GPS地壳形变监测网应变解算方法与程序设计

分析了在平面直角坐标系和大地坐标系内解算应变的方法及其特点,并以Matlab为开发平台,研制出一套在平面直角坐标系和大地坐标系中解算应变的程序GPSstrain。利用GPS监测网测站位移(速率),该程序能够解算剪切应变(γ1、γ2)、面应变、块体旋转、主应变及其方向、最大剪切应变及其方向,同时也可解算出这些应变分量的误差。另外该程序还具有高斯投影解算功能,根据各测站坐标能够自动形成所有的Delaunay三角形,并以图形方式显示。最后以实际算例给出了该解算程序的部分结果,并进行了初步的分析和讨论。     

SEISMIC IMPACT LOADING IN INELASTIC TENSION-ONLY CONCENTRICALLY BRACED STEEL FRAMES: MYTH OR REALITY?

Tension-Only Concentrically Braced Frames (TOCBF) exhibit deteriorating pinched hysteretic behaviour during strong earthquakes. Slender braces transit between an elastic buckling state, a restraightening state, in which they carry almost no load, an elastic tensile loading state as they are suddenly taut and, finally, a tensile yielding state. It has long been suspected that the sudden increase in tensile forces in the braces of TOCBSF creates detrimental impact loading on the connections and other structural elements. No experimental evidence, however, has been provided so far to confirm, or to quantify, this impact phenomenon. This paper addresses this issue through shake table tests of half scale, two-storey, TOCBF models. By normalizing the hysteresis loops of braces obtained from shake table tests to the yield strength of steel obtained from quasi-static tests, the increase in tensile forces in the braces was obtained. Results of dynamic tensile tests on steel coupons under similar strain rates as observed during the shake table tests showed that this increase in tensile forces is not the result of impact, but is rather caused by a yield strength increase of the steel under high strain rate. A procedure is proposed to estimate and account for this increase in tensile forces in the braces at the design stage.     

The Monagas Fold-Thrust Belt of Eastern Venezuela. Part I: Structural and thermal modeling

The Eastern Venezuelan Basin (EVB) contains one of the largest hydrocarbon accumulations in the world. Main petroleum targets are buried structures of the Monagas Fold-Thrust Belt (MFTB) which forms the northeastern edge of the EVB. The objective of this study is to integrate the seismic and well data that has been acquired over the last 10 years across the MFTB and EVB, to create an updated structural model. Three regional cross sections 60-75 km long are presented across an area of 4000 km².Five structural domains are described: Amarilis, Furrial, Jusepín, Cotoperí and Pirital. They are characterized by thrusts and high-angle reverse faults. Structural style changes along strike are related to variations in depth of detachment levels and to the strike-slip component of the deformation. We have estimated a shortening between 43 and 59 km that increases eastward over a distance of 40 km.The evolution of the MFTB is divided in four episodes based on stratigraphic, structural and thermal maturity evidences: (1) Oligocene-early Miocene initial movement of Pirital thrust. (2) Early Miocene simultaneous movement on Pirital, Furrial and Cotoperí thrusts. (3) Middle Miocene increases in velocity and change in geometry of Pirital thrust, during an out of sequence period of thrusting. (4) Late Miocene to Holocene minor thrust activity. This evolution is consistent with the oblique convergence between the Caribbean and South American plates and the convergence between North and South America that affected Eastern Venezuela during the Cenozoic.By analyzing the along-strike variations in structural style, new exploratory opportunities have been identified. Under the Orocual and Santa Bárbara fields two untested duplex structures are proposed; they were developed during the middle Miocene. Other prospective hydrocarbon traps are associated to oblique transpressive faults that create anticline structures.     

Sub-seismic scale fracture pattern and in situ permeability data in the chalk atop of the Krempe salt ridge at Lägerdorf, NW Germany: Inferences on synfolding stress field evolution and its impact on fracture connectivity

Chalk is exposed in the Heidestrasse quarry at Lägerdorf, at the top of the NE-SW trending Krempe salt ridge. Structural data indicate the presence of two joint sets, striking almost parallel and perpendicular to the salt ridge, respectively, and of a set of conjugate extensional faults and fault zones striking NW-SE, i.e. almost perpendicular to the salt ridge. Within the overall NW-SE trend of joints and faults, strike variations occur from the massive chalk exposed in the lower half of the quarry, to the overlying layered chalk. A large variability characterizes the normalized spacing of both joint sets, which does not show any clear trend with layer dip. In situ measurements indicate that the cross-sectional permeability of tight joints increases 1-2 orders of magnitude with respect to the undeformed chalk. We propose that joint and fault azimuthal variability resulted from changes through time of the stress ellipsoid at the top of the salt ridge, while joint spacing variability is associated with the weak mechanical influence of bedding in chalk. Azimuthal variability improves fracture connectivity and, hence, permeability and fluid flow.     

Elastic response of catamaran wetdeck to liquid impact

The impact of an elastic plate onto the compressible fluid without free surface deformation is considered. The ability of the liquid volume to be deformed is geometrically limited which leads to severe impact conditions. The present analysis is focused on the stresses in the plate and the hydrodynamic loads under the impact. The motivation for this research comes from ship hydrodynamics, where the hulls of a catamaran restrict the liquid outflow and the water impacts onto the wetdeck. The influence of the air on the impact process is investigated. The analysis did not reveal any great advantage of utilizing the air-cushion effect or ejection of air into the water near the impact region to prevent high stresses in the elastic plate. It was found that in the problem considered, the stress peaks far from the plate centre and the one-mode approximation does not provide correct information about the stress level.     

Significant load and green water on deck of offshore units/vessels

In this paper the probability of green water occurrence is investigated by taking into account the threshold of the vertical relative motion exceeding the freeboard. The number of wetting of the unit/vessel is predicted using probabilistic method. This paper compares the significant load, due to shipping of green water with the works of other researchers, and the loads are found to be close with the results presented in this paper. There is no direct relation between the velocities in the waves and the water velocity over the deck. The water velocities around the bow are heavily distributed by the presence of the bow. This scenario makes the flow very complex for schematic modelling.     

Sustainable development: Social outcomes of structural adjustments in a South Australian fishery

The assessment of sustainable development is a relatively recent advent in policy and the evaluation of industry structural adjustments. Although the elements of economic and environmental assessment have been relatively well developed and accepted, the effective inclusion of ‘social’ aspects in assessments of sustainable development are still being grappled with.     

Control of Aptian palaeobathymetry on turbidite distribution in the Buchan Graben,Outer Moray Firth,Central North Sea

It is widely recognised that palaeobathymetry is a key control on the distribution of turbidite deposits. Thus, the utilisation of palaeobathymetric surfaces as an input for numerical turbidity current modelling offers a potentially powerful method to predict the distribution of deep marine sands in ancient (subsurface or outcrop) successions. Such an approach has been tested on an Aptian turbidite deposit from the Buchan Graben, UK Central North Sea, where modelled sand distributions could be quality controlled against available well data.     

Improved assessments of wave-induced fatigue for free spanning pipelines

For subsea pipeline projects, the costs related to seabed correction and free span intervention are often considerable. Development of reliable methods for fatigue analyses of pipelines in free spans contributes to minimize costs without compromising pipeline integrity. Assessment of wave-induced fatigue damage on multi-span pipelines is investigated, and improved analysis methods are suggested in this paper. A time-domain (TD) algorithm is developed, which accounts for non-linear hydrodynamic loading and dynamic interaction between adjacent spans. The proposed TD approach is employed to evaluate linearized frequency-domain (FD) solutions from recognized design standards and to study the dynamic response of multi-span pipelines to direct wave loading. Differences between multi- and single-span analyses are described for the first time, and the common assumption that the main fatigue damage contribution comes from the fundamental mode is demonstrated not to hold for multi-spans. An improved FD solution capable of predicting multi-mode response is derived and demonstrated to give accurate fatigue life estimates for multi-span pipelines.     

Laboratory and case studies of thermal cycling and stored strain on the stability of selected marbles

Studies of marble panels from the exterior of two buildings document the processes leading to bowing of the material. Bowing of panels is most extensive in those areas that are exposed to direct or reflected thermal energy. The thermal anisotropic behavior of calcite results in grain-boundary separation, grain sliding and microfracturing. The resulting loss of strength is one factor leading to bowing. The development of bows further reduces the panel strength as the outer portions elongate by inelastic deformation mechanisms. Laboratory experiments cycling marble samples for over 200 cycles at three temperatures up to 107°C above room conditions show similar strength losses as the natural situation. The second factor contributing to the bowing process is the release of residual elastic strain. The strain is in part stored in the marble from its geologic history, but may also be accumulated during thermal cycling due to the properties of calcite. Marble panels have been found to bow when stored outside, but not attached to any framework, indicating that the release of residual strain is a critical factor in producing the bows.