沸石强化过滤的中试及生产性试验研究

对新型水处理材料沸石强化常规给水处理工艺进行了中试和生产性试验,并与石英砂滤料做了对比.中试结果表明粒径为0.80-1.20mm沸石对浊度、氨氮、有机物都表现出良好的去除效果,过滤时的水头损失、反冲洗强度明显小于石英砂,不仅能满足反冲洗要求,还可节省反冲洗水量,降低运行成本.在生产性试验条件下,沸石对浊度、氨氮、耗氧量的去除率分别为95%、83%和39%.因此,在当前水源水遭到污染的情况下,用沸石替代石英砂滤料可明显改善水质,在不增加处理构筑物的情况下,对给水处理工艺可起到强化作用     

南黄海表层沉积物天然湿容重和含水量的分布及其与粒度之间的关系

本文论述了南黄海表层沉积物天然湿容重和含水量的分布,并利用回归分析的方法讨论了容重和含水量与粒度之间的关系。结果表明,容重和含水量与粘土粒级相关性最好,容重与粘土粒级含量(相似文献   

山东近海牙鲆(Paralichthys olivaceus)自然和养殖群体10个微卫星基因座位的遗传多态性分析

采用微卫星遗传标记技术对山东近海牙鲆自然群体和养殖群体的遗传多样性进行了研究。实验所用牙鲆于2003年5月分别采自山东近海和青岛胶南养鱼场，各20尾，取全血或肌肉组织，以酚-仿抽提方法提取基因组DNA，利用筛选获得的10对微卫星引物进行PCR扩增，反应产物经8％非变性聚丙烯酰胺凝胶电泳分离、EB显色，用ImageMasterl D Elite(Version 3．01)软件分析电泳结果，并计算了相应的遗传学参数。结果表明，在自然和养殖群体中，10个基因座位的等位基因平均数(α)分别为6．7和6．1，每个基因座位有效等位基因数(αe)分别为1．8—6．8和2．5—6．7，群体平均杂合度(H)分别为0．8120和0．7310；两个群体间的遗传相似性系数、遗传距离和基因分化系数为0．8558、0．1557和0．0558；自然群体内每个座位上的多态信息含量(PIC)为0．59—0．84、个体识别率(DP)为0．54—0．86、非父排除率(PPE)为0．41—0．72，其累积个体识别率和非父排除率均达到0．9999，表明所选座位属中高识别力的遗传标记，可以将它们应用于今后牙鲆雌核发育群体的遗传变异分析以及进一步的遗传育种的研究中。     

太平洋西部3个岩芯沉积物的粒度组成及其天然湿容重和含水量的变化

本文讨论了太平洋西部3个岩芯孔的粒度组成、天然湿容重和含水量的变化。沉积物组成以粉砂和粘土细粒为主,砂粒含量很少,而且多为有孔虫介壳。容重与沉积物粒度呈正相关,含水量则呈负相关。当粒度组成不变时,容重随岩芯埋藏深度的增加而增大,而含水量则减少。     

An alternative approach to the structural motion analysis of wedge-beam offshore structures supporting a load

For convenience of dynamic analysis, some offshore structures such as fixed-type platforms are often modeled as the wedge beams supporting tip lumped masses. It is well-known that, due to the effect of the surrounding water, the natural frequencies of a beam in air (or dry beam) are different from those of the same beam immersed in water (or wet beam). However, if the natural frequencies and the associated mode shapes of a dry beam are calculated by taking account of the “added mass” for the immersed beam, then the last natural frequencies and mode shapes will be equal to the corresponding ones of the wet beam. Based on the last concept, the closed form solutions for natural frequencies and the associated mode shapes of the dry beam were determined first, then the partial differential equation of motion for the wet beam was transformed into a matrix equation by using the expansion theorem and the foregoing closed form solutions of free vibration responses for the dry beam. Solving the last matrix equation will give the required natural frequencies and the associated mode shapes of the wet beam. The formulation of this paper is available for the fully or partially immersed double tapered beams with either circular, square or rectangular cross-sections. The taper ratio for width and that for depth may be equal or unequal. The numerical results of this paper were compared with the existing results or the finite-element-method results and good agreement was achieved.     

Catch-quota balancing in multispecies individual fishing quotas

Individual fishery quotas (IFQs) are an increasingly prevalent form of fishery management around the world, with more than 170 species currently managed with IFQs. Yet, because of the difficulties in matching quota holdings with catches, many argue that IFQs are not appropriate for multispecies fisheries. Using on-the-ground-experience with multispecies IFQ fisheries in Iceland, New Zealand, Australia, and Canada, we assess the design and use of catch-quota balancing mechanisms. Our methodology includes a mix of interviews with fishery managers, industry representatives, and brokers, literature review, and data analysis. We find that a combination of incentives and limits on use rates for the mechanisms provide sufficient flexibility to the quota owner without the fishery manager incurring excessive levels of overexploitation risk. Contrary to some opinions, these programs are evidence that it is possible to implement IFQ programs for multispecies fisheries and that they can be profitable and sustainable.     

Determination of cadmium(II), copper(II), manganese(II) and nickel(II) species in Antarctic seawater with complexing resins

The strong species of cadmium(II), copper(II), manganese(II) and nickel(II) in an Antarctic seawater sample are investigated by a method based on the sorption of metal ions on complexing resins. The resins compete with the ligands present in the sample to combine with the metal ions. Two resins with different adsorbing strengths were used. Very stable metal complexes were investigated with the strong sorbent Chelex 100 and weaker species with the less strong resin, Amberlite CG-50. Strong species were detected for three of the considered metal ions, but not for Mn(II). Cu(II) is completely linked to species with a side reaction coefficient as high as log α_M(I) = 11.6 at pH = 7.3. The ligand concentration was found to be similar to that of the metal ion, and the conditional stability constant was around 10²⁰ M^− 1. In the considered sample, only a fraction of the metal ions Cd(II) and Ni(II) is bound to the strong ligands, with side reaction coefficients equal to log α_M(I) = 5.5 and 6.5 at pH = 7.3 for Cd(II) and Ni(II), respectively. These findings were confirmed by the test with the weaker sorbent Amberlite CG-50. It can be calculated from the sorption equilibria that neither Mn(II) nor Ni(II) is adsorbed on Amberlite CG-50 under the considered conditions and, in fact, only a negligible fraction of Mn(II) and Ni(II) was adsorbed. A noticeable fraction of Cd(II) was adsorbed on Amberlite CG-50, meaning that cadmium(II) is partially linked to weak ligands, possibly chloride, while no copper(II) was adsorbed on this resin, confirming that copper(II) is only combined in strong species. These results are similar, but not identical, to those obtained for other seawater samples examined in previous investigations.     

Coping with disaster: Rehabilitating coastal livelihoods and communities

This paper examines lessons from past approaches to natural disasters, as well as early lessons from the post-2004 Asian tsunami rehabilitation, to draw out general principles for rehabilitating livelihoods in poor coastal communities. We contend that avoiding the mistakes of the past requires: (1) a framework for understanding the diversity of coastal people's livelihood strategies and the sources of their vulnerability, (2) a process for designing interventions that build on this understanding in order to strengthen and revitalize coastal communities, including a means of assessing and selecting the most promising livelihood options, and (3) a focus on the longer-term challenge of building future resilience and sustainability in the communities by addressing the root causes of vulnerability.     

沸石基储能基元的研究

以酸活化沸石为载体,十二醇为储能工质.制备沸石基储能基元,并采用X射线衍射、红外光谱和差示扫描量热等对沸石基储能基元进行表征.结果表明:储能基元在2θ=22.50时的衍射峰变强,相变储能材料十二醇和沸石栽体之间仅仅是简单的嵌合关系.储能基元的相变温度有一定的降低,并且熔融峰变宽.     

Effect of some additives on synthesis of zeolite from coal fly ash

Hydrothermal conversion of fly ash into zeolites was conducted and the effects of the addition of sodium halide and waste solutions produced after zeolitization of fly ash, as well as the adjustment of the Si/Al ratio prior to synthesis process on the formation and cation exchange capacity (CEC) of zeolite product were evaluated. Both the addition of NaCl and NaF ameliorated the crystallinity and CEC of synthesized zeolite, but NaF had a better improvement effect. Na⁺ was considered to enhance the crystallization of zeolite, while F⁻ favored the dissolution of fly ash. The type of zeolite formed depended on the Si/Al ratio of the starting material prior to the nucleation and crystallization of zeolite. The adjustment of the Si/Al ratio of fly ash by addition of Na₂SiO₄ and Al(OH)₃ changed the type and CEC of zeolite. Waste solutions contained large amount of Si and little Al due to the formation of a zeolite named NaP1 in zeolite terminology with the Joint Committee of Powder Diffraction Standard (JCPDS) code of 39-0219. The alkalinity decreased largely. As a result, the CEC value of zeolite products synthesized with waste solution as alkali source decreased. The supplementation of new alkali to adjust the alkalinity of waste solution could enhance the CEC of synthesized product. It was concluded that: (1) addition of sodium halide and adjustment of the Si/Al ratio prior to synthesis can improve the quality of zeolite; (2) waste solutions produced following the zeolitization of fly ash can be reused as an alkali source in the activation of fly ash; zero-emission of waste solution in the synthesis of zeolite from fly ash is possible.