利用热红外温差识别沙尘

沙尘识别是沙尘灾害监测和沙尘气溶胶特性研究的首要工作。利用辐射传输方程进行了沙尘气溶胶的辐射计算 ,对不同沙尘气溶胶光学厚度下的热红外通道温差ΔT(T11μm-T12 μm)的变化进行了分析。理论分析表明 ,利用热红外通道的温度差ΔT进行陆地沙尘识别是可行的。并利用NOAA AVHRR热红外通道的温度差ΔT进行了陆地沙尘识别的实验 ,经与地面气象站实测的沙尘天气现象相比较 ,结果一致。     

Historical measurements of the Earth's magnetic field compared with remanence directions from lava flows in Italy over the last four centuries

Direct measurements of the Earth's magnetic field in Italy since 1640 a.d. have been used to check the remanence directions derived from historically dated volcanic rocks of Etna and Vesuvius. Direct measurements consist of the records of L’Aquila and Pola geomagnetic observatories, the repeat stations of the Italian Magnetic Network and the data base of the Historical Italian Geomagnetic Data Catalogue. All have been relocated to the same reference site (Viterbo — lat. 42.45°N, long. 12.03°E) in order to draw a reference secular variation (SV) curve. The direction of the Earth's field at Viterbo has also been calculated from the historical records (2000-1600) of ref. [Jackson, A., Jonkers, A.R.T., Walker, M.R., 2000. Four centuries of geomagnetic secular variation from historical records. Phil. Trans. R. Soc. London, Ser. A 358, 957-990] database. The remanence directions from Etna show a general agreement with the trend of the SV curve, although their inclination is usually lower than that from the direct measurement. The directions from Vesuvius are more scattered. Large discrepancies occur at both volcanoes and in some cases have been ascribed in the literature to poor geographic information, making it difficult to identify the flows actually emplaced during the eruptions reported in the chronicles. Closer examination shows that the great majority of the best-defined remanence directions (semi-angle of confidence α₉₅ < 2.5°) deviate significantly from the geomagnetic direction measured at the time of the emplacement, the angle between the two directions being larger than the α₉₅ value. The value of 2.5-3.0° can thus be regarded as a conservative evaluation of the error when dealing with dating Etna and Vesuvius lava flows older than 17th century, even when the accuracy attained in remanence measurements is higher. In default of a SV curve for Italy derived from archaeological artefacts, a further error in dating is introduced when reference is made to SV curves of other countries, even if well-established, as these are from regions too far from Italy (>600 km) to confidently relocate magnetic directions.     

Quantum-thermodynamic treatment of intrinsic anharmonicity; Wallace’s theorem revisited

Wallace (in Thermodynamics of crystals, 1972) developed a theorem, rooted in rigid lattice dynamics, which incorporates intrinsic anharmonic effects in solids. The practical application of this theorem in mineral physics is computationally involved and this is the main reason for the theorem not getting the attention it deserves. Because intrinsic anharmonicity is an important issue at the extreme conditions in planetary mantles, we derived a method which removes the computational obstacles in applying this theorem. We extended the theorem to incorporate details of the phonon spectrum and tested our algorithm on forsterite (Mg₂SiO₄). Using a least squares inversion technique applied to all available experimental data, we show that it results in an accurate representation of thermodynamic properties and sound wave velocities of Mg₂SiO₄ in its complete pressure–temperature stability range. We also show that the accuracy of our results is not significantly affected by the use of a different equation of state.     

Thermal evolution of an extensional detachment as constrained by organic metamorphic data and thermal modeling: Graz Paleozoic Nappe Complex (Eastern Alps)

Following Early Cretaceous nappe stacking, the Eastern Alps were affected by late-orogenic extension during the Late Cretaceous. In the eastern segment of this range, a Late Cretaceous detachment separates a very low- to low-grade metamorphic cover (Graz Paleozoic Nappe Complex, GPNC) above a low- to high-grade metamorphic basement. Synchronously, the Kainach Gosau Basin (KGB) collapsed and subsided on top of the section.Metamorphism of organic material within this section has been investigated using vitrinite reflectance data and Raman spectra of extracted carbonaceous material. In the southern part of the GPNC, vitrinite reflectance indicates a decrease in organic maturity towards the stratigraphic youngest unit. The remaining part of the GPNC is characterized by an aureole of elevated vitrinite reflectance values and Raman R2 ratios that parallels the margins of the GPNC. Vitrinite reflectance in the KGB shows a steep coalification gradient and increases significantly towards the western basin margin. The observed stratigraphic trend in the southern GPNC is a result of deep Paleozoic to Early Cretaceous burial. This maturity pattern was overprinted along the margins by advective heat and convective fluids during Late Cretaceous to Paleogene exhumation of basement rocks.During shearing, the fault zone was heated up to ca. 500 °C. This overprint is explained by a two-dimensional thermal model with a ramp-flat fault geometry and a slip rate of 1 to 1.5 cm/year during 5 Ma fault movement. The collapse basin above the detachment subsided in a thermal regime which was characterized by relaxing isotherms.     

Polymorphic phase transition in Superhydrous Phase B

We synthesized superhydrous phase B (shy-B) at 22 GPa and two different temperatures: 1200°C (LT) and 1400°C (HT) using a multi-anvil apparatus. The samples were investigated by transmission electron microscopy (TEM), single crystal X-ray diffraction, Raman and IR spectroscopy. The IR spectra were collected on polycrystalline thin-films and single crystals using synchrotron radiation, as well as a conventional IR source at ambient conditions and in situ at various pressures (up to 15 GPa) and temperatures (down to −180°C). Our studies show that shy-B exists in two polymorphic forms. As expected from crystal chemistry, the LT polymorph crystallizes in a lower symmetry space group (Pnn2), whereas the HT polymorph assumes a higher symmetry space group (Pnnm). TEM shows that both modifications consist of nearly perfect crystals with almost no lattice defects or inclusions of additional phases. IR spectra taken on polycrystalline thin films exhibit just one symmetric OH band and 29 lattice modes for the HT polymorph in contrast to two intense but asymmetric OH stretching bands and at least 48 lattice modes for the LT sample. The IR spectra differ not only in the number of bands, but also in the response of the bands to changes in pressure. The pressure derivatives for the IR bands are higher for the HT polymorph indicating that the high symmetry form is more compressible than the low symmetry form. Polarized, low-temperature single-crystal IR spectra indicate that in the LT-polymorph extensive ordering occurs not only at the Mg sites but also at the hydrogen sites.     

Combining two filter paper‐based analytical methods to monitor temporal variations in the geochemical properties of fluvial suspended particulate matter

Many of the commonly used analytical techniques for assessing the properties of fluvial suspended particulate matter (SPM) are neither cost effective nor time efficient, making them prohibitive to long‐term high‐resolution monitoring. We present an in‐depth methodology utilizing two types of spectroscopy which, when combined with automatic water samplers, can generate accurate, high‐temporal resolution SPM geochemistry data, inexpensively and semi‐destructively, directly from sediment covered filter papers. A combined X‐ray fluorescence spectroscopy and diffuse reflectance infrared Fourier transform spectroscopy approach is developed to estimate concentrations for a range of elements (Al, Ca, Ce, Fe, K, Mg, Mn, Na, P, Si, Ti) and compounds (organic carbon, Al_dithionate, Al_oxalate, Fe_dithionate, and Fe_oxalate) within SPM trapped on quartz fibre filters at masses as low as 3 mg. Calibration models with small prediction errors are derived, along with mass correction factor models to account for variations in retained SPM mass. Spectral pre‐processing methods are shown to enhance the reproducibility of results for some compounds, and the importance of filter paper selection and homogeneous sample preparation in minimizing spectral interference is emphasized. The geochemical signal from sediment covered filter papers is demonstrated to be time stable enabling samples to be stored for several weeks prior to analysis. Example results obtained during a heavy precipitation event in October 2012 demonstrate the methodology presented here has considerable potential to be utilized for high‐resolution monitoring of SPM geochemistry under a range of in‐stream hydrological conditions. Copyright © 2013 John Wiley & Sons, Ltd.     

Quantitative estimation of submarine groundwater discharge using airborne thermal infrared data acquired at two different tidal heights

Submarine groundwater discharge (SGD) plays an important role in coastal biogeochemical processes and hydrological cycles, particularly off volcanic islands in oligotrophic oceans. However, the spatial and temporal variations of SGD are still poorly understood owing to difficulty in taking rapid SGD measurements over a large scale. In this study, we used four airborne thermal infrared surveys (twice each during high and low tides) to quantify the spatiotemporal variations of SGD over the entire coast of Jeju Island, Korea. On the basis of an analytical model, we found a linear positive correlation between the thermal anomaly and squares of the groundwater discharge velocity and a negative exponential correlation between the anomaly and water depth (including tide height and bathymetry). We then derived a new equation for quantitatively estimating the SGD flow rates from thermal anomalies acquired at two different tide heights. The proposed method was validated with the measured SGD flow rates using a current meter at Gongcheonpo Beach. We believe that the method can be effectively applied for rapid estimation of SGD over coastal areas, where fresh groundwater discharge is significant, using airborne thermal infrared surveys.     

Submarine groundwater discharge revealed by aerial thermal infrared imagery: a case study on Jeju Island,Korea

Submarine groundwater discharge (SGD) is a global phenomenon that carries large volumes of groundwater and dissolved chemical species such as nutrient, metals, and organic compounds to coastal zones. We report the influence of SGD on the coastal waters of Jeju Island, Korea, using high‐resolution aerial thermal infrared (TIR) mapping techniques and field investigations. An aircraft‐based system was implemented using a cost‐effective TIR camera for aerial TIR mapping. Ground‐based calibrations and system integration with GPS/IMU (global positioning system/inertial measurement unit) were performed for the aerial systems. The aerial surveys showed distinct low‐temperature signatures of SGD along the coasts of Jeju Island, revealing large groundwater inputs from the coastal aquifers to the ocean. Multiple aerial surveys over a range of seasons and tidal stages revealed that SGD rates dynamically affect the sea surface temperature (SST) of the coastal zone. The in‐situ measurements supported that SGD has a substantial influence on the coastal water chemistry as well as SST. Our observations highlight the extent to which aerial‐based TIR mapping can serve as a powerful tool for studying SGD and other coastal processes. Copyright © 2016 John Wiley & Sons, Ltd.     

PMODTRAN: a parallel implementation based on MODTRAN for massive remote sensing data processing

MODerate resolution atmospheric TRANsmission (MODTRAN) is a commercial remote sensing (RS) software package that has been widely used to simulate radiative transfer of electromagnetic radiation through the Earth's atmosphere and the radiation observed by a remote sensor. However, when very large RS datasets must be processed in simulation applications at a global scale, it is extremely time-consuming to operate MODTRAN on a modern workstation. Under this circumstance, the use of parallel cluster computing to speed up the process becomes vital to this time-consuming task. This paper presents PMODTRAN, an implementation of a parallel task-scheduling algorithm based on MODTRAN. PMODTRAN was able to reduce the processing time of the test cases used here from over 4.4 months on a workstation to less than a week on a local computer cluster. In addition, PMODTRAN can distribute tasks with different levels of granularity and has some extra features, such as dynamic load balancing and parameter checking.     

DEM simulations of methane hydrate exploitation by thermal recovery and depressurization methods

Methane hydrate (MH, also called fiery ice) exists in forms of pore filling, cementing and load-bearing skeleton in the methane hydrate bearing sediment (MHBS) and affects its mechanical behavior greatly. To study the changes of macro-scale and micro-scale mechanical behaviors of MHBS during exploitation by thermal recovery and depressurization methods, a novel 2D thermo-hydro-mechanical bonded contact model was proposed and implemented into a platform of distinct element method (DEM), PFC2D. MHBS samples were first biaxially compressed to different deviator stress levels to model different in-situ stress conditions. With the deviator stress maintained at constant, the temperature was then raised to simulate the thermal recovery process or the pore water pressure (i.e. confining pressure for MH bond) was decreased to simulate the depressurization process. DEM simulation results showed that: during exploitation, the axial strain increased with the increase of temperature (in the thermal recovery method) or decrease of pore water pressure (in the depressurization method); sample collapsed during MH dissociation if the deviator stress applied was larger than the compression strength of a pure host sand sample; sample experienced volume contraction but its void ratio was slightly larger than the pure host sand sample at the same axial strain throughout the test. By comparison with the laboratory test results, the new model was validated to be capable of reproducing the exploitation process by thermal recovery and depressurization methods. In addition, some micro-scale parameters, such as contact distribution, bond distribution, and averaged pure rotation rate, were also analyzed to investigate their relationships with the macroscopic responses.