我国西北地区21世纪季节气候变化情景分析

使用各国政府间气候变化专门委员会(IPCC)数据分发中心提供的7个全球海气耦合气候系统模式(CCC、CCSR、CSIRO、DKRZ、GFDL、HADL、NCAR)的模拟结果,对我国西北地区未来21世纪考虑温室气体增加(GG)和温室气体与硫化物气溶胶共同影响(GS)时,冬夏季的气候变化情景进行了分析.模式集成结果分析表明,我国西北地区的变暖趋势与全球、东亚和中国一致,但变暖幅度明显高于全球、东亚和中国.对未来100年各个季节线性倾向的分析表明,西北地区GG和GS时都是冬季变暖最大,可高达5～8℃/100a,且整个西北地区中新疆地区为最大变暖区.21世纪由于人类活动,西北地区最低温度和最高温度都将明显升高,其线性趋势可达4～6℃/100 a.由于全球气候模式对区域尺度的模拟存在较大的不确定性,未来需要作更多的深入研究.     

PETROLEUM GEOLOGY

正20140890 Bai Ru(National Key Laboratory of Continental Dynamics,Department of Geology,Northwest University,Xi’an 710069,China);Zhang Jingong Characteristics of Pore Character and Its Controls of Chang 6Reservoir of Zhiluo Oilfield(Journal of Northwest University,ISSN1000-274X,CN61-1072/N,     

热带气旋直接降水对中国的影响研究

本文基于RSMC台风最佳路径资料以及TRMM逐日降水资料,对1998—2013年间中国区域热带气旋(TC)直接降水的时空分布特征进行了统计研究。结果表明:约54.2%的西北太平洋TC在中国陆地上产生了直接降水。TC直接降水对中国的影响范围较广,未变性TC的降水决定了全部TC降水的西界,而潜在变性TC的降水决定了全部TC降水的北界。自每年的4月开始,TC直接降水开始影响中国,以8月最为频繁,潜在变性TC的影响以9月为最。降水首日,全体TC以台风及以上强度为主,中心主要分布在30°N以南。未变性的TC强度较弱,降水面积大、降水强度强;而潜在变性TC则以台风(TY)及以上强度为主,其单个TC的平均降水面积和降水强度以热带低压(TD)及以下强度TC为最大。本文工作为TC在中国直接降水的气候特征以及TC变性前期降水分布特征提供了一些有意义的结论。     

香格里拉旅游气候的适宜度

利用云南省农业气候资料,采用了旅游舒适度指标,对香格里拉腹地中甸县的旅游气候进行分析,认为该地夏季最适于开展旅游活动,春季和秋季为次适于开展旅游活动,并提出发展旅游业应注意的气候问题     

低水位体系域在地质学上的意义——以赣西北地区为例

低水位体系域在层序地层中是一种很重要的海退式层序单元,沉积作用颇具特色,它是指示地层划分与对比,岩相,构造古地理,板块活动的良好标志。     

天文准19年周期与西北降水

从天体运行周期角度分析发现,月亮等天体运行存在显著的准１９年周期。相应对年际气候变化有重要影响的厄尔尼诺事件也有准１９年周期,每１９年出现４～５个厄尔尼诺事件。在月赤纬最大值谷点年附近,西北区容易出现春旱;在月赤纬最大值峰点年附近,西北区春雨正常偏多     

Ophiuroid fauna of cobalt-rich crust seamounts in the Northwest Pacific Ocean

Seamounts are vulnerable ecosystems in the deep sea and can be heavily impacted by human activities, such as bottom fishing and deep-sea mining. The species composition and distribution patterns of benthic fauna is key information for the designation of marine protected areas and environmental management plans. Three contracts for cobalt-rich crust exploration have been granted to China, Japan and Korea in the Northwest Pacific Ocean by the International Seabed Authority. However, our knowledge of benthic biodiversity in this area is extremely insufficient. During 2013–2020, eight Chinese Ocean Mineral Resources R&D Association (COMRA) cruises were conducted to investigate the benthic assemblages of nine seamounts in this region. In this study, 191 ophiuroids collected from seamounts in the Northwest Pacific were identified into 29 species in 11 families. Ophiacanthidae and Euryalidae were the two most dominant families with 12 and 6 species, respectively. Ophiotomidae and Ophiopyrgidae were represented by two species each, while seven families were represented by only one species. Four species were widely distributed among 4–5 seamounts, and 17 species were found only at a single site. An integrated regional taxonomic dataset of Ophiuroidea was generated and analyzed. A total of 23 and 14 species were obtained from the Magellan Seamount Chain (MSC) and the Marcus-Wake seamounts (MWS), respectively, with 8 species shared between the two seamount groups. The individual-based rarefaction curves did not reach an asymptote, suggesting that the sampling effort was inadequate for either the entire region or each single seamount. Most species distributed in a narrow depth range, and the species composition was different between water depths above and below 2000 m. Our results greatly improve the understanding of megafaunal biodiversity from seamounts in the Northwest Pacific Ocean, and highlight the necessity of further surveys to provide more robust information for environmental protection and management in this region.     

An exploration of potential raw materials for prehistoric pottery production in the Tao River Valley,Gansu Province,China

Northwest China is known for its Majiayao-style Neolithic painted pottery which has received much praise for its high level of craftsmanship, yet its chain of production, in particular the step of raw material selection, is still poorly understood. To fill this lacuna, the present study explores the raw materials used in producing these wares from a geological and technological perspective. At its core stands the first geoarchaeological survey conducted around the eponymous site of Majiayao which collected 47 samples of raw materials suitable for ceramic production including clay, loess and rocks, which were all analysed macroscopically. A selection was analysed using thin-section petrography, and a subset of the clay and loess samples were subjected to firing experiments. Additionally, three clay samples were analysed by scanning electron microscope with energy-dispersive X-ray spectrometer to understand their composition and behaviour in ceramic production. These were then compared to archaeological ceramics, thus providing insights into raw-material availability and selection that will be of importance not only for research on Majiayao-style pottery but also for later-period ceramics produced in the area. This research shows how an archaeologically informed geological survey can contribute insights into human–environment interaction in early pottery production, especially the interplay between raw-material availability, technological know-how and potters' choices.     

Influence of natural fractures on gas accumulation in the Upper Triassic tight gas sandstones in the northwestern Sichuan Basin,China

The Upper Triassic Xujiahe Formation in the northwestern Sichuan Basin, China, is a typical tight gas sandstone reservoir that contains natural fractures and has an average porosity of 1.10% and air permeability less than 0.1 md because of compaction and cementation. According to outcrops, cores and image logs, three types of natural fractures, namely, tectonic, diagenetic and overpressure-related fractures, have developed in the tight gas sandstones. The tectonic fractures include small faults, intraformational shear fractures and horizontal shear fractures, whereas the diagenetic fractures mainly include bed-parallel fractures. According to thin sections, the microfractures also include tectonic, diagenetic and overpressure-related microfractures. The diagenetic microfractures consist of transgranular, intragranular and grain-boundary fractures. Among these fractures, intraformational shear fractures, horizontal shear fractures and small faults are predominant and significant for fluid movement. Based on the Monte Carlo method, these intraformational shear fractures and horizontal shear fractures improve the reservoir porosity and permeability, thus serving as an important storage space and primary fluid-flow channels in the tight sandstones. The small faults may provide seepage channels in adjacent layers by cutting through layers. In addition, these intragranular and grain-boundary fractures increase the connectivity of the tight gas sandstones by linking tiny pores. The tectonic microfractures improve the seepage capability of the tight gas sandstones to some extent. Low-dip angle fractures are more abundant in the T₃X³ member than in the T₃X² and T₃X⁴ members. The fracture intensities of the sandstones in the T₃X³ member are greater than those in the T₃X² and T₃X⁴ members. The fracture intensities do not always decrease with increasing bed thickness for the tight sandstones. When the bed thickness of the tight sandstones is less than 1.0 m, the fracture intensities increase with increasing bed thickness in the T₃X³ member. Fluid inclusion evidence and burial history analysis indicate that the tectonic fractures developed over three periods. The first period was at the end of the Triassic to the Early Jurassic. The tectonic fractures developed during oil generation but before the matrix's porosity and permeability reduced, which suggests that these tectonic fractures could provide seepage channels for oil migration and accumulation. The second period was at the end of the Cretaceous after the matrix's porosity and permeability reduced but during peak gas generation, which indicates that gas mainly migrated and accumulated in the tectonic fractures. The third period was at the end of the Eogene to the Early Neogene. The tectonic fractures could provide seepage channels for secondary gas migration and accumulation from the Upper Triassic Xujiahe Formation into the overlying Jurassic Formation.