海洋沉积物黏土矿物相对含量不同计算方法对比研究

海洋沉积物黏土矿物相对含量计算存在多种计算方法,并不统一,限制了异源黏土矿物的整合和使用。文章选取了两种较为常见的计算方法,即Biscaye和国标中规定的计算方法,分别对东印度洋109个表层样品黏土矿物的相对百分含量进行计算,分析对比了两种方法计算结果之间的差异。结果显示,两种计算方法结果存在显著正相关,都能显示黏土矿物分布的变化趋势,4种黏土矿物相关系数由高到底分别为:蒙皂石0.986、伊利石0.974、绿泥石0.924、高岭石0.923。相对于Biscaye计算方法,国标计算方法会增加伊利石和高岭石的相对百分含量而降低蒙皂石和绿泥石的相对百分含量。两种计算方法黏土矿物的含量相关性较好,可以建立起相互数学转换关系式。但在不同的海区,由于矿物成因、结晶程度以及混层矿物的出现可能会使衍射峰形态发生改变,从而相关性系数和转换关系也会相应发生改变。     

基于"一带一路"建设的环渤海地区港口优势评价

港口作为海陆运输的节点,是一个城市和国家的重要门户,对推动经济发展和对外贸易有着不可忽视的作用。基于国家提出的"一带一路"建设,评估环渤海港口的发展优势,逐步实现从沿海、沿江开放向内陆延伸具有重要意义。文章选取环渤海港口中的大连、天津、唐山、丹东、营口、锦州、秦皇岛、黄骅、日照、青岛、威海和烟台共12个港口进行发展优势对比。从港口吞吐量、港口规模范围、港口城市及腹地、港口未来发展4个方面构建环渤海港口优势评价体系。并利用熵权-TOPSIS法进行深入的实证分析。结果表明,环渤海港口群港口发展优势水平悬殊,基本可以分为4个档次。基于此,环渤海各港口应合理准确定位,通过错位发展和协同合作等方式谋求共赢。     

不同插值方法在海域气象参数估算中的可靠性评价

海域条件下的气象观测具有数据稀少、变化大且观测站点分布不均的特点,其插值精度受插值方法影响较大。首先对常规插值方法进行理论分析,进而选取了反距离加权法、克里金法和样条函数法三种插值方法进行了插值实验和精度分析。根据渤海湾某区域的气象历史数据,采用不同方法绘制了温度、压强和湿度的插值平面图,并基于交叉验证的方式对各插值方法进行了对比,给出了不同方法的插值估算可靠性评价。结果表明:温度、压强和湿度的插值精度均是基于反距离加权法的插值结果最优(MAE_(温度)=2.42,RMSE_(温度)=1.92,MAE_(压强)=2.05,RMSE_(压强)=1.30,MAE_(湿度)=11.394, RMSE_(压强)=6.43),同时基于反距离加权法的图形绘制可视化效果也要优于其他两种方法。研究结果可为海域气象参数估算提供理论和实践依据。     

Wave Attenuation Performance and the Influencing Factors of A Lower Arc-Plate Breakwater

Comprehensive experimental and numerical studies have been undertaken to investigate wave energy dissipation performance and main influencing factors of a lower arc-plate breakwater. The numerical model, which considers nonlinear interactions between waves and the arc-plate breakwater, has been constructed by using the velocity wave- generating method, the volume of fluid (VOF) method and the finite volume method. The results show that the relative width, relative height and relative submergence of the breakwater are three main influencing factors and have significant influence on wave energy dissipation of the lower arc-plate open breakwater. The transmission coefficient is found to decrease with the increasing relative width, and the minimum transmission coefficient is 0.15 when the relative width is 0.45. The reflection coefficient is found to vary slightly with the relative width, and the maximum reflection coefficient is 0.53 when the relative width is 0.45. The transmission and reflection coefficients are shown to increase with the relative wave height for approximately 85% of the experimental tests when the relative width is 0.19 0.45. The transmission coefficients at relative submergences of 0.04, 0.02 and 0 are clearly shown to be greater than those at relative submergences of 0.02 and 0.04, while the reflection coefficient exhibits the opposite relationship. After the wave interacts with the lower arc-plate breakwater, the wave energy is mainly converted into transmission, reflection and dissipation energies. The wave attenuation performance is clearly weakened for waves with greater heights and longer periods.     

象山港海域分区评价方法研究

文章根据2011-2018年在象山港海域调查的象山港水文、水团、水环境、沉积物环境、生物生态等调查数据,将象山港海域划分为若干个具有不同生态变化特征的区域,研究象山港海域内的空间异质性,以便剖析各区域环境的问题。研究发现：象山港水交换特征、水团分布、水环境、沉积环境和生物生态特征将象山港划分为A、B、C、D、E 5个区评价较为合理。该方法可以有效并合理地对象山港海域做出评价,并为相关海洋科学工作者和管理者提供科学依据。     

Energy saving performance analysis of contra-rotating azimuth propulsor

The energy saving performance of contra-rotating azimuth propulsor (CRAP) is investigated based on low order potential-based panel method. The hydrodynamic interactions among the forward propeller (FP), rear propeller (RP) and the pod unit (PU) which includes the pod body and the strut are considered through induced velocities which are obtained by panel method. In order to have a better understanding about the energy saving performance of CRAP, the hydrodynamic performance of a conventional propeller (CP) supplying the same thrust with CRAP at design condition is also calculated. At design condition, CRAP has a decrease in delivered power by approximately 8% comparing with CP, and the tangential induced velocities in slipstream show that CRAP recovers the rotational energy of slipstream effectively. At off-design conditions, the rotational speed of CRAP is adjusted to supply the same thrust with CP. In general, the delivered power of CRAP is significantly smaller than that of CP, and the energy saving performance of CRAP increases with the decrease of inflow velocity.     

基于经验模态分解和小波分解估算海气通量涡相关计算中的截断时间尺度

基于时长38天的海表风场实测数据,应用经验模态分解(EmpiricalModeDecomposition,EMD)和小波分解(Wavelet Decomposition, WD)这两种数据处理方法首先对涡相关法中的截断时间尺度(CutoffTimescale,CTS)进行估算,结果显示:基于EMD与WD方法估算出的CTS一般都在40秒左右(EMD的结果略小),远远小于传统涡相关法中CTS的取值(固定为10分钟),且EMD和WD的使用使得每一段数据都能够根据自身的湍流特点而获得合适的CTS; EMD方法和WD方法有效的去除了计算结果中的非湍部分,且对通量传输方向的刻画也更加合理,极大提高了通量的计算精度,所得通量与传统方法计算的通量偏差平均值高达45%;研究还对EMD和WD的优缺点进行了对比分析,结果表明EMD相比于WD有更高的自主性,而WD对信号的分离程度则更高。     

莱州湾表层沉积物粒度和黏土矿物分布特征与运移趋势分析

运用粒度参数分析、黏土矿物含量分析、Flemming三角图示法和Gao-Collins二维的"粒度趋势分析"等方法,对采自莱州湾海域的表层沉积物样品和黏土矿物样品进行分析,了解了该研究区域的沉积环境及沉积物的运移趋势。研究区由岸向海沉积物类型大致依次为砂-粉砂质砂-砂质粉砂-粉砂-黏土质粉砂,并且研究区表层沉积物在近岸区域呈现较为明显的平行岸线的条带状特征;同时沉积物的平均粒径、分选系数、偏态、峰态等粒度参数也呈现出良好的正相关性或负相关性;研究区黏土矿物为伊利石、蒙脱石、绿泥石、高岭石,除伊利石分布大致为黄河三角洲近岸低,向研究区东北方向逐渐升高外,其余的黏土矿物都表现出了近岸高,远海低的分布特征,且主要物源为黄河物质输入。Flemming三角图研究区所有采样点大部分分布在Ⅱ区,少部分分布在Ⅲ区,说明研究区整体水动力较强;采样点在A—E区均有分布,但在C、D两区分布最多,说明研究区沉积物粒径较集中。研究区表层沉积物整体呈由岸向海输运的趋势,具体来看,黄河沉积物入海后向北、向东、向南运移,研究区内沉积物的来源是黄河输沙以及周围入海的小河流的输沙和沿岸冲刷的物质。     

海气动量通量研究综述

海气界面动量通量也称为风应力,是海流和表面海浪的主要驱动力,是海洋从大气获得动量的重要途径。因此,合理可靠的海洋表面风应力的参数化对于海洋、大气和波浪以及气候模式的准确预报都具有非常重要的科学意义和实用价值。对风应力拖曳系数的参数化是风应力参数化的主要内容。近来的观测发现,风应力拖曳系数随着风速的增加出现了先增后减的趋势,同时还与海面的波浪状态以及海流有关。基于观测或理论分析,目前已经得到了一系列的风应力拖曳系数计算方法或公式,有的考虑了海浪的作用,有的没有,但这些方案大都是适合中低风速,在高风速下的适用性还有待检验。本文回顾了目前在海气动量通量观测和参数化方面的研究进展,并建议应增加高风速下风速、海流以及海浪等的同步观测,以进一步完善风应力参数化方案。     

Numerical modeling investigation on turbulent oscillatory flow over a plane rough bed composed by randomly arrayed particles

A three-dimensional numerical model is established to simulate the turbulent oscillatory boundary layer over a fixed and rough bed composed by randomly arrayed solid spheres based on the lattice Boltzmann method and the large eddy simulation model.The equivalent roughness height,the location of the theoretical bed and the time variation of the friction velocity are investigated using the log-fit method.The time series of turbulent intensity and Reynolds stress are also investigated.The equivalent roughness height of cases with Reynolds numbers of 1×10~4–6×10~4 is approximately 2.81 d(grain size).The time variation of the friction velocity in an oscillatory cycle exhibits sinusoidal-like behavior.The friction factor depends on the relative roughness in the rough turbulent regime,and the pattern of solid particles arrayed as the rough bed in the numerical simulations has no obvious effect on the friction factor.