堤坝管涌的室内试验与颗粒流细观模拟研究

本文对水流垂直方向的堤坝管涌现象分别进行了室内模型模拟和颗粒流模拟实验。在室内模型试验模拟中采用先进的数码成像跟踪设备在细观的尺度上对土样在管涌发生发展的全过程进行了观察和记录,为颗粒流细观模拟提供了必要的细观参数及宏观依据。提出的二维孔隙率与三维孔隙率转换的关系公式很好的将室内模型试验的孔隙率同颗粒流数值模拟结合,运用颗粒流程序采用固液耦合的分析模型对管涌现象作进一步的数值模拟分析。根据模拟结果,分析了管涌产生、发展在颗粒细观尺度的原因,对管涌产生发展中的试样细观变化规律及流速的变化规律进行了分析。这些结果为PFC2D在渗流和渗透破坏等方面的深入研究应用提供了一定的实用依据,同时也为在细观尺度上解释和分析管涌现象提供了一条新的途径。     

保证混凝土结构实体质量措施的探讨

结合国家现行混凝土结构工程验收规范,从混凝土质量及钢筋制作、安装施工质量方面,对混凝土结构实体存在的质量问题作了阐述,提出了相应的解决措施。     

金川软岩蠕变破坏机理电镜实验研究

为探讨金川矿岩石蠕变破坏机理,应用微观扫描电镜(SEM)对蠕变受力情况下岩石破坏断口微观形态进行了观察研究,并分析了其产生的微观破坏机制。结果表明:岩石蠕变断裂的微观机制主要是拉伸、剪切作用下岩石发生脆性断裂,从岩石断裂微观形态研究岩石蠕变断裂,可以更好的揭示岩石断口微观形貌特征、裂纹生核、扩展、及断裂方式与岩石蠕变演进过程的联系。     

桩端土加固处理设计及检测方法的探讨

介绍了人工挖孔桩桩端土承载力不足进行旋喷桩处理的设计过程以及处理后检测过程中遇到的问题。桩端土处理设计可以遵循一般的地基处理设计方法和原则,并针对复合地基承载力检测和桩端土极限端阻力的检测中存在的差异和共同点,提出组合静载荷试验的思路和方法,并在工程中予以实施,并取得了较好的效果。     

应用深层平板载荷试验选择桩端持力层

深层平板载荷试验是一种新兴的原位测试方法。通过安阳某工程人工挖孔扩底灌注桩深层平板载荷试验的现场实践,确定了不同土层地基土的承载力特征值,为设计单位选择持力层提供数据,并为甲方节省了大量建设资金。     

A numerical study on 2-D compressive wave propagation in rock masses with a set of joints along the radial direction normal to the joints

An explosion in a borehole or an accidental explosion in a tunnel will generate a two-dimensional (2-D) compressive wave that travels through the surrounding rock mass. For the problem of 2-D compressive wave propagation in a rock mass with parallel joints in the radial direction normal to the joints, parametric studies on the transmission ratio and the maximum rebound ratio are performed in universal distinct element code. The variation of the transmission ratio with the ratio of joint spacing to wavelength is generalized into a characteristic curve, which can be used as a prediction model for estimating the transmission ratio. The relationship between the maximum rebound ratio and the influence factors is obtained in charts. The charts can be used as a prediction model for estimating the maximum rebound ratio. The proposed prediction models for estimating the transmission ratio and the maximum rebound ratio are applied to a field explosion test, Mandai test in Singapore. The minimum possible values of peak particle velocity (PPV) at the monitoring points are estimated by using the proposed prediction model for estimating the transmission ratio along the radial direction normal to the joints. On the other hand, the maximum possible values of PPV are estimated by using the proposed prediction model for estimating the maximum rebound ratio along the same radial direction. The comparison shows a good agreement between the field-recorded PPVs and the estimated range of PPVs given by the minimum possible PPVs and the maximum possible PPVs at the monitoring points in Mandai test. The good agreement between the estimated and field-recorded values validates the proposed prediction models for estimating peak particle velocity in a rock mass with a set of joints due to application of a compressive wave at the boundary of a tunnel or a borehole.     

New method for in situ characterization of loose material for landslide mapping purpose

The assessment of grain size distribution and plasticity of loose geological material, during in situ geological investigations, is not obvious. Visual appreciation allows an approximative quantification of the coarse granulometric fractions, but not of the fine ones. Field soils determination methods suggested until now, are visual and tactile tests leading to a very rough estimate, which is only qualitative and not very reproducible. The new proposed field test (GEOLEP method) allows a quick quantification of the fine fraction of loose material. It allows the determination of the sand fraction (fine and medium grained sands) as well as the methylene blue value of the samples. The necessary equipment to perform this test is light and compact and the time needed to analyze one sample is approximately 15 min. Thus it is also possible to carry out numerous measurements in one day. The calibrations were carried out on a selection of 13 natural samples, chosen for their representativeness of the typical alpine quaternary deposits. The results obtained with GEOLEP method are relevant compared with standardized laboratory tests; the obtained correlation indexes are of 73% for the comparison with laboratory stain test results and of 89% with a laboratory method using a similar procedure than the field test. The correlation we performed with Atterberg's limits tests shows that a rough approximation of plasticity index can also be obtained (R² = 75%). This method thus brings a new tool which should allow taking into account the lithological factor (by some quantitative and representative variables) in a reliable way for the evaluation of landslide hazards.     

土石混合料剪切面分形特征试验研究

土石混合料因具有良好的工程特性而被广泛应用于道路、堤坝等工程，填筑体受力后往往沿薄弱面发生剪切破￡混合料的抗剪强度成为稳定和变形分析的重要力学指标。由于土石混合料物质组成的复杂性、结构分布的不规律性及采柠困难性，且受检测仪器的限制，确定其强度指标较为困难。应用改进的直剪试验仪进行了不同类别、不同最大粒径土石福料的室内大型直剪试验，在获得强度指标同时，再现剪切面的实际情况，量测剪切面的起伏特征。根据分形几何学原理，切面具有良好的分形特征，应用三角形棱柱表面积覆盖法编程计算了剪切面的分形维数。初步建立了剪切面分形维数与福料杭萌强度之间的关系，用来快速预测土石混合料的强度指标。     

帷幕灌浆在坝基防渗处理中的应用——以新疆乌什水水库为例

新疆乌什水水库为注入式水库。于1984年始修,总库容3850×104m3,灌溉下游农田。因坝基严重渗漏,2002年被新疆水利专家评为险库,对坝基需进行防渗帷幕灌浆处理。为此,设计和施工中确定了坝基防渗处理原则,从而探索出一套最佳的灌浆工艺。现场运用多种手段对灌浆质量进行全面检查,对施工全过程实施质量控制和跟踪监理,使施工的838个灌浆孔(总进尺25804.18m)的优良率达84.8%,7个固结灌浆单元和21个帷幕灌浆单元工程合格率达100%。固结灌浆和帷幕灌浆部分工程及坝基防渗帷幕单位工程均被评为优良工程。     

Static load tests of driven concrete piles under CFRP confinement

ABSTRACT

This paper describes compressive static load tests of concrete driven piles confined by Carbon Fibre Reinforced Polymer (CFRP). The tested piles include one concrete pipe pile and one concrete rectangular pile which are all partially confined by CFRP, and other two piles with the same dimensions without CFRP application. Tests program was performed to obtain the behaviours of these composite piles. Four Static Loading Tests (SLTs) were conducted and the results shown that those two types of composite pile demonstrate less vertical displacement with the same loading of traditional concrete piles. Furthermore, the traditional methods of Load-settlement (Q-s) curves, Settlement-lg (Load) (s-lgQ) curves and Settlement-lg (Time) curves are analysed. Due to un-plunging condition, the interpretation methods of Davisson’s, DeBeers, Double-Tangent as well as Chin’s methods are demonstrated for the ultimate bearing capacity of these four piles. It is concluded that the CFRP confinement increased the ultimate bearing capacity and this composite material can be perfectly applied in geotechnical condition.