Effects of ageing and overconsolidation on the elastic stiffness of a remoulded clay

Summary Results of resonant column tests were used to determine values of low amplitude shear modulus (G ₀) of a remoulded kaolinite clay for different durations of ageing and for different values of consolidation stress (₀) and overconsolidation ratio (OCR). It was found that after completion of primary consolidation the values of G ₀ increased linearly with the logarithm of time and after a week of confinement the value of normalized rate of secondary increase of shear modulus (N _G ) could be reliably estimated. Values of N _G were found to derease linearly with the logarithm of OCR and with the logarithm of ageing duration. This similarity of behaviour provided a basis for establishing an equivalency between age and equivalent overconsolidation ratio (OCR)_eq. The effects of ₀ and OCR on the value of G ₀ were also established in a functional form that indicated a stronger influence compared to that predicted by the Hardin Equation.     

北京云蒙山地区花岗岩穹隆及伸展构造的探讨

北京云蒙山花岗岩为一中生代侵入的花岗岩穹隆,花岗岩穹隆的叶理普遍发育,叶理轨迹基本平行于穹隆的外部边界,并显示出从核部到边部逐渐增强,东南侧明显强于西北侧的特点。变形构造研究显示,花岗岩穹隆的边部及围岩中普遍存在不同层次及不同运动方向的伸展构造。东南侧以具河防口－水峪伸展型韧性剪切带为特征,剪切运动标志显示为从ＮＷ－ＳＥ的正剪切运动,有限应变分析估算其剪切位移量在１０ｋｍ以上,剪切带上部被河防口正     

A Step Towards Evaluation of the Seismic Response Reduction Factor in Multistorey Reinforced Concrete Frames

A seismic nonlinear time-history analysis was made for four-, six-, and eight-storey reinforced concrete buildings. These buildings were made as three-dimensional space frame structures with shear walls in both orthogonal directions. They have five bays with 4.8 m spacing each in the horizontal direction, and three bays with 4.2 m spacing each in the transversal direction. The frames were designed according to the Jordanian Seismic Code of practice for Seismic Zones 4, 3, 2, and 1 as proposed for Jordan by several authors. Time-history analysis was made using the El Centro (N-S) earthquake record of May 1940 as an actual earthquake excitation. The response reduction factor (R) that primarily consists of two factors that are the ductility reduction (Rµ) and the overstrength (), is obtained. It has been seen that the seismic zoning has a slight effect on the ductility reduction factor for different buildings, since it ranges from Zone 4 to Zone 1 as 2.37 to 2.52, 1.72 to 1.78, and 1.14 to 1.18 for four-, six-, and eight-storey buildings, respectively. Moreover, it is observed that, for different buildings and different seismic zones, the ductility reduction factor (Rµ) is slightly different from the system ductility factor (µ) especially for higher values of µ (i.e., Rµ µ). The response reduction factor, called overstrength (), was evaluated. The overstrength factor was found to vary with seismic zones (Z) , number of stories, and design gravity loads. However, the dependency on seismic zones was the strongest. The average overstrength of these buildings in Zones 4 and 1 was 2.61 and 6.94, respectively. The overstrength increased as the number of storeys decreased: overstrength of a four-storey building was higher than an eight-storey building by 36% in Zone 4, and 39% in Zone 1. Furthermore, buildings of the three heights had an average overstrength 165.9% higher in Zone 1 than in Zone 4. These observations have a significant implications for the seismic design codes which currently do not take into account the variation of the response reduction factor, R (i.e., ductility reduction factor times overstrength).     

Direct shear tests on Mexico City clay with reference to friction pile behaviour

Summary This paper presents results of static and cyclic direct shear tests performed on undisturbed and remoulded samples of Mexico City clays, including results of soil-on-interface tests. Experiments show that the static adhesion coefficient depends on the soils' liquidity index and that it diminishes due to the effect of repeated dynamic loads. Dynamic overstrength effects were not apparent, as has been observed when testing this clay in other apparatus. Interface strength in remoulded clays is initially less than half the strength of interfaces with undisturbed materials but it increases with time. At least in the materials tested in this research, it did not equal the strength of interfaces with undisturbed materials. Correction factors derived from experimental data can be used to modify the adhesion coefficient to account for dynamic and remoulding effects.     

坡地农林复合系统的结构类型与效益分析─以长江三峡库区坡地农业为例

本义认为现代术语的农林复合系统来源于生产实践,体现了农业与林业的有机结合、品种生态和经济的有机结合、产品多样化以及管理科学化4个方面相统一的特点。文章在分析三峡库区农林复合系统的类型结构基础上,提出了农林复合系统可以进行层次结构划分的观点。最后,以典型案例研究方法入手,对1种农林结构类型进行效益分析,结果表明,采用植物篱农林复合坡地系统,是现阶段生产力水平下实现坡地生态经济协调发展的有效途径,值得广泛推广。     

哀牢山-红河剪切带的热年代学研究——多重扩散域模式的应用实例

洛弗拉等人(1989)把Dodson(1973)建立的单一扩散域模式扩展成矿物扩散域不连续分布的模式,即多重扩散域模式,与之对应具有某一封闭温度范围,因此利用单个K-长石矿物样品可以揭示更长时间段上的冷却过程。对云南哀牢山-红河剪切带的K-长石样品(FA-2-1)进行40Ar/39Ar同位素分析,利用多重扩散域模式,揭示在距今约20～19Ma问该带存在一快速冷却过程,这与西藏南部曲水地区快速抬升的时间是一致的     

短周期仪器记录在远震分析中的应用

地震泼由多种频率成份组成,在其传播过程中。由于地球介质的滤波作用,随着传播距离的增大。高频成份逐渐被衰减。周期越大的成份传播越远。因此,在地震观测上,不同频带的地震仪用于观测不同震中距范围的地震,使仪器较好地响应,就我国台网而言,短周期仪用于地方震、近震的监测,中长周期仪和长周期仪用于远震,极远震的监测,其中长周期仪偏重于记录极远震。但作者在实际分析工作中注意到,短周期仪的记录应用于远震,极远震的分析,显示出独特的作用,充分挖掘和利用短仪资料,将会更加丰富远震、极远震的震相资料。本文以高台地震台的资料为依据,从震中距和震级角度,与中长仪和长仪作比较,对短仪记录远震、极远震的震相及特征作了统计分析与初步探讨,并对新疆地区“影区”地震S波的记录、日本地区地震_PPcP等震相的出现提出了现象的存在,给出了相应的观测结果,以待步一步研究。     

Scattering of elastic waves by a fracture zone containing randomly distributed cracks

We theoretically study the scattering ofP, SV andSH waves by a zonal distribution of cracks, which simulates a fault fracture zone. An investigation is conducted how the geometrical properties of the crack distribution and the frictional characteristics of the crack surface are reflected in the attenuation and dispersion of incident waves, as well as in the amplitudes of the transmitted and reflected waves from the zone. If the crack distribution within the fault zone changes temporally during the preparation process of the expected earthquake, it will be important for earthquake prediction to monitor it, utilizing the scattering-induced wave phenomena.We consider the two-dimensional problem. Aligned cracks with the same length are assumed to be randomly distributed in a zone with a finite width, on which elastic waves are assumed to be incident. The distribution of cracks is assumed to be homogeneous and sparse. The crack surface is assumed to be stress-free, or to undergo viscous friction; the latter case simulates fluid-filled cracks. The opening displacement of the crack is assumed to be negligibly small. The idea of the mean wave formalism is employed in the analysis, and Foldy's approximation is assumed.When the crack surface is stress-free, it is commonly observed for every wave mode (P, SV andSH) that the attenuation coefficientQ ^–1 peaks aroundka1, the phase velocity is almost independent ofk in the rangeka<1 and it increases monotonically withk in the rangeka>1, wherek is the intrinsicS wavenumber anda is the half length of the crack. The effect of the friction is to shift the peak ofQ ^–1 and the corner of the phase velocity curve to the low wavenumber range. The high wavenumber asymptote ofQ ^–1 is proportional tok ^–1 independently of model parameters and the wave modes. If the seismological observation thatQ ^–1 ofS waves has a peak at around 0.5 Hz in the earth's crust is combined with our results, the upper limit of crack size within the crust is estimated about 4 km. The information regarding the transmitted and reflected waves, such as the high wavenumber limit of the amplitude of the transmitted wave etc., allows estimation of the strength of the friction.     

云南大地热流及地热地质问题

本文报道了云南20多个大地热流测试数据。据热流分布特点并参考前人有关资料,结合地球物理测深资料、岩石热物性与放射性生热率测试数据,对各区地壳深度范围的温度、热流配分组成作了粗略分析,划分出各有特征的若干地质-热流区。云南普遍地热偏高(滇东南小范围除外)的主要原因是新构造运动强烈;怒江以西近代岩浆活动亦强烈,具有典型的板块交汇带的基本地热特点