Consolidation and creep behaviors of two typical marine clays in China

This paper presents an experimental investigation into the deformation characteristics of two typical marine clays obtained from Dalian and Shanghai, respectively, in China. Three kinds of laboratory tests, i.e. conventional oedometer tests, one-dimensional and triaxial creep tests were carried out. The results obtained from consolidation tests demonstrate linear v e ？ log？ relationships for Shanghai clay at normally consolidated state, while partly or even global non-linearrelationships for Dalian clay. The compression index c C for both clays follows the correlation of Cc=0.009（WL-10）where WL is the liquid limit of soil. The relationship between v log Kv （ Kv is the hydraulic conductivity of soil） and voidratio e is generally linear and the hydraulic conductivity change index kv C can be described by their initial void ratio forboth clays. The secondary compressibility of Dalian clay lies in medium to high range and is higher than that of Shanghaiclay which lies in the range of low to medium. Furthermore, based on drained triaxial creep tests, the stress-strain-timerelationships following Mesri＇s creep equation have been developed for Dalian and Shanghai clays which can predict thelong-term deformation of both clays reasonably well.     

结构面中粘土矿物及含水率变化对边坡稳定性影响的试验研究

以南京某边坡结构面中的滑带土为研究对象,定量分析不同的滑带土颗粒级配情况下,岩质边坡结构面中粘土矿物含量及含水率的变化对边坡稳定性影响机制及变化规律.随着粘土矿物的增加,安全系数值整体上呈现减小的趋势,安全系数在45％～55％之间时达到最低;随含水率的增加,安全系数值也呈下降的趋势.采用了粒子群算法对试验成果作以解析,结果显示,随着粘土矿物含量的增加,安全系数的变化为非线性,但始终表现出较好的相关性,其相关系数由小变大;安全系数值与含水率呈现出一种负相关的线性关系,且保持较高的相关性,相关系数在0.90以上,较符合一般的自然规律.     

动应力对粉质土变形、强度的影响

研山铁矿设计采用露天开采,最终最大边坡高达600m。边坡上部为粉土和粉砂、中砂、卵石、粉质粘土,下部为砂质粘性土和砾质粘性土。由于边坡高,受环境动应力影响因素大,因此分析粉土和粉质粘土层在动应力作用下对变形和强度的影响,对边坡稳定分析具有重要意义。     

Mud dispersal across a Cretaceous prodelta: Storm‐generated,wave‐enhanced sediment gravity flows inferred from mudstone microtexture and microfacies

Determining sediment transport direction in ancient mudrocks is difficult. In order to determine both process and direction of mud transport, a portion of a well‐mapped Cretaceous delta system was studied. Oriented samples from outcrop represent prodelta environments from ca 10 to 120 km offshore. Oriented thin sections of mudstone, cut in three planes, allowed bed microstructure and palaeoflow directions to be determined. Clay mineral platelets are packaged in equant, face‐face aggregates 2 to 5 μm in diameter that have a random orientation; these aggregates may have formed through flocculation in fluid mud. Cohesive mud was eroded by storms to make intraclastic aggregates 5 to 20 μm in diameter. Mudstone beds are millimetre‐scale, and four microfacies are recognized: Well‐sorted siltstone forms millimetre‐scale combined‐flow ripples overlying scoured surfaces; deposition was from turbulent combined flow. Silt‐streaked claystone comprises parallel, sub‐millimetre laminae of siliceous silt and clay aggregates sorted by shear in the boundary layer beneath a wave‐supported gravity flow of fluid mud. Silty claystone comprises fine siliceous silt grains floating in a matrix of clay and was deposited by vertical settling as fluid mud gelled under minimal current shear. Homogeneous clay‐rich mudstone has little silt and may represent late‐stage settling of fluid mud, or settling from wave‐dissipated fluid mud. It is difficult or impossible to correlate millimetre‐scale beds between thin sections from the same sample, spaced only ca 20 mm apart, due to lateral facies change and localized scour and fill. Combined‐flow ripples in siltstone show strong preferred migration directly down the regional prodelta slope, estimated at ca 1 : 1000. Ripple migration was effected by drag exerted by an overlying layer of downslope‐flowing, wave‐supported fluid mud. In the upper part of the studied section, centimetre‐scale interbeds of very fine to fine‐grained sandstone show wave ripple crests trending shore normal, whereas combined‐flow ripples migrated obliquely alongshore and offshore. Storm winds blowing from the north‐east drove shore‐oblique geostrophic sand transport whereas simultaneously, wave‐supported flows of fluid mud travelled downslope under the influence of gravity. Effective wave base for sand, estimated at ca 40 m, intersected the prodelta surface ca 80 km offshore whereas wave base for mud was at ca 70 m and lay ca 120 km offshore. Small‐scale bioturbation of mud beds co‐occurs with interbedded sandstone but stratigraphically lower, sand‐free mudstone has few or no signs of benthic fauna. It is likely that a combination of soupground substrate, frequent storm emplacement of fluid mud, low nutrient availability and possibly reduced bottom‐water oxygen content collectively inhibited benthic fauna in the distal prodelta.     

Determination of trace and rare-earth elements in Chinese soil and clay reference materials by ICP-MS

Inductively coupled plasma mass spectrometry(ICP-MS) has become a powerful tool for providing reliable analytical results in many laboratories around the word. In this study, the mixture of HF and HNO3 acids in high-temperature and high-pressure closed-vessel digestion technique were used to decompose some Chinese reference materials, and thirty seven elements were determined by ICP-MS. Most of the results for Chinese soil reference materials were found to be in reasonable agreement with the reference values, except Cs, Ta, Li, Ge, Zn, Nd, Tb and Ta whose values need to be revised. Their precisions were typically lower than 5% RSD. However, the Precisions of Chinese clay reference materials, especially for GBW03102 and GBW03102a, were significantly different with reference values, probably reflecting the existence of a coarser-grained fraction(70 μm) in samples, and the formation of fluorides in Al-rich samples during sample decomposition by using the mixture of HF and HNO3 acids. Moreover, thirty-seven trace elements covering the mass range from Li to U in four Chinese clay reference materials were firstly provided with good precision and accuracy in this study.     

Paleoclimate and Paleoenvironment of Gonghe Basin, Qinghai-Tibet Plateau, During the Lastdeglacial: Weathering, Erosion and Vegetation Cover Affect Clay Mineral Formation

With the analysis of the sources and formation mechanism of the clay minerals in the sediment core from the Dalianhai lake in the Gonghe Basin,northeastern Tibet-Qinghai Plateau,clay mineral composition proxies,grain-size and carbonate contents have been employed for high-resolution study in order to reconstruct East Asian Summer Monsoon （EASM） over the northeastern Tibet-Qinghai Plateau during the lastdeglacial.The study also extended to establish a relationship between vegetation cover changes and erosion during the last 14.5 ka with pollen record and clay mineral proxies.Smectite/kaolinite and smectite/（illite＋chlorite） ratios allow us to assess hydrolysis conditions in lowlands and/or physical erosion process in highlands of the Gonghe Basin.Before 12.9 Cal ka BP,both mineralogical ratios show low values indicative of strong physical erosion in the basin with a dominant cold and dry phase.After 12.9 Cal ka BP,an increase in both mineralogical ratios indicates enhanced chemical weathering in the basin associated with a warm and humid climate.The beginning of Holocene is characterized by high smectite/（illite＋chlorite） and smectite/kaolinite ratios that is synchronous as with deposition of many peat laminae,implying the best warm and humid conditions specifically between 8.0 to 5.5 Cal ka BP.The time interval after 5.0 Cai ka BP is characterized by a return to high physical erosion and low chemical weathering with dry climate conditions in the basin.Comparing variations of clay mineral assemblages with previous pollen results,we observe a rapid response in terms of chemical weathering and physical erosion intensity to a modification of the vegetation cover in the basin.     

粘土矿物的提取、鉴定及其古气候意义——以柴达木盆地怀头他拉剖面为例

沉积物中粘土矿物类型主要有自生粘土矿物和碎屑粘土矿物。其中,自生粘土矿物含量较少,是在沉积环境中形成,可能是沉积再循环或成岩作用的产物,可作为沉积环境某方面的指示标志;而碎屑粘土矿物是母岩风化的产物,受沉积环境影响较小,能够有效示踪物源区化学风化过程,进而反映古气候变化。近年来利用碎屑粘土矿物特征来重建物源区古气候的方法得到了广泛的应用。然而,由于粘土矿物主要存在于<2 μm硅酸盐粘粒中,粘土矿物的提取、鉴定比较困难,且自生粘土矿物易受沉积环境等的影响。因此,在利用粘土矿物重建古气候变化时,需慎重选择粘土矿物的提取方法,并考虑物源和沉积环境变化以及成岩作用等对粘土矿物解释的影响。本文以柴达木盆地东北缘怀头他拉剖面硅酸盐粘土矿物的提取、鉴定及其古环境指示意义为例,介绍粘土矿物的提取及应用,为后期粘土矿物研究提供参考。     

Characteristics and distribution of clay minerals and their effects on reservoir quality: Huagang Formation in the Xihu Sag,East China Sea Basin

Abstract

The characteristics and distribution of clay minerals and their effects on reservoir quality in the Huagang sandstones in the Xihu Sag, East China Sea Basin were studied by using X-ray diffraction, casting thin-sections, scanning electron microscopy, electron microprobe analysis, fluid inclusion analysis, constant-rate mercury injection and nuclear magnetic resonance. Clay minerals consist of kaolinite, chlorite, illite and illite–smectite mixed layer (I/S); kaolinite forms from dissolved feldspars, chlorite occurs as clay coatings that are transformed from clay precursors owing to the flocculation of suspended detrital clays or the crystallisation of pore fluids, and illite forms from the illitisation of detrital smectite, authigenic kaolinite and K-feldspars. Clay distribution is controlled by sedimentary environments, burial history and lithologies. Typical reservoirs in the western sub-sag are thin and developed in braided river facies at relatively shallow burial depths with clays dominated by kaolinite. However, typical reservoirs in the central inversion tectonic zone are thicker and developed in a braided delta front facies at deeper burial depths with clays mainly consisting of chlorite, illite and I/S. High-quality reservoirs are characterised by coarse granularity, high quartz content and low clay content with widespread development of chlorite coatings that inhibit quartz cements at low temperatures. At higher temperatures, the high-quality reservoirs develop more pores providing growth space for quartz cements and result in the coexistence of chlorite coatings and quartz cements. The high-quality reservoirs are controlled by their lithological characteristics rather than chlorite coatings. Illite and I/S clays create severe damage to reservoirs by reducing the size and connectivity of pore-throats.     

Extension of the Griffith's fracture criteria to saturated clays

Inglis [1] has solved the problem of distribution of stress in an elastic plate around an elliptical hole. His works clarify the role of cracks in the failure of an elastic material. However, his solution cannot be applied to saturated clay because he considers only total stresses, while, in saturated clay, the criterion of rupture should be expressed in terms of effective and not total stresses. The solution of Atkinson and Craster [2] using Biot's poroelasticity theory, shows that there is no high pore pressure in the vicinity of the crack tips for saturated clay. The major difference between this approach and the Biot's theory of is that, in saturated clay, strain is a function of the variation of the effective stress [3], while, in poroelastic media, strain is only a function of the variation of the total stress [4, Equation 2.2]. Also in their solution there is continuity between the pore fluid and the inner fluid in the crack. Their solution is valid for poroelastic media involving a movement of the pore fluid. In our solution there is no movement of the pore fluid (Undrained condition). In this paper we have solved the same problem as Inglis [1], but for the particular case of saturated clay obeying elastic law. By solving this problem we obtained the expressions for pore pressure, effective stress, total stress and displacements. The results show that not only the total stress but also the pore pressure and the effective stress are also high in the vicinity of the crack tips. A new failure criterion, based on Griffith's strain energy principle [5] and maximum tensile stress [6], valid for saturated clay is developed in this paper. Copyright © 2003 John Wiley & Sons, Ltd.