The Cenomanian–Turonian Boundary Event (CTBE) event is not associated with a transgression on the southern margin of the Subalpine Basin, but with a steady shallowing-up trend beginning in the lower half of the δ13C positive shift. The SW–NE Rouaine Fault had a complex role, first in isolating a black shale basin to the west and a large, deep submarine plateau devoid of black shale to the east, then by a strike-slip movement that induced a forced progradation to the north of the southern platform in the eastern compartment. This compressive tectonic reactivation of the southern margin began around the deposition of the local equivalent of the Plenus bed of boreal basins, as shown by correlation supported by both isotope and palaeontological data. Other local data are pieced together to suggest that the whole of SE France underwent a short-lived transpressive tectonic pulse around the Cenomanian–Turonian boundary, probably connected with the early compressive movement of Africa vs. Europe. On a larger scale, other published data suggest that this pulse could be a global one. It is coeval with renewed thrust loading, volcanism and transgression in the North-American Western Interior, local emergences during the event along the eastern Atlantic margin, suggesting a slight tendency to inversion of the margin, and a tilting to the east of the North-Africa plate that could explain the large transgression recorded from Morocco to Tunisia on the Saharan Craton.New isotope and palaeontological (coiling ratio of Muricohedbergella delrioensis) data from SE France suggest that two coolings of suprabasinal importance occurred just before and during the build-up of the d13C shift, including the boreal “Plenus Marls“, especially its middle limestone bed and its SE France equivalent.Regarding the extinction of the genus Thalmaninella and Rotalipora and during the event, neither anoxia nor climate changes can fully explain the palaeontological crisis, given that Rotalipora cushmani crosses the first phase of anoxia without harm, as well as the two coolings, not only in SE France but on a large scale, as shown by the correlation of the published data. This extinction needs alternative explanations as we challenge both anoxia and climate as major causes. 相似文献
The results of seismic measurements along the deep seismic sounding profile VII and terrestrial heat flow measurements used for construction of heat generation models for the crust in the Paleozoic Platform region, the Sudetic Mountains (Variscan Internides) and the European Precambrian Platform show considerable differences in mantle heat flow and temperatures. At the base of the crust variations from 440–510°C in the models of Precambrian Platform to 700–820°C for the Paleozoic Platform and the Variscan Internides (Sudets) are found. These differences are associated with considerable mantle heat flow variations.The calculated models show mantle heat flow of about 8.4–12.6 mW m–2 for the Precambrian Platform and 31 mW m–2 to 40.2 mW m–2 for Paleozoic orogenic areas. The heat flow contribution originating from crustal radioactivity is almost the same for the different tectonic units (from 33.5 mW m–2 to 37.6 mW m–2). Considerable physical differences in the lower crust and upper mantle between the Precambrian Platform and the adjacent areas, produced by lateral temperature variations, could be expected. On the basis of carbon ratio data it can be concluded that the Carboniferous paleogeothermal gradient was much lower in the Precambrian Platform area than in the Paleozoic Platform region. 相似文献
Field, hand specimen, and microscopic investigations alongside X-ray diffraction analyses revealed four types of hydrothermal alteration (Type-A, -B, -C, and -D) based on the mode of occurrence of altered rocks and alteration mineral assemblage at Hakusui-kyo and Horai-kyo along the Arima-Takatsuki Tectonic Line (ATTL) in western Japan. Type-A alteration locally occurred as gray alteration halos with sulfide minerals. Type-B and -C alterations were confined to fault gouge veins and occurred as greenish-gray veins and brown veins, respectively. Type-C alteration crosscut Type-B alteration. These alterations were associated with a number of granitic fragments including cohesive breccia and micrographic facies. Type-D alteration occurred locally in brown sediments. Different mineralogical features in the four alterations are summarized as (Type-A) illite; (Type-B) chlorite; (Type-C) limonite (Fe3+ hydroxides and goethite) and calcite; and (Type-D) limonite. We propose that the alterations can be broadly divided into Paleocene hydrothermal alteration (Type-A) and post-Late Miocene hydrothermal alteration (Type-B, -C, and -D): Type-A alteration occurred at approximately 200 °C during hydrothermal activity after a granitic intrusion in Late Cretaceous; Type-B, -C and -D alterations occurred under hydrothermal activity accompanying deep fluids with repeated ascents invoked by the seismicity of the ATTL after the Late Miocene. The fluids may have been the “Arima-type thermal waters” (i.e., mixtures of convective groundwater and Na-Ca-Cl-HCO3-type fluids). Type-B alteration occurred in fractures at depths where the temperature was ≥150 °C. Type-C alteration overprinted Type-B alteration as a result of mixing of new deep fluids and descending oxidized meteoric water near the surface. Fe3+ hydroxides and calcite precipitated from the fluids due to the oxidation of Fe2+ and the degassing of CO2, respectively, at ambient to near-boiling temperatures. When the ascending fluids gushed out from the fractures, they generated Type-D alteration at the surface under similar temperature conditions due to the oxidation of Fe2+. 相似文献