Microphysical Responses to Catalysis During a Stratocumulus Aircraft Seeding Experiment over the Sanjiangyuan Region of China

This study explores the microphysical responses to a cloud seeding operation in the Sanjiangyuan region, China. The cloud seeding was performed using a zigzag flight pattern, while the detection phase was accomplished using a back-and-forth flight pattern through the top of a stratocumulus layer. Global Position System（GPS） and Particle Measuring System（PMS） data obtained during the operation are used to determine the efective cloud area before and after the operation, diferentiate the phase states of cloud particles, and analyze changes in the concentrations of liquid cloud particles and ice crystals, the evolution of the cloud particle spectrum, and the content of supercooled water. The median diameter of liquid cloud particles in the area of the cloud-seeding operation was 3.5–18.5 μm, most cloud particles observed in the 21.5–45.5-μm size regime were ice crystals, while all particles of size 50 μm and above were in the ice phase. Changes in the concentration and typical diameter of cloud particles within 36 km downwind of the cloudseeding operation did not exceed natural fluctuations in the cloud area before the operation; however, the concentration of liquid cloud particles decreased substantially in areas with high concentrations of supercooled water（concentrations of supercooled water exceeding 0.01 g m 3）. The concentration of ice crystals within the measuring range of the Forward Scattering Spectrometer Probe（FSSP） increased substantially, the water content of ice-phase particles increased, and the average supercooled water content in the cloud decreased from（68.3± 23.1）% before the operation to（34.2± 12.4）%. The efects of cloud seeding were more pronounced in parts of the cloud where the content of supercooled water was higher. Little to no efects were observed in parts of the cloud with low concentrations of supercooled water.     

Low-frequency solar radiophysics with LOFAR and FASR

Low-frequency radio observations offer unique diagnostics of the solar corona and solar wind. After a prolongued hiatus, there is renewed interest in this important frequency regime. Two new ground-based instruments will provide critical new low-frequency observations: the low-frequency array (LOFAR) and the frequency agile solar radiotelescope (FASR). This brief topical review summarizes low-frequency radio phenomena that will be accessible to detailed study by LOFAR and FASR in the coming decade. Energy release, drivers of space weather, and studies of the solar wind are emphasized. Both instruments are expected to play important roles in both basic research problems and national and international space weather capabilities. While FASR is a solar-dedicated instrument, LOFAR is not. Solar observing requirements for LOFAR are briefly discussed.     

Doppler radar sounding of volcanic eruption dynamics at Mount Etna

Besides their common use in atmospheric studies, Doppler radars are promising tools for the active remote sensing of volcanic eruptions but were little applied to this field. We present the observations made with a mid-power UHF Doppler radar (Voldorad) during a 7-h Strombolian eruption at the SE crater of Mount Etna on 11–12 October 1998. Main characteristics of radar echoes are retrieved from analysis of Doppler spectra recorded in the two range gates on either side of the jet axis. From the geometry of the sounding, the contribution of uprising and falling ejecta to each Doppler spectrum can be discriminated. The temporal evolution of total power backscattered by uprising targets is quite similar to the temporal evolution of the volcanic tremor and closely reproduces the overall evolution of the eruption before, during and after its paroxysm. Moreover, during the sharp decrease of eruptive activity following the paroxysm, detailed analysis of video (from camera recording), radar and seismic measurements reveals that radar and video signals start to decrease simultaneously, approximately 2.5 min after the tremor decline. This delay is interpreted as the ascent time through a magma conduit of large gas slugs from a shallow source roughly estimated at about 500 m beneath the SE crater. Detailed analysis of eruptive processes has been also made with Voldorad operating in a high sampling rate mode. Signature of individual outburst is clearly identified on the half part of Doppler spectra corresponding to rising ejecta: temporal variations of the backscattered power exhibit quasi periodic undulations, whereas the maximum velocity measured on each spectrum displays a sharp peak at the onset of each outburst followed by a slow decay with time. Periodicity of power variations (between 3.8 and 5.5 s) is in agreement with the occurrence of explosions visually observed at the SE vent. Maximum vertical velocities of over 160 m s^–1 were measured during the paraoxysmal stage and the renewed activity. Finally, by using a simplified model simulating the radar echoes characteristics, we show that when Voldorad is operating in high sampling rate mode, the power and maximum velocity variations are directly related to the difference in size and velocity of particles crossing the antenna beam.Editorial responsibility: A. Woods     

Processes affecting deposition of sediment in a small, morphologically complex lake

Devil Lake is morphologically complex as a result of Pleistocene glacial erosion of the Frontenac Axis of the Canadian Shield. In order to assess the processes causing highly variable sedimentation in the lake, we monitored currents, suspended sediment and temperature in the lake before and during autumn overturn in 2002. Strong summer thermal stratification (stability number to 0.11 s^–1 declining with the approach of overturn) was insufficient to prevent a dynamic response in the hypolimnion to wind forcing. Superimposed on a gradual increase in suspended sediment concentration in the last weeks of stratification from less than 2 g/l to about 30 g/l were shorter-term rises lasting up to several days. Associated with these events was an increase in particle size of the sediment from a mode of 40–50 to 150–200 m ascribed to flocculation from primary particles. These events culminated in rapid (<1 h) clearing of the water associated with strong, sustained winds over the lake, especially from the southwest. After overturn, the events were more frequent, and flocculation was unable to develop as well in the more vigorous circulation. However, currents in the hypolimnion occurred throughout the period before, during and after overturn with speed related to wind speed, but direction largely independent of wind direction. The results represent an approach to understanding the nature of sedimentary processes and thus to strengthening the use of sedimentary records as proxy in environmental and paleoenvironmental assessment.     

Improvement and Application of the Similarity Saltation Model: Wind-Tunnel Experimental Investigation and Numerical Simulation of the Vertical Sand Mass Flux Distribution in the Saltation Layer

Based upon comparisons between published experimental data and simulated results on the vertical sand flux distribution in the saltation layer, Shao’s similarity saltation model has been greatly improved by correcting the average vertical particle lift-off velocity and using a more suitable universal roughness length. By the improved model, the vertical sand flux profile over the bare, dry and loose uniform sandy surface, which is quite representative of real desert surfaces, can be reproduced very well. Meanwhile, the surface transport rate and the characteristic and average saltation heights have been simulated and analyzed in detail, disclosing their relationships with friction velocity, particle size and roughness length, and the possible underlying mechanisms. Besides, the average particle lift-off velocity and the average mean vertical aerodynamic action upon the ascending particle, which determine the saltation process, are explicitly expressed by parameters involved in the similarity model, and their relationships with friction velocity, particle size and roughness length are also described concisely. The corrected average particle lift-off velocity makes it possible to investigate the characteristic particle trajectory, whose initial velocity equals the average lift-off velocity, so as to estimate the average particle against surface impacting velocity and the average aerodynamic action upon the saltation process.     

粒子群算法与支持向量机相结合的热带气旋强度预报试验

支持向量机(SVM)的惩罚参数及核参数的选择直接影响到模型效果,通过粒子群算法(PSO)解决支持向量机的参数选择问题,实现了参数选择的自动化。将该方法应用于热带气旋强度预报,利用气候持续性因子,挑选了1990年的100个左右样本进行预报检验,预报时效为12 h、24 h、36 h、48 h的强度平均绝对误差分别为3.00、4.35、4.93和6.68 m/s。另外,还与国外预报结果及采用最小二乘回归法的预报结果进行了效果的比较,SVM方法显示了更好的预报能力。     

Swarm intelligence-based solver for parameter estimation of laboratory through-diffusion transport of contaminants

Theoretical approaches are of fundamental importance to predict the potential impact of waste disposal facilities on ground water contamination. Appropriate design parameters are generally estimated by fitting theoretical models to data gathered from field monitoring or laboratory experiments. Transient through-diffusion tests are generally conducted in the laboratory to estimate the mass transport parameters of the proposed barrier material. These parameters are usually estimated either by approximate eye-fitting calibration or by combining the solution of the direct problem with any available gradient-based techniques. In this work, an automated, gradient-free solver is developed to estimate the mass transport parameters of a transient through-diffusion model. The proposed inverse model uses a particle swarm optimization (PSO) algorithm that is based on the social behavior of animals searching for food sources. The finite difference numerical solution of the forward model is integrated with the PSO algorithm to solve the inverse problem of parameter estimation. The working principle of the new solver is demonstrated and mass transport parameters are estimated from laboratory through-diffusion experimental data. An inverse model based on the standard gradient-based technique is formulated to compare with the proposed solver. A detailed comparative study is carried out between conventional methods and the proposed solver. The present automated technique is found to be very efficient and robust. The mass transport parameters are obtained with great precision.     

地表下沉系数选取的LWPSO-BP方法研究

针对BP神经网络自身收敛速度慢、容易陷入局部极小点的缺点,本文以线性下降惯性权重粒子群优化算法(LLWPSO)为前处理器,优化BP网络的权值和阈值,利用实测资料数据,建立LWPSO-BP的地表下沉系数预计模型,并同普通BP模型预计结果对比结果表明:LWPSO-BP神经网络不仅训练速度快,而且预测精度明显提高,该模型对地...     

A new portable in situ flume for measuring critical shear stress on river beds

A new portable in situ flume(PISF)for measuring critical bed shear stress(CBSS)was developed in this study.The PISF consists of an open bottom sediment erosion chamber and an electrically-driven pump.Unlike most existing in situ flumes with similar designs,the new PISF does not rely on monitoring the flow conditions or particle density in the sediment erosion chamber;instead,it is a pre-calibrated flume.The calibration was performed by first determining CBSS of various selected sediment samples of known particle size and density(using the law of the wall),based on flow velocity-depth profiles measured in a 6 m straight open-channel flume using a Particle Image Velocimetry(PIV)system.These same particles of known CBSS were then used in the new in-situ flume under controlled lab conditions to obtain a series of calibration curves of CBSS vs.pump electrical power.A wide variety of particle types and sizes(simulated sediments)were used in this two-step calibration procedure to widen CBSS measurement range and simulate cohesive force effects.The size of the PISF is much smaller and more practical than other similar devices as lamellar flow conditions are not required and it can be applied to a wide range of sediment types including cohesive sediments.