圆形重力式网箱阻力性能研究

采用网箱模型试验 ,对周长 5 0 m,深 8m的 HDPE双管圆形重力式网箱 ,在不同配重、网片规格和流速条件下的阻力性能进行研究。结果表明 ,在 2 .5 kn的相对流速范围内 ,网箱的整体阻力在 75 0 0 kg以内 ;在网箱整体阻力中 ,框架及重锤阻力所占比重较小 ,而网箱箱体阻力占近90 %。不同重锤配重的网箱 ,其整体阻力与流速均呈幂函数关系 F=a Vb,网箱重锤配重增加 ,网箱阻力也随之增大 ,而重锤配重变化对网箱阻力的影响程度又随流速的增加而减小     

Large-eddy simulation of the flow past a circular cylinder at sub- to super-critical Reynolds numbers

Large-eddy simulation of turbulent flow past a circular cylinder at sub- to super-critical Reynolds numbers is performed using a high-fidelity orthogonal curvilinear grid solver. Verification studies investigate the effects of grid resolution, aspect ratio and convection scheme. Monotonic convergence is achieved in grid convergence studies. Validation studies use all available experimental benchmark data. Although the grids are relatively large and fine enough for sufficiently resolved turbulence near the cylinder, the grid uncertainties are large indicating the need for even finer grids. Large aspect ratio is required for sub-critical Reynolds number cases, whereas small aspect ratio is sufficient for critical and super-critical Reynolds number cases. All the experimental trends were predicted with reasonable accuracy, in consideration the large facility bias, age of most of the data, and differences between experimental and computational setup in particular free stream turbulence and roughness. The largest errors were for under prediction of turbulence separation.     

Hydrodynamics of the Semi-Immersed Cylinder by Forced Oscillation Model Testing

In this paper, the hydrodynamic coefficients of a horizontal semi-immersed cylinder in steady current and oscillatory flow combining with constant current are obtained via forced oscillation experiments in a towing tank. Three non-dimensional parameters (Re, KC and Fr) are introduced to investigate their effects on the hydrodynamic coefficients. The experimental results show that overtopping is evident and dominates when the Reynolds number exceeds 5×10⁵ in the experiment. Under steady current condition, overtopping increases the drag coefficient significantly at high Reynolds numbers. Under oscillatory flow with constant current condition, the added mass coefficient can even reach a maximum value about 3.5 due to overtopping while the influence of overtopping on the drag coefficient is minor.     

Vibration of two elastically mounted cylinders of different diameters in oscillatory flow

Vibration of two elastically mounted cylinders in an oscillatory flow at a Keulegan-Carpenter number of 10 is simulated numerically. The two cylinders are rigidly connected with each other and are allowed to vibrate in the cross-flow direction only. The aim of this paper is to identify the effects of the orientation of the cylinders and the gap between the cylinders on the vibration. The two-dimensional Reynolds-Averaged Navier-Stokes equations are solved to predict the flow and the cylinder vibration is predicted using the equation of motion. When the two cylinders are in a tandem arrangement, a combined single pair flow regime and attached pair flow regime are observed as reduced velocity exceeds 10 and this combined regime and the single pair regime occurs intermittently. Periodic vibration is found when the two cylinders are in a staggered arrangement with a 45° flow attack angle. When the two cylinders are in a side-by-side arrangement, a new single vortex regime is observed. This single vortex remains attached to the cylinder surface and rotates around the cylinder. The intermittent switch between this single vortex regime and the single pair regime are observed.     

Experimental Study on Flow past A Rotationally Oscillating Cylinder

A series of experiments was carried out to study the flow behaviour behind a rotationally oscillating cylinder at a low Reynolds number (Re=300) placed in a recirculation water channel. A stepper motor was used to rotate the cylinder clockwise- and- counterclockwise about its longitudinal axis at selected frequencies. The particle image velocimetry (PIV) technique was used to capture the flow field behind a rotationally oscillating cylinder. Instantaneous and time-averaged flow fields such as the vorticity contours, streamline topologies and velocity distributions were analyzed. The effects of four rotation angle and frequency ratios F_r (F_r=f_n/f_v, the ratio of the forcing frequency f_n to the natural vortex shedding frequency f_v) on the wake in the lee of a rotationally oscillating cylinder were also examined. The significant wake modification was observed when the cylinder undergoes clockwise-and-counterclockwise motion with amplitude of π, especially in the range of 0.6≤F_r≤1.0.     

基于MPS方法模拟低雷诺数方柱绕流问题

柱体绕流问题是流体力学领域一个非常经典的问题。当流体流经柱体时,由于黏性的存在,会发生许多复杂的流动现象,如流动分离、涡旋周期性生成与脱落等,经常被作为标准验证算例。同时,柱体绕流广泛存在于实际工程中,并在一定工况下可能对工程产生巨大危害,因此对柱体绕流进行深入研究具有重要意义。研究中,拟将一种无网格类方法——半隐式移动粒子方法(moving particle semi-implicit method,简称MPS)引入到柱体绕流问题的数值研究中,并对不同雷诺数下二维方柱绕流问题进行数值模拟。首先,使用基于MPS方法自主开发的MLParticle-SJTU求解器,结合入口边界条件和出口边界条件,模拟了雷诺数Re分别为40、200和1 000时均匀来流条件下的方柱绕流。随后,将模拟的绕流结果与文献中试验和数值计算结果进行了对比,结果吻合较好,并且在雷诺数为200和1 000时,可以清晰地捕捉到方柱尾流中的卡门涡街现象,验证了MPS方法在柱体绕流问题模拟上的有效性和适用性。     

The vertical mode method in the problems of flexural-gravity waves diffracted by a vertical cylinder

The linear three-dimensional problem of ice loads acting on a vertical circular cylinder frozen in an ice cover of infinite extent is studied. The loads are caused by an uni-directional hydroelastic wave propagating in the ice cover towards the cylinder mounted to the see bottom in water of constant depth. There are no open water surfaces in this problem. The deflection of the ice cover is described by the Bernoulli–Euler equation of a thin elastic plate of constant thickness. At the contact line between the ice cover and the surface of the cylinder, some edge conditions are imposed. In this study, the edge of the ice plate is either clamped to the cylinder or has no contact with the cylinder surface, with the plate edge being free of stresses and shear forces. The water is of finite constant depth, inviscid and incompressible. The problem is solved by both the vertical mode method and using the Weber integral transform in the radial coordinate. Each vertical mode corresponds to a root of the dispersion relation for flexural-gravity waves. It is proved that these two solutions are identical for the clamped edge conditions. This result is non-trivial because the vertical modes are non-orthogonal in a standard sense, they are linearly dependent, the roots of the dispersion relation can be double and even triple, and the set of the modes could be incomplete. A general solution of the wave-cylinder interaction problem is derived by the method of vertical modes and applied to different edge conditions on the contact line. There are three conditions of solvability in this problem. It is shown that these conditions are satisfied for any parameters of the problem.     

Three-dimensional flow around a square cylinder near a wall

In this study, two- and three-dimensional numerical simulations were performed to investigate the effect of the flow structure in the wake of a square cylinder placed near a plane wall by applying a fully implicit finite-difference method to the Navier-Stokes equations. The gap ratio between the cylinder and the wall, G/D, was varied from 0.2 to 4 for the Reynolds numbers of 175, 185 and 250. The role of the 3D structure on the lift and drag coefficients and Strouhal number was investigated. The results were compared with those of the 2D numerical simulations. The deviations of the 3D flow structure of the cylinder-wall pair from that of a single cylinder were also reported. At Re=250, B type secondary vortices were determined in the wake region. At Re=175 and 185, transition from A type vortex to fully periodic B type vortices was observed when the cylinder was brought closer to the wall.     

不同倒角半径四柱体绕流数值模拟及水动力特性分析

为研究四柱体布置情况下倒角半径变化对柱体绕流水动力特性的影响,使用Fluent软件,采用大涡模拟方法研究了在雷诺数Re=3 900下6种不同倒角半径的柱体在方形四柱体布置时的三维流场。在模型分析验证有效后,分析了柱体后方瞬时流场、水动力参数、时均流场的变化情况。分析结果表明:随着倒角半径的增大,上游柱体的平均阻力系数逐渐减小,下游柱体的平均阻力系数除了在R~+=0.1处增幅很大以外,其余均随倒角半径变大而平稳变大;各柱体的升力系数均方根变化趋势基本相同;R~+=0.1、0.5时,上下游两柱体的升力系数曲线相位相反,而在R~+=0.2、0.3和0.4时,上下游两柱体的升力系数曲线相位相同。     

低雷诺数下圆柱强迫振动特性光滑粒子流体动力学模拟

基于光滑粒子流体动力学(SPH)方法,开发了能够准确描述水流作用下圆柱强迫振动特性的数学模型。通过引入适合于无网格粒子法的开边界算法,来模拟出入流边界条件,建立了具有造流功能的SPH数值水槽。圆柱及计算域的上下边界均采用修正的动力边界条件进行模拟。借助于粒子位移矫正和压力修正算法,避免了圆柱周围流体粒子压力大幅震荡以及结构下游区域出现空腔等非物理性现象。使用典型的圆柱绕流数据,验证了所建SPH模型的计算性能,研究了固定圆柱在低雷诺数情况下的尾涡脱落模式和升阻力变化规律。明确了低雷诺数下强迫振动圆柱在频率锁定以及非锁定区间内的升力变化规律,量化了升力与外界激励频率之间的关系。