基于模糊集合理论的GPS高程多面函数拟合模型平滑因子优选

建立GPS高程多面函数拟合模型,其平滑因子是否合适,对GPS水准高程测量精度将产生重要影响.基于模糊集合理论,提出平滑因子的优选方法,实例分析表明,该方法具有较好的实用价值.     

低阻区利用地回路标定航空TEM系统的理论研究

本文针对吊舱式航空TEM系统,建立了基于地回路的系统参数标定模型,并分别计算了自由空间模型响应(TLR)、均匀大地模型响应(TER)、地回路与大地耦合模型响应(TELR和TLER).由于TER响应表现为幅度沿测线不变,据此提出通过增加拟合参数的方法实现系统标定,消除了TER响应对标定的影响.TELR和TLER早期响应具...     

Improved estimators of correlation and R2 for skewed hydrologic data

ABSTRACT

The coefficient of determination R² and Pearson correlation coefficient ρ = R are standard metrics in hydrology for the evaluation of the goodness of fit between model simulations and observations, and as measures of the degree of dependence of one variable upon another. We show that the standard product moment estimator of ρ, termed r, while well-behaved for bivariate normal data, is upward biased and highly variable for bivariate non-normal data. We introduce three alternative estimators of ρ which are nearly unbiased and exhibit much less variability than r for non-normal data. We also document remarkable upward bias and tremendous increases in variability associated with r using both synthetic data and daily streamflow simulations from 905 calibrated rainfall–runoff models. We show that estimators of ρ = R accounting for skewness are needed for daily streamflow series because they exhibit high variability and skewness compared to, for example, monthly/annual series, where r should perform well.     

Correlation between plate age and layer separation of double seismic zones

Global seismicity catalogs are sufficient for characterizing double seismic zones (DSZs) in subducting slab and facilitate to estimate layer separation without inconsistent uncertainties as local catalogs. Previous studies have shown the correlation between DSZs layer separation and plate age while correlation for those younger than ~60 Ma is suspicious. The lacking of DSZs with layer separation less than 10 km further makes it difficult to precisely estimate such correlation. Thus, we incorporate eight DSZs data determined through local seismicity into globally-determined dataset and reexamine such correlation. The best fitting results show that both a linear model and a square root of plate age can mathematically fit the layer separation well. However, it is difficult to distinguish these two models when plate age is greater than ~20 Ma since their difference is less than 2 km. However, if extrapolation is possible, both models should provide physical information that DSZs will not form if there is no subducting lithosphere. As a result, the DSZs cannot be produced until the oceanic lithospheric age becomes greater than 0.9 Ma in the square root model while the linear model gives a misleading result. As such the square root model demonstrates the relationship physically better than the linear one, it still needs further test in the future with more available data, nevertheless, our study might also provide evidence for the suggestion that the plate age is a primary control factor of the DSZs geometry as well as the subducting process which disregards any local tectonic stresses.     

Heat calculation and numerical simulation in steam mining of permafrost gas hydrate

Steam mining method was injecting hot steam into the borehole to heat the hydrate strata at the same time of depressurization mining,which could promote further decomposition and expand mining areas of gas hydrate. Steam heat calculation would provide the basis for the design of heating device and the choice of the field test parameters. There were piping heat loss in the process of mining. The heat transfer of steam flowing in the pipe was steady,so the heat loss could be obtained easily by formula calculation. The power of stratum heating should be determined by numerical simulation for the process of heating was dynamic and the equations were usually nonlinear. The selected mining conditions were 500-millimeter mining radius,10 centigrade mining temperature and 180 centigrade steam temperature. Heat loss and best heating power,obtained by formula calculation and numerical simulation,were 21. 35 W/m and 20 kW.     

Design principle for parameters and interferences of tungsten carbide insert interface on roller bits

The lifetime of roll-bits with inserted tooth will be obviously decreased while drilling in strata and the tungsten carbide can be integrally separated from the roll-cone,which will need more trip out time to replace the roller bit.This study provides an entire analysis on stress as well as strength for teeth and tooth holes in loaded conditions.Qualities of tooth drop from matrix within roller bit.The optimized interferences of teeth inserted into the bit can be reasonably obtained by the critical interference derived from some relevant influence factors on the tooth-fixing quality of roller bits.     

Automatic techniques for 3D reconstruction of critical workplace body postures from range imaging data

The paper shows techniques for the determination of structured motion parameters from range camera image sequences. The core contribution of the work presented here is the development of an integrated least squares 3D tracking approach based on amplitude and range image sequences to calculate dense 3D motion vector fields. Geometric primitives of a human body model are fitted to time series of range camera point clouds using these vector fields as additional information. Body poses and motion information for individual body parts are derived from the model fit. On the basis of these pose and motion parameters, critical body postures are detected. The primary aim of the study is to automate ergonomic studies for risk assessments regulated by law, identifying harmful movements and awkward body postures in a workplace.     

变形测量异常数据处理中小波变换最佳级数的确定

综合分析数据去噪效果的4个分项评价指标,即数据的均方根差变化量、互相关系数、信噪比及平滑度,将各分项评价指标归化到0,1后相加得到总体评价指标,将总体评价指标最大值所对应的级数定义为小波分解与重构的最佳级数。模拟和实测两个算例验证了此方法的有效性。     

鞍本地区早前寒武纪地质体铅同位素组成及铀源条件定量计算方法研究

本文对比了鞍本地区前寒武纪铅-锌-银矿区和铀矿区的硫化物矿石和花岗岩长石Pb同位素组成,分别用矿石铅二阶段普通铅法、铅构造模式图解和全岩铅同位素组成三阶段拟合法计算了年龄和全岩原始铀含量。结果表明,矿石铅和长石铅模式年龄约为2000 Ma,在铅构造模式图上投影于2000~1600 Ma间,花岗岩和辽河群全岩拟合年龄为2000~1800 Ma;铅同位素组成显示铅-锌-银来自早元古代辽河群地层,连山关地区明显为放射性成因Pb同位素组成,源于富铀花岗岩。连山关矿石铅年龄和全岩三阶段年龄与该区铀矿床沥青铀矿的年龄基本一致;花岗岩原始铀的得失计算表明,该地区不同地质体均经历了约2000~1800 Ma花岗岩重熔改造,花岗质岩石发生了铀的丢失,是连山关地区铀矿的主要来源。     

基于广义极值分布的设计波高推算

简介了广义极值分布函数及其3种参数估计方法,包括极大似然(ML)、线性矩(LM)和间隔最大积(MPS)估计的计算方法。使用广义极值分布函数推算了北部湾涠洲岛海域3个波向的年波高极值序列设计波高,并与Weibull分布、Gumbel分布和皮尔逊Ⅲ型分布的推算结果加以对比。分析表明,涠洲岛海域极值波高服从于广义极值Ⅲ型分布,拟合优度检验结果表明广义极值分布能更好地拟合极值波高;MPS方法是一种优良的参数估计法,推算的设计波高可作为海岸环境工程设计的首要参考值。