鄂尔多斯盆地北部砂岩型铀矿铀矿物地质地球化学特征及其成因意义

鄂尔多斯盆地北部已发现系列砂岩型铀矿,由东往西依次有东胜铀矿、杭锦旗(纳岭沟)铀矿、大营铀矿等大型、特大型矿床,成为我国目前砂岩型铀矿发现规模最大、最具远景的地区。研究表明,它们具有相似的矿床地质特征和形成环境。在矿床成矿作用研究中,铀的存在形式及铀矿物特征对砂岩铀矿来说是一项重要的内容,其认识对铀的地浸开采可提供重要依据,也是了解砂岩型铀矿形成机制或矿床形成环境及成因的重要信息。本文主要从三个方面对鄂尔多斯盆地北部大营铀矿、纳岭沟铀矿等主要砂岩型铀矿中铀矿物地质地球化学特征和成因进行了研究和探讨。通过电子探针测试,高分辨率扫描电镜观察等手段,认为盆地北部铀矿的铀矿物类型主要为铀石,含少量的沥青铀矿、钛铀矿、水硅铀石、钍铀石等;铀矿物常与黄铁矿、有机质(煤屑)及方解石相伴生。采用逐级化学提取等方法定量地分析了铀矿物占矿石中铀配分的比例关系,认为其中铀矿物和吸附态约各占铀存在形式的50%。首次对砂岩型铀矿的铀矿物进行微区原位LA-ICP-MS稀土元素分析,认为ΣREE在铀矿物铀石中高度富集,是矿石中稀土元素的主要载体;稀土元素是铀矿石中可综合利用的有益组份,其标准化曲线表现为明显的右倾型,轻稀土富集,轻重稀土分馏强烈,δEu和δCe具较弱的负异常,说明总体上铀矿化形成于外生后成环境。从上述铀矿物特征,初步探讨了铀矿化形成的环境与成因,认为铀矿化形成经历了至少为低温流体作用的环境;铀矿化形成于浅部地壳即外生后成环境而与深源作用无关。     

Optimal routing for waste collection: a case study in Singapore

ABSTRACT

To collect and dispose growing amounts of municipal solid waste (MSW) changed to be a hot topic along with the rapid urbanization in past decades. Cities are more and more dependent on the incineration instead of landfilling due to the cost-efficiency and environmental concerns. Considering the limited number of incineration plants and complicated situation of transportation in both spatial and temporal dimensions in different cities, the optimal routing for waste collection turns to be meaningful research topic. In this research, the ant colony optimization (ACO)-based multi-objective routing model coupled with min-max model and Dijkstra’s algorithm is proposed to address the question of which route to take from these waste-generating points to the target incineration plant(s) considering travel time, accident probability (black spots), and population exposure, so as to support the routing decision-making. The model is successfully implemented in Singapore and the effectiveness of the model has also been justified. Besides, few limitations of this research have also been discussed, some of which would also be the future directions of our research, especially the design and integration of a web-based routing decision-making support system.     

An Analytical Solution for Dynamic Response of the Plate with Different Impedances Subjected to Underwater Explosion

In this paper, the transmitted part of the incident wave is considered to revise Taylor’s solution, which is used to extend its application for analytical models to predict the response of the plate with different material properties. The influence of the material properties and the boundary condition of the plate on fluid and structural dynamics is systematically investigated. The analytical results are compared with those of detailed dynamic FE simulations and the two are in good agreement. The results indicate that the analytical method is valid and suitable for the plates with different material properties subjected to underwater explosion. It is found that Taylor’s results of the plate with small impedance are invalid, which indicates a potential application field for the analytical method.     

Effect of Groundwater Fluctuations on Pore Pressures and Earth Pressures on Coastal Excavation Retaining Walls

Pore water and earth pressures acting on retaining structures are investigated using an efficient coastal double-layered excavation model to determine offshore excavation responses to groundwater fluctuations outside foundation pits. Total pore water pressure includes excess pore water pressure (due to groundwater fluctuations) and steady pore water pressure (due to steady seepage) determined using one-dimensional consolidation theory of double-layered soil and one-dimensional steady-state flow theory, respectively. Rankine's active and passive earth pressures are obtained from pore water pressure. This method is applicable to arbitrary groundwater fluctuation conditions. How physical parameters affect pore water pressure is numerically investigated using examples, demonstrating the method's practicality for calculating pore water and earth pressures.     

Is Ziarat a Potential Site for Conventional or Unconventional Energy Resources?

A structural interpretation of the Ziarat block in the Balochistan region (a part of the Suleiman Fold and Thrust Belt) has been carried out using seismic and seismological data. Seismic data consists of nine 2.5D pre‐stack migrated seismic lines, whereas the seismological data covers the Fault Plane Solution and source parameters. Structural interpretation describes two broad fault sets of fore and back thrusts in the study area that have resulted in the development of pop‐up structures, accountable for the structural traps and seismicity pattern in terms of seismic hazard. Seismic interpretation includes time and depth contour maps of the Dungan Formation and Ranikot group, while seismological interpretation includes Fault Plane Solution, that is correlated with a geological and structural map of the area for the interpretation of the nature of the subsurface faults. Principal stresses are also estimated for the Ranikot group and Dungan Formation. In order to calculate anisotropic elastic properties, the parameters of the rock strength of the formations are first determined from seismic data, along with the dominant stresses (vertical, minimum horizontal, and maximum horizontal). The differential ratio of the maximum and minimum horizontal stresses is obtained to indicate optimal zones for hydraulic fracturing, and to assess the potential for geothermal energy reservoir prospect generation. The stress maps indicate high values towards the deeper part of the horizon, and low towards the shallower part, attributed to the lithological and structural variation in the area. Outcomes of structural interpretation indicate a good correlation of structure and tectonics from both seismological and seismic methods.     

成层软土地基预固结处理后桩基水平承载力估算方法

目前通过对软土地基预加固处理来提高桩基水平承载力已被工程界认可,但如何在工程前期设计过程中估算软土地基预处理后桩基水平承载力提高值仍是技术难点。基于此,参考Bowles[1]的地基土水平抗力计算式,同时考虑成层软土地基预排水固结处理影响,通过数学推导,推求出根据原状软土室内土工试验抗剪强度指标及预加固处理时间,估算软土地基预处理后桩基水平承载力提高值的实用计算方法。考虑桩侧土弹塑性屈服影响,推导出成层软土中水平受荷桩弹塑性解析解及塑性区深度的计算式,给出了桩顶水平位移、桩身最大弯矩的无量纲计算式及相关计算源代码。依托于浙江省某水闸桩基工程案例,根据提出的计算方法对桩基水平承载力、桩顶水平位移及桩身最大弯矩等性状进行预估计算,并与地基预处理前、后现场试桩检测值进行验证对比,认为桩基水平承载力、桩顶水平位移及桩身最大弯矩等预估计算成果与工程现场试桩的检测值较接近,对类似工程设计具有较好的参考价值。     

Lateral dynamic response of a pipe pile in saturated soil layer

This paper presents an analytical solution for the lateral dynamic response of a pipe pile in a saturated soil layer. The wave propagations in the saturated soil and the pipe pile are simulated by Biot's three‐dimensional poroelastic theory and one‐dimensional elastic theory, respectively. The governing equations of soil are solved directly without introducing potential functions. The displacement response and dynamic impedances of the pipe pile are obtained based on the continuous conditions between the pipe pile and both the outer and inner soil. A comparison with an existing solution is performed to verify the proposed solution. Selected numerical results for the lateral dynamic responses and impedances of the pipe pile are presented to reveal the lateral vibration characteristics of the pile‐soil system. Copyright © 2015 John Wiley & Sons, Ltd.     

Bearing capacity of strip foundations reinforced with geogrid sheets by using upper bound finite‐element limit analysis

By using the upper bound finite‐elements limit analysis, with an inclusion of single and two horizontal layers of reinforcements, the ultimate bearing capacity has been computed for a rigid strip footing placed over (i) fully granular, (ii) cohesive‐frictional, and (iii) fully cohesive soils. It is assumed that (i) the reinforcements are structurally strong so that no axial tension failure can occur, (ii) the reinforcement sheets have negligible resistance to bending, and (iii) the shear failure can take place between the reinforcement and soil mass. It is expected that the different approximations on which the analysis has been based would generally remain applicable for reinforcements in the form of geogrid sheets. A method has been proposed to incorporate the effect of the reinforcement in the analysis. The efficiency factors, η_c and η_γ, to be multiplied with N_c and N_γ , for finding the bearing capacity of reinforced foundations, have been established. The results have been obtained (i) for different values of ? in case of fully granular and cohesive‐frictional soils, and (ii) for different rates at which the cohesion increases with depth for a fully cohesive soil. The optimum positions of the reinforcements' layers have also been determined. The effect of the reinforcements' length on the results has also been analyzed. As compared to cohesive soils, the granular soils, especially with higher values of ?, cause a much greater increase in the bearing capacity. The results compare reasonably well with the available theoretical and experimental data from literature. Copyright © 2013 John Wiley & Sons, Ltd.     

One‐dimensional consolidation with a threshold gradient: a Stefan problem with rate‐dependent latent heat

During the process of one‐dimensional consolidation with a threshold gradient, the seepage front moves downward gradually, and the problem is indicated as a Stefan problem. The novel feature in this Stefan problem is a latent heat that varies inversely with the rate of the moving boundary. An exact solution for the external load that increases in proportion to the square root of time is constructed using the similarity transformation technique. Computational examples concerning the effect of different parameters on the motion of the seepage front are presented. The exact solution provides a worthwhile benchmark for verifying the accuracy of numerical and approximate methods. Copyright © 2013 John Wiley & Sons, Ltd.     

Analytical solutions for Euler–Bernoulli beam on visco‐elastic foundation subjected to moving load

Analytical solutions for the steady‐state response of an infinite beam resting on a visco‐elastic foundation and subjected to a concentrated load moving with a constant velocity are developed in this paper. The beam responses investigated are deflection, bending moment, shear force and contact pressure. The mechanical resistance of the foundation is modeled using two parameters k_s and t_s — k_s accounts for soil resistance due to compressive strains in the soil and t_s accounts for the resistance due to shear strains. Since this model represents the ground behavior more accurately than the Winkler spring model, the developed solutions produce beam responses that are closer to reality than those obtained using the existing solutions for Winkler model. The dynamic beam responses depend on the damping present in the system and on the velocity of the moving load. Based on the study, dynamic amplification curves are developed for beam deflection. Such amplification curves for deflection, bending moment, shear force and contact pressure can be developed for any beam‐foundation system and can be used in design. Copyright © 2012 John Wiley & Sons, Ltd.