天然气溶解过程中组分分馏模型及其应用

天然气不同组分在水中溶解度的差异,导致溶解相与残留游离相天然气组分组成不同,即发生组分的溶解分馏效应。溶解分馏效应在天然气水溶运移、溶解散失等过程中均有发生。揭示天然气组分的溶解分馏规律、建立定量分馏模型,有助于天然气气源对比和成藏过程示踪。以Henry定律为依据,对不同组分溶解特征分析,提出了溶解度分数的概念,并建立了溶解分馏模型。根据该模型和各组分的溶解度分数和天然气溶解量,可计算各组分的溶解分馏量,恢复天然气初始组成特征。计算表明,威远震旦系气藏初期的天然气组成为:CH4为72.70%,C2H6为0.09%,CO2为22.41%,N2为4.07%,干燥系数(C1/C1-5)为99.876%。溶解作用使天然气中CO2含量显著降低,烃类气体含量增加,而天然气干燥系数降低。结果有助于天然气成因判识和气源对比等。     

利用UML模型构建Geodatabase的方法与实践

利用UML模型生成Geodatabase数据库便于数据库的更新及移植,同时能很好地反映数据库结构及对象之间的关系。论文分析了利用VISIO建模工具构建Geodatabase的UML模型以及在此基础上利用ArcGIS Desktop相关模块生成Geodatabase数据库的方法,并以上海市绿化林业信息数据库为例,演示了Geodatabase的创建及更新过程。     

Dynamic data integration for structural modeling: model screening approach using a distance-based model parameterization

This paper proposes a novel history-matching method where reservoir structure is inverted from dynamic fluid flow response. The proposed workflow consists of searching for models that match production history from a large set of prior structural model realizations. This prior set represents the reservoir structural uncertainty because of interpretation uncertainty on seismic sections. To make such a search effective, we introduce a parameter space defined with a “similarity distance” for accommodating this large set of realizations. The inverse solutions are found using a stochastic search method. Realistic reservoir examples are presented to prove the applicability of the proposed method.     

塔里木盆地巴楚地区中奥陶统一间房组露头礁滩复合体储层地质建模及其对塔中地区油气勘探的启示

通过1：5万礁滩复合体地质填图,在巴楚地区共发现大小不等的礁滩复合体90余个,层位为中奥陶统一间房组二段．台缘为礁滩复合体密集发育区,礁滩体规模大,台内为礁滩复合体零星发育区,礁滩体规模小。通过对6个典型礁滩复合体的解剖,研究了礁滩复合体的微相类型、组合和各微相的岩石特征、生物群落,并对其生长发育阶段进行了分析。根据6个典型礁滩复合体及礁间的大量铸体薄片鉴定和物性资料,分析了储层的特征、成因和非均质性,建立了台缘礁及礁间、台内礁及礁间2种背景条件下的储层地质模型。巴楚地区露头礁滩复合体储层地质模型对塔中地区上奥陶统良里塔格组礁滩复合体的勘探具有重要的指导意义,并为勘探实践所证实。     

地面核磁共振模型约束反演含水层参数

导电模型的地面核磁共振感应电动势是含水量的非线性函数.引入模型约束的迭代反演方法求解该非线性问题的反演.在反演过程中,根据理论公式计算迭代过程中灵敏度矩阵,并采用平坦模型和光滑模型两种约束.对均匀半空间、层状导电模型和实际数据进行了反演模拟,结果表明,模型约束迭代反演方法能从地面核磁共振感应电动势获得含水层较为合理的含水量及分布,且该结果可以从作为初始模型的均匀含水量分布反演得到.对无噪音数据,平坦模型和光滑模型约束对反演的含水量分布影响不大;但当数据存在一定的噪音时,平坦模型约束将比光滑模型约束获得更为精确的含水层参数.     

初至层析静校正在复杂山地三维地震勘探中的应用

随着地形高差增大、地貌单元多变、近地表模型复杂,目前被广泛应用的初至折射静校正的精度已无法满足精细勘探的要求。初至层析静校正技术,由给定的初始模型进行正演,用射线追踪方法得到初始模型的初至波,利用该初至波和实际拾取的初至波进行比较,计算地表模型的修正量,反复迭代求得准确的地表模型。山西省国阳新能股份有限公司二矿390水平九采扩区地表标高940～1100m,地貌单元复杂,在对该区资料处理时,利用初至层析折射静校正,经9次迭代计算后,真实地刻划出近地表模型。在二种静校正技术对比中,初至折射静校正不但近地表模型精度低于层析折射静校正,而且其叠加剖面精细程度也远低于层析静校正,如在初至折射静校正叠加剖面同相轴上呈现的凹凸形态,在层析静校正叠加剖面并无显示,且后者剖面的信噪比也比前者明显提高。     

苏里格气田盒8气藏气水层测井识别研究

鄂尔多斯盆地苏里格气田盒8气藏为弹性驱动的河流相低效气藏,储层非均质性强,在开发中普遍见水。根据试采情况将气藏储层分为气层、水层、气水层三类,开展气、水层的测井识别研究。以区内26口井50个射孔层段各层的试油结果作为依据,选出了700个样本点作为判识建模的标本,以声波时差和中子孔隙度等8个原始测井值作为判识变量组合,采用模糊判别分析,建立了各层的判识模型。回判结果表明,模型对气层精度达到97％,水层为89％,气水层为94％。利用未参加建模的出水井射孔段对模型进行验证,判识结果基本符合实际情况,模型具有较高精度。     

The dynamics and thermodynamics of large ash flows

 Ash flow deposits, containing up to 1000 km³ of material, have been produced by some of the largest volcanic eruptions known. Ash flows propagate several tens of kilometres from their source vents, produce extensive blankets of ash and are able to surmount topographic barriers hundreds of metres high. We present and test a new model of the motion of such flows as they propagate over a near horizontal surface from a collapsing fountain above a volcanic vent. The model predicts that for a given eruption rate, either a slow (10–100 m/s) and deep (1000–3000 m) subcritical flow or a fast (100–200 m/s) and shallow (500–1000 m) supercritical flow may develop. Subcritical ash flows propagate with a nearly constant volume flux, whereas supercritical flows entrain air and become progressively more voluminous. The run-out distance of such ash flows is controlled largely by the mass of air mixed into the collapsing fountain, the degree of fragmentation and the associated rate of loss of material into an underlying concentrated depositional system, and the mass eruption rate. However, in supercritical flows, the continued entrainment of air exerts a further important control on the flow evolution. Model predictions show that the run-out distance decreases with the mass of air entrained into the flow. Also, the mass of ash which may ascend from the flow into a buoyant coignimbrite cloud increases as more air is entrained into the flow. As a result, supercritical ash flows typically have shorter runout distances and more ash is elutriated into the associated coignimbrite eruption columns. We also show that one-dimensional, channellized ash flows typically propagate further than their radially spreading counterparts. As a Plinian eruption proceeds, the erupted mass flux often increases, leading to column collapse and the formation of pumiceous ash flows. Near the critical conditions for eruption column collapse, the flows are shed from high fountains which entrain large quantities of air per unit mass. Our model suggests that this will lead to relatively short ash flows with much of the erupted material being elutriated into the coignimbrite column. However, if the mass flux subseqently increases, then less air per unit mass is entrained into the collapsing fountain, and progressively larger flows, which propagate further from the vent, will develop. Our model is consistent with observations of a number of pyroclastic flow deposits, including the 1912 eruption of Katmai and the 1991 eruption of Pinatubo. The model suggests that many extensive flow sheets were emplaced from eruptions with mass fluxes of 10⁹–10¹⁰ kg/s over periods of 10³–10⁵ s, and that some indicators of flow "mobility" may need to be reinterpreted. Furthermore, in accordance with observations, the model predicts that the coignimbrite eruption columns produced from such ash flows rose between 20 and 40 km. Received: 25 August 1995 / Accepted: 3 April 1996     

About the specification of erosion flux for soft stratified cohesive sediments

The present paper deals with the specification of bed erosion flux that accounts for the effects of sediment-induced stratification in the water column. Owing to difficulties in measuring the bed shear stress _b and the erosive shear strength _s, we suggest a series of methods that combine laboratory and numerical experiments. A simplified turbulent transport model that includes these effects helps to quantify _b and _s. Focusing on soft stratified beds, the present study considers erosion rate formulas of the form =_f exp {[T_b-T_s]} where is a model constant (=1 for Gularte's (1978) formula and =1/2 for Parchure's (1984) formula). First, the bed erosive strength profile _s(Z) is adjusted by forcing the turbulent transport model with measured erosion rates. Second, three procedures are suggested to determine the erosion rate formula coefficients _f and : a global procedure and two different layer-by-layer procedures. Each procedure is applied to an erosion experiment conducted in a rotating annular flume by Villaret and Paulic (1986). The use of the layer-by-layer procedure based on a least squares fitting technique provides a closer fit than the global procedure. The present study points out the complementarity of experimental and numerical approaches and also suggests possible improvements in laboratory test procedures.     

华北典型箕状断陷盆地层序地层学模式及其与油气赋存关系

本文根据层序地层学的基本原理,立足东部箕状断陷盆地的特点,以冀中拗陷和二连盆地为重点研究对象,提炼出陆相断陷盆地层序地层学模式,在缓坡带,以风暴浪基面作为“陆架边角”的参照物,层序地层特征相似于海相被动大陆边缘背景;在陡坡带则截然不同,并以湖面与边界断裂的交点取代“陆架边角”,各体系域所含沉积体系与海相模式不尽相同,在盆地形成初期的层序,低水位体系域发育,湖泊消亡以后,主要发育高水位体系域。此外,本文还探索了层序地层与油气赋存的关系,指出富砂的“盆底扇”是今后勘探开发的重要方向。