Estimation of Uplift Capacity of Rapidly Loaded Plate Anchors in Soft Clay

Plate anchors are extensively used in civil engineering constructions as they provide an economical alternative to gravity and other embedded anchors. The rate of loading is one of the important factors that affects the magnitude of soil resistance as well as soil suction force. This article outlines the effect of pullout rate on uplift behavior of plate anchors (70 mm diameter) buried in soft saturated clay by varying the pullout rate from 1.4 mm/min to 21.0 mm/min. The variation of breakout force and suction force with embedment depth and rate of pull are presented. A correlation between the rate of increase of undrained strength of clay and anchor capacity with rate of strain has been established. Finally an empirical equation has been proposed that includes the rate of pull in the estimation of breakout capacity of anchors.     

Calculation of transverse hydrodynamic coefficients using computational fluid dynamic approach

Computational Fluid Dynamic (CFD) based on Reynolds Averaged Navier–Stokes equation is used for determining the transverse hydrodynamic damping force and moment coefficients that are needed in the maneuverability study of marine vehicles. Computations are performed for two geometrical shapes representing typical AUVs presently in use. Results are compared with available data on similar geometries and from some of the available semi-empirical relations. It is found that the CFD predictions compares reasonable well with these results. In particular, the CFD predictions of forces and moments are found to be nonlinear with respect to the transverse velocity, and therefore both linear and nonlinear coefficients can be derived. A discussion on the sources of the component forces reveal that the total force and moment variations should in fact be nonlinear.     

Wave interaction with a submarine pipeline in clayey soil due to random waves

The wave pressure and uplift force due to random waves on a submarine pipeline (resting on bed, partially buried and fully buried) in clayey soil are measured. The influence of various parameters viz., wave period, wave height, water depth, burial depth and consistency index of the soil on wave pressures around and uplift force on the submarine pipeline was investigated. The wave pressures were measured at three locations around the submarine pipeline (each at 120° to the adjacent one). It is found that the wave pressure and uplift force spectrum at high consistency index of the soil is smaller compared to that of low consistency index. Just burying the pipeline (e/D=1.0) in clayey soil reduces the uplift force to less than 60% of the force experienced by a pipeline resting on the seabed (e/D=0.0) for I_c=0.33.     

On the radiation and diffraction of linear water waves by an infinitely long rectangular structure submerged in oblique seas

The radiation and diffraction of linear water waves by an infinitely long rectangular structure submerged in oblique seas of finite depth is investigated. The analytical expressions for the radiated and diffracted potentials are derived as infinite series by use of the method of separation of variables. The unknown coefficients in the series are determined by the eigenfunction expansion matching method. The expressions for wave forces, hydrodynamic coefficients and reflection and transmission coefficients are given and verified by the boundary element method. Using the present analytical solution, the hydrodynamic influences of the angle of incidence, the submergence, the width and the thickness of the structure on the wave forces, hydrodynamic coefficients, and reflection and transmission coefficients are discussed in detail.     

Wave interaction with a perforated wall breakwater with a submerged horizontal porous plate

This study examines the hydrodynamic performance of a new perforated-wall breakwater. The breakwater consists of a perforated front wall, a solid back wall and a submerged horizontal porous plate installed between them. The horizontal porous plate enhances the stability and wave-absorbing capacity of the structure. An analytical solution based on linear potential theory is developed for the interaction of water waves with the new proposed breakwater. According to the division of the structure, the whole fluid domain is divided into three sub-domains, and the velocity potential in each domain is obtained using the matched eigenfunction method. Then the reflection coefficient and the wave forces and moments on the perforated front wall and the submerged horizontal porous plate are calculated. The numerical results obtained for limiting cases are exactly the same as previous predictions for a perforated-wall breakwater with a submerged horizontal solid plate [Yip, T.L., Chwang, A.T., 2000. Perforated wall breakwater with internal horiontal plate. Journal of Engineering Mechanics ASCE 126 (5), 533–538] and a vertical wall with a submerged horizontal porous plate [Wu, J.H., Wan, Z.P., Fang, Y., 1998. Wave reflection by a vertical wall with a horizontal submerged porous plate. Ocean Engineering 25 (9), 767–779]. Numerical results show that with suitable geometric porosity of the front wall and horizontal plate, the reflection coefficient will be always rather small if the relative wave absorbing chamber width (distance between the front and back walls versus incident wavelength) exceeds a certain small value. In addition, the wave force and moment on the horizontal plate decrease significantly with the increase of the plate porosity.     

Evaluation of bending moments and shear forces at unit connections of very large floating structures using hydroelastic and rigid body analyses

This paper investigates the characteristics of bending moments, shear forces and stresses at unit connections of very large floating structures (VLFS) under wave loads. The responses of VLFS are calculated by solving multi-body motion equation considering hydroelasticity and connection stiffness. Hydroelastic responses are calculated by the direct method. Higher-order boundary element method (HOBEM) is used for fluid analysis and finite element method (FEM) is introduced for structural analysis. The equation of motion is modified to describe the unit connections by employing spring elements. Bending moments and shear forces at the connections are obtained from the dynamic equilibrium condition for pressures and inertia forces. Two types of VLFS units such as tandem arranged units and side-by-side arranged units are considered in the numerical examples. The influences of connection stiffness, wave frequency and heading angle on responses of VLFS are investigated through the numerical examples. Rigid body analysis along with hydroelastic analysis is also carried out in the numerical analysis and comparison of those two approaches is discussed.     

塞曼石墨炉原子吸收法直接测定海水中的铜

本文选择酒石酸消除海水基体对铜信号的干扰,用塞曼石墨炉原子吸收法直接测定海水中的铜。从Cu的原子化曲线可知,加入酒石酸后,背景值减小,Cu原子吸收信号增强,且出现时间提前,表明酒石酸是有效的海水基体改进剂。用P.E.Z3030光谱仪测得双蒸水及海水中的元素Cu的特征质量(m。)分别为12.5pg及12.7pg;检测限分别为0.18μg/L和0.19μg/L,表明基体效应已消除,符合海洋监测要求。可用纯Cu标准溶液作校正曲线,以国家海洋局的两个标准海水样品中的Cu评定本法的准确度,相对偏差为0及-4.6%,与经典的经富集后的FAAS法的结果相比,相对偏差在3.0—6.5％范围内。用不同类型的光谱仪测定了30个海水样品,回收率在89—104％范围内。本法操作简便、快速。     

日本鳗鲡白仔鳗耳石中心部分的电镜扫描观察

对在１９９０年４月取自长江口的白仔鳗耳石进行扫描电镜观察,发现了耳石中心核及其外周的深暗凹槽生长轮之间存在着数个生长轮。     

Statistics of wave forces on large horizontal cylinders

To the first order in a Stokes expansion, the pressure force exerted by a sea state on a large horizontal cylinder represents a stationary random Gaussian process. A relationship is obtained between the spectrum of this process and the wave spectrum. As a consequence, the basic statistical properties of the height and period of the individual waves of the force-process are also obtained. It is proven that these statistical properties agree very well with the data from a small scale field experiment.