Hydrogeology of thermal waters in Viterbo area, central Italy

A conceptual hydrogeological model of the Viterbo thermal area (central Italy) has been developed. Though numerous studies have been conducted on its geological, geochemical and geothermal features, there is no generalized picture defining the origin and yield of the hydrothermal system. These latter aspects have therefore become the objectives of this research, which is based on new hydrogeological and geochemical investigations. The geological setting results in the coexistence of overlapped interacting aquifers. The shallow volcanic aquifer, characterized by fresh waters, is fed from the area around the Cimini Mountains and is limited at its base by the semiconfining marly-calcareous-arenaceous complex and low-permeability clays. To the west of Viterbo, vertical upflows of thermal waters of the sulphate-chloride-alkaline-earth type with higher gas contents, are due to the locally uplifted carbonate reservoir, the reduced thickness of the semiconfining layer and the high local geothermal gradient. The hot waters (30–60°C) are the result of deep circulation within the carbonate rocks (0.5–1.8 km) and have the same recharge area as the volcanic aquifer. The upward flow in the Viterbo thermal area is at least 0.1 m³/s. This flow feeds springs and deep wells, also recharging the volcanic aquifer from below.     

Temperature dependence of large-scale water-retention curves: a case study

A local-scale model for temperature-dependence of water-retention curves may be applicable to large scales. Consideration of this temperature dependence is important for modeling unsaturated flow and transport in the subsurface in numerous cases. Although significant progress has been made in understanding and modeling this temperature effect, almost all the previous studies have been limited to small scales (on the order of several centimeters). Numerical experiments were used to investigate the possibility of extending a local-scale model for the temperature-dependence of water retention curves to large scales (on the order of meters). Temperature effects on large-scale hydraulic properties are of interest in many practical applications. Numerical experiment results indicate that the local-scale model can indeed be applicable to large-scale problems for special porous media with high air entry values. A typical porous medium of this kind is the porous tuff matrix in the unsaturated zone of Yucca Mountain, Nevada, the proposed geologic disposal site for national high-level nuclear wastes. Whether this finding can approximately hold for general cases needs to be investigated in future studies.     

Surface temperature differences between minerals in crystalline rocks: Implications for granular disaggregation of granites through thermal fatigue

Thermal expansion differences between minerals within rocks under insolation have previously been assumed to drive breakdown by means of granular disaggregation. However, there have been no definitive demonstrations of the efficacy of this weathering mechanism. Different surface temperatures between minerals should magnify thermal expansion differences, and thus subject adjacent minerals to repeated stresses that might cause breakdown through fatigue failure. This work confirms the existence of surface temperature differences between minerals in granitic rocks under simulated short-term temperature fluctuations so as to discriminate their potential for initiating granular disaggregation. The influence of colour, as a surrogate for albedo, and crystal size, as a function of thermal mass are specifically identified because of their ease of quantification. Four rock types with a range of these properties were examined, and subjected to repeated short-term temperature cycles by radiative heating and cooling under laboratory conditions. Results show that while albedo is the main control for overall and individual maximum temperatures, crystal size is the main factor controlling higher temperature differences between minerals. Thus, stones with large differences of mineral sizes can undergo magnified stresses due to thermal expansion differences.     

The effect of thermal treatment on the 57Fe Mössbauer spectrum of beryl

Mössbauer spectra (MS) of blue, green and yellow beryl (ideally Be₃Al₂Si₆O₁₈) containing approximately 1% of iron were obtained at 295 and 500 K. Room temperature (RT) spectra of both blue and green samples showed the presence of an asymmetric Fe²⁺ doublet (ΔE _Q~2.7 mm/s, δ~1.1 mm/s), with a very broad low-velocity peak. There is no clear evidence for the presence of a ferric component. The MS of the yellow sample at RT consists of an intense central absorption with parameters typical for Fe³⁺ (ΔE _Q~0.4 mm/s, δ~0.29 mm/s), plus an apparently symmetrical Fe²⁺ doublet. This sample acquires a light-blue shade upon heating in air at about 620 K. Thermal treatments at high temperatures caused no significant changes in the MS, but the green and yellow beryl acquire a blue colour. All these results are interpreted in relation to the existence of channel water and the distribution of iron among the available crystallographic sites.     

库车坳陷侏罗系煤成气动力学模拟研究

应用黄金管—高压釜封闭体系热模拟实验与GC、GC-IRMS分析技术,结合KINETICS专用软件,对库车坳陷侏罗系煤成气进行了动力学模拟研究。库车坳陷侏罗系煤具有高的产气性,在高演化阶段主要产甲烷气;侏罗系煤热解气甲烷碳同位素为-36‰～-25‰,乙烷碳同位素为-28‰～-16‰;甲烷、C2-C5气态烃的生成活化能分别为(47～64k)calm/ol、(55～72k)calm/ol,频率因子各为5.265×1013s-1、5.388×1018s-1。在此基础上,进一步探讨了克拉2气田天然气的成因。研究认为,克拉2气田天然气属阶段捕获的煤成气,主要聚集了5～1Ma时期的天然气,其成熟度Ro分布范围为1.3%～2.5%。     

中尺度模式中的边界层特征量分析

在中尺度数值天气预报模式MM4中，用level3及E-ε-l两种湍流闭合方法对原总体边界层参数化方案进行改进，使得中尺度模式中可以直接输出有关湍流量，并对地表通量参数化方案进行改进，进而对不同下势需如沙漠，植被上的有关湍流量和边界层特征量进行分析。研究中尺度系统中边界层结构的特征，本文主要从地表通量，湍流交换系数，湍流动能（q^2)，温度脉动方差（θ^2)及风温廓线等几个方面进行研究，结果表明，新方案能更好地反映边界层特征。     

Aerosol climatology for the planetary boundary layer derived from regular lidar measurements

Regular aerosol extinction and backscatter measurements using a UV Raman Lidar have been performed for almost 3 years in Hamburg in the frame of the German Lidar Network. A set of 92 aerosol extinction and 164 aerosol backscatter profiles has been used for statistical investigations. Mean values and variances of the aerosol extinction and backscatter in the boundary layer have been calculated. Large fluctuations during the whole year have been found. The measured aerosol extinction over Hamburg shows a seasonal cycle with highest values in early fall and a second less prominent peak in spring.An analysis of the data using back trajectories showed a dependence of the aerosol extinction on the origin of the air mass. The residence time of the air mass over industrialized areas was found to be an important parameter for the measured aerosol extinction at Hamburg. However, only a small part of the total variability could be explained by the air mass origin.For 75 cases of aerosol extinction measurements under cloud-free conditions, the aerosol backscatter profile and therefore, the lidar ratio as a function of altitude could be determined. Winter measurements of the lidar ratio are often close to model results for maritime aerosol, the summer measurements are close to the model results for urban or continental aerosols.The high quality of the data has been proven by intercomparisons with other lidar systems and with star photometer measurements of the aerosol optical depth during the Lindenberg Aerosol Characterization Experiment (LACE'98) field campaign.     

中国西北部盆地岩石热导率和生热率特征

本文根据大量实测数据,首次系统地报道了中国西北地区塔里木盆地、准噶尔盆地和柴达木盆地内的岩石热导率、岩石放射性生热率数据及其分布特征.对600多个岩石热导率和100多个实测岩石生热率的统计分析表明,沉积盆地中岩石的热物理性质与其岩性、埋藏深度和地层时代密切相关.随深度和地层时代的加大,岩石热导率增大;塔里木盆地的岩石热导率的总体平均值最大,而柴达木盆地的最小.岩石生热率在上地壳的分布是随深度的增加而减小的,但在沉积盆地的深度范围内几乎不变,其分布是均匀的,仅不同岩性的生热率差别较大.估算的岩石放射性生热产生的热量可以占到盆地地表热流的25%～45%.因此,岩石热物理性质的参数不仅与盆地的地温分布和大地热流特征密切相关,还可以为该地区盆地热历史恢复及深部地球物理的研究提供有效的参数和边界条件.     

Heat flow and thermal modeling of the Yinggehai Basin, South China Sea

Geothermal gradients are estimated to vary from 31 to 43 °C/km in the Yinggehai Basin based on 99 temperature data sets compiled from oil well data. Thirty-seven thermal conductivity measurements on core samples were made and the effects of porosity and water saturation were corrected. Thermal conductivities of mudstone and sandstone range from 1.2 to 2.7 W/m K, with a mean of 2.0±0.5 W/m K after approximate correction. Heat flow at six sites in the Yinggehai Basin range from 69 to 86 mW/m², with a mean value of 79±7 mW/m². Thick sediments and high sedimentation rates resulted in a considerable radiogenic contribution, but also depressed the heat flow. Measurements indicate the radiogenic heat production in the sediment is 1.28 μW/m³, which contributes 20% to the surface heat flow. After subtracting radiogenic heat contribution of the sediment, and sedimentation correction, the average basal heat flow from basement is about 86 mW/m².Three stages of extension are recognized in the subsidence history, and a kinematic model is used to study the thermal evolution of the basin since the Cenozoic era. Model results show that the peak value of basal heat flow was getting higher and higher through the Cenozoic. The maximum basal heat flow increased from 65 mW/m² in the first stage to 75 mW/m² in the second stage, and then 90 mW/m² in the third stage. The present temperature field of the lithosphere of the Yinggehai Basin, which is still transient, is the result of the multistage extension, but was primarily associated with the Pliocene extension.     

Thermal expansion and crystal structure of FeSi between 4 and 1173 K determined by time-of-flight neutron powder diffraction

The thermal expansion and crystal structure of FeSi has been determined by neutron powder diffraction between 4 and 1173?K. No evidence was seen of any structural or magnetic transitions at low temperatures. The average volumetric thermal expansion coefficient above room temperature was found to be 4.85(5)?×?10^?5?K^?1. The cell volume was fitted over the complete temperature range using Grüneisen approximations to the zero pressure equation of state, with the internal energy calculated via a Debye model; a Grüneisen second-order approximation gave the following parameters: θ_D=445(11)?K, V ₀=89.596(8)?ų, K ₀′=4.4(4) and γ′=2.33(3), where θ_D is the Debye temperature, V ₀ is V at T=0?K, K ₀′ is the first derivative with respect to pressure of the incompressibility and γ′ is a Grüneisen parameter. The thermodynamic Grüneisen parameter, γ_th, has been calculated from experimental data in the range 4–400?K. The crystal structure was found to be almost invariant with temperature. The thermal vibrations of the Fe atoms are almost isotropic at all temperatures; those of the Si atoms become more anisotropic as the temperature increases.