3D gravity modelling for Anyongbok Seamount in the East Sea

A seamount chain with an approximately WNW trend is observed in the northeastern Ulleung Basin. It has been argued that these seamounts, including two islands called Ulleung and Dok islands, were formed by a hotspot process or by ridge related volcanism. Many geological and geophysical studies have been done for all the seamounts and islands in the chain except Anyongbok Seamount, which is close to the proposed spreading ridge. We first report morphological characteristics, sediment distribution patterns, and the crustal thickness of Anyongbok Seamount using multibeam bathymetry data, seismic reflection profiles, and 3D gravity modeling. The morphology of Anyongbok Seamount shows a cone shaped feature and is characterized by the development of many flank cones and flank rift zones. The estimated surface volume is about 60 km³, and implies that the seamount is smaller than the other seamounts in the chain. No sediments have been observed on the seamount except the lower slope, which is covered by more than 1,000 m of strata. The crustal structure obtained from a 3D gravity modeling (GFR = 3.11, SD 3.82 = mGal) suggests that the seamount was formed around the boundary of the Ulleung Plateau and the Ulleung Basin, and the estimated crustal thickness is about 20 km, which is a little thicker than other nearby seamounts distributed along the northeastern boundary of the Ulleung Basin. This significant crustal thickness also implies that Anyongbok Seamount might not be related to ridge volcanism.     

Spatial variability in the partial pressures of CO2 in the northern Bering and Chukchi seas

In the summers of 1999 and 2003, the 1st and 2nd Chinese National Arctic Research Expeditions measured the partial pressure of CO₂ in the air and surface waters (pCO₂) of the Bering Sea and the western Arctic Ocean. The lowest pCO₂ values were found in continental shelf waters, increased values over the Bering Sea shelf slope, and the highest values in the waters of the Bering Abyssal Plain (BAP) and the Canadian Basin. These differences arise from a combination of various source waters, biological uptake, and seasonal warming. The Chukchi Sea was found to be a carbon dioxide sink, a result of the increased open water due to rapid sea-ice melting, high primary production over the shelf and in marginal ice zones (MIZ), and transport of low pCO₂ waters from the Bering Sea. As a consequence of differences in inflow water masses, relatively low pCO₂ concentrations occurred in the Anadyr waters that dominate the western Bering Strait, and relatively high values in the waters of the Alaskan Coastal Current (ACC) in the eastern strait. The generally lower pCO₂ values found in mid-August compared to at the end of July in the Bering Strait region (66–69°N) are attributed to the presence of phytoplankton blooms. In August, higher pCO₂ than in July between 68.5 and 69°N along 169°W was associated with higher sea-surface temperatures (SST), possibly as an influence of the ACC. In August in the MIZ, pCO₂ was observed to increase along with the temperature, indicating that SST plays an important role when the pack ice melts and recedes.     

Design of a 3D Chirp Sub-bottom Imaging System

Chirp sub-bottom profilers are marine acoustic devices that use a known and repeatable source signature (1–24 kHz) to produce decimetre vertical resolution cross-sections of the sub-seabed. Here the design and development of the first true 3D Chirp system is described. When developing the design, critical factors that had to be considered included spatial aliasing, and precise positioning of sources and receivers. Full 3D numerical modelling of the combined source and receiver directivity was completed to determine optimal source and receiver geometries. The design incorporates four source transducers (1.5–13 kHz) that can be arranged into different configurations, including Maltese Cross, a square and two separated pairs. The receive array comprises 240 hydrophones in 60 groups whose group-centres are separated by 25 cm in both horizontal directions, with each hydrophone group containing four individual elements and a pre-amplifier. After careful consideration, it was concluded that the only way to determine with sufficient accuracy the source–receiver geometry, was to fix the sources and receivers within a rigid array. Positional information for the array is given by a Real Time Kinematic GPS and attitude system incorporating four antennas to give position, heading, pitch and roll. It is shown that this system offers vertical positioning accuracy with a root-mean-square (rms) error less than 2.6 cm, while the horizontal positioning rms error was less than 2.0 cm. The system is configured so that the Chirp source signature can be chosen by software aboard the acquisition vessel. The complete system is described and initial navigational and seismic data results are presented. These data demonstrate that the approach of using fixed source-receiver geometry combined with RTK navigation can provide complete 3D imaging of the sub-surface.     

Variability of organic δC and C/N in the Mersey Estuary, U.K. and its implications for sea-level reconstruction studies

Microfossil analysis (e.g. diatoms, foraminifera and pollen) represents the cornerstone of Holocene relative sea-level (RSL) reconstruction because their distribution in the contemporary inter-tidal zone is principally controlled by ground elevation within the tidal frame. A combination of poor microfossil preservation and a limited range in the sediment record may severely restrict the accuracy of resulting RSL reconstructions. Organic δ¹³C and C/N analysis of inter-tidal sediments have shown some potential as coastal palaeoenvironmental proxies. Here we assess their viability for reconstructing RSL change by examining patterns of organic δ¹³C and C/N values in a modern estuarine environment. δ¹³C and C/N analysis of bulk organic inter-tidal sediments and vegetation, as well as suspended and bedload organic sediments of the Mersey Estuary, U.K., demonstrate that the two main sources of organic carbon to surface saltmarsh sediments (terrestrial vegetation and tidal-derived particulate organic matter) have distinctive δ¹³C and C/N signatures. The resulting relationship between ground elevation within the tidal frame and surface sediment δ¹³C and C/N is unaffected by decompositional changes. The potential of this technique for RSL reconstruction is demonstrated by the analysis of part of an early Holocene sediment core from the Mersey Estuary. Organic δ¹³C and C/N analysis is less time consuming than microfossil analysis and is likely to provide continuous records of RSL change.     

添加纳米TiO2的氯醚树脂的XPS分析

在紫外线老化前后,利用光电子能谱(XPS)研究了分别添加金红石型和锐钛型纳米TiO2的氯醚树脂。研究发现,氯醚树脂中氯、氧元素具有表面富积现象——趋肤效应,而钛和碳元素在内层聚集;添加颜料粒子越小,在表面含量越大;金红石型纳米二氧化钛紫外屏蔽性好,减缓树脂老化;而锐钛型纳米二氧化钛具有显著的光催化活性,加速树脂老化。因此,金红石型纳米二氧化钛将是一种有前途的紫外线吸收剂。     

Comparison of two three-dimensional hydrodynamic modeling systems for coastal tidal motion

A comparison of two three-dimensional numerical modeling systems for tidal elevations and velocities in the coastal waters is presented. The two modeling systems are: (1) the Princeton Ocean Model (POM) and (2) the MIKE 3 flow model. The model performance results for Singapore's coastal waters show that the predicted tidal elevations from the two hydrodynamic modeling systems are almost identical and are in very good agreement with field measurement data. The simulated tidal current velocities match well with field measurement data at the selected stations, but it seems that the POM provides the slightly better simulation, compared to the MIKE 3 flow model. The depth profiles of the velocities obtained from the two modeling systems may be greatly different at some time, due to the vertical diffusion coefficient calculated from different turbulent sub-models in the two modeling systems. The POM generally predicts larger peak tidal velocities. The maximum speed differences for the model results from the two modeling systems occur in the top and differ from time to time and from location to location, reaching up to 20%.     

不同生长期坛紫菜多糖中组分含量的变化

于１９９０－１９９１年，运用＾１３Ｃ－ＮＭＲ和化学分析方法研究南方产和移植北方养殖的不同生长发育阶段坛紫菜多糖的组分变化，结果表明，随着藻体生长发育，坛紫菜琼胶中３，６－内醚－Ｌ－半乳糖和６－ＯＣＨ３－Ｄ－半乳糖的含量逐渐增加，而硫酸基的含量呈现先增加后减少的规律；北移坛紫菜琼胶中３，６－内醚－Ｌ－半乳糖的含量高于南方坛紫菜，而硫酸基和６－ＯＣＨ３－Ｄ－半乳糖的含量低于南方坛紫菜。     

氨基酸在粘土高岭石上吸附等温线的研究

研究了4种氨基酸（甘氨酸，赖氨酸，天冬氨酸，谷氨酸）在粘土高岭石上的吸附等温线以及金属铜离子对其等温线的影响。研究表明，氨基酸在高岭石上的吸附等温线以及金属铜离子存在时的吸附等温线均属Langmuir型等温线；铜离子浓度增加时，其等温线斜率也增加，并认为体系可形成Ⅰ型三元表面络合物，铜离子对氨基酸在高岭石上等温线影响的规律和在相同体系中它对氨基酸在高岭石上交换吸附百分率E（%）-pH曲线的影响规律相一致。     

LAPP对中国对虾(Penaeus chinensis)生长、缺氧耐受力及免疫抵抗力的影响

实验研究维生素C多聚磷酸酯（LAPP）添加在对虾饲料中，对中国对虾的生长、缺氧耐受力及免疫抵抗力的影响；实验进一步证明了中国对虾饲料中LAPP的最适添加量为400mg／100g饲料;本文还提出饲料中的LAPP能够提高中国对虾的缺氧耐受力，在溶氧超过3．1mg／kg海水的情况下，效果显著，在降低到2．3mg／kg海水时，作用减弱；用副溶血弧菌（Vibroparahaemolyticus）注射入虾体内，12小时内记录发现，饲料中不含LAPP的一组中国对虾，死亡率高于其它组，并且，LAPP含量最高的一组，死亡率明显低，死亡时间也出现较晚，这证明LAPP能够提高中国对虾的免疫抵抗力；本实验用注射金黄色葡萄球菌后细胞的吞噬百分率作指标，研究对虾细胞的吞噬作用，发现饲料中不含LAPP的对虾的吞噬百分率较低，随着饲料中LAPP浓度的提高，对虾血细胞的吞噬百分率逐渐升高，说明中国对虾细胞的吞噬作用逐步增强。