聚焦电流法隧道超前探测导电纸模拟

为了解决传统直流电法隧道超前探测易受旁侧影响的问题,文章根据侧向测井的电极系布置,研究和提出了三种聚焦电流法隧道超前探测电极布置方式。在导电纸实验中,通过不同的电极排列方式和实验参数设置,研究和分析了聚焦电流法隧道超前探测效果的影响因素及其探测曲线特征。导电纸实验表明：聚焦电流法具有较好的超前探测效果,并且数据处理解释简单。     

基于统一强度理论深埋圆形隧道围岩的剪胀分析

基于连续介质理论中岩体的剪胀角与围压和塑性剪切应变密切相关,隧洞周边岩体的应力状态因开挖卸荷而发生应力重分布,迫使其围压由原地应力逐渐衰减,塑性剪切应变不断增加,引起剪胀效应呈非线性变化。首先,基于统一强度理论和非关联流动法则,将潜在塑性区围岩按等围压释放划分为若干同心圆,提出了考虑中间主应力和非线性剪胀性的有限差分法,计算应变软化围岩的力学问题,并以实例验证其正确性。其次,通过参数分析,研究塑性区内岩体的剪胀角受中间主应力、临界软化系数和支护力的影响规律。研究结果表明,中间主应力主要影响剪胀角的峰值,随着中间主应力效应增加,剪胀峰值增加;临界软化系数主要影响剪胀角的变化率,随着临界软化系数的增加,剪胀角变化缓慢;中间主应力和临界软化系数共同影响塑性区剪胀角的变化;随着支护力的增加,洞壁处的剪胀角增加;双剪强度理论计算的位移值较小,应谨慎采用,同时采用Mohr-Coulomb强度准则时可以适当考虑围岩的承载潜力。     

双线盾构施工时邻近地下管线安全性判别

研究双线盾构隧道施工时邻近地下管线的安全性判别方法。基于Winker弹性地基梁模型,考虑管土效应,建立连续管线应变与地表沉降关系式;假设管线位移与土体位移相同,建立非连续管线接头转角与地表沉降关系式;同时考虑管线老化,定义与时间相关的折减系数,建立一种通过测量地表沉降值即可判断管线安全性的方法。当管线应变或接头转角为安全允许值时,对应的地表沉降即为控制值。施工时,若地表沉降超过该值,则表明管线存在危险。该方法将不易监测的管线状态转化为可见的地表沉降。研究结果表明：预测值与实测值的对比说明了所提方法具有可靠性;双线隧道水平间距L值对地表沉降控制值的影响非常大。当L较小时,最大值出现在两隧道中轴线处;当L较大时,最大值出现在隧道轴线上方附近处;随着L的增大,最大控制值逐渐减小。     

平面P波入射下浅埋平行双洞隧道注浆加固减震机制

地震动作用下小净距隧道双洞之间存在动力放大效应,依托某强震区小净距盾构隧道工程,基于傅里叶贝塞尔级数展开法,给出了平面P波垂直入射下地下半空间弹性介质中圆形双洞复合式衬砌洞室动应力解析解,深入研究了洞室间距、隧道全环注浆加固参数对衬砌动应力集中的影响。研究表明：洞室间距对衬砌的动应力有显著影响,随着洞室之间距离减小,左右洞室衬砌动应力明显放大;2.5倍洞径可以作为双洞洞室动力临界净距,当洞室间距小于2.5倍洞径时,应进行抗减震设计;注浆全环加固隧道周边土体,可以明显降低衬砌动应力,随着注浆加固区土体刚度增加,衬砌动应力幅值减小;结合工程实际,建议注浆加固区厚度取0.5倍的洞室半径值,加固区岩体和围岩剪切波速度之比取1.2。     

隧道工程围岩大变形类型与机制研究

通过对国内外隧道工程在施工和运营中以及正在施工的公路隧道遇到的围岩大变形问题的分析研究,在对围岩大变形进行定义的基础上,对围岩大变形进行了类型和机制划分,对我国今后长大深埋隧道工程大变形地质灾害的预测和防治具有重要意义。     

隧道掘进机施工条件下的隧洞围岩分类方法探讨

针对隧道掘进机(Tunnel Boring Machine--TBM)施工隧洞中的围岩分类问题,指出TBM施工条件下的隧洞围岩分类应针对围岩的可钻掘性,充分考虑影响TBM掘进效率的主要工程地质因素,提出了在《工程岩体分级标准》围岩稳定性基本分级的基础上,依据岩石的单轴抗压强度、岩石的耐磨性和岩体的完整性将TBM施工条件下的隧洞围岩分为A(好)、B(一般)、C(差)3个级别的围岩分类新方法。     

穿越公路偏压小净距隧道施工方法探讨

西康高速公路长哨小净距隧道地形复杂特殊,尤其在出口段存在浅埋、偏压现象,且左隧道覆盖层上部为陕西省S102省道,隧道开挖期间,省道正常开通。为研究隧道开挖方式对省道路面沉降及洞室开挖后围岩稳定性的影响,通过建立符合实际地形的三维模型,分别针对上下台阶法、留核心土法、侧壁导坑法3种开挖方法进行了数值模拟,对不同开挖方式隧道不同位置的塑性区、围岩变形及地表沉降进行了分析,提出了符合实际的开挖施工方案,并同实际现场监测数据进行了比较。研究结果表明,采用上下台阶开挖法实现省道下的小净距隧道穿越方式,可保证施工期间省道的正常运行及隧道围岩的稳定性。     

阿里山森林铁路隧道复建工程的设计与施工探讨

2009年8月8日莫拉克台风重创南台湾,嘉义阿里山区72 h的累积雨量高达2 500 mm以上,百年历史的阿里山森林铁道因沿线路基严重流失而停驶。其中两处大崩塌路段的复建工程以顺应自然为原则,采取迂回隧道方式避开崩塌区,需克服沿线地质变化及地下水问题,评估结果是以凿岩机工法及钻爆工法进行开挖。两座隧道的西口段崩积层分别长达109.8、99 m,是隧道开挖阶段的关键地段。隧道开挖支撑设计系依据台湾岩体分类与支撑系统（PCCR系统）及新奥工法的理念,沿线采用先进支撑材料包括超前管棚钢管、桁型钢支护、钢纤维喷射混凝土及自钻式锚杆等,除了可确保施工安全外,亦可提高施工进度。目前两隧道均已贯通且变形量控制均符合安全,说明隧道采用先进支撑方式穿越破碎崩积层段的成效良好,其研究结果可为相关工程设计提供参考。     

Seismic response of shallow circular tunnels in two-layered ground

The effect of ground stratification on the seismic response of circular tunnels is investigated, as most practice-oriented studies consider homogeneous ground. A finite element plain-strain model of a circular tunnel cross-section embedded in a two-layered ground is used to highlight the influence of stratification on the tunnel׳s seismic response. The layers interface was placed at the crown, centre and invert level.It is proved that ground stratification has an important role in the lining seismic forces. When the tunnel is fully embedded in one of the layers, the seismic lining forces may vary significantly in comparison with the single-layer case. If the tunnel intercepts both layers, maximum lining forces aggravation occurs when the lower layer is very stiff.     

Comparative mineralogy and geochemistry of hydrothermal iron‐rich crusts from the Pitcairn,Teahitia‐mehetia,and Macdonald hot spot areas of the S. W. pacific

Abstract

Hydrothermal iron‐rich crusts have been recovered from a number of hot spot volcanos including Crough Seamount, Pitcairn Volcanos 2 and 1, Cyana Seamount, Teahitia, Moua Pihaa, and Macdonald Seamount in the S. W. Pacific. Mineralogically, the crusts consists of ferrihydrite with traces of the weathering products of volcanic ash (feldspar, nontronite, pyroxene, and serpentinite). The iron oxyhydroxide phase has a mean particle size of 3–4 nm indicating rapid deposition. Electron microprobe studies have revealed the presence of filamentous iron‐silica deposits within the crusts reflecting the possible bacterial oxidation of iron from the hydrothermal fluids. The crusts display wide variability in composition both between individual sampling stations and between seamounts. Endmember analysis shows that the compositional data can be resolved into three endmembers: a Fe‐rich endmember, a light and heavy rare earth element endmember, and a Ba (barite)‐rich endmember. The Fe‐rich endmember appears to contain very low concentrations of most trace elements. For bulk samples, the composition of the iron‐rich crusts reflects dilution of the iron oxyhydroxide phase by volcanic ash and, to a lesser extent, a hydrogenous component. This is illustrated by the wide variability in SiO₂ (11.1–71.3%) and Mn (0.01–1.21%) contents of the crusts. For iron‐rich crusts containing greater than 40% Fe, the Pitcairn crusts display lower contents of Pb, Ba, Mo, U, Th, As, and rare earth elements (REE) and lower cerium anomalies than those from Teahitia. REE profiles of crusts from each of the hot spot volcanoes are characterized by small negative cerium anomalies but pronounced positive europium anomalies. The low average La/Fe ratios of the crusts from the various seamounts (47–572 X 10^‐6) and positive Eu anomalies of the crusts suggest rapid deposition of the iron oxyhydroxide near the hydrothermal vent. The high Fe/Mn ratio of vent fluids at hot spot volcanoes (8.5–5.6) may account for the formation of these iron‐rich crusts. The present data indicate that there may be differences in the nature of the iron‐rich crusts based on the depth of occurrence. This influences the temperature of the venting hydrothermal fluids and the possibility of occurrence of submarine phreatomagmatic eruptions.