环境矿物材料治理镉（Cd^2＋）污染研究进展

近年来,环境矿物材料以其经济、有效、无二次污染等特点,在重金属废水处理和土壤修复方面显示出了众多优势,可替代传统的镉污染处理方法。本文综述了国内外环境矿物材料在处理镉污染方面的研究进展,并对今后应用环境矿物材料治理镉污染提出了一些建议。     

Physical properties of ultrahigh-pressure metamorphic rocks from the Sulu terrain, eastern central China: implications for the seismic structure at the Donghai (CCSD) drilling site

About 30 samples representing major lithologies of Sulu ultrahigh-pressure (UHP) metamorphic rocks were collected from surface exposures and exploration wells, and compressional (Vp) and shear wave (Vs) velocities and their directional dependence (anisotropy) were determined over a range of constant confining pressures up to 600 MPa and temperatures ranging from 20 to 600 °C. Samples range in composition from acidic to ultramafic. P- and S-wave velocities measured at 600 MPa vary from 5.08 to 8.64 km/s and 2.34 to 4.93 km/s, respectively. Densities are in the range from 2.60 to 3.68 g/cm³. To make a direct tie between seismic measurements (refraction and reflection) and subsurface lithologies, the experimental velocity data (corresponding to shallow depths) were used to calculate velocity profiles for the different lithologies and profiles of reflection coefficients at possible lithologic interfaces across the projected 5000-m Chinese Continental Scientific Drilling Program (CCSD) crustal segment. Comparison of calculated in situ velocities with respective intrinsic velocities suggests that the in situ velocities at shallow depths are lowered by an increased abundance of open microcracks. The strongly reflective zone beneath the Donghai drill site can be explained by the impedance contrasts between the different lithologies. Contacts between eclogite/peridotite and felsic rocks (gt-gneiss, granitic gneiss), in particular, may give rise to strong seismic reflections. In addition, shear-induced (lattice preferred orientation (LPO)-related) seismic anisotropy can increase reflectivity. For the explanation of the high velocity bodies (>6.4 km/s) around 1000 m and below 3200-m depth, large proportions of eclogite/peridotite (about 40 and 30 vol.%, respectively) are needed.     

松潘—甘孜造山带中丹巴地区变质岩的流体包裹体研究

对丹巴地区动热变质岩石英中的流体包裹体研究表明，第一类型包裹体为高密度CO2包裹体，与深层滑脱作用密切相关，其温度、压力可代表变质峰期的温压条件。第二类型包裹体为CO2－H2O包裹体，H2O含量增加，与变质峰期后的抬升作用有关。第三类型包裹体为NaCl－H2O包裹体，以H2O为主，与抬升作用引起的退变质作用有关。其形成温度依次降低，说明它们是在变质作用的不同阶段捕获的。     

红外,紫外及荧光分析在有机包裹体研究中的应用

本文利用红外，紫外及荧光分析方法，对岩石中吸附有机质和包裹体有机质进行了分析研究，红外分析结果表明，生油岩中的包裹体有机质有明显的石油峰，并且与吸附有机质的峰形有较大差别，紫外分析结果也表明，生油岩中两种有机质的光谱性质不一致，而非生油岩则相反，生油岩荧光光谱特征为：荧光强度大（〉４０），λｍａｘ在４５０ｎｍ左右，光谱位于蓝绿光区，演化程度属高成熟原油阶段，这些可作为评价生油潜力，演化程度的方法及     

江西永平铜矿金属矿物化学成份及矿物包体特征

永平铜矿黄铁矿、黄铜矿的化学成份特征以及矿物测温和石英包体成份分析特征表明成矿经历了一个较低温度阶段，但所反映的后期成矿作用的改造特征也非常明显，特征是闪锌矿，其化学成份具明显的后期改造成矿特征，是岩浆热作用的产物。黄铁矿的同生成矿较为明显，闪锌矿的后期改造成矿特征更为明显，而黄铜矿具有明显的沉积改造特征。     

秦家屯油田储层的敏感性评价

储层的敏感性评价是研究储层损害机理、保护储层或减小储层损害的依据,是搞好油田注水开发的基础。采用岩心流动实验装置,开展了储层敏感性的室内实验。结果表明秦家屯油田储集层对流体速度表现为弱敏感性,对盐敏表现为中等偏弱盐敏性,对酸表现为无敏感性,随着注水速度的增加,岩心的渗透率也随之增大,并未出现“桥堵”和“卡堵”现象,说明储层中不稳定的固相颗粒含量低,不能堵塞地层,油层增产可采用提高注入速度、酸化等措施,油层水敏为中等偏弱到中等偏强,注水前要注入稳定剂。碱敏表现为弱碱敏或中等碱敏,对该区三次采油作业中,尤其是碱水驱油要特别注意。     

会泽超大型铅锌矿床成矿时代研究

云南会泽超大型铅锌矿床由麒麟厂和矿山厂两个独立的铅锌矿床组成。利用两组同源矿物组合Rb Sr等时线方法测定了麒麟厂6号矿体的成矿时代,测定结果分别为(225 1±2 9)Ma和(225 9±3 1)Ma,根据已知的分布于该矿床北部和西南部分布的峨眉山玄武岩成岩时代为250Ma左右,有多个火山喷发旋回,显示多期次的喷发活动,认为川—滇—黔成矿区内铅锌成矿作用与峨眉山玄武岩岩浆活动存在成因联系。     

青铜文物腐蚀过程中的次生矿物

产于不同环境不同地方的青铜文物经矿相显微镜观察、电子探针成分分析和X射线衍射研究表明，在青铜文物腐蚀层中观察到次生矿物——赤铜矿、孔雀石、蓝铜矿、白铅矿和锡石。由上述矿物组成的腐蚀层在青铜器表面形成保护层。腐蚀层细分为红色赤铜矿层、绿色碳酸盐矿物层和黄色锡石层组成，其厚度小于1mm。青铜合金在潮湿条件下的腐蚀比在干旱条件下要严重，另外青铜合金是适用于作高放废物地质处置系统中的废物罐的候选材质。     

“Three-Component” Digital Prospecting Method：A New Approach for Mineral Resources Quantitative Prediction and Assessment

“Three-component” method consists of three clase-connected aspects: geological anomaly,diversity of mineralization and mineral deposit spectrum. All these three concepts are not new separately, but it is a new approach to combine these three aspects in one single concept for quantitative mineral resources prediction and assessment and it is also the first time to conduct a more detailed study in each aspect. Investigation and clarification of geological anomalies, diversity of mineralization and spectrum of mineral deposits are realized by digitization and quantification of ore forming controlling factors, oreexisting symbols or marks, characteristics of mineralization and regulation of ore-genesis and laws of distribution. These procedures lead to construction of a “digital model“ for mineral resources prediction andassessment.