任意刚性基础竖向动阻抗的简化计算

对于均质弹性半空间上的任意形状的刚性明置和埋置基础,其动刚度和阻尼系数的确定,已有很多这方面的研究。通常基础的任意形状用其外包的规则几何形状代替原有的不规则基础形状,以达到确定动刚度和阻尼系数的目的,而且这两个参数的确定仅仅是对单独刚性基础的,无法考虑相邻基础对其产生的影响。针对上述两方面不完善之处作了进一步探讨,引入相邻基础动力相互作用因子的概念,并利用地基为平面应变假定以求之。推荐的方法经验证,非常准确。     

MODAL ANALYSIS OF SOFT-SOIL SITES INCLUDING RADIATION DAMPING

For the one-dimensional analysis of soft-soil layers on an elastic half-space, a general form of analytical solution is developed for converting radiation damping due to energy leaking back to the half-space into equivalent modal damping, allowing the modal analysis technique to be extended to a site where radiation damping has to be accounted for. Closed-form solutions for equivalent modal damping ratios and effective modal participation factors are developed for a single layer with a shear wave velocity distribution varying from constant to linearly increasing with depth. Compact and recursive forms of solutions for equivalent modal damping ratios are developed for a system with an arbitrary number of homogeneous layers on an elastic half-space. Comparisons with numerical solutions show that the modal solutions are accurate. The nominal frequency of a site, i.e. the inverse of four times the total shear wave travel time through the layers, is an important parameter for estimating the high mode frequencies. A parameter study shows that for the same impedance ratio of the bottom layer to the elastic half-space, a system of soil layers with an increasing soil rigidity with depth has, in general, larger peak modal amplifications at the ground surface than does a single homogeneous layer on an elastic half-space, while a system with a decreasing soil rigidity with depth has smaller modal peak amplifications. © 1997 by John Wiley & Sons, Ltd.     

Effects of the improper modeling of viscous damping on the first-mode and higher-mode dominated responses of base-isolated buildings

In many finite element platforms, a classical global damping matrix based on the elastic stiffness of the system (including isolators) is usually developed as part of the solution to the equations of motion of base-isolated buildings. The conducted analytical and numerical investigations illustrate that this approach can lead to the introduction of unintended damping to the first and higher vibration modes and the spurious suppression of the respective structural responses. A similar shortcoming might be observed even when a nonclassical damping model (ie, an assembly of the superstructure and isolation system damping sub-matrices) is used. For example, the use of Rayleigh damping approach to develop the superstructure damping sub-matrix can lead to the undesired addition of damping to the isolated mode arising from the mass-proportional component of the superstructure damping. On the other hand, the improper use of nonclassical stiffness-proportional damping (eg, determining the proportional damping coefficient, β_k , based on the first mode) can result in assigning significant damping to the higher-modes and the unintended mitigation of the higher-mode responses. Results show that a nonclassical stiffness-proportional model in which β_k is determined based on the second modal period of a base-isolated building can reasonably specify the intended damping to the higher modes without imparting undesirable damping to the first mode. The nonclassical stiffness-proportional damping can be introduced to the numerical model through explicit viscous damper elements attached between adjacent floors. In structural analysis software such as SAP2000®, the desired nonclassical damping can be also modeled through specifying damping solely to the superstructure material.     

重复循环荷载作用下原状黄土动力特性试验研究

为探究重复循环荷载作用下含水率、固结压力对原状黄土动力特性、变形性状的影响规律,利用英国GDS双向动态三轴试验系统模拟交通荷载,对海东地区原状黄土进行动三轴试验研究。试验结果表明：单一重复循环动荷载作用下,在加载初期,海东地区原状黄土的轴向动应变随着循环次数的增大急剧增加,后期缓慢增加至趋于稳定,即发生应变硬化现象。在加载初期,含水率、固结压力对原状黄土的轴向动应变无明显影响,当循环次数N>400时,原状黄土的轴向动应变随含水率的升高而增加,随固结压力的增大而减小。动剪切模量随循环次数的增加出现先减小后增加再减小的变化,随含水率的升高有较大幅度的降低。动阻尼比随循环次数的增加先增加后减小,随含水率的升高而增大。表明海东地区原状黄土所具有的大孔隙架空结构使其在重复循环荷载作用下易发生振动变形。     

具有低频超宽衰减域的部分埋入式表面波屏障

针对低频Rayleigh表面波,设计了部分埋入式工字形截面周期波屏障。利用有限元方法计算了结构的频散曲线,分析了带隙的形成机理,讨论了屏障埋入土体深度和截面参数对带隙的影响,在此基础上设计了具有低频超宽衰减域的梯度及分段梯度波屏障并计算了其传输谱。结果表明:周期波屏障存在较宽带隙,板埋入深度和端部尺寸是影响带隙的关键参数,通过参数调节可实现不同频段Rayleigh波的调控。工字形变截面波屏障比等截面具有更优越的隔震性能且节省材料。梯度及分段梯度波屏障显著拓宽了衰减域的频率范围,对1.5~20 Hz范围内的Rayleigh表面波实现了全覆盖,用小尺寸控制了大波长。     

长河坝—黄金坪水库区域地震台网监测能力分析

位于四川省甘孜藏族自治州康定市内大渡河干流的长河坝-黄金坪水电站,为大渡河流域开发中,以长河坝、大岗山、瀑布沟等形成主要梯级格局开发方案中,"三库22级"水电站中的第10和11级电站,其地震监测台网也采用梯级设计方式,长河坝-黄金坪上下游水库地震监测台网统一设计、建设及监测,共享同一地震监测能力。通过对监测设备的技术指标、台基地噪声水平和震级-频度对数关系的分析,结果表明,长河坝-黄金坪水库区域地震固定台站建成后,地震监测能力达到并优于设计的理论监测能力,地震监测震级达到下限为M_L 0.5的设计要求。     

2017年6月16日湖北秭归Ms4.3地震成因初探

北京时间2017年6月16日19时48分, 湖北省秭归县发生M_S4.3地震(震中位置31.06°N, 110.48°E)。 此次地震导致当地160多间建筑物出现不同程度损坏, 100多人生活受到影响, 震区中危岩体出现一定程度破坏。 分析此次地震的震源参数将有助于了解其震源特征和发震机制。 本文首先获取了震中距在3°以内的40个宽频带固定台站的三分量数据, 然后利用FK(Frequency wavenumber)方法计算了在不同深度下Crust2.0模型和改进的1-D模型的格林函数, 分别使用Cut And Paste(CAP)方法反演得到本次地震的震源机制解和深度; 并采用基阶Rayleigh波振幅谱进一步约束了质心深度。 结果表明此次地震的最佳震源机制解的节面Ⅰ: 68°/59°/163°; 节面Ⅱ: 166°/75°/32°, 最佳矩震级为M_W4.3, 最佳深度约为5 km。 对比2013年巴东地震、 2014年秭归地震以及2011年湖北阳新—江西瑞昌地震的震源参数和余震信息, 此次地震有可能是水库诱发地震, 但要判断成因还需进一步研究。     

STUDY ON FOCAL DEPTH OF THE MS5.4 CANGWU EARTHQUAKE IN GUANGXI

On July 31th, 2016, a magnitude 5.4 earthquake struck Cangwu Country, Guangxi Zhuang Autonomous Region, it was the largest earthquake recorded by Guangxi Seismological Network since it set up. The number of people affected by the earthquake had reached 20 000, and the direct economic losses caused by the earthquake were nearly 100 million Yuan. After the earthquake, USGS provided a global earthquake catalog showing that the focal depth of Cangwu earthquake was about 24.5km. However, the result given by the Global Centroid Moment Tensor showed the focal depth of this earthquake was 15.6km. However, the result obtained by Xu Xiaofeng et al. using CAP method was 5.1km. It was clear that the focal depths of Cangwu earthquake given by different institutions were quite different from each other. However, accurate focal depth of the earthquake has important significance for exploring the tectonic mechanism near the epicenter, so it is necessary to further determine the more accurate depth of the Cangwu earthquake. In order to further accurately determine the focal depth of Cangwu earthquake, we used the global search method for travel-time residual to calculate the focal depth of this earthquake and its error range, based on the regional velocity model, which is a one-dimensional velocity model of the Xianggui tectonic belt produced by the comprehensive geophysical profile. Then, we inverted the focal mechanism of this earthquake with the CAP method. Based on this, the focal depth of Cangwu M_S5.4 earthquake was further determined by the method of the Rayleigh surface wave amplitude spectrum and the sPL phase, respectively. Computed results reveal that the focal depth of this earthquake and its error range from the travel-time residual global search method is about(13±3)km, the focal depth inverted by CAP method is about 10km, the focal depth from sPL phase is about 10km, and the focal depth from Rayleigh surface wave amplitude spectrum is about 9~10km. Finally, we confirmed that the focal depth of Cangwu M_S5.4 earthquake is about 10km, which indicates that this earthquake still occurred in the upper crust. In the case of low network density, the sPL phase and Rayleigh wave amplitude spectrum recorded by only 1 or 2 broadband stations could be used to obtain more accurate focal depth. The focal depth's accuracy of Cangwu M_S5.4 earthquake in the USGS global earthquake catalog has yet to be improved. In the future, we should consider the error of the source parameters when using the USGS global earthquake catalog for other related research.     

特高压互连电气设备减震性能振动台试验

为研究铅金属减震器对特高压互连电气设备的减震效果,进行由硬管母线连接的特高压避雷器设备和电容式电压互感器设备组成的互连耦合体系的地震模拟振动台试验。通过白噪声扫频、抗震及减震试验,测定互连耦合体系抗震结构及减震结构的自振频率以及关键部位的应变、加速度响应。试验结果表明:抗震结构中避雷器设备的最大应变响应大于互感器设备,互连耦合体系中的避雷器设备属于易损设备;安装减震器后互连设备频率降低幅度较小,减震器基本不会影响电气设备的正常运行;安装减震器后互连耦合体系中的避雷器设备和互感器设备在较大峰值加速度地震波作用下,设备顶端加速度响应和最大应变响应均有较大幅度的降低,避雷器设备和互感器设备的最大应变响应的减震效率分别为75%和50%,减震效果显著,减震器的应用大幅提升了互连耦合体系的抗震能力。     

新型半主动调谐质量阻尼器减震性能的数值模拟

为了改良被动式调谐质量阻尼器(TMD)对建筑结构的减震效果,本文提出了一种新型的可实时调节频率和电涡流阻尼的半主动调谐质量阻尼器(SATMD)。由Hilbert-Huang变换(HHT)识别出结构的瞬时频率,通过基于HHT的控制算法实时调节SATMD的质量进行频率的调谐;通过基于线性二次型高斯(LQG)的控制算法实时调整磁导间距来调节电涡流阻尼系数。为了验证SATMD对建筑结构的减震效果,以一单自由度结构模型为例进行地震响应模拟,同时采用一经优化设计的被动TMD作为对比,并考虑由于主结构的累积损伤等引起自身频率下降而造成被动TMD的去谐效应。以主结构的加速度和位移时程峰值、整体均方根值及TMD的耗能性能作为评价指标,对比了SATMD在主结构发生损伤前后对被动TMD的改良效果。数值模拟结果表明,在主结构发生损伤前后,SATMD均比经优化设计的被动TMD有更好的减震效果及耗能能力。