镇康芦子园铅锌矿床特征及成因

芦子园铅锌矿产于镇康复背斜核部寒武系沙河厂组大理岩、板岩、片岩地层中，沿背斜轴部产生的断层及层间破碎带是主要的容矿构造，成矿物质来源于地层、酸性及基性岩浆热液，矿床成因为沉积-热液改造叠生型铅锌矿床。     

Three mechanisms of ore re-mobilisation during amphibolite facies metamorphism at the Montauban Zn–Pb–Au–Ag deposit

The relative importance of mechanical re-mobilisation, hydrothermal dissolution and re-precipitation, and sulphide melting in controlling redistribution of metals during concurrent metamorphism and deformation is evaluated at the middle amphibolite facies Montauban deposit in Canada. As at many other deposits, ductile deformation was important in driving mechanical re-mobilisation of massive sulphides from limb regions into hinge regions of large-scale folds and is thus the most important for controlling the economics of Pb and Zn distribution. Two possible stages of hydrothermally driven re-mobilisation are discussed, each of which produces characteristically different alteration assemblages. Prograde hydrothermal re-mobilisation is driven by pyrite de-sulphidation and concurrent chlorite dehydration and is thus an internally driven process. At Montauban, the H₂S-rich fluid generated through this process allowed re-mobilisation of gold into the wall rock, where it was deposited in response to sulphidation of Fe Mg silicates. Retrograde hydrothermal re-mobilisation is an externally driven process, whereby large volumes of fluids from outside the deposit may dissolve and re-precipitate metals, and cause hydration of silicate minerals. This second hydrothermally driven process is not recognised at Montauban. Sulphide melting occurred as temperatures neared the peak metamorphic conditions. Melting initiated in the massive sulphides through arsenopyrite breakdown, and a small volume of melt was subsequently re-mobilised into the wall rock. Trace element partitioning and fractional crystallisation of this melt generated a precious metal-rich fractionate, which remained mobile until well after peak metamorphism. Thus, prograde hydrothermal re-mobilisation and sulphide melting were the most important mechanisms for controlling the distribution of Au and Ag.     

Experimental study of surface texture and resonance mechanism of booming sand

The sound-producing mechanism of booming sand has long been a pending problem in the blown sand physics. Based on the earlier researches, the authors collected some silent sand samples from Teng- ger Desert, Australian Desert, Kuwait Desert, beaches of Hainan Island and Japanese coast as well as the soundless booming sand samples from the Mingsha Mountain in Dunhuang to make washing ex- periments. In the meantime the chemical corrosion experiment of glass micro-spheres, surface coating experiment and SEM examination were also conducted. The experimental results show that the sound production of booming sand seems to have nothing to do with the presence of SiO2 gel on the surface of sand grains and unrelated to the surface chemical composition of sand grains but is related to the resonance cavities formed by porous (pit-like) physical structure resulting from a number of factors such as wind erosion, water erosion, chemical corrosion and SiO2 gel deposition, etc. Its resonance mechanism is similar to that of Hemholz resonance cavity. Under the action of external forces, nu- merous spherical and sand grains with smooth surface and porous surface are set in motion and rub with each other to produce extremely weak vibration sound and then become audible sound by human ears through the magnification of surface cavity resonance. However the booming sands may lose their resonance mechanism and become silent sand due to the damping action caused by the invasion of finer particles such as dust and clay into surface holes of sand grains. Therefore, clearing away fine pollutants on the quartz grain surface is an effective way to make silent sand emit audible sound.     

湘中锡矿山式锑矿成矿地质条件分析

湘中锡矿山式锑矿形成于晚白垩-古新世,空间上与岩脉关系密切,各锑矿床、矿化点都伴有或附近发育有煌斑岩及中-酸性岩脉群,在锑矿成矿同期地质事件中,还有周缘一些中-新生代红色盆地的形成及基性火山岩喷发,据之,提出湘中锡矿山式锑矿成矿与燕山晚期拉张构造-岩浆活化作用有关.锑矿床(点)基本上都产出于两组或两组以上断裂的交汇点附近,3组断裂的交汇部位对应于最主要的锑矿床(点).矿体具体受断裂交汇部位附近的次级短轴背斜轴部、倾伏背斜的倾伏端及其翼部被纵向陡倾角断裂构造所切穿的部位控制,是断裂导矿与背斜构造圈闭的体现.岩性组合控矿表现为易于硅化蚀变交代的砂质碳酸盐岩与隔挡层泥质岩所构成的岩性圈闭.根据包裹体均-温度和盐度测定成果,推算成矿压力为(200～300)×10⁵Pa,成矿深度约为1 km.     

721矿山南铀矿石微生物槽浸的适应性实验研究

以山南铀矿石为研究对象，探讨了微生物槽浸铀实验过程中有关参数（Fe^3 ,Fe^2 ,pH,Eh,U)的变化规律。在此基础上，评价了山南铀矿石微生物槽浸的适应性。     

地电提取测量法在北衙寻找隐伏矿的可行性

地电化学提取测量法是应生产需要而发展起来的一种轻便，快捷的寻找隐伏矿床的方法，在云南鹤庆县北衙地区进行实验研究，取得较好的效果，并在末知矿区圈定了远景规划区，为进一步探矿提供科学依据。     

渝东武隆上寒武统孔隙结构特征及成岩作用研究

渝东武隆上寒武统地层，储集空间以次生孔隙为主，包括晶间孔、晶间溶孔、粒内溶孔、粒间溶孔、铸模孔、溶洞、裂缝。成岩作用是影响储集性能的主要因素。研究区成岩作用，依据其对孔缝的影响，以及本组地层特征可分为建设性成岩作用和破坏性成岩作用两种类型，前者包括白云石化作用、溶蚀作用、破裂作用；后者包括胶结作用、压实压溶作用、充填作用。     

基于分形理论的航空图像分类方法

提出一种基于分形理论和BP神经网络的航空遥感图像有监督分类方法。该方法尝试将航空图像的光谱信息和纹理特征相结合。它首先将彩色航空图像由RGB格式转化为HSI格式，然后，根据亮度计算分数维、多重分形广义维数谱q-D(q)和“空隙”等基于分形的纹理特征，同时加入归一化的色度和饱和度作为光谱特征，采用BP神经网络作为分类器。通过对彩色航空图像的分类实验，结果证实该方法行之有效。     

灰岩成因-结构分类的进展及其相关问题讨论

由Folk在1959，1962年及Dunham在1962年所提出的灰岩因－结构分类体系，具有划时代的意义，至今还得到极为广泛的应用，Embry和Klovan在1971年关于生物礁灰岩的成因－结构分类，即关于骨架灰岩，障积灰岩，粘结灰岩的成因－结构分类的第一次重要的补充，它解决了与生物作用有关的灰岩不符合Folk和Dunham的结构成熟度概念的矛盾，而对成岩作用及其产物的更深入研究，地质学家们发现了许多布成岩作用形成的泥晶化作用和颗粒化作用，由它们所形成的岩石也不符合Folk和Dunbam的结构成熟度概念，导致了Wright在1992年提出了一个更完整的灰岩成因－结构分类体系，把灰岩分为生物作用类，沉积作用类及成岩作用类三大类，即Folk和Dumban描述的分类均属于沉积作用类。要特别指出的是，在从松散沉积物到已石化的竖硬石头的成岩过程中，不但灰岩的结构会发生变化，而且组分也会发生变化，从而使灰岩的成因－结构分类变得更加复杂，关于这方面还存在许多有待进一步研究的问题。在审视Wright在1992年的分类体系时，有必要在沉积作用类中增加“非正常沉积作用亚类灰岩”，针对许多非礁相地层中发育的由生物礁岩石构成的生物层及生物丘，因而有必要对生物作用灰灰岩进行更进一步的分类。     

胶东海阳所堆积辉长岩的变质反应结构、石榴石形成及P—T演化

海阳所堆积辉长岩由橄长岩、橄榄辉长岩和辉长岩组成。在橄长岩和橄榄辉长岩中发育有典型的变质反应结构：主要为橄榄石与斜长石之间形成由斜方辉石、尖晶石、角闪石和石榴石等矿物组成的多期次次变边，并有三个不同世代变质矿物，早期Cpx＋Opx＋Spl，中期Amp，晚期Grt；期次是钛铁矿与斜长石之间形成石榴石次变边，相对比较简单，只有一个世代变质矿物，为Grt＋Amp＋Rut或Grt＋Rut岩中石榴石是通过斜长石与角闪石或斜长石与钛铁矿之间的变质反应形成的，虽为峰值变质作用的产物，但变质反应的期次及类型不同导致了所形成石榴石的温度和压力有所不同。堆积辉长岩形成演化的温压计算表明，堆积辉长岩在经过近等压降温的岩浆作用之后的变质作用早期，仍为近等压降温，而晚期则表现为近等温升压。这一特殊的P－T演化可能反映了堆积辉长冷侵位与深俯冲特征。