河北省唐山地区丰台—野鸡坨断裂第四纪活动性——来自14C和磁性地层年代学的证据

丰台—野鸡坨断裂为唐山地区主要断裂之一，西侧为鸦鸿桥凹陷，东侧为唐山凸起，断裂两侧第四系厚度之差巨大。本文依据该断层两侧钻孔对其第四纪以来活动性进行初步的探讨。通过对丰台—野鸡坨断裂上下两盘PZK14和PZK20孔磁性地层学研究，并结合钻孔岩石地层，及浅部光释光和¹⁴C测年结果，建立第四纪地层格架。结果表明：两孔底部“泥包砾”为新近纪沉积；PZK14孔下更新统底界埋深为387 m，中更新统底界埋深为114 m，上更新统底界埋深为71 m，全新统底界埋深为6 m；PZK20孔下更新统底界埋深为155 m，中更新统底界埋深为73 m，上更新统底界为36 m，无全新世地层。丰台—野鸡坨断裂活动在早更新世时表现为逐渐增强的特点，活动速率由早期的5.4 cm/ka增加到13.9 cm/ka。中更新世断裂活动基本处于停滞状态，活动速率为1.0 cm/ka。晚更新世以后，断裂重新活动，且更加剧烈，活动速率达到了54.5 cm/ka。     

Latitudinal variation of measured O3 photolysis frequencies J(O1D) and primary OH production rates over the Atlantic Ocean between 50° N and 30° S

The latitudinal variation of the photolysis frequency of ozone to O(¹D) atoms, J(O¹D), was measured using a filter radiometer during the cruise ANT VII/1 of the research vessel Polarstern in September/October 1988. The J(O¹D) noon values exhibited a maximum of 3.6×10^-5 s^-1 (2 sr) at the equator and decreased strongly towards higher latitudes. J(O¹D) reached highest values for clean marine background air with low aerosol load and almost cloudless sky. The J(O¹D) data, measured under these conditions and a temperature of 295 K, can be expressed by: % MathType!MTEF!2!1!+-% feaafiart1ev1aaatCvAUfeBSjuyZL2yd9gzLbvyNv2CaerbuLwBLn% hiov2DGi1BTfMBaeXatLxBI9gBaerbd9wDYLwzYbItLDharqqtubsr% 4rNCHbGeaGqiVu0Je9sqqrpepC0xbbL8F4rqqrFfpeea0xe9Lq-Jc9% vqaqpepm0xbba9pwe9Q8fs0-yqaqpepae9pg0FirpepeKkFr0xfr-x% fr-xb9adbaqaaeGaciGaaiaabeqaamaabaabaaGcbaGaamOsaiaacI% cacaqGpbWaaWbaaSqabeaaiiaacqWF8baFaaGccaqGebGaaeykaiaa% bccacqWF9aqpcaqGGaGaaeyzaiaabIhacaqGWbGaaeiiaiaabUhacq% GHsislcaaI4aGaaiOlaiaaicdacaaIYaGaeyOeI0IaaGioaiaac6ca% caaI4aGaaiiEaiaaigdacaaIWaWaaWbaaSqabeaacqGHsislcaaIZa% aaaOGaaeiiaiaabIhacaqGGaGaam4uaiabgUcaRiaaiodacaGGUaGa% aGinaiaacIhacaaIXaGaaGimamaaCaaaleqabaGaeyOeI0IaaGOnaa% aakiaadofadaahaaWcbeqaaiaaikdaaaGccaGG9bGaaeikaiaaboha% daahaaWcbeqaaiabgkHiTiaaigdaaaGccaGGPaaaaa!5EE9!\[J({\text{O}}^| {\text{D) }} = {\text{ exp \{ }} - 8.02 - 8.8x10^{ - 3} {\text{ x }}S + 3.4x10^{ - 6} S^2 \} {\text{(s}}^{ - 1} )\] where S represents the product of the overhead ozone column (DU) and the secant of the solar zenith angle. The meridional profile of the primary OH radical production rate P(OH) was calculated from the J(O¹D) measurements and simultaneously recorded O₃ and H₂O mixing ratios. While the latitudinal distribution of J(O¹D) and water vapour was nearly symmetric to the equator, high tropospheric ozone levels up to 40 ppb were observed in the Southern Hemisphere, SH, resulting in higher P(OH) in the SH.     

Field calibration and performance of sediment traps in a eutrophic holomictic lake

In wind-stressed and unstratified Lough Neagh low aspect ratio sediment traps, which allow for internal resuspension, collected sediment at a rate close to the natural sediment accumulation rate inferred from dated sediment cores. High aspect ratio traps grossly overestimated the natural rate of sediment accumulation as did, but to a lesser extent, burial rate measurements on an artificial stratigraphic marker. The former type of trap deployed over long exposure periods is therefore recommended as providing the best estimate of net downward particle flux in lakes such as Lough Neagh. However, it is emphasized that all sediment trap types, when operated in shallow turbulent lakes, will to a greater or lesser extent be contaminated by secondary or redeposited material and so will not provide a direct measure of primary sedimentation. Use of tube traps in lakes such as Lough Neagh should not, however, be discounted since they can provide a record of the quality of sedimenting material through time.     

Uniaxial compression and tension tests of anthracite and loading rate dependence of peak strength

The mechanical characteristics of coal under uniaxial compressive stress and uniaxial tensile stress are key factors in investigations of the stability of galleries and coal faces, and are vital considerations for the efficient design of coalmines, disaster prevention, and environmental preservation. These mechanical characteristics have long been a topic of research, but remain insufficiently understood. In this study we performed uniaxial compression tests and uniaxial tension tests on coal, with particular attention to two concerns. The first was to measure the loading rate dependence of the peak strength of coal. Coal shows high sample-to-sample scatter in strength; test methods that are successful in comparatively homogeneous rock types cannot be used for coal. We therefore used an alternative test method that was recently developed by the authors. Anthracite samples were subjected to alternating slow and fast strain rates. Measured variations in stress during this process were used to estimate the loading rate dependence of peak strength. The second objective was to obtain complete stress–strain curves for coal under uniaxial tensile stress. It is difficult to hold samples secure during a tensile test; consequently, such curves have yet to be obtained. This study presents a successful application of the authors' method to the analysis of coal samples, yielding a complete stress–strain curve under tensile stress. The two methods presented here hold promise for application not only to anthracite but also to a wide variety of coals. It is possible to derive the values of the constants used in constitutive equations from the obtained experimental results. Once these equations are determined, they can be incorporated into finite-element software to investigate various time-dependent behaviors of coal and aid in the efficient design of coalmines and the prevention of subsidence and mine disasters.     

An electrochemical study of pyrite oxidation in the presence of carbon coatings in cyanide medium

The anodic and cathodic behaviour of pyrite with clay and different carbon coatings of activated carbon, graphite and carbonaceous matter in cyanide medium was investigated using the potentiodynamic method. The presence of clay coating did not change the polarisation curve appearance for either the anodic oxidation of pyrite or the cathodic reduction of oxygen or the potential of the current plateau, but only decreased the plateau current especially at a higher coating thickness. The presence of the carbon coatings marginally shifted the rest potential for pyrite to a more anodic position and slightly changed the polarisation curve appearance for pyrite oxidation. The current density for pyrite oxidation largely increased in the presence of the carbon coatings, the potential at the plateau shifted to more cathodic positions, and the plateau width became smaller. These effects became more noticeable at a higher coating thickness. The activated carbon, graphite and carbonaceous matter coatings performed similarly in affecting pyrite oxidation at a similar thickness. The carbon coatings significantly increased the limiting current densities for oxygen reduction on pyrite, and the limiting current plateau became steeper at a higher coating thickness. The carbon coatings increased the limiting current density for oxygen reduction to a similar extent at a low coating thickness, but increased to varied extents at a higher coating thickness. The carbon coatings also greatly increased the cathodic current density for gold reduction on pyrite. The enhancement of pyrite oxidation and oxygen or gold reduction on pyrite by the carbon coatings was likely attributed to the electrochemical interaction between pyrite and the carbon materials with electron-rich surfaces and high conductivity. The presence of the carbon coatings significantly increased the oxidation of pyrite in aerated cyanide solutions and the preg-robbing of pyrite especially at a higher coating thickness.     

Visualization experiments of iron precipitates: Application for in-situ arsenic remediation

Laboratory experiments were carried out to acquire more insight and understanding of the phenomena associated with the in-situ arsenic remediation. Visualization techniques are the most informative for the detection of Fe(II) while flowing in soils. Green Rust (GR) was considered as representative of in-situ iron precipitates. In a visualization flat cell, the change in color of GR to orange, due to oxidation, was monitored by a digital camera and the images were analyzed giving the spatial and temporal distribution of Fe(II). Moreover, both oxygen and pH changes in time were recorded in two sections along the flow direction in the cell. The measured and calculated concentration profiles were compared and the actual reaction rates were predicted. The reaction rate constants measured in this study, under flowing conditions, are in a good agreement with the values obtained from batch experiments reported in the literature.     

Aragonite cycles: diagenesis caught in the act

Organic biomarker and nannofossil assemblages are used in combination with sedimentary petrology to identify the role of diagenesis for the formation of a rhythmic calcareous succession. A record from the Early Pliocene of the Maldives (Ocean Drilling Program, ODP Leg 115) is presented containing precession and eccentricity cycles expressed as variable aragonite content. Additional sub‐Milankovitch cycles are caused by rhythmic precipitation of calcite cement in the lower part of the interval. Comparison with palaeo‐productivity indicators (nannofossils, chlorin, total organic carbon) suggests that cementation occurs preferentially in intervals characterized by increasing or decreasing productivity. The coupled variability in productivity and carbonate diagenesis is attributed to the effect of organic matter degradation in the sediment. The observed combination of primary and diagenetic factors hampers the interpretation of the cyclicity on Milankovitch and sub‐Milankovitch scales. Diagenetically stable proxies for palaeo‐productivity, such as nannofossil assemblage data, were used to distinguish between palaeoclimate and diagenetic influences.     

3-D seismic structure of the source area of the 1993 Latur, India, earthquake and its implications for rupture nucleations

The Latur earthquake (M_w 6.1) of 29 September 1993 is a rare stable continental region (SCR) earthquake that occurred on a previously unknown blind fault. In this study, we determined detailed three-dimensional (3-D) P- and S-wave velocity (V_p, V_s) and Poisson's ratio (σ) structures by inverting the first P- and S-wave high-quality arrival time data from 142 aftershocks that were recorded by a network of temporary seismic stations. The source zone of the Latur earthquake shows strong lateral heterogeneities in V_p, V_s and σ structures, extending in a volume of about 90 × 90 × 15 km³. The mainshock occurred within, but near the boundary, of a low-V_p, high-V_s and low-σ zone. This suggests that the structural asperities at the mainshock hypocenter are associated with a partially fluid-saturated fractured rock in a previously unknown source zone with intersecting fault surfaces. This might have triggered the 1993 Latur mainshock and its aftershock sequence. Our results are in good agreement with other geophysical studies that suggest high conductivity and high concentration of radiogenic helium gas beneath the source zone of the Latur earthquake. Our study provides an additional evidence for the presence of fluid related anomaly at the hidden source zone of the Latur earthquake in the SCR and helps us understand the genesis of damaging earthquakes in the SCR of the world.     

Continuous air rate measurement in flotation cells: Some fundamental considerations

A robust and reliable sensor to measure gas (air) superficial velocity (J_g) continuously in flotation systems is introduced. It is based on the sampling of bubbles by buoyancy with the accumulating air allowed to exit through an orifice. At steady state, pressure drop is measured and related to the J_g by prior calibration. The continuous device is readily automated and extended to a multi-unit set-up. The sensor and data collections are described. The governing gas flow equation and models of the dynamic response to air flow rate set point change and fluctuations in froth depth are derived. Model predictions are confirmed against plant data. By taking a moving average, the J_g remains valid in the face of typical plant disturbances.