地壳演化与成矿作用——以川滇地洼系“四层楼”铜矿床序列为例

提出川滇地洼系“四层楼”铜矿床序列的形成与陆壳演化的成生联系,是与本区陆壳由前地槽—地槽—地台—地洼演化各阶段与之相匹配的成矿作用的产物.与此同时,并总结了本区“四层楼”铜矿床序列的成矿作用具有明显的继承性、新生性、旋回性及层控性四大特点和多因复成矿床的成矿模式.     

贵州和四川盆地云量的气候研究

贵州和四川盆地是我国云量最多的地区,素有“天无三日晴”和“蜀犬吠日”之说,盆地西缘的雅安古时还有“雅州天漏”的谚语。从全球日照百分率分布推知,川黔地区也是世界上天气最阴沉的地区之一。川黔之阴一向为国内外气象界所注意,本文根据1951—1980     

Alluvial architecture of the Holocene Rhine–Meuse delta (the Netherlands)

Ancient fluvial successions often act as hydrocarbon reservoirs. Sub‐surface data on the alluvial architecture of fluvial successions are often incomplete and modelling is performed to reconstruct the stratigraphy. However, all alluvial architecture models suffer from the scarcity of field data to test and calibrate them. The purposes of this study were to quantify the alluvial architecture of the Holocene Rhine–Meuse delta (the Netherlands) and to determine spatio‐temporal trends in the architecture. Five north–south orientated cross‐sections, perpendicular to the general flow direction, were compiled for the fluvial‐dominated part of the delta. These sections were used to calculate the width/thickness ratios of fluvial sandbodies (SBW/SBT) and the proportions of channel‐belt deposits (CDP), clastic overbank deposits (ODP) and organic material (OP) in the succession. Furthermore, the connectedness ratio (CR) between channel belts was calculated for each cross‐section. Distinct spatial and temporal trends in the alluvial architecture were found. SBW/SBT ratios decrease by a factor of ca 4 in a downstream direction. CDP decreases from ca 0·7 (upstream) to ca 0·3 (downstream). OP increases from less than 0·05 in the upstream part of the delta to more than 0·25 in the downstream delta. ODP is approximately constant (0·4). CR is ca 0·25 upstream, which is approximately two times larger than in the downstream part of the delta. Furthermore, CDP in the downstream Rhine–Meuse delta increases after 3000 cal yr BP. These trends are attributed to variations in available accommodation space, floodplain geometry and channel‐belt size. For instance, channel belts tend to narrow in a downstream direction, which reduces SBW/SBT, CDP and CR. Tectonics cause local deviations in the general architectural trends. In addition, the positive correlation between avulsion frequency and the ratio of local to regional aggradation rate probably influenced alluvial architecture in the Rhine–Meuse delta. The Rhine–Meuse data set can be a great resource when developing more sophisticated models for alluvial architecture simulation, which eventually could lead to better characterizations of hydrocarbon reservoirs. To aid such usage of the Rhine–Meuse data set, constraints for relevant parameters are provided at the end of the paper.     

A seismic source zone model for the seismic hazard assessment of the Italian territory

We designed a new seismic source model for Italy to be used as an input for country-wide probabilistic seismic hazard assessment (PSHA) in the frame of the compilation of a new national reference map.

We started off by reviewing existing models available for Italy and for other European countries, then discussed the main open issues in the current practice of seismogenic zoning.

The new model, termed ZS9, is largely based on data collected in the past 10 years, including historical earthquakes and instrumental seismicity, active faults and their seismogenic potential, and seismotectonic evidence from recent earthquakes. This information allowed us to propose new interpretations for poorly understood areas where the new data are in conflict with assumptions made in designing the previous and widely used model ZS4.

ZS9 is made out of 36 zones where earthquakes with M_w > = 5 are expected. It also assumes that earthquakes with M_w up to 5 may occur anywhere outside the seismogenic zones, although the associated probability is rather low. Special care was taken to ensure that each zone sampled a large enough number of earthquakes so that we could compute reliable earthquake production rates.

Although it was drawn following criteria that are standard practice in PSHA, ZS9 is also innovative in that every zone is characterised also by its mean seismogenic depth (the depth of the crustal volume that will presumably release future earthquakes) and predominant focal mechanism (their most likely rupture mechanism). These properties were determined using instrumental data, and only in a limited number of cases we resorted to geologic constraints and expert judgment to cope with lack of data or conflicting indications. These attributes allow ZS9 to be used with more accurate regionalized depth-dependent attenuation relations, and are ultimately expected to increase significantly the reliability of seismic hazard estimates.     

A preliminary stable isotope study on Mogok Ruby, Myanmar

The primary occurrence of ruby in the Mogok area, northern Myanmar is exclusively found in marble along with spinel–forsterite-bearing marble and phlogopite–graphite marble. These marble units are enclosed within banded biotite–garnet–sillimanite–oligoclase gneisses. Samples of these marbles collected for C–O stable isotope analysis show two trends of δ¹³C–δ¹⁸O variation resulting most likely from fluid–rock interactions. Ruby-bearing marble and phlogopite–graphite marble follow a trend with coupled C–O depletion, whereas spinel–forsterite-bearing marble follows a δ¹⁸O depletion trend with relatively constant δ¹³C values. Ruby formation might have resulted from CO₂-rich fluid–rock interaction, while spinel–forsterite-bearing marble was genetically related to CO₂-poor fluid–rock interaction. Both fluids may have arisen from external sources. Based on graphite Raman spectral thermometry, the estimated temperature for phlogopite–graphite marble, and probably ruby-bearing marble, was lower than 607 °C, and for spinel–forsterite-bearing marble, lower than 710 °C. Contrasting C/O diffusion between graphite/ruby/spinel/forsterite and calcite, local variations of isotopic compositions of newly formed minerals as a result of non-pervasive fluid infiltration, and open-system isotopic disturbance during cooling may have affected C-/O-isotopic fractionations between minerals. The estimated high formation temperatures for ruby and spinel/forsterite imply that the parental fluids may have been related to nearby igneous intrusions and/or metamorphic processes. Whether these two types of fluid were genetically related is unclear based on the present data.     

“Cretaceous black flysch” in the Pieniny Klippen Belt, West Carpathians: a case of geological misinterpretation

This is a critical assessment of the paper by Oszczypko et al. (2004: Cretaceous Research 25, 89–113), in which they tried to prove a mid-Cretaceous age for the Szlachtowa (“black flysch”) and Opaleniec Formations, in the Pieniny Klippen Belt, West Carpathians, both of which had previously been shown to be of Jurassic age. We argue that the mid-Cretaceous age assignment is a misinterpretation, primarily resulting from their field samples having been collected from some Cretaceous lithostratigraphic units, tectonically associated with the Jurassic formations, and/or from tectonic contact-breccias involving Jurassic and Cretaceous strata. In addition, we suggest that they have overlooked a number of significant palaeontological papers, published since 1962, which record the presence of in situ ammonites, aptychi, belemnites, thin-shelled bivalves (Bositra), gryphaeids, foraminifera, and ostracod assemblages, all indicating a Jurassic (mainly Aalenian), and not a Cretaceous, age for the Szlachtowa Formation, and also the in situ Jurassic (Bajocian) ammonites and thin-shelled bivalves (Bositra), Bositra-microfacies, and age-diagnostic foraminiferal assemblages of the Opaleniec Formation.Our presentation here of recently published dinocyst data from well-preserved assemblages further supports the Jurassic ages for the Szlachtowa (“black flysch”) and Opaleniec Formations.     

气相色谱法测定地下水中六六六结果的不确定度评定

依照《测量不确定度评定与表示》,对气相色谱法测定地下水中六六六(HCH)四种单体结果进行了不确定度评定。分析了测量过程中引入的不确定度来源,包括提取液体积的量取、样品提取溶液的定容体积、分析仪器的进样量、标准系列溶液的测量以及仪器重复测定等分量引入不确定度及其各参数的采集和计算方法,最后合成标准不确定度,通过乘以95%概率下的扩展因子2,获得测量结果的扩展不确定度。     

碱消解-高效液相色谱-电感耦合等离子体质谱法测定生物样品中的甲基汞和乙基汞

建立了碱消解-高效液相色谱-电感耦合等离子体质谱联用系统测定生物样品中甲基汞(MeHg)与乙基汞(EtHg)的分析方法。为提高灵敏度,选用微流量的PFA雾化器,在优化的检测条件下,MeHg及EtHg检出限可达到0.036μg/L和0.03μg/L;线性范围达到4个数量级,两条工作曲线线性相关系数为1。对1.78μg/L MeHg、1.65μg/L EtHg的混合标准溶液重复测定7次,色谱峰面积的相对标准偏差(RSD)分别为1.79%和1.44%。对标准物质BCR 464(金枪鱼)的分析结果表明,测定值与标准值基本吻合,但略低于标准值;甲基汞和乙基汞的加标回收率分别为85.9%和84.5%。高效液相色谱与质谱联用技术的高灵敏度和低检出限能够满足生物样品中汞形态定量分析的要求。     

徐州土壤多环芳烃的环境地球化学迁移特征

选择江苏徐州黄棕壤进行不同深度层位多环芳烃含量的定量分析,研究并探讨了多环芳烃在土壤深度剖面中的地球化学迁移特征。研究结果显示,多环芳烃在徐州土壤剖面中主要集中在地表0~20 cm内。其中低环多环芳烃化合物的迁移能力较强,4~6环等高环化合物相对较难迁移,主要残留于地表生态系统环境中。     

激光拉曼光谱法分析多种显微组分荧光变化及其应用

利用激发488 nm激光的氩离子激光器作为RENISHAW inVia型激光拉曼光谱仪的光源,建立了多种显微组分荧光变化(FAMM)分析方法,并对镜质体反射率明显抑制的东营凹陷有效烃源岩进行了测定。结果表明,东营凹陷有效烃源岩的有机质类型越好,镜质体反射率抑制程度越高,有效烃源岩的真实成熟度应主要处于0.64%~1.30%,而不是实测镜质体反射率所反映的0.37%~1.10%。