速度传感反馈地震计的参数稳定性分析

从理论上定量分析机械摆和环路滤波等开环诸参数变化对速度传感反馈地震计闭环参数的影响.研究指出,在环路设计中可半自由选取的开环阻尼取值对参数稳定性有重要影响.过大或过小的开环阻尼取值均可能造成参数稳定性急剧变差,影响地震计在只标不调的状况下长期连续稳定工作.     

瑞利数对热对流的影响——在地幔柱中的应用

本文分别在直角坐标系和柱坐标系下,研究瑞利数从104逐渐增大到107对热对流的影响,数值计算结果表明:瑞利数越大,地幔柱越窄,地幔柱上升速度也越快;源自上地幔的地幔柱半径的范围为9到210 km.根据峨眉山内带的半径推算出地幔的黏性系数约为3.8×1021Pa·s,地幔柱平均流动速度为2.5 cm/a.     

新疆地区环境噪声层析成像研究

本文利用北京大学宽频带流动地震台阵和新疆地震监测台网12个月连续地震记录数据,采用环境噪声层析成像方法获得了新疆地区的周期从10～35 s范围内的瑞利面波相速度异常分布图像.研究结果与地表地质构造相一致,新疆地区的天山、两盆大地构造与瑞利面波相速度异常有较好的对应关系.短周期10～20 s的图像显示两个盆地内都呈现低速...     

Rayleigh波勘探中“之”字形频散曲线“起跳点”频率研究

当层状介质中存在低速层的时候,实际提取到的Rayleigh波频散曲线往往会发生“之”字形回折.已有研究表明,“之”字形回折与各模式的激发能量有关.特别的,“之”字形回折的“起跳点”(发生“之”字形回折的点)与介质参数有一定关系,因此在应用中它反映了介质的一些特征.但是,这一关系是怎样的还没有人进行详细研究.本文计算了三...     

Influence of Uneven Trace Spacing on Rayleigh Wave Dispersion

Rayleigh wave dispersion signals are significant to underground investigation.Tradition-ally,uniformed trace spacing is employed in surface wave surveys.In some cases,however,uneven trace spacing is often encountered because of the limitations of the site condition.In order to study the influence of uneven trace spacing on the dispersion data construction of Rayleigh waves,data acquisi-tion is performed based on a 2.5D field layout with a linear array of geophones fixed and a mobile source.The observation d...     

多道瞬态瑞雷波法在地基强夯质量检测中的应用探讨

为了提高地基承载力,减少填土的不均匀沉降,对软土地基进行强夯加固是一种十分经济有效的地基处理方法。在沿海地区,填海工程和低丘整平地基处理中,大量使用强夯法。因此,强夯地基效果的检测十分重要。本文通过对多道瑞雷波法理论以及在强务地基检测应用效果的探讨,采用加权平均值法统计各测试．最地基土的承载力特征值,对整个测区的强夯效果进行全面评价。     

微动物探方法探测采空区

采空区探测通常采用瞬变电磁法与地震勘探方法,前者采用人工电场,后者采用人工震源,但二者施工难度大,数据采集也困难.微动探测是从台阵微动记录的垂直分量中提取瑞利波相速度频散曲线,再通过对频散曲线的反演估算地下介质S波速度,利用其低速异常解释采空区.以铜川东坡煤矿某区的探测为例,在煤层埋深50m左右、微动探测深度100m的情况下,即解释的采空区与地面电法解释的结果高度一致.     

Dipping-interface Mapping Using Mode-separated Rayleigh Waves

Multichannel analysis of surface waves (MASW) method is a non-invasive geophysical technique that uses the dispersive characteristic of Rayleigh waves to estimate a vertical shear (S)-wave velocity profile. A pseudo-2D S-wave velocity section is constructed by aligning 1D S-wave velocity profiles at the midpoint of each receiver spread that are contoured using a spatial interpolation scheme. The horizontal resolution of the section is therefore most influenced by the receiver spread length and the source interval. Based on the assumption that a dipping-layer model can be regarded as stepped flat layers, high-resolution linear Radon transform (LRT) has been proposed to image Rayleigh-wave dispersive energy and separate modes of Rayleigh waves from a multichannel record. With the mode-separation technique, therefore, a dispersion curve that possesses satisfactory accuracy can be calculated using a pair of consecutive traces within a mode-separated shot gather. In this study, using synthetic models containing a dipping layer with a slope of 5, 10, 15, 20, or 30 degrees and a real-world example, we assess the ability of using high-resolution LRT to image and separate fundamental-mode Rayleigh waves from raw surface-wave data and accuracy of dispersion curves generated by a pair of consecutive traces within a mode-separated shot gather. Results of synthetic and real-world examples demonstrate that a dipping interface with a slope smaller than 15 degrees can be successfully mapped by separated fundamental waves using high-resolution LRT.     

Seismic isolation by rubber–soil mixtures for developing countries

This paper proposes a promising seismic isolation method particularly suitable for developing countries, which makes use of rubber–soil mixtures. Apart from reducing the level of shaking in the horizontal direction, the distinctive advantage of the proposed method is that it can also significantly reduce the shaking level of vertical ground motion, to which an increasing attention has been paid in the earthquake engineering community. On the other hand, the use of scrap tires as the rubber material can provide an alternative way to consume the huge stockpile of scrap tires all over the world. Moreover, the low cost of this proposed seismic protection scheme can greatly benefit those developing countries where resources and technology are not adequate for earthquake mitigation with well‐developed, yet expensive, techniques. The proposed method has been demonstrated through a series of numerical simulations and a parametric study has also been carried out. Lastly, five important issues regarding the concept and feasibility have been discussed. Copyright © 2007 John Wiley & Sons, Ltd.     

初始中主应力系数对中密粉煤灰动模量阻尼比影响的试验研究

利用土工静力-动力液压三轴-扭转多功能剪切仪,开展了在三向非均等固结状态下的饱和中密粉煤灰循环扭剪试验。着重探讨了初始中主应力系数对饱和中密粉煤灰的动模量和阻尼比特性的影响。试验结果表明：初始中主应力系数对粉煤灰动剪切模量有一定的影响,对阻尼比没有影响。根据仪器量测系统的特点,采用了大小位移计联合测量角位移的方法,不仅能够提高测试精度,而且能够获得完整的动模量和阻尼比随动剪应变幅值的变化过程。