VORTEX FLOW FIELD IN A SCOUR HOLE AROUND ABUTMENTS

The three-dimensional flow field in a scour hole around different abutments under a clear water regime was experimentally measured in a laboratory flume, using the Acoustic Doppler Velocimeter (ADV). Three types of abutments used in the experiments were vertical-wall (rectangular section), 45° wing-wall (45° polygonal section) and semicircular. The three-dimensional time-averaged velocity components were detected at different vertical planes for vertical-wall abutment and azimuthal planes for wing-wall and semicircular abutments. The velocity components were also measured at different horizontal planes. In the upstream, presentations of flow field through vector plots at vertical / azimuthal and horizontal planes show the existence of a primary vortex associated with the downflow inside the scour hole. On the other hand, in the downstream, the flow field shows a reversed flow near the abutments having a subsequent recovery with a passage of flow as a part of the main flow. The data presented in this p     

Mid‐Holocene sub‐blanket‐peat alluvia and sediment sources in the upper Liffey valley,Co. Wicklow,Ireland

A recently exposed section across a ?rst‐order valley buried beneath the regional blanket peat on hillside slopes in the upper Liffey valley, Co. Wicklow, is described. The section shows two alluvia within a shallow valley form underlain by an extensive boulder and stone line over regional till and weathered granite. ¹⁴C dates from wood in the alluvia indicate the older alluvium to have formed between 4324 ± 53 BP and 4126 ± 45 BP and the younger between 3217 ± 53 BP and 2975 ± 53 BP . The basal layer of the overlying peat yielded a date of 2208 ± 61 BP . The younger alluvium shows the effects of soil paludi?cation prior to the peat expansion. Dated pollen analyses elsewhere in the upper catchment con?rm the spread of blanket peat over most areas above 350 m after 4000–3600 BP . The buried valley was contributing sediments to the mid‐Holocene ?oodplains in the upper Liffey valley prior to the extension of blanket peat over the catchment after which sediment yields from it and the other catchment slopes declined. Copyright © 2003 John Wiley & Sons, Ltd.     

Spatial probabilistic modeling of slope failure using an integrated GIS Monte Carlo simulation approach

Spatial probabilistic modeling of slope failure using a combined Geographic Information System (GIS), infinite-slope stability model and Monte Carlo simulation approach is proposed and applied in the landslide-prone area of Sasebo city, southern Japan. A digital elevation model (DEM) for the study area has been created at a scale of 1/2500. Calculated results of slope angle and slope aspect derived from the DEM are discussed. Through the spatial interpolation of the identified stream network, the thickness distribution of the colluvium above Tertiary strata is determined with precision. Finally, by integrating an infinite-slope stability model and Monte Carlo simulation with GIS, and applying spatial processing, a slope failure probability distribution map is obtained for the case of both low and high water levels.     

酒店气象专用电视频道技术方案

阐述了酒店气象专用电视频道的工作原理,同时还推荐了本系统软硬件具体的配置,最后对专用系统软件的工作流程及其使用方法进行了详细的说明。     

Streambank fish-shelter structures help stabilize tributary streams in Wisconsin

 A significant proportion of stream sediment yield in North America comes from stream channel and bank erosion. One method used for stream stabilization is the bank installation of timber and stone fish-shelter structures, but there is little evidence for their potential effectiveness. Nine to nineteen years of precise survey data from Coon Creek, Wisconsin, however, show that fish structures enhance sediment deposition along the stream and may retard lateral migration of channels. Such structures have greater utility for sediment control when streams are eroding away a high bank and replacing it with a lower bank. Received: 18 October 1996 · Accepted: 4 February 1997     

黄土斜坡地震动时程分析

应用地震危险性分析理论和地震动人工合成技术，给出Newmark法中所需的地震动时程，解决了斜坡稳定性分析Newmark法中难以选取合适地震动时程的难题。通过对黄土斜坡实例计算，给出了坡体中地震动峰值加速度与深度的关系；在计算坡体位移时，提出了等效峰值加速度的概念；对比了使用地面地震动时程和使用坡体内等效地震动时程的计算结果。     

Bedload transport resistance in rough open‐channel flows

During bedload movement by saltation, streamwise momentum is transferred from the ?ow to the saltating grains. When the grains collide with other grains on the bed or in the ?ow, streamwise momentum is reduced, and there is a decrease in streamwise ?ow velocity and an increase in ?ow resistance, herein termed bedload transport resistance f_bt. Based on experiments in two ?umes with ?xed and mobile plane beds and previously published data, an equation is developed that may be used to predict f_bt for both capacity and non‐capacity ?ows. The variables in this equation are identi?ed by dimensional analysis and the coef?cients are determined by non‐linear regression. This equation applies to rough turbulent open‐channel ?ows, where the relative submergence is between 1 and 20 and the entire sediment load moves by saltation. An investigation of the relative magnitudes of f_bt and grain resistance f_c suggests that where dimensionless shear stress θ is less than 1 and saltation is the dominant mode of bedload transport, f_bt/f_c increases with θ but never exceeds 1. Copyright © 2004 John Wiley & Sons, Ltd.     

Comparison of hydraulic geometry between sand‐ and gravel‐bed rivers in relation to channel pattern discrimination

A comparison has been made between the hydraulic geometry of sand‐ and gravel‐bed rivers, based on data from alluvial rivers around the world. The results indicate a signi?cant difference in hydraulic geometry among sand‐ and gravel‐bed rivers with different channel patterns. On this basis, some diagrams for discrimination of meandering and braided channel patterns have been established. The relationships between channel width and water discharge, between channel depth and water discharge, between width–depth ratio and water discharge and between channel slope and water discharge can all be used for channel pattern discrimination. The relationship between channel width and channel depth can also be used for channel pattern discrimination. However, the accuracy of these relationships for channel pattern discrimination varies, and the depth–discharge relationship is a better discriminator of pattern type than the classic slope–discharge function. The cause for this difference has been explained qualitatively. To predict the development of channel patterns under different natural conditions, the pattern discriminator should be searched on the basis of independent or at least semi‐independent variables. The relationship between stream power and bed material grain size can be used to discriminate channel patterns, which shows a better result than the discriminator using the slope–discharge relationship. Copyright © 2004 John Wiley & Sons, Ltd.     

MODELING OF THE DIVERSION CHANNEL CLOSURE FOR THE THIRD STAGE OF THE THREE GORGES PROJECT

The closure of third stage diversion channel for the Three Gorges Dam is characterized by large closure discharge, large drop in water surface, and high gap velocity. 1D and 2D flow mathematical models were used in this paper to simulate the hydraulic conditions during the closure. The variation of discharge in the diversion channel and the drops in water surface shared by the upstream and downstream cofferdams were computed using the ID model, and the detailed hydraulic patterns in the diversion channel were simulated using the 2D model. The computed results indicate that the designed closure scheme for discharge of 9,010 m^3/s was feasible for construction, while the designed closure scheme for discharge of 12,200 m^3/s was inapplicable.