Formation of a shelfbreak front by freshwater discharge

The circulation and transport of freshwater generated by an idealized buoyant source is studied using a three-dimensional primitive equation model. Freshwater enters the continental shelf, turns anticyclonically and moves downstream in the direction of Kelvin wave propagation. In the region close to the source, the flow reaches an equilibrium in the bottom boundary layer so that freshwater does not spread offshore any further. This offshore equilibrium distance increases as we move downstream until the freshwater is able to feel the presence of the shelfbreak. A shelfbreak front forms and the shelfbreak prevents any further offshore spreading of freshwater in the bottom boundary layer.Two complimentary mechanisms are responsible for the slow cross-shelf migration of freshwater and subsequent trapping of shelfbreak fronts: bottom stress and topographic changes. The shelfbreak creates an active, dynamic process preventing leakage from the continental shelf region to the slope region. However, the dynamical process that traps the front to the shelfbreak is still unclear.The location of the shelfbreak front depends on four dimensionless parameters: scaled inlet volume transport, scaled breadth, scaled “diffusivity” and scaled shelf width. We develop empirical relations for predicting the location of the frontal bottom intersection, given these parameters.     

长江三峡工程奉节库岸边坡地下水渗流场模拟分析

长江三峡工程正常蓄水位为175m，在蓄水过程中随着库水位的抬升，必然会引起库岸边坡地下水渗流场的变化。运用3D－Modflow软件模拟了三峡工程的蓄水过程中奉节库段边坡岩土体内部地下水位的动态变化，为长江三峡工程奉节库区段移民迁建地质灾害预测与防治提供科学依据。     

武汉市区第四系含水层地下水有机污染敏感性研究

在详细调查武汉市水文地质条件和地下水污染现状的基础上，获得了高精度的武汉市水环境中微量有机污染物的组成数据。所检测出的有机组分达30余种，以苯及相关苯系物为主，污染程度较高的地下水主要分布在人口密集区和工业，商业区，应用改进的DRASTIC模型－地下水污染敏感性评价模型，在GIS平台上，编制了武汉市区地下水污染敏感性分区图。根据其评价结果，建议集中对那些敏感性相对较高的区域采取有效的环保措施，开发利用时应作出风险评价。     

地下水水质预警信息系统研究

地下水水质预警是对地下水水质现状及变化趋势适时给出相应给别警戒信息的方法，包括状态预警和趋势预警两部分。以GIS技术为核心，将水质预警模型与GIS技术相结合，建立了地下水水质预警信息系统。并以吉林省西部平原地区地下水水质为例，研究了该区地下水水质恶化地区的分布、趋势、恶化预警等级及其成因。地下水水质预警系统为地下水资源管理，减少地下水水质恶化的风险提供了科学依据。     

离散裂隙渗流方法与裂隙化渗透介质建模

流体渗流模拟的连续介质方法通常适用于多孔地质体，并不一定适用于裂隙岩体，由于裂隙分布及其特征与孔隙差异较大。若流体渗流主要受裂隙的控制，对于一定尺寸的裂隙岩体，多孔介质假设则较难刻划裂隙岩体的渗流特征。离散裂隙渗流方法不但可直接用于模拟裂隙岩体非均质性和各向异性等渗流特征，而且可用其确定所研究的裂隙岩体典型单元体及其水力传导（渗透）张量大小。主要讨论了以下问题：（1）饱和裂隙介质中一般的离散流体渗流模拟；（2）裂隙岩体中的REV（典型单元体）及其水力传导（渗透）张量的确定；（3）利用离散裂隙网络流体渗流模型研究裂隙方向几何参数对水力传导系数和REV的影响；（4）在二维和三维离散裂隙流体渗流模型中对区域大裂隙和局部小裂隙的处理方法。调查结果显示离散裂隙流体渗流数学模型可用来评价不同尺度上的裂隙岩体的水力特征，以及裂隙方向对裂隙化岩体的水力特征有着不可忽视的影响。同时，局部小裂隙、区域大裂隙应当区别对待，以便据其所起的作用及水力特征，建立裂隙化岩体相应的流体渗流模型。     

Impact of Kiri dam on the lower reaches of river Gongola, Nigeria

Changes in Geomorphic characteristics in the lower reaches of the Gongola River channel following construction of Kiri dam have been investigated. The study focused on changes in the channel bankfull width and of riverbed width after the control of the river flow, variation in discharge characteristics between pre- and post- dam periods and the impact of discharge variation on post- dam river channel. Results of the analysis revealed that the main effect of the impoundment of the Gongola channel is a drastic decrease in flood peaks below the reservoir by 11.5% (from 1,420 m³/sec to 1,256 m³/sec). The low flows have on the other hand increased by 268% (from 5.7 m³/sec to 21 m³/sec). The resultant effect of decrease in the discharge was reduction in the channel bankfull and riverbed widths by 38.3% and 72.2% respectively. Also, the post- dam channel became less sinuous and braided in some of the reaches downstream. Discharges of high peaks were found during the period of maximum precipitation (June to September) whereas low discharges were recorded during the period of minimum or no precipitation (December to May). Some of the observed implications of the flow control on the geometric variables were reduction in the overall channel width, concave bank erosion and emergence of vegetation in some of the reaches.     

Identifying and quantifying urban recharge: a review

The sources of and pathways for groundwater recharge in urban areas are more numerous and complex than in rural environments. Buildings, roads, and other surface infrastructure combine with man-made drainage networks to change the pathways for precipitation. Some direct recharge is lost, but additional recharge can occur from storm drainage systems. Large amounts of water are imported into most cities for supply, distributed through underground pipes, and collected again in sewers or septic tanks. The leaks from these pipe networks often provide substantial recharge. Sources of recharge in urban areas are identified through piezometry, chemical signatures, and water balances. All three approaches have problems. Recharge is quantified either by individual components (direct recharge, water-mains leakage, septic tanks, etc.) or holistically. Working with individual components requires large amounts of data, much of which is uncertain and is likely to lead to large uncertainties in the final result. Recommended holistic approaches include the use of groundwater modelling and solute balances, where various types of data are integrated. Urban recharge remains an under-researched topic, with few high-quality case studies reported in the literature. Electronic Publication     

Quantitative analysis of variations in depositional sequence thickness from submarine channel levees

Abstract Thickness variations across‐levee and downchannel in acoustically defined depositional sequences from six submarine channel‐levee systems show consistent and quantifiable patterns. The thickness of depositional sequences perpendicular to the channel trend, i.e. across the levee, decreases exponentially, as characterized by a spatial decay constant, k. Similarly, the thickness of sediment at the levee crest decreases exponentially down the upper reaches of submarine channels and can be characterized by a second spatial decay constant, λ. The inverse of these decay constants has units of length and defines depositional length scales such that k^?1 is a measure of levee width and λ^?1 is a measure of levee length. Quantification of levee architecture in this way allowed investigation of relationships between levee architecture and channel dimensions. It was found that these measures of levee e‐folding width and levee e‐folding length are directly related to channel width and relief. The dimensions of channels and levees are thus intimately related, thereby limiting the range of potential channel‐levee morphologies, regardless of allocyclic forcing. A simple sediment budget model relates the product of the levee e‐folding width and e‐folding length to through‐channel volume discharge. A classification system based on the quantitative downchannel behaviour of levee architecture allows identification of a ‘mid‐channel’ reach, where sediment is passively transferred from the through‐channel flow to the levees as an overspilling flow. Downstream from this reach, the channel gradually looses its control on guiding turbidity currents, and the resulting flow can be considered as an unconfined or spreading flow.     

扎赉诺尔煤田水文地球化学特征及成因分析

扎赉诺尔煤田地处山前,有利的地理环境条件形成了独特的水文地质特征—地下水的垂直分带和地下水顺层径流。其特有的水文地球化学环境导致了地下水成分的差异性。本文从水文地球化学的角度,对煤田地下水的水文地球化学特征及成因进行了论述分析。     

深井水氡主要干扰因素及映震效能分析

对甘肃省玉门青6井和平凉泾川泾3井两口深水井的水氡及辅助项目观测资料采用多元逐步回归、相关距平、一阶差分等方法进行处理，分析并排除了主要干扰因素，显示出两井在肃南5.4级、托莱6.0级和礼县5.1级地震前有明显异常，对两井的映震效能和地震预报前景进行了评价。