宜昌砾石层的沉积环境及地貌意义

宜昌砾石层上覆中更新世网纹红土,下伏白垩纪红层,共有22个岩性层组成,总厚超过100m。通过对宜昌地区剖面出露砾石层的沉积相分析表明,善溪窑和云池剖面由下至上出现冲积扇扇中-扇根亚相;李家院剖面与上述两剖面间有沉积间断,由下至上出现冲积扇扇端-扇中亚相。粒度分析也证明了该砾石层中的砂体属冲积扇中的辫状水道沉积,与沉积相分析所得结论一致。研究认为,宜昌砾石层具有典型的冲积扇沉积环境特征,主要为冲积扇扇顶部分。该冲积扇在宜昌东南地区如此大规模的发育,显示其形成时具有强大的水动力条件,通过对其形成的地貌环境意义进行探讨,初步认为,该冲积扇为长江三峡贯通的产物。据前人研究推断,宜昌砾石层的形成时代应该在1.08～0.73MaB.P.,三峡贯通应在1.0MaB.P.之前。     

Behavior of soil plugs in open‐ended model piles driven into sands

Calibration chamber tests were conducted on open‐ended model piles driven into dried siliceous sands with different soil conditions in order to clarify the effect of soil conditions on load transfer mechanism in the soil plug. The model pile used in the test series was devised so that the bearing capacity of an open‐ended pile could be measured as three components: outside shaft resistance, plug resistance, and tip resistance. Under the assumption that the unit shaft resistance due to pile‐soil plug interaction varies linearly near the pile tip, the plug resistance was estimated. The plug capacity, which was defined as the plug resistance at ultimate condition, is mainly dependent on the ambient lateral pressure and relative density. The length of wedged plug that transfers the load decreases with the decrease of relative density, but it is independent of the ambient pressure and penetration depth. Under several assumptions, the value of earth pressure coefficient in the soil plug can be calculated. It gradually reduces with increase in the longitudinal distance from the pile tip. At the bottom of the soil plug, it tends to decrease with increase in the penetration depth and relative density, and to increase with the increase of ambient pressure. This may be attributed to (1) the decrease of friction angle as a result of increase in the effective vertical stress, (2) the difference in the dilation degree of the soil plug during driving with ambient pressures, and (3) the difference in compaction degree of soil plug during driving with relative densities. Based on the test results, an empirical equation was suggested to compute the earth pressure coefficient to be used in the calculation of plug capacity using one‐dimensional analysis, and it produces proper plug capacities for all soil conditions.     

不同沙源供给条件下砾石床面的风沙流结构与蚀积量变化风洞实验研究

通过对不同沙源供给条件下各种砾石床面的风沙流结构、床面风蚀及堆积沙量变化的风洞实验,结果表明,风沙流结构是判断戈壁风沙流饱和与不饱和的一个重要途径,不同的戈壁风沙流结构对床面输、阻沙特性具有不同的指示意义。近地表0～6 cm高度内的风沙流结构决定了床面的输、阻性质,而6 cm以上的风沙流结构反映了风力对沙物质的输送状况。沙源供给的丰富与否,决定了风沙流的饱和程度,以及风沙流在砾石床面产生的蚀积状况。同等风速条件下,饱和风沙流的输沙率是非饱和风沙流输沙率的2～8倍。在饱和风沙流情形下,床面过程总体以积沙为主,且随风力的增强,床面积沙量急剧增加。在不饱和风沙流情形下,砾石床面总体以风蚀和输送沙物质过程为主,风沙流结构在0～2 cm高度内反映出砾石床面具有明显的阻沙功能,在2～5 cm高度上出现最大输沙值。     

老公营子煤矿煤层顶板突水机理

为探查内蒙古平庄煤业(集团)有限责任公司老公营子煤矿Ⅰ03(2)工作面突水机理,从工作面涌(突)水量、含水层地下水位、突水点水质3个参数的动态变化判别了突水水源,认为第四系含水层水的参与使矿井涌水量变大而引发突水;从导水裂缝带发育高度、有效隔水层性质、基岩风化带厚度3方面分析了导水通道的形成过程,认为由导水裂缝带、顶板含水层水压作用下的渗流通道和基岩风化带组成的复合导水通道是突水发生的原因。揭示了煤层顶板突水是在特定地质、采矿条件下发生的一个动态变化过程,导水裂缝带是否波及主要充水含水层并非突水是否发生的唯一判据。     

城市非点源污染负荷估算研究

针对污染地表水环境的城市径流污染源,利用SCS降雨径流模拟建立了城市径流不同土地利用类型径流系数与年降雨量的相关关系,其相关性显著;在不同降雨强度条件下,对典型示范区城市排污口实施降雨过程监测,获得了有代表性的城市径流污染物平均浓度,从而估算出辽宁省城市径流污染负荷总量。     

海南典型热带海草床4种代表性鱼类的生长特征及其对海草资源量变化的响应

文章以海南岛新村湾、黎安港和潭门港海草床为研究区域, 选取褐篮子鱼(Siganus fuscessens)、点斑篮子鱼(Siganus guttatus)、四带牙鯻(Pelates quadrilineatus)和细鳞鯻(Terapon jarbua) 4种代表性鱼类为研究对象, 分析其体长与体质量的关系, 并探讨4种鱼类对海草资源量变化的响应。结果表明, 除栖息于潭门港海草床的4种鱼为负异速生长, 其他区域海草床的鱼类均为正异速或等速生长; 4种鱼的体质量生长速率(即异速生长因子b)和肥满度呈现黎安港>新村湾>潭门港的趋势, 并与3个海草床的海草覆盖率、密度和生物量的变化趋势一致; 推测海草资源量下降可能增加鱼类的被捕食压力和减少食物来源, 从而导致生活于海草床的代表性鱼类生长速率下降。     

信阳地震台水管倾斜仪加速E倾变化分析

信阳地震台水管倾斜仪EW分量2016年5月出现加速E倾变化,为确定异常性质及产生原因,从观测洞室环境、仪器观测系统、气象数据、环境干扰等进行调查,并采用有限元法和不规则荷载模型,计算台站附近的信阳林业学校拆迁荷载变化对水管倾斜仪观测的影响,最终判定本次异常为林校拆迁所致。     

伊宁盆地尼勒克剖面侏罗系烃源岩有机地球化学特征

本对伊宁盆地北侧尼勒克剖面侏罗系烃源岩有机地球化学特征进行研究,结合盆地的沉积相及构造演化,探讨其生烃潜力及油气远景。该套烃源岩有机质丰度达到“中一好”的级别,有机质类型泥岩以Ⅲ1为主,煤为Ⅲ1、Ⅲ2型,处于低成熟演化阶段,具有一定的生烃潜力。推测在盆地内部更有利于烃源岩的成熟和保存。     

输导层和岩性圈闭中石油运移和聚集模拟实验研究

利用二维模型进行了输导层和岩性圈闭中石油运移与聚集模拟实验研究。结果表明：（１）地怪中的高渗透带是石油运移的主要通道,对油的运移和聚集构成重要的影响;（２）当上覆地层渗透性较大时,下部地层中的油可向上覆地层运移,并在运移过程中发生弥散和扩散作用,导致油的散失量增大;（３）油驱水过程中的排水过程滞后于注油过程,排出的水量并不随注油量加而线性增加,而是脉冲式变化。     

Multi-scale limit load analysis for discontinuous rock mass based on the homogenization method

A new method to evaluate the strength of rock mass structures is proposed and examined. The method is based on the collapse load analysis of elasto-perfectly plastic material along with the homogenization method, which enables the multi-scale analyses for heterogeneous media. The homogenization process replaces a rock mass with cracks by an equivalent continuum medium with macroscopic stiffness while the failure criterion for the rock mass is estimated in the localization process. It is shown that both the averaged stiffness and the macroscopic failure criterion of the discontinuous rock mass are numerically obtained via the finite element analyses. Thus, the failure strength of a rock mass structure is evaluated by the collapse load analysis in the form of Linear Programming with the macroscopic failure criterion. This is the first attempt to apply the homogenization method to the strength analysis of rock mass. Copyright © 1999 John Wiley & Sons, Ltd.