液氮冻结条件下岩石孔隙结构损伤试验研究

液氮温度极低,约在-195.56^-180.44℃之间,当与岩石接触时会对岩石孔隙结构产生损伤。根据这一特点,低温液氮有望作为压裂流体对储层进行压裂改造。为了研究液氮冻结对岩石孔隙结构损伤的影响,选取两种不同砂岩岩样,分别在不同初始含水饱和度条件下进行液氮冻结处理。对冻结前、后的岩样进行孔隙度以及核磁共振测试,得到岩样在冻结前、后的孔隙度、横向弛豫时间T2分布以及T2谱面积变化情况。试验结果表明:液氮冻结会对岩石的孔隙结构产生损伤,损伤程度受到岩性、孔隙度和岩石含水饱和度等因素影响;岩石含水饱和度越大,损伤就越严重,当岩石含水饱和度达到100%时,岩石表面产生了明显裂纹;岩石在液氮冻结下损伤形式主要是微孔隙的发育和扩展,微孔隙的增加会使岩石孔隙结构的连通性增强,甚至会产生新的大尺寸孔隙,从而对孔隙结构造成严重损伤。     

温度对煤系泥岩力学特征影响的试验研究

利用RMT-150B岩石力学试验系统和GD-65/150高低温环境箱,对经历不同温度后煤系泥岩的力学特性进行试验研究,分析不同温度下煤系泥岩的应力-应变全过程曲线、峰值应力、峰值应变、弹性模量、变形模量以及泊松比受温度的影响。研究结果表明,不同温度下泥岩的力学特性有差异。随温度的升高,其峰值应力、峰值应变有不同程度的降低,其峰值应力从25℃时的9.153 MPa下降到55℃时的8.271 MPa,降幅为9.6%;峰值应变从25℃时的11.002×10-3下降到55℃时的8.249×10-3,降幅达25.0%。弹性模量随温度的升高逐渐减小,变形模量随温度的升高而增大,泊松比随温度的升高逐渐减小,由此得到各参数变量随温度的变化关系。研究成果可为深井高温软岩巷道的围岩控制提供理论基础。     

高水压下岩体裂纹扩展的渗流-断裂耦合机制与数值实现

采用渗流力学、断裂力学理论结合Monte Carlo方法描述岩体裂纹的随机分布,研究高水压作用下岩体原生裂纹的变形和翼形裂纹的萌生、扩展、贯通的渗流-断裂耦合作用机制,建立高水压作用下岩体裂纹的渗流-断裂耦合数学模型,给出该数学模型的求解策略与方法,在Fortran95平台下开发高水压下岩体裂纹扩展的渗流-断裂耦合分析程序HWFSC.for。高水压下岩体裂纹扩展的渗流-断裂耦合体现在岩体裂纹网络和渗流初始条件都随渗流时步变化。对高压注水岩体裂纹扩展过程进行渗流-断裂耦合分析。结果表明,高压注水条件下,岩体裂纹扩展存在起动水压力,当水压力大于起动水压力时,裂纹尖端开始萌生翼形裂纹,随着裂纹水压力的增加,翼形裂纹扩展,进而与其他裂纹搭接贯通,停止扩展。渗流-断裂耦合分析考虑了裂纹动、静水压力对裂纹产生的法向扩张效应及翼形裂纹的扩展而形成新的渗流通道两方面的影响,连通裂纹数随渗流的发展而增加。岩体裂纹的渗流-断裂耦合分析,能较真实地再现岩体裂纹的水力劈裂现象,描述岩体裂纹的扩展、贯通过程及与之相耦合的渗流响应。     

基于岩体精细化描述的围岩分类及力学参数概率分布特征分析

针对目前水电站地下厂房工程中不同围岩分类方法存在评价结果不一致、围岩力学参数存在室内试验值与实际情况不吻合的现象,现推荐采用岩体精细化描述体系对围岩岩体结构进行定量化评价。将常用围岩分类方法(RMR、Q、RMi、GSI、BQ、HC)评价指标予以归纳分组,并通过各组内不同指标对比分析获得围岩分类方法中的基础评价指标。以大岗山水电站主厂房某区段为分析对象,采取现场岩体精细化地质素描与后期数据挖掘、拟合相结合方法,并依据评价指标间的关联关系,获得了基础、非基础评价指标的分布概型及对应参数,实现对该段围岩岩体精细化描述认知;基于精细化描述结果,应用Monte Carlo法生成符合各评价指标分布概型的大量随机数,而后参照各分类方法评价思路与评分流程,得到评价指标在各分类方法对应的大量随机评分值,通过归纳统计获得不同围岩分类方法评价结果的分布概型;基于各围岩分类方法评价结果与力学参数值之间的关联关系实现对力学参数概率特征分析。该分析方法与思路可为类似工程围岩质量及力学参数的精确确定提供一定借鉴,并可为实现围岩支护极限状态设计提供必要的原始参数支持。     

花山岩画开裂岩体声波测试与分析

阐述了声波测试的方法和过程,通过在岩体中声波的传播速度,建立开裂岩体厚度与劣化程度的数学模型。结果表明,开裂岩体厚度小于30 mm时,强度损失较大;开裂岩体厚度大于30 mm时,强度基本保持不变,为今后花山岩画的保护提供科学可靠的理论依据。     

Thermal simulation of basic volcanic fluid influence on different source rocks

Based on thermal simulation experiment, interactions between volcanic fluids and source rocks were studied. Gas generations in the dry system and fluid system under different temperatures were analyzed. The results showed that the various types of source rocks are similar in composition, containing gaseous C1-C5 hydrocarbons, H2 and CO2 whose gas yields increase with increasing temperature. The gas yield of source rocks of type I is the high- est, followed by type II, and that of source rocks of type III is the lowest, indicating that the yield of hydrocarbon gases is related to their hydrocarbon generating potential. Although the generating potential of type III is the lowest, it can still be regarded as a useful gas source when it is buried deeply enough. The basic volcanic fluid restrains the generation of gaseous hydrocarbons in different types of source rocks, but promotes the generation of inorganic gases.     

Effects of Lateral Variation in Vegetation and Basin ‘Dome’ Shape on Tropical Lowland Peat Stabilisation in the Kota Samarahan-Asajaya Area, West Sarawak, Malaysia

Field surveys indicate lateral variation in peat humification levels （von Post） in dominantly occurring fibric,fibric to hemic,sapric and hemie to sapric peats across a gradient from the margin towards the centre of tropical lowland peat domes.Cement-peat stabilisation can be enhanced by adding mineral soil fillers （silt,clays and fine sands） obtained from Quaternary floodplain deposits and residual soil （weathered schist）.The unconfined compressive strength （UCS） of the stabilised cement-mineral soil fifler-peat mix increases with the increased addition of selected mineral soil filler.Lateral variation in the stabilised peat strength （UCS） in the top 0 to 0.5 m layer was found from the margin towards the centre of the tropical lowland peat dome.The variations in the UCS of stabilised tropical lowland peats along a gradient from the periphery towards the centre of the peat dome are most likely caused by a combination of factors due to variations in the mineral soil or ash content of the peat and horizontal zonation or lateral variation in the dominant species of the plant assemblages （due to successive vegetation zonation of the peat swamp forest from the periphery towards the centre of the tropical lowland peat dome）.     

Provenance and Paleogeography of the Late Cretaceous Mengyejing Formation,Simao Basin,Southeastern Tibetan Plateau

正The Mengyejing potash salt deposit(MPSD)is the only pre-Quaternary potash salt deposit in China.The MPSD is located in the southern Simao Basin,southeastern Tibetan Plateau.The MPSD,along with rock salts and clastic rocks,     

New Evidence for Genesis of the Zoige Carbonate-Siliceous-Pelitic Rock Type Uranium Deposit in Southern Qinling: Discovery and Significance of the 64 Ma Intrusions

The carbonaceous-siliceous-argillitic rock type uranium deposit in the Zoige area is located in the northeastern margin of the Tibetan Plateau, and has gained much attention of many geologists and ore deposit experts due to its scale, high grade and abundant associated ores. Because of the insufficient reliable dating of intrusive rocks, the relationship between mineralization and the magmatic activities is still unknown. In order to study this key scientific issue and the ore-forming processes of the Zoige uranium ore field, the LA-ICP-MS zircon U-Pb dating of magmatic rocks was obtained:64.08±0.59 Ma for the granite-prophyry and ~200 Ma for the dolerite. U-Pb dating results of uraninite from the Zoige uranium ore field are mainly concentrated on ~90 Ma and ~60 Ma. According to LA-ICP-MS U-Pb zircon dating, the ages for the dolerite, porphyry granite and granodiorite are 200 Ma, 64.08 Ma approximately and 226.5-200.88 Ma, respectively. This indicates that the mineralization has close relationship with activities of the intermediate-acidic magma. The ages of the granite porphyry are consistent with those uraninite U-Pb dating results achieved by previous studies, which reflects the magmatic and ore-forming event during the later Yanshanian. Based on the data from previous researches, the ore bodies in the Zoige uranium ore field can be divided into two categories:the single uranium type and the uranium with polymetal mineralization type. The former formed at late Cretaceous(about 90 Ma), while the latter, closely related to the granite porphyry, formed at early Paleogene(about 60 Ma). And apart from ore forming elemental uranium, the latter is often associated with polymetallic elements, such as molybdenum, nickel, zinc, etc.     

青岛青山湾-垭口变沉积岩岩石地球化学特征及其物质来源

青岛青山湾—垭口出露一套浅变质的海相陆缘碎屑沉积岩,上覆岩浆锆石的LA-ICP-MS U-Pb年龄为(118.9±3.3)Ma,成熟度较低,与中新生代造山带砂岩类似。稀土元素球粒陨石化标准配分曲线均为轻稀土明显富集的右倾型,表明,研究区碎屑岩具有相同的物源区和构造背景,与活动陆缘的稀土元素配分曲线非常接近。Ce具弱的负异常,指示碎屑岩为大陆边缘海相成因,(La/Ce)N(PAAS)表明陆缘碎屑物质对该区碎屑岩有明显的贡献。主微量元素构造环境判别图解表明,研究区碎屑岩具有活动陆缘和大陆岛弧的特征,经历了相对简单的沉积演化过程;结合稀土元素配分曲线的特征,该区碎屑岩更可能是活动大陆边缘沉积形成。主微量元素分析揭示研究区碎屑岩物源富长英质岩石,镁铁质岩石作为物源也参与到成岩过程中。