Evaluation of soil liquefaction in the Chi-Chi, Taiwan earthquake using CPT

During the 1999 Chi-Chi, Taiwan earthquake, many sand boiling phenomena were observed in central Taiwan, which caused severe ground settlement and structure damages. According to the installed accelerograms, the peak ground surface horizontal accelerations in the liquefaction-affected areas range from 774.42 to 121.3 gal. The writers carried out an extensive investigation of soil liquefaction in this earthquake. In this paper, we present results of the CPT exploration and post-earthquake liquefaction analysis. Two hundred and seventy five (275) cone penetration test data were collected from the liquefaction-affected areas, and 46 liquefaction case histories and 88 non-liquefaction case histories were derived that can be used to evaluate the accuracy of existing liquefaction evaluation models. In addition, the strength of the liquefied soils after earthquake and the implication of its liquefaction potential in the future event are discussed.     

Influence of the zone of weakness on dip angle and shear heating of subducted slabs

We study the importance of the zones of weakness and the pattern of downgoing flow in steady-state models of subducting lithosphere, which interacts mechanically and thermally with the ambient mantle. The non-linear system of governing equations consists of (i) the momentum equation in stream function formulation and (ii) the steady-state heat transfer equation including conduction and advection of heat and dissipation. A finite element method has been applied to this system. We consider the viscosity to be a non-linear function of both the temperature and the stream function. In steady-state two-dimensional (2D) flow, the stream function isolines follow material trajectories. They are used to follow the top of the subducting slab, which because of its possible increase in water content, is assumed to have a lower viscosity. The zone of weakness has been thus obtained in the self-consistent fashion since the stream function as well as the temperature are the output from our modeling and no a priori assumptions about the shape of the bending lithosphere are taken into account. It was shown that several orders decrease of viscosity in the zone of weakness is required to obtain the dip angle of about 45°. If the decrease of viscosity is not sufficient enough, the subducted slab either sinks almost vertically or does not exhibit a plate-like behavior. We have also demonstrated that shear heating can unrealistically increase at the zone of weakness for fast subductions if decrease of viscosity is underestimated.     

Women’s use of public space and sense of place in the Raval (Barcelona)

This article deals with women's use of public space and sense of place in El Raval, a neighbourhood located in the historical center of Barcelona. Attention will be paid to discover to what degree the existence of a quality public space fosters the creation of socially meaningful places, thus contributing to the construction of womens sense of place and urban identities. A qualitative approach, based on direct observation and in-depth interviews with women living in the neighbourhood, has allowed us to capture the main aspects of the building of a sense of place and belonging, that is the use of public space and facilities, the attitude towards living in the neighbourhood, etc. This revised version was published online in July 2006 with corrections to the Cover Date.     

Are isolated stable rigid clasts in shear zones equivalent to voids?

Particles in shear enclose important information about a rock's past and can potentially be used to decipher the kinematic history and mechanical behavior of a certain outcrop or region. Isolated rigid clasts in shear zones often exhibit systematic inclinations with respect to the shear-plane at small angles, tending towards the instantaneous stretching direction of the shear zone. This shape preferred orientation cannot be easily explained by any of the analytical theories used in geology. It was recently recognized that a weak mantle surrounding the clast or a slipping clast–matrix interface might be responsible for the development of the observed inclinations. Physical considerations lead us to conjecture that such mantled, rigid clasts can be effectively treated as voids that are not allowed to change their shape. The resulting equivalent void conjecture agrees well with numerical and field data and has the following important geological implications. (i) Clasts in shear zones can have stable positions in simple shear without the requirement of an additional pure shear component. (ii) The stable orientation can be approached either syn- or antithetically; hence, the clast can rotate against the applied shear sense. (iii) The strain needed to develop a strong shape preferred orientation is small (γ≈1) and therefore evaluations based on other theories may overestimate strain by orders of magnitude. (iv) The reconstruction of far-field shear flow conditions and kinematic vorticity analysis must be modified to incorporate these new findings.     

Fold-Thrust-Belt Structure of the Proterozoic Eastern Ghats Mobile Belt: A Proposed Correlation Between India and Antarctica in Gondwana

The Proterozoic Eastern Ghats Mobile Belt along the east coast of India shares a thrusted lower contact with the surrounding cratons. The thrust, known as the Terrane Boundary shear zone, is associated with two large lateral ramps resulting in a curved outline on the northwestern corner of the mobile belt. The Eastern Ghats Mobile Belt is divided into two lithotectonic units, the Lathore Group and the Turekela Group, based on their lithological assemblages and deformational history. On the basis of published data from a Deep Seismic Sounding (DSS) profile of the Eastern Ghats crust, the Terrane Boundary Shear Zone is considered to be listric in nature and acts as the sole thrust between craton and mobile belt. The Lathore and Turekela Groups are nappes. With this structural configuration the NW part is described as a fold thrust belt. However, the thrusting postdates folding and granulite metamorphism that occurred in the Eastern Ghats, as in the Caledonide type of fold thrust belt of NW Scotland. The Terrane Boundary Shear Zone is interpreted to be contiguous with the Rayner-Napier boundary of the Enderby Land in a Gondwana assembly.     

Deformation History of the Kunavaram Complex, Eastern Ghats Belt, India: Implications for Alkaline Magmatism Along the Indo-Antarctica Suture

The Kunavaram alkaline complex is a NE-SW trending elongate body located along a major lineament, the Sileru Shear Zone (SSZ) that is regarded as a Proterozoic suture related to Indo-Antarctica collision. The complex is hosted within migmatitic quartzofeldspathic gneisses, mafic granulites retrogressed to amphibolites, and quartzites. The structural evolution of the country rocks and the alkaline complex are similar. The first phase of deformation, D₁, produces a pervasive segregation banding (S₁) in all rock units within and outside the complex. A second deformation phase D₂ isoclinally folded S₁ along subvertical axial planes with shallow plunging axes. F₂ isoclinal folds are ubiquitous in the country rocks and the eastern extremity of the complex. In the interior of the alkaline body, D₂ strain decreases and S₁ is commonly subhorizontal. While amphibolite to granulite facies conditions prevailed during deformation, post-D₂ annealing textures testify to persisting high grade conditions. In the west, a NNE-SSW trending dextral shear zone with strike-slip sense (D₃) truncates the complex. Within this shear zone, quartzofeldspathic country rocks are plastically deformed, while hornblende-K-feldspar assemblages of the complex are retrogressed to biotite and plagioclase. Warping related to D₃ shears also resulted in fold interference patterns on the subhorizontal S₁ foliation in low D₂ strain domains. Based on its steep dip, north-easterly trend, and non-coaxial nature with dextral strike-slip sense, the D₃ shear zone can be correlated with the SSZ. Since this shear zone, i.e., the SSZ, is not associated with primary igneous fabrics and resulted in solid state deformation of the complex, it cannot be considered as a conduit for alkaline magmatism, but is probably responsible for the post-tectonic disposition of the pluton.     

Deep seismic reflection profiling in the Archaean northeastern Yilgarn Craton, Western Australia: implications for crustal architecture and mineral potential

Deep seismic reflection data across the Archaean Eastern Goldfields Province, northeastern Yilgarn Craton, Western Australia, have provided information on its crustal architecture and on several of its highly mineralised belts. The seismic reflection data allow interpretation of several prominent crustal scale features, including an eastward thickening of the crust, subdivision of the crust into three broad layers, the presence of a prominent east dip to the majority of the reflections and the interpretation of three east-dipping crustal-penetrating shear zones. These east-dipping shear zones are major structures that subdivide the region into four terranes. Major orogenic gold deposits in the Eastern Goldfields Province are spatially associated with these major structures. The Laverton Tectonic Zone, for example, is a highly mineralised corridor that contains several world-class gold deposits plus many smaller deposits. Other non crustal-penetrating structures within the area do not appear to be as well endowed metallogenically as the Laverton structure. The seismic reflection data have also imaged a series of low-angle shear zones within and beneath the granite–greenstone terranes. Where the low-angle shear zones intersect the major crustal-penetrating structures, a wedge shaped geometry is formed. This geometry forms a suitable fluid focusing wedge in which upward to subhorizontal moving fluids are focused and then distributed into the nearby complexly deformed greenstones.     

Annihilation of both place and sense of place: the experience of the Cheslatta T'En Canadian First Nation within the context of large-scale environmental projects

The water resources of Canada are today, and have always been, of major importance to the welfare of Canadians. Throughout most of Canada's history, these resources have been viewed within a supply–management framework and, frequently, exploited through the construction of 'megaprojects', often with little or no concern for issues such as environmental harm and social and community disruption. As in many parts of the world, those most affected by such large-scale water resource developments have been aboriginals (in Canada, 'First Nations' peoples). Although the issues of environmental, social and economic damage to First Nations as a result of water megaprojects have been investigated, little has been written about the impact of such projects – especially dam construction – on the loss of sense of place of deracinated peoples. This paper investigates one example of such loss of sense of place, that of the Cheslatta T'En forcibly removed from their ancestral lands in the 1950s so as to allow for the construction of a private hydroelectric dam by the Aluminum Company of Canada (Alcan).     

Directional dependence of P- and S-wave propagation and polarization in foliated rocks from the Kola superdeep well: Evidence from laboratory measurements and calculations based on TOF neutron diffraction

We have measured P- and S-wave velocities on two amphibolite and two gneiss samples from the Kola superdeep borehole as a function of pressure (up to 600 MPa) and temperature (up to 600 °C). The velocity measurements include compressional (Vp) and shear wave velocities (Vs1, Vs2) propagating in three orthogonal directions which were in general not parallel to inherent rock symmetry axes or planes. The measurements are accompanied by 3D-velocities calculations based on lattice preferred orientation (LPO) obtained by TOF (Time Of Flight) neutron diffraction analysis which allows the investigation of bulk volumes up to several cubic centimetres due to the high penetration depth of neutrons. The LPO-based numerical velocity calculations give important information on the different contribution of the various rock-forming minerals to bulk elastic anisotropy and on the relations of seismic anisotropy, shear wave splitting, and shear wave polarization to the structural reference frame (foliation and lineation). Comparison with measured velocities obtained for the three propagation directions that were not in accordance with the structural frame of the rocks (foliation and lineation) demonstrate that for shear waves propagating through anisotropic rocks the vibration directions are as important as the propagation directions. The study demonstrates that proper measurement of shear wave splitting by means of two orthogonal polarized sending and receiving shear wave transducers is only possible when their propagation and polarization directions are parallel and normal to foliation and lineation, respectively.     

Fabric studies within the Cascade Lake shear zone, Sierra Nevada, California

The Cascade Lake shear zone occurs on the eastern margin of the Tuolumne Intrusive Suite, Sierra Nevada Batholith, California. Foliation in the zone is NNW trending and subvertical, and lineation is moderately south plunging. Deformation is syn-tectonic with emplacement of the Cathedral Peak granodiorite. A deformation gradient exists toward the NE margin of this pluton, with higher strains and lower temperatures of deformation found near the contact. We compare fabric data collected very densely in this shear zone using several techniques: field fabrics, 3D orientation of K-feldspar megacrysts, and AMS (anisotropy of magnetic susceptibility) analysis. In general, the results from the three different methods are in agreement. Deformation in this shear zone is part of a larger pattern of deformation within the Cathedral Peak granodiorite, as recorded by AMS analysis, and dextral shearing associated within the last stage of plutonism within the Sierra Nevada magmatic arc.