原状非饱和黄土的三轴试验研究

利用特制的非饱和土三轴仪器,对不同含水量条件下原状非饱和黄土的强度和土-水特征曲线进行了试验研究。试验结果表明：非饱和黄土的抗剪强度随着含水量的不同而不同,含水量越大,非饱和黄土的基质吸力就越小,抗剪强度亦越小。含水量趋于饱和时,非饱和黄土的抗剪强度值逐渐接近于饱和黄土的强度值。原状非饱和黄土的抗剪强度均高于饱和黄土的抗剪强度。非饱和黄土的内摩擦角受含水量的影响不大。凝聚力受含水量的影响很大,含水率越大,基质吸力越小,总凝聚力越小。根据实验结果,提出了非饱和土的抗剪强度模型,该模型易于确定,与实测基本吻合,误差较小,满足非饱和黄土的强度计算要求。     

复合单元法的物理和数值试验验证

简述了复合单元法的基本原理和算法,该方法的主要优点在于可以明显地减少前处理的工作量和难度,且可以与有限单元很好地耦合在一个系统中。介绍了宝珠寺重力坝的物理模型超载试验。分别采用三维弹黏塑性复合单元法和三维弹黏塑性有限单元法对宝珠寺重力坝的超载工况进行了数值试验,并与物理试验进行比较。结果表明,三种方法得到的特征点位移吻合得较好,两种数值试验方法的整体位移和应力也基本一致。研究验证了复合单元法的正确性,也说明了该算法的主要优点：前处理简单,计算精度与有限单元法相当,同时还证实了复合单元单元法可以较好地解决复杂岩基上重力坝的变形与破坏问题。     

横观各向同性冻土弹性常数及强度预测

在分析冻土形成过程及其组构前提下,从冻土细观结构特征出发,将冻土视为由冰层与干硬土层黏结组成的横观各向同性固体介质。根据复合材料力学理论,求出冻土各向同性面内及面外的弹性模量和泊松比;基于Tsai-Wu 准则,预测了横观各向同性冻土的强度。根据实验数据,分析了不同组分对冻土弹性常数及强度的影响。在工程应用中可根据环境温度及土质、系统有无水分补给、温降速度与冻结速率是否同步、冻土受力方向与冻结封面方向的具体情况选用即可,从而大幅降低室内外试验次数。为冻土工程数值计算奠定了基础,为进一步了解冻土力学特性提供了理论依据     

竖向荷载作用下桩筏基础可视化模型试验研究

进行了群桩基础可视化模型试验。在试验过程中对各级竖向荷载作用下群桩基础桩、土的变形采用高清晰数码相机拍摄了照片。通过对照片进行后处理分析,得到了桩、土的位移场,也对桩身轴力也进行了量测,在该基础上研究了群桩基础的变形性状和破坏模式,重点分析对比了桩间距和桩长对桩端土体沉降以及桩身侧摩阻力的影响。试验发现,桩距是影响桩土相对滑移量的主要因素,桩距越大,桩身与土的相对滑移量就越大,桩端刺入量也越大。在柔性筏基下,随桩距增加中桩的桩土相对滑移量可能会大于边桩。桩端刺入量是大桩距桩基础主要的沉降构成,以桩端刺入量为研究对象建立一套大桩距基础新的沉降计算理论,似乎值得进一步研究。桩顶向上刺入（可通过设置褥垫层、桩顶预留净空或设置可压缩垫块来实现）有利于桩间土的压密,减小桩端刺入量,甚至改变破坏模式。     

纳米氧化物颗粒对水基钻井液润滑性能影响的试验研究

通过在水基钻井液中添加纳米氧化物颗粒,来改善其润滑性能。选用了Al2O3、TiO2及SiO2三种纳米氧化物颗粒作为钻井液改性添加剂,利用极压润滑仪及销盘摩擦磨损实验仪研究了添加不同种类和浓度纳米颗粒氧化物对水基钻井液的润滑性能及减摩效果的影响。结果表明,所添加的3种球形纳米颗粒均有润滑减阻减摩的效果,其中SiO2颗粒的钻井液的润滑性能、滤失性能以及减摩效果都是最好的。当纳米SiO2颗粒加量为0.4%时,滤失量最小,润滑系数降低率达到15.6%,摩擦系数降低率为32.0%,磨痕轨迹平滑,减摩效果最为明显。当纳米颗粒浓度超过0.5%时,减摩效果降低,磨盘脱层磨损明显。     

Pan-African Tectonism in the Western Maud Belt: P-T-t Path for High-grade Gneisses in the H.U. Sverdrupfjella, East Antarctica

Extensive high-grade polydeformed metamorphic provinces surroundingArchaean cratonic nuclei in the East Antarctic Shield recordtwo tectono-thermal episodes in late Mesoproterozoic and lateNeoproterozoic–Cambrian times. In Western Dronning MaudLand, the high-grade Mesoproterozoic Maud Belt is juxtaposedagainst the Archaean Grunehogna Province and has traditionallybeen interpreted as a Grenvillian mobile belt that was thermallyoverprinted during the Early Palaeozoic. Integration of newU–Pb sensitive high-resolution ion microprobe and conventionalsingle zircon and monazite age data, and Ar–Ar data onhornblende and biotite, with thermobarometric calculations onrocks from the H.U. Sverdrupfjella, northern Maud Belt, resultedin a more complex P–T–t evolution than previouslyassumed. A c. 540 Ma monazite, hosted by an upper ampibolite-faciesmineral assemblage defining a regionally dominant top-to-NWshear fabric, provides strong evidence for the penetrative deformationin the area being of Pan-African age and not of Grenvillianage as previously reported. Relics of an eclogite-facies garnet–omphaciteassemblage within strain-protected mafic boudins indicate thatthe peak metamorphic conditions recorded by most rocks in thearea (T = 687–758°C, P = 9·4–11·3kbar) were attained subsequent to decompression from P >12·9 kbar. By analogy with limited U–Pb singlezircon age data and on circumstantial textural grounds, thisearlier eclogite-facies metamorphism is ascribed to subductionand accretion around 565 Ma. Post-peak metamorphic K-metasomatismunder amphibolite-facies conditions is ascribed to the intrusionof post-orogenic granite at c. 480 Ma. The recognition of extensivePan-African tectonism in the Maud Belt casts doubts on previousRodinia reconstructions, in which this belt takes a pivotalposition between East Antarctica, the Kalahari Craton and Laurentia.Evidence of late Mesoproterozoic high-grade metamorphism duringthe formation of the Maud Belt exists in the form of c. 1035Ma zircon overgrowths that are probably related to relics ofgranulite-facies metamorphism recorded from other parts of theMaud Belt. The polymetamorphic rocks are largely derived froma c. 1140 Ma volcanic arc and 1072 ± 10 Ma granite. KEY WORDS: Maud Belt; Pan-African orogeny; geochronology; P–T–t path, East Antarctica     

香港全风化花岗岩饱和直剪试验中的剪胀问题

通过对全风化花岗岩的慢剪试验,指出了在直剪试验中出现的两种垂直位移变化形式,其对土体的剪胀剪缩性质的 反映与三轴试验是一致的。剪胀的发生与土体的密实程度密切相关;随垂直压力的增大,剪胀发生所需剪应力也增大;剪应 力达到峰值所需要剪位移总是比剪胀发生时所需的剪位移大。     

顺层岩质边坡开挖模型试验及稳定性影响因素分析

用地质力学模型试验方法,对顺层岩质边坡进行开挖破坏试验。同时在有限元分析的基础上,采用多层结构模型对顺层岩质路堑边坡稳定性的影响因素进行了分析。指出当边坡走向与岩层走向夹角超过30后,边坡发生顺层滑动破坏的可能性很小,基本上可不视为顺层边坡。同时也阐明了岩层倾角以及结构面抗剪强度对顺层岩质边坡稳定性的影响。文中结论可为顺层岩质边坡的科研、设计和施工提供参考。     

桩底注浆钻孔灌注桩承载力的研究

通过天津地区几例钻孔灌注桩桩底注浆的静载荷试桩结果 ,分析天津地区钻孔灌注桩桩底注浆单桩竖向极限承载力标准值的估算方法     

Experimental and numerical investigations of stresses in a fully grouted rock bolts

Rock bolts are widely used for rock reinforcement in hard-rock mining and civil engineering since a long time. However the use of fully grouted rock bolts and cable bolts is limited in coal mines. In order to improve performance of the rock bolts as a supplementary roof support system for any type of roof condition in coal measured formations, it is necessary to have a good understanding of the behavior of the bolt–grout and grout–rock interactions as well as the mechanism of load transfer in rock bolts.As the performance of grouted bolts depends on bond strength, extensive laboratory pullout as well as pushout tests were conducted in the present investigations with the variations in the bolt diameters, length and cement–water mixing ratios of grout. The load–displacement curves were developed and were verified with the numerical results obtained from finite element analysis using ALGOR software.Numerical models were validated for pushout tests and a detailed analysis was carried out to know the displacement, stress, strain distribution along the bolt.