测氡在滑坡研究中的应用

测氡是一种放射性地球物理方法,利用滑坡体与其周边岩土体的结构差异,应用测氡可对滑坡进行勘探,对滑坡的结构特征进行研究,达到节约投资,缩短勘探时间的目的,并可与地质分析相互验证,为工程应用提供依据。     

黄土滑坡临滑预报的应变控制方法

我国西北部地区黄土沉积巨厚，地质构造复杂，土体强度低，水敏感性强，各种类型的黄土滑坡广泛分布。黄土滑坡具有滑动规模大、滑动速度快、灾害损失严重等特点。黄土滑坡滑动时间预报，特别是临滑预报在地质灾害防治领域具重要意义。根据黄土力学性质试验与典型黄土滑坡变形分析研究结果，在对比分析黄土剪切应变特性与滑坡滑动破坏机制的基础上，论文提出了一种黄土滑坡临滑预报的应变控制方法。建立了中、浅层与厚层黄土滑坡的应变破坏标准。经多处滑坡实例验证，结果基本合理，可应用于黄土滑坡临滑预报。     

软土大变形固结计算中参数识别的遗传算法

含水量很高的饱和软土在外荷载作用下沉降很大,小变形分析误差太大,必须通过大变形非线性固结计算来模拟。遗传算法是一种全局优化和搜索的仿生算法。近年来随着工程领域中复杂的大规模非线性系统的出现,遗传算法日益得到青睐,目前已经广泛应用到各个领域中。本文对遗传算法做了改进,主要体现在杂交算子的选取和轮盘赌模型的模拟退火拉伸,并将其用于饱和软土的大变形固结分析,解决其中的关键参数识别问题。研究表明该方法是行之有效的,值得进一步研究探索。     

基于应变模态法识别刚架桥梁的损伤

基于应变模态方法，对刚架桥的损伤识别进行了研究。通过对某刚架桥在不同损伤工况下的数值仿真计算，探讨了应变模态方法用于刚架桥损伤识别的能力。计算结果表明：利用应变模态差曲线能比较准确地识别出刚架桥的损伤位置；应变模态差曲线在刚架桥损伤单元处的跳跃幅值随单元损伤程度的增加而增大，依此可定性地识别出刚架桥的损伤程度。     

山西高平地震

阐述了发生在山西高平的地震和对高平有影响的地震，分析了高平市的地震灾害，通过分析得出高平地震与晋获断裂带活动有关的结论。     

低应变反射波法在基桩检测中的应用实例及一些问题的探讨

根据应力波理论，介绍了用低应变反射波法在桩身完整性检测中的几个应用实例，并对检测中的一些问题作了探讨。     

GPS技术应用于中国地壳运动研究的方法及初步结果

文中主要就中国利用GPS等空间测地资料研究地壳运动、构造变形 ,以及用于地震预测探索方面 ,从方法技术和近年来取得的一些初步结果进行了概要性论述。介绍了利用GPS技术资料研究地壳水平运动速度场、水平应变场、建立地壳运动模型等方法研究的进展。由GPS观测给出的地壳水平运动初步结果表明 :中国大陆现时水平运动在全球参考系中为整体向东 ,并兼有顺时针扭转运动。西部地区构造形变强烈 ,整个青藏块体及其边界带 ,以及新疆西部是应变值最高的区域 ,水平应变场主压应变优势分布方向为近NE向 ,空间差异显著 ,反映了印度板块碰撞推挤和青藏块体强烈构造运动的影响。中国大陆东部水平运动的差异性不显著。强震分布于地壳运动的大小、方向显著变化的区域 ,大地震通常发生在水平剪应变高值区或其边缘 ,尤其是与区域主干断裂的构造活动背景相一致的剪应变率高值区。     

Aseismic negative dislocation model and deformation analysis of crustal horizontal movement during 1999——2001 in the northeast margin of Qinghai-Xizang block

Through numerical simulation for GPS data, aseism/c negative dislocation model for crustal horizontal movement during 1999-2001 in the northeast margin of Qinghai-Xizang block is presented, combined with the spatial distri-bution of apparent strain field in this area, the characteristics of motion and deformation of active blocks and their boundary faults, together with the place and intensity of strain accumulation are analyzed. It is shown that: a) 9 active blocks appeared totally clockwise motion from eastward by north to eastward by south. Obvious sinistral strike-slip and NE-NEE relative compressive motion between the blocks separated by Qilianshan-Haiyuan fault zone was discovered; b) 20 fault segments (most of them showed compression) locked the relative motion between blocks to varying degrees, among the total, the mid-east segment of Qilianshan fault (containing the place where it meets Riyueshan-Lajishan fault) and the place where it meets Haiyuan fault and Zhuanglanghe fault, more favored accumulation of strain. Moreover, the region where Riyueshan-Lajishan fault meets north boundary of Qaidam block may have strain accumulation to some degree, c) Obtained magnitude of block velocities and locking of their boundaries were less than relevant results for observation in the period of 1993-1999.     

Movement and strain conditions of active blocks in the Chinese mainland

The definition of active block is given from the angles of crustal deformation and strain. The movement and strain parameters of active blocks are estimated according to the unified velocity field composed of the velocities at 1598 GPS stations obtained from GPS measurements carried out in the past years in the Chinese mainland and the surrounding areas. The movement and strain conditions of the blocks are analyzed. The active blocks in the Chinese mainland have a consistent E-trending movement component, but its N and S components are not consistent. The blocks in the western part have a consistent N-trending movement and the blocks in the eastern part have a consistent S-trending movement. In the area to the east of 90°E, that is the area from Himalayas block towards NE, the movement direction of the blocks rotates clockwisely and the movement rates of the blocks are different. Generally, the movement rate is large in the west and south and small in the east and north with a difference of 3 to 4 times between the rates in the west and east. The distributions of principal compressive strain directions of the blocks are also different. The principal strain of the blocks located to the west of 90oE is basically in the SN direction, the principal compressive strain of the blocks in the northeastern part of Qingzang plateau is roughly in the NE direction and the direction of principal compressive strain of the blocks in the southeastern part of Qingzang plateau rounds clockwisely the east end of Himalayas structure. In addition, the principal strain and shear strain rates of the blocks are also different. The Himalayas and Tianshan blocks have the largest principal compressive strain and the maximum shear strain rate. Then, Lhasa, Qiangtang, Southwest Yunnan (SW Yunnan), Qilian and Sichuan-Yunan (Chuan-Dian) blocks followed. The strain rate of the blocks in the eastern part is smaller. The estimation based on the stain condition indicates that Himalayas block is still the area with the most intensive tectonic activity and it shortens in the NS direction at the rate of 15.2±1.5 mm/a. Tianshan block ranks the second and it shortens in the NS direction at the rate of 10.1±0.9 mm/a. At present, the two blocks are still uprising. It can be seen from superficial strain that the Chinese mainland is predominated by superficial expansion. Almost the total area in the eastern part of the Chinese mainland is expanded, while in the western part, the superficial compression and expansion are alternatively distributed from the south to the north. In the Chinese mainland, most EW-trending or proximate EW-trending faults have the left-lateral or left-lateral strike-slip relative movements along both sides, and most NS-trending faults have the right-lateral or right-lateral strike-slip relative movements along both sides. According to the data from GPS measurements the left-lateral strike-slip rate is 4.8±1.3 mm/a in the central part of Altun fault and 9.8±2.2 mm/a on Xianshuihe fault. The movement of the fault along the block boundary has provided the condition for block movement, so the movements of the block and its boundary are consistent, but the movement levels of the blocks are different. The statistic results indicate that the relative movement between most blocks is quite significant, which proves that active blocks exist. Himalayas, Tianshan, Qiangtang and SW Yunnan blocks have the most intensive movement; China-Mongolia, China-Korea (China-Korea), Alxa and South China blocks are rather stable. The mutual action of India, Pacific and Philippine Sea plates versus Eurasia plate is the principal driving force to the block movement in the Chinese mainland. Under the NNE-trending intensive press from India plate, the crustal matter of Qingzang plateau moves to the NNE and NE directions, then is hindered by the blocks located in the northern, northeastern and eastern parts. The crustal matter moves towards the Indian Ocean by the southeastern part of the plateau.