土非线性参数变异性对标准设计谱的影响

岩土工程中存在许多不确定性,建筑物抗震规范设计中的标准设计谱实际代表着一种平均结果,并没有考虑到场地土体非线性参数的变异性。文中采用数值模拟的方法研究了土非线性参数变异性对标准设计谱的影响。给出了考虑土非线性参数变异性的概率设计谱。结果表明,土非线性参数变异性对标准设计谱的影响显著;粘性土和无粘性土的动剪切模量比对标准设计谱的影响决定于土非线性参数的概率水准,同时也取决于概率设计谱的频段;烈度7度、8度和9度下土体动剪切模量比变异性使标准设计谱平台最大变化50%、80%和100%,阻尼比变异性使标准设计谱平台最大变化40%、45%和60%。     

Discussion of ‘Modelling viscous damping in nonlinear response history analysis of buildings for earthquake excitation’ by Anil K. Chopra and Frank McKenna

This discussion deals with recommendations in the paper on appropriate damping formulations for use in nonlinear response history analysis of buildings. Concern over potentially excessive damping forces and moments should extend beyond the damping moments produced by the stiffness proportional part of Rayleigh damping that corresponds to rotational springs used to explicitly model plastic hinges. The key to an appropriate damping formulation for nonlinear analysis is a realistic mechanism that allows all damping forces and moments to be meaningfully assessed. Then features can be added to keep these forces and moments within reasonable bounds. Copyright © 2016 John Wiley & Sons, Ltd.     

瑞利阻尼对砂土场地非线性地震响应的影响分析

在地震荷载作用下,自由场地会产生土体侧向变形和地表响应放大现象。由于土体的高度非线性,计算自由场地地震响应时,不同的阻尼比及剪切模量取值是造成其计算结果与试验结果相差较大的原因之一。目前动力计算常采用瑞利阻尼方法,其系数取值会在一定程度上影响计算结果。选用两模态简化瑞利阻尼系数计算方法,分析土体阻尼比及控制频率的取值对计算结果的影响,对比离心机模型试验,利用开源有限元平台OpenSees,采用适合于土体动力分析的多屈服面本构模型(PDMY),建立剪切梁模型模拟三维自由场地,并分析瑞利阻尼参数对自由场地地震响应和侧向变形计算结果的影响。结果表明,针对相对密度为60%的Nevada干砂,阻尼比为4%、控制频率比为5时,场地响应计算结果与试验结果较为符合。综合分析显示场地非线性响应时域计算时,应特别注意选用的瑞利阻尼参数值。     

Soil–pile–structure interaction: experimental outcomes from shaking table tests

An effective way to study the complex seismic soil‐structure interaction phenomena is to investigate the response of physical scaled models in 1‐g or n‐g laboratory devices. The outcomes of an extensive experimental campaign carried out on scaled models by means of the shaking table of the Bristol Laboratory for Advanced Dynamics Engineering, University of Bristol, UK, are discussed in the present paper. The experimental model comprises an oscillator connected to a single or a group of piles embedded in a bi‐layer deposit. Different pile head conditions, that is free head and fixed head, several dynamic properties of the structure, including different masses at the top of the single degree of freedom system, excited by various input motions, e.g. white noise, sinedwells and natural earthquake strong motions recorded in Italy, have been tested. In the present work, the modal dynamic response of the soil–pile–structure system is assessed in terms of period elongation and system damping ratio. Furthermore, the effects of oscillator mass and pile head conditions on soil–pile response have been highlighted, when the harmonic input motions are considered. Copyright © 2015 John Wiley & Sons, Ltd.     

综合工程物探在九寨沟核心景区水循环系统研究中应用评价

综合物探技术是一种高新技术,在岩土工程中有广泛的应用前景。文章介绍了瑞雷波勘探和直流电法在九寨沟核心景区水循环系统中的应用,对方法原理进行了简单阐述,并探讨了对综合工程物探技术在九寨沟景区第四系化学沉积钙华层和冰碛地层的划分的分析评价。     

存在流体介质夹层时瑞利波频散曲线的完整求解

应用介质分界面上位移应力连续性的变化关系,采用δ矩阵法和固体层状介质中的瑞利波频散方程,推导了含流体介质夹层情况下瑞利波的频散方程。利用推导的频散方程对理论模型进行模拟计算,并与以往文献计算方法进行比较,模拟结果吻合较好,验证了公式的正确性;同时,模拟计算结果也说明了本文公式的普遍适用性和计算结果的完整性。根据文中对4个理论模型的模拟结果来看,与固体层状介质的情况相比,当存在流体夹层时,瑞利波频散曲线模式中多出了一个文中定义的0阶模式,在今后的多道瞬态瑞利波法应用中,应该可以将其看成是流体介质夹层存在的标志性曲线。     

地震走时层析成像方法及在陨石坑探测中的应用

地震走时层析成像是地球物理反演中成熟的方法之一,已在许多领域得到广泛应用,并取得了良好的效果。本文介绍的地震层析成像方法包括模型参数化、射线追踪和理论走时计算、非线性方程组的线性化、线性化方程组的求解以及解的评价。观测数据使用了中国地震局地球物理勘探中心在岫岩陨石坑取得的浅层地震折射资料,反演得到两条近垂直交叉剖面的P波速度结构。结果表明,该坑为一简单坑,直接撞击形成的区域为直径约1．8km、深度约700m的坑体;坑中心深度约700m周围以及向下出现的7．0km／s以上的高波速可能是陨石撞击时所产生的高温高压使表层岩石达到熔融状态,改变了围岩的性质,致使围岩速度升高。     

Accuracy of the half-power bandwidth method with a third-order correction for estimating damping in multi-DOF systems

A third-order correction was recently suggested to improve the accuracy of the half-power bandwidth method in estimating the damping of single DOF systems.This paper analyzes the accuracy of the half-power bandwidth method with the third-order correction in damping estimation for multi-DOF linear systems.Damping ratios in a two-DOF linear system are estimated using its displacement and acceleration frequency response curves,respectively.A wide range of important parameters that characterize the shape of these response curves are taken into account.Results show that the third-order correction may greatly improve the accuracy of the half-power bandwidth method in estimating damping in a two-DOF system.In spite of this,the half-power bandwidth method may significantly overestimate the damping ratios of two-DOF systems in some cases.     

Performance spectra based method for the seismic design of structures equipped with passive supplemental damping systems

A new direct performance‐based design method utilizing design tools called performance‐spectra (P‐Spectra) for low‐rise to medium‐rise frame structures incorporating supplemental damping devices is presented. P‐Spectra are graphic tools that relate the responses of nonlinear SDOF systems with supplemental dampers to various damping parameters and dynamic system properties that structural designers can control. These tools integrate multiple response quantities that are important to the performance of a structure into a single compact graphical format to facilitate direct comparison of different potential solutions that satisfy a set of predetermined performance objectives under various levels of seismic hazard. An SDOF to MDOF transformation procedure that defines the required supplemental damping properties for the MDOF structure to achieve the response defined by the target SDOF system is also presented for hysteretic, linear viscous and viscoelastic damping devices. Using nonlinear time‐history analyses of idealized shear structures, the accuracy of the transformation procedure is verified. A seismic performance upgrade design example is presented to demonstrate the usefulness of the proposed method for achieving design performance goals using supplemental damping devices. Copyright © 2012 John Wiley & Sons, Ltd.     

Reactive Rayleigh–Taylor turbulent mixing: a one-dimensional-turbulence study

We study the problem of reactive Rayleigh–Taylor turbulence in the Boussinesq framework using one-dimensional-turbulence (ODT) simulations. In this problem a reaction zone between overlying heavy/cold reactants and underlying light/hot products moves against gravity. First, we show that ODT results for global quantities in non-reactive Rayleigh–Taylor turbulence are within those from direct numerical simulations (DNS). This comparison give us confidence in using ODT to study unexplored flow regimes in the reactive case. Then, we show how ODT predicts an early stage of reactive Rayleigh–Taylor turbulence that behaves similarly to the non-reactive case, as observed in previous DNS. More importantly, ODT indicates a later stage where the growth of the reaction zone reduces considerably. The present work can be seen as a step towards the study of supernova flames with ODT.