火焰原子吸收法间接测定磷矿中氯

火焰原子吸收法间接测定磷矿中氯达刘生１云南个旧市化肥厂中心化验室个旧６６１４１１目前磷矿中Ｃｌ－含量的测定多采用浊度法、氯离子选择电极法及离子色谱法。本文采用火焰原子吸收法来间接测定磷矿中Ｃｌ－，即在试样溶液中加入定量的Ａｇ＋，试样中Ｃｌ－与Ａｇ＋生...     

锇粉中杂质元素分析方法研究

利用ＩＣＰ＿ＭＳ技术建立了锇粉中痕量杂质元素的分析方法。在浓ＨＮＯ３介质中，锇以ＯｓＯ４形式挥发除去，分离锇基体后，可直接测定的痕量元素达５０余种。取样量０．１ｇ，测定限为０．２～２４６ｎｇ／ｇ，可实现质量分数ｗ（Ｏｓ）为９９．９９９９％锇粉中杂质元素测定。结合ＩＣＰ＿ＡＥＳ测定Ｋ、Ｎａ、Ｃａ、Ｍｇ、Ａｌ、Ｆｅ、Ｓｉ和Ｐ，可实现锇粉原料及产品的纯度分析。     

铋的原子吸收光谱分析进展

文章对１９８５年以来用原子吸收光谱法测定Ｂｉ的情况进行了综述，着重介绍了用氢化物发生法、石墨炉法和火焰法测Ｂｉ时，为了提高灵敏度所采用的各种氢化物发生装置及根据不同试样所使用的各种分离富集手段。主要参考文献１０１篇。     

X射线荧光测井井液的影响与校正

X射线荧光测井中 ,井液位于井下探管与井壁之间 ,它的影响不但表现在对特征X射线的吸收 ,而且表现在对源初级射线和特征 X射线的散射。井液的校正采用硬件与软件相结合的方法 ,在硬件上 ,使含有探测器的部分制成单独的短臂 ,有效地保证了探测窗与井壁的良好接触 ;在软件上 ,提出的双散射峰法和散射峰 -逃逸峰法 ,能够校正 0 - 10 mm厚的井液对 X射线荧光测井结果的影响     

涂钨热解石墨管－石墨炉原子吸收法测定天然水中痕量钡

选择涂钨热解石墨管测钡，克服了钡的碳化物形成而提高了方法的灵敏度，采用钙做基体补偿不仅克服钙对测钡的影响，同时也对测钡起增敏作用，结合其它测定条件的优化实现了石墨炉原子吸收法测定天然水中的痕量钡。其线性范围在０～７０μｇ／Ｌ检出限３．３ｐｇ，特征质量为２．９ｐｇ／１％吸收，对５μｇ／ＬＢａ试液测定１１次，其ＲＳＤ为６．９％，加标回收率８９％～１２０％。方法经标样分析验证，结果与标准值相符。     

Surface chemical analysis in coal preparation research: complementary information from XPS and ToF-SIMS

The application of X-ray photoelectron spectroscopy (XPS) to coal surface characterisation for preparation research is described. Progress towards the acquisition of complementary surface chemical information by time-of-flight secondary ion mass spectrometry (ToF-SIMS) is also discussed. Surface-based beneficiation techniques such as flotation are assuming greater importance as the proportion of fines in raw coal increases due to the proliferation of high capacity mining methods. A necessary condition for the floatability of a coal particle is adequate hydrophobicity, and the degree of hydrophobicity of the flotation concentrate is one factor influencing the ease with which its dewatering can be affected. The hydrophobicity of a coal is very difficult to measure directly because of microporosity, and it is often necessary to deduce the degree of hydrophobicity from a knowledge of the surface chemistry. XPS is able to provide sufficient analytical data to allow relative levels of hydrophobicity to be estimated. In principle, ToF-SIMS should be able to supply additional information enabling refinement of such estimates; however, there are insufficient data at present to allow the ionic fragments detected to be related to specific functional groups at the coal surface.     

X射线荧光测井的井液效应及其校正

本文从Ｘ射线的性质，以及Ｘ射线与物质作用的机理出发，对井液效应进行了研究，并对其影响过程进行模拟。在理想井液模型上，推导出Ｘ射线活度与钻孔参数的数理关系。在此基础上，进一步研究得到了能适应野外多变情况的井液效应校正公式（ＣＢＷＥ）和方法。     

超灵敏加速器质谱计测定^32Si样品制备新技术

介绍了制备元素硅的一种化学方法，它可用于ＡＭＳ装置的离子源。含硅的物质溶解在ＨＦ中，用ＬｉＡｌＨ４把ＳｉＦ４还原成ＳｉＨ４，再将ＳｉＨ４加热分解成元素硅，并且沉淀在石墨盘上，用ＡＭＳ测定ｗ３２Ｓｉ／ｗＳｉ总比值，其灵敏度可达１０＾－１３。     

原位磁化X射线粉末衍射法测还原铁粉的微观磁致伸缩系数

首次报导X射线粉末衍射法测量铁粉晶胞的磁致伸缩系数。还原铁粉样品原位磁化后 ,铁立方晶胞产生磁致伸缩效应 ,晶胞参数的变化引起衍射峰位置和晶面间距的变化。实验测得铁晶胞λ1 0 0 为 3 .3 3× 10 - 4,此结果表明铁晶胞的微观磁致伸缩系数比棒状、薄膜或粉末压片的系数大约 16倍。对此现象进行了合理的理论解释 ,指出大块材料中的粉末多晶之间具有较大的空隙 ,从而使得宏观磁致伸缩系数变小     

CHARACTERIZATION OF DEFORMATION AND X-RAY PETROFABRICS IN THE MIDDLE PART OF THE WAHONGSHAN FAULT ZONE, QINGHAI PROVINCE, NORTHWESTERN CHINA

The Wahongshan fault zone in Qinghai province is one of the most important faults in westem China. In this paper, deformation and X-ray petrofabrics have been studied in the middle segment of the fault. The results show that the formation of the fault zones can be divided into two major stages: ductile shear deformation stage and brittle deformation stage. The early stage ductile shearing leads to the formation of the NW-NNW trending mylonite zones along the fault, which is intensely cut by the late-formed brittle faults. X-ray petrofabrics of rocks near the faults indicate that the minerals in the tectonites show a great degree of orientation in the alignment. The quartz, which is a very important mineral in the tectonites, is deformed by basal face gliding or near basal face gliding, and sometimes by prismatic face sliding, which indicates that the rocks are deformed in epithermal to mesothermal or mesothermal environment, and the dynamic recrystallization also plays an important role in the formation