佛山市顺德区飞鹅山Ⅲ号滑坡形成机理与防治技术

采用工程地质钻探、物探、地质测绘及室内试验等技术方法探讨飞鹅山Ⅲ号滑坡形成机理与防治技术。结果表明：1）滑坡体主要岩性为泥质粉砂岩,飞鹅山滑坡属于新形成的深层中型牵引式滑坡,在平面上呈圈椅状。2）滑坡属于双层滑面滑坡,主滑面以中型深层滑坡为主,主滑体上部发育中型中厚层滑坡。3）滑坡产生的原因为：(1)泥质粉砂岩倾向与坡向基本一致,且岩层倾角为中等倾角;(2)人工开挖使坡脚形成高陡临空面,抗滑力大为降低;(3)雨水沿层面及节理裂隙入渗至坡体深部,大大增加岩土体容重,同时泥质粉砂岩遇水软化,抗剪强度显著降低。4）结合该滑坡区地质环境条件,采用坡面削坡+锚杆（索）+格构梁+双排预应力锚拉抗滑桩+三维网植草绿化+截排水+毛石挡墙的综合治理方法进行防治,监测结果显示该滑坡变形及位移已得到有效控制,整治效果良好。     

基于蚁群算法的严格最大剩余推力临界滑动面搜索

临界滑动面搜索一直是边坡稳定性分析中十分重要的课题,由于极限平衡法具有理论简单,易于被工程师掌握的优点,因此,仍在工程应用中占主导地位。剩余推力法是国内学者提出的一种简单实用且有较高精度极限平衡法,已被纳入国家规范。针对目前剩余推力法条间力假设简单,只考虑了力的平衡而忽略力矩平衡的缺点,通过Spencer法迭代构造了严格剩余推力法边坡临界滑动面搜索优化的模型,并结合蚁群算法搜索出了最大的剩余推力相应的临界滑动面。该模型具有精度高,收敛快的特点。最后给出的两个算例与传统的蚁群算法直接搜索安全系数最小得到的结果做了比较,表明了本文方法的正确性。     

考虑库水升降和滑带弱化作用的岸坡启滑机制分析

以三峡库区凉水井滑坡为研究对象,采用理论分析与数值模拟的研究手段,构建了滑带强度弱化模型,提出了渗流驱动的滑坡启滑判据,应用Geo-studio有限元程序分析了库水不同升降速率对滑坡稳定性的影响,揭示了库水升降作用下岸坡渗流场演变规律和渗流驱动下的启滑机制。研究表明：（1）渗透压力与渗透时间的变化是滑带土强度弱化的关键因素,弱化到临界强度时,在渗流驱动下发生压剪破坏而启滑,由局部向整体以渐进模式破坏失稳;（2）库水升降过程中,坡体内孔隙水压力滞后性较明显,水位升降速率会影响坡体地下水响应时程,升降速率越大,孔隙水压力变化越大,渗流驱动力越大,滑坡稳定性变化越快,越趋近于渐进破坏;（3）库水位从175 m降到145 m,凉水井滑坡滑面法向应力最大降低了38.19%,剪应力最大降低了22.20%,有效法向应力最大落差为168.64 kPa,抗剪强度最大落差为63.45 kPa。以上分析结论与规律可为涉水滑坡启滑机制分析、库岸山体滑坡失稳研究及应急防治工程等提供科学依据和理论方法。     

Timing and development of sedimentation of the Cleaverville Formation and a post‐accretion pull‐apart system in the Cleaverville area,coastal Pilbara Terrane,Pilbara, Western Australia

In the Cleaverville area of Western Australia, the Regal, Dixon Island, and Cleaverville Formations preserve a Mesoarchean lower‐greenschist‐facies volcano‐sedimentary succession in the coastal Pilbara Terrane. These formations are distributed in a rhomboidal‐shaped area and are unconformably overlain by two narrowly distributed shallow‐marine sedimentary sequences: the Sixty‐Six Hill and Forty‐Four Hill Members of the Lizard Hills Formation. The former member is preserved within the core of the Cleaverville Syncline and the latter formed along the northeast‐trending Eighty‐Seven Fault. Based on the metamorphic grade and structures, two deformation events are recognized: D₁ resulted in folding caused by a collisional event, and D₂ resulted in regional sinistral strike‐slip deformation. A previous study reported that the Cleaverville Formation was deposited at 3020 Ma, after the Prinsep Orogeny (3070–3050 Ma). Our SHRIMP U–Pb zircon ages show that: (i) graded volcaniclastic–felsic tuff within the black shale sequence below the banded iron formation in the Cleaverville Formation yields an age of (3 114 ±14) Ma; (ii) the youngest zircons in sandstones of the Sixty‐Six Hill Member, which unconformably overlies pillow basalt of the Regal Formation, yield ages of 3090–3060 Ma; and (iii) zircons in sandstones of the Forty‐Four Hill Member show two age peaks at 3270 Ma and 3020 Ma. In this way, the Cleaverville Formation was deposited at 3114–3060 Ma and was deformed at 3070–3050 Ma (D₁). Depositional age of the Cleaverville Formation is at least 40–90 Myr older than that proposed in previous studies and pre‐dates the Prinsep Orogeny (3070–3050 Ma). After 3020 Ma, D₂ resulted in the formation of a regional strike‐slip pull‐apart basin in the Cleaverville area. The lower‐greenschist‐facies volcano‐sedimentary rocks are distributed only within this basin structure. This strike‐slip deformation was synchronous with crustal‐scale sinistral shear deformation (3000–2930 Ma) in the Pilbara region.     

芦山地震有限断层混合震源模型模拟

建立了基于有限断层的芦山地震的混合震源模型,突出破裂面上滑动量分布中凹凸体的主导作用,同时借助k平方模型表达对震源复杂性认识尚不够深入所带来的随机性.混合震源模型中全局震源参数均值与局部震源参数均值的确定,主要依据统计的半经验标定公式,进一步借助截断正态分布将区域地震、地质构造、地震活动性提供的参数限值结合起来,生成最终的震源参数值.基于上述思路,本文共建立了30组芦山地震混合震源模型,进而以芦山地震8个近场观测台站为试算点,借助地震动反应谱残差评价的方法,从30组模型中选定了表达“平均”特征的混合震源模型.     

考虑滑脱效应和温度场的煤层气渗流数值模拟

由于煤层气的解吸热效应,煤层气的运移过程是一个非等温过程。因此,温度场对煤层气渗流有着重要的影响。前人在研究煤层气渗流规律的研究中并没有同时考虑滑脱效应和温度场因素的影响,而在实际的深部开采中综合考虑滑脱效应和温度场的影响对研究深部煤层气运移规律有着重要的意义。因此本文建立了考虑滑脱效应及温度场的煤层气渗流数学模型,利用有限元数值方法研究了考虑滑脱效应和温度场耦合的煤层气运移规律;研究了考虑滑脱效应和温度场对压力场分布的影响;对考虑滑脱效应及温度场因素的煤层气产量进行了预测。得出了随着温度的升高煤储层的压力在降低,温度的升高对煤层气的产量有着负面的影响这一重要结论。     

Creep,stable sliding,and premonitory slip

Summary The current status of laboratory investigations into creep, stable sliding and premonitory slip is reviewed and some new material is presented. It is postulated that pre-cut rocks and those with simulated gouge layers undergo a transition with increasing confining pressure from (1) stable sliding to stick-slip, to (2) sliding along the pre-cut with deformation of the country rock, to (3) homogeneous flow of the specimen without slip along the pre-cut. Stick-slip behavior is not always present. Decreasing displacement rates are found to enhance stick-slip. Mixtures of gouge are found to be significant in controlling the behavior of sliding with 10–20 percent of anhydrite mixed with quartz or clays mixed with anhydrite shifting the sliding mode from stable stick-slip or stick-slip to stable sliding, respectively. Premonitory slip may be one of the most significant short term precursors of earthquakes. Although widely recognized in the laboratory, little systematic work has been completed. Variations in pore pressure, resistivity and seismic velocities have been investigated. Clearly much work needs to be done into these topics before a clear understanding is achieved.     

遗传算法在边坡抗震稳定性分析中的应用

根据遗传算法的思想和拟静力瑞典法基于圆弧滑动面的假定，提出一种用遗传算法搜索最危险滑动面及其对应的最小安全系数的方法。该方法模拟了生物遗传进化过程，克服了传统方法容易陷和局部极小值的缺点，是一种全局优化算法。并通过一个工程实例对其进行了验证。     

浙江山地滑坡现状及其成因

在考察浙西、浙南山地滑坡灾害点的基础上,结合地质、土壤、土地背景资料确定了庆元、青田、龙泉等１５个县（市）为滑坡集中分布区;中小型基岩风化残坡积土层滑坡是浙江主要滑坡类型。山高坡陡的地貌特征、软硬互层的地层岩性、多组断珐交叉的区域地质构造和发育深厚的土壤类型,是滑坡形成的地学基础;人为切坡、流水蚀坡、水耕梯田、植被破坏和集中降雨,是滑坡的诱发因子。