖保护区,以追求最大持续产量。     

鹧鸪菜组织和细胞培养的研究Ⅳ.藻体任意碎片的培养与损伤藻体再生的观察

把鹧鸪菜藻体切成大小不同的切段、以及任意切碎,培养于添加氮、磷素的消毒海水中,后者分10℃、15℃、20℃、25℃四种不同温度条件培养,结果全部切段、切碎片都很快再生出假根附着于基质,并再生出一至多个叶状体;叶状体长大后从基部长出新的假根成为完整的幼苗(再生苗)。试验表明,大的切段其再生苗生长快、长度大,但出苗率(一定长度的藻体长出再生苗数量)低。培养温度较高时(20—25℃),藻体任意切碎片再生速度快、附着速度快、数量多且较牢固。利用藻体切碎片来培养鹧鸪菜幼苗是可行的;培养的适宜温度为20℃以上、海水比重为1.010左右。本文还对鹧鸪菜损伤藻体再生的情况(繁殖生殖学)进行一些观察和描述。