渭河河谷甘肃段水资源承载能力分析

本文在论述渭河河谷甘肃段水资源分布特点及现状利用量和承载量的基础上,分析了水资源的承栽能力,认为区内水资源最佳承载量是355万人,355亿元工业产值和248.5万亩的可灌高效农田.据此提出了城市发展规模的大小,目的是供地方政府规划参考.     

Sampling Fauna in Stream Sediments as well as Groundwater Using One Net Sampler

Groundwater bores act as traps. Net samplers are regularly used for sampling this type of trap for fauna. To enable direct comparisons of faunal communities in groundwater bores and stream sediments, stream sediment tubes were built similar to groundwater bores and were sampled with net samplers for fauna. These stream sediment tubes consisted of a tube anchored in the stream sediment, also called interstitial space. To test the efficacy of this trap method in stream sediments, it was compared to another type of trap, Hahn's trap. Faunal communities sampled by a net in the stream sediment tubes did not differ hugely from fauna in Hahn's trap samples. Physical and chemical factors of sampled water in both the stream sediment tubes, the surrounding interstitial sediments and the second type of traps, Hahn's traps, showed that water in both the tubes and Hahn's traps was closely related to interstitial water. The net sampler is inexpensive and easy to handle. It is suggested that sampling stream tubes with nets may be an appropriate method for long‐term monitoring studies.     

FLOW FIELD IN SCOURED ZONE OF CHANNEL CONTRACTIONS

Experiments were conducted in a laboratory flume to measure the two-dimensional turbulent flow field in the scoured zone of channel contractions under a clear-water scour condition. The Acoustic Doppler Velocimeter (ADV) was used to detect the flow field at different vertical lines along the centerline of uncontracted (main channel) and contracted zones of the channel. The distributions of time-averaged velocity components, turbulent intensity, turbulent kinetic energy, and Reynolds stresses are presented in nondimensional graphical form. The bed shear stresses are computed from the measured Reynolds stresses being in threshold condition within the zone of contraction where bed was scoured. The data presented in this paper would be useful to the investigators for the development of kinematic flow model and morphological model of scour at a channel or river contraction.     

某滑坡软弱夹层抗剪强度取值方法的研究

文章主要针对软弱夹层抗剪强度取值所存在的争议，通过对贵州新街子滑坡的软弱夹层分别选择比例极限、屈服极限及峰值作为剪应力值，采用最小二乘法获得比例抗剪强度、屈服抗剪强度和峰值抗剪强度。以参数选取中应用较为成熟的反分析方法推求力学性质参数c、φ值作为判据对以上3种参数进行比较。计算结果表明：本滑坡软弱夹层中由于含泥量较大，而且粘塑性较强，屈服抗剪强度和反分析得到的抗剪强度偏差最小，比例抗剪强度偏差最大，峰值抗剪强度居中。并以此3种抗剪强度进行天然状态下滑坡稳定性验算，结果表明选用比例极限抗剪强度与当前滑坡的地质现象不符，选用峰值极限抗剪强度安全储备较低，而选取屈服极限抗剪强度最为合理。用此参数进行设计，滑坡已经得到了良好的治理。在取值研究中认为采用试验与反分析相结合的方法确定滑坡稳定性计算参数是比较合理的。以上结论为滑坡中软弱夹层抗剪强度取值的选择提供了重要的依据。     

水布垭面板堆石坝的三维弹塑性数值分析研究

在建的清江水布垭面板堆石坝高达233 m,是目前同类坝型中最高的.采用MSC.Marc非线性有限元程序,发展了三维子模型法,对该坝进行了三维弹塑性有限元仿真分析,模拟了面板的分缝、坝体材料分区、填筑及蓄水过程,采用双屈服面弹塑性模型模拟堆石体的变形特征.根据数值分析的结果,对坝体和面板的应力变形分布规律进行了探讨.     

Pollution history and recovery of a boreal lake exposed to a heavy bleached pulping effluent load

We examined the effects of heavy pulp mill discharges on the Lake Lievestuoreenjärvi ecosystem and the later recovery of diatom and chironomid communities from age-dated short core samples. Beginning in 1927 the lake received a heavy effluent load from a sulphite pulp mill. Except for the recession during the Second World War and the temporary closure of the mill from 1967 to 1971, the industrial load, containing large quantities of nutrients, organic matter and toxic compounds, increased continuously. In the early 1980s, laboratory documents were falsified by the directors of the mill and the systematic illegal effluent overload led to a collapse of the whole lake ecosystem. In 1985, the outdated plant was finally closed down. Based on the assessment of chemical properties and biological remains of the sediment, we distinguished five developmental phases in the ecological state of the lake. In the pre-industrial phase, the pelagic and profundal benthic communities were dominated by species preferring ultraoligotrophic or oligotrophic lakes. Concomitant with the increasing discharge and deposition of chlorine compounds, resin acids, and mercury, as well as strong acidity and hypolimnetic and epilimnetic anoxia, the ecological status changed in a short period from excellent to bad. Finally, in the early 1960s, the majority of the lake was virtually dead and the aquatic life survived only in the uppermost littoral zone. Since 1985, a fast recovery in the water quality has led to a strong, but temporary eutrophy in pelagic communities. The main peak of eutrophication was caused by the invasion of a species new to the lake,Aulacoseira granulata var.angustissima. Later, the pelagic communities shifted towards oligotrophy, but the original, pre-industrial status has not been re-established. The profundal benthic communities have not achieved the pre-industrial structure, but at present indicate mesotrophy.     

Record of Late Pleistocene Glaciation and Deglaciation in the Southern Cascade Range. I. Petrological Evidence from Lacustrine Sediment in Upper Klamath Lake, Southern Oregon

Petrological and textural properties of lacustrine sediments from Upper Klamath Lake, Oregon, reflect changing input volumes of glacial flour and thus reveal a detailed glacial history for the southern Cascade Range between about 37 and 15 ka. Magnetic properties vary as a result of mixing different amounts of the highly magnetic, glacially generated detritus with less magnetic, more weathered detritus derived from unglaciated parts of the large catchment. Evidence that the magnetic properties record glacial flour input is based mainly on the strong correlation between bulk sediment particle size and parameters that measure the magnetite content and magnetic mineral freshness. High magnetization corresponds to relatively fine particle size and lower magnetization to coarser particle size. This relation is not found in the Buck Lake core in a nearby, unglaciated catchment. Angular silt-sized volcanic rock fragments containing unaltered magnetite dominate the magnetic fraction in the late Pleistocene sediments but are absent in younger, low magnetization sediments. The finer grained, highly magnetic sediments contain high proportions of planktic diatoms indicative of cold, oligotrophic limnic conditions. Sediment with lower magnetite content contains populations of diatoms indicative of warmer, eutrophic limnic conditions. During the latter part of oxygen isotope stage 3 (about 37–25 ka), the magnetic properties record millennial-scale variations in glacial-flour content. The input of glacial flour was uniformly high during the Last Glacial Maximum, between about 21 and 16 ka. At about 16 ka, magnetite input, both absolute and relative to hematite, decreased abruptly, reflecting a rapid decline in glacially derived detritus. The decrease in magnetite transport into the lake preceded declines in pollen from both grass and sagebrush. A more gradual decrease in heavy mineral content over this interval records sediment starvation with the growth of marshes at the margins of the lake and dilution of detrital material by biogenic silica and other organic matter.     

Long-term bed load transport rate based on aerial-photo and ground penetrating radar surveys of fan-delta growth, Coast Mountains, British Columbia

Sequential aerial photography, sonar bathymetry, ground-penetrating radar (GPR), and sediment sampling and analysis provide the basis for calculating the volumetric and mass rate of progradation of the delta of Fitzsimmons Creek, a steep, high-energy, debris-flow-dominated channel draining about 100 km² of the southern Coast Mountains of British Columbia. Fitzsimmons Creek is typical of small mountain rivers in the region. GPR imaging is used to define the pre-depositional morphology of the receiving basin, a technique that improves the accuracy of the volumetric survey. The 52-year record (1947–1999) of progradation yielded an average annual volumetric transport rate of 1.00±0.16×10⁴ m³ year⁻¹ for bed load, corresponding to a mass transport rate of 1.60±0.28×10⁴ Mg year⁻¹. Bed load yields are consistent with those obtained in hydrogeomorphically similar basins in the region and elsewhere. Decade-based annual rates, which vary from 0.64±0.11×10⁴ to 2.85±0.38×10⁴ Mg year⁻¹, provide poor estimates of the 52-year average. Indeed, the 52-year record may also not be long enough to fully integrate the significant fluctuations in the sediment efflux from Fitzsimmons Creek. The methodology proposed in this paper can be transferred to other comparable mountain environments worldwide.     

A parameterisation for the threshold shear velocity to initiate deflation of dry and wet sediment

A new parameterisation for the threshold shear velocity to initiate deflation of dry and wet particles is presented. It is based on the balance of moments acting on particles at the instant of particle motion. The model hence includes a term for the aerodynamic forces, including the drag force, the lift force and the aerodynamic-moment force, and a term for the interparticle forces. The effect of gravitation is incorporated in both terms. Rather than using an implicit function for the effect of the aerodynamic forces as reported earlier in literature, a constant aerodynamic coefficient was introduced. From consideration of the van der Waals force between two particles, it was further shown that the effect of the interparticle cohesion force between two dry particles on the deflation threshold should be inversely proportional to the particle diameter squared. The interparticle force was further extended to include wet bonding forces. The latter were considered as the sum of capillary forces and adhesive forces. A model that expresses the capillary force as a function of particle diameter squared and the inverse of capillary potential was deduced from consideration of the well-known model of Fisher and the Young–Laplace equation. The adhesive force was assumed to be equal to tensile strength, and a function which is proportional to particle diameter squared and the inverse of the potential due to adhesive forces was derived. By combining the capillary-force model and the adhesive force model, the interparticle force due to wet bonding was simplified and written as a function of particle diameter squared and the inverse of matric potential. The latter was loglinearly related to the gravimetric moisture content, a relationship that is valid in the low-moisture content range that is important in the light of deflation of sediment by wind. By introducing a correction to force the relationship to converge to zero moisture content at oven dryness, the matric potential–moisture content relationship contained only one unknown model parameter, viz. moisture content at −1.5 MPa. Working out the model led to a rather simple parameterisation containing only three coefficients. Two parameters were incorporated in the term that applies to dry sediment and were determined by using experimental data as reported by Iversen and White [Sedimentology 29 (1982) 111]. The third parameter for the wet-sediment part of the model was determined from wind-tunnel experiments on prewetted sand and sandy loam aggregates. The model was validated using data from wind-tunnel experiments on the same but dry sediment, and on data obtained from simulations with the model of Chepil [Soil Sci. Soc. Am. Proc. 20 (1956) 288]. The experiments showed that soil aggregates should be treated as individual particles with a density equal to their bulk density. Furthermore, it was shown that the surface had to dry to a moisture content of about 75% of the moisture content at −1.5 MPa before deflation became sustained. The threshold shear velocities simulated with our model were found to be in good agreement with own observations and with simulations using Chepil's model.     

Potential toxicity of resuspended particulate matter and sediments: Environmental samples from the Bay of Banyuls-sur-Mer and Thermaikos Gulf

This contribution attempts to determine whether, and to what degree, environmental samples of resuspended particulate matter and sediments exert a toxicological impact. Further, an attempt is made also to screen the toxic level of potentially hazardous sites, based upon established sediment toxicity criteria. Therefore, a rapid, cost-effective and highly sensitive biotest (bioluminescence assay, based upon marine bacteria) has been applied on: biological fluid extracts; bottom sediments; and sediment trap samples. Samples were taken either from the Bay of Banyuls-sur-Mer (northwestern Mediterranean, France) or Thermaikos Gulf (northeastern Mediterranean, Greece). Biological fluid extracts and sediment trap samples corresponded to periods of resuspension events, or preceding and following such events.The results have revealed that the sampling strategy and biotest implemented in this study might be a useful tool for screening the toxicity of resuspended matter and sediments. Resuspension events appear to be able to exert an influence on the chemical forms of the micro-pollutants; thus on their bioavailability and toxicity. Nevertheless, based upon chemical analysis combined with the bioassay, the toxic level of the sediment samples could be determined, with the level at potentially hazardous sites being characterised.