Geometry and accuracy of reflecting points in bistatic satellite altimetry

The analysis of the time and space distribution of specular (reflecting) points in bistatic altimetry between GPS and CHAMP satellites or SAC-C (taken as examples) is extended from Wagner and Klokočník (2003 J. Geod 77: 128–138). We demonstrate a significantly higher number and density of reflecting points in bistatic altimetry in comparison with traditional monostatic altimetry. After an outline of our older accuracy assessment for the vertical position of the reflecting point, we add a new independent derivation and compare both approaches. We account for orbit errors of both the transmitters (GPS) and receiver (CHAMP) satellites, and the measurement (delay) error. We found that the accuracy of the vertical position of the reflecting point decreases only slowly with increasing off-nadir angle and that the orbit errors must be accounted for if decimeter and better accuracy is required. In this paper, we do not study errors such as state of the ocean, technical parameters of the receiving system, and atmospheric corrections.     

Outlier detection algorithms and their performance in GOCE gravity field processing

The satellite missions CHAMP, GRACE, and GOCE mark the beginning of a new era in gravity field determination and modeling. They provide unique models of the global stationary gravity field and its variation in time. Due to inevitable measurement errors, sophisticated pre-processing steps have to be applied before further use of the satellite measurements. In the framework of the GOCE mission, this includes outlier detection, absolute calibration and validation of the SGG (satellite gravity gradiometry) measurements, and removal of temporal effects. In general, outliers are defined as observations that appear to be inconsistent with the remainder of the data set. One goal is to evaluate the effect of additive, innovative and bulk outliers on the estimates of the spherical harmonic coefficients. It can be shown that even a small number of undetected outliers (<0.2 of all data points) can have an adverse effect on the coefficient estimates. Consequently, concepts for the identification and removal of outliers have to be developed. Novel outlier detection algorithms are derived and statistical methods are presented that may be used for this purpose. The methods aim at high outlier identification rates as well as small failure rates. A combined algorithm, based on wavelets and a statistical method, shows best performance with an identification rate of about 99%. To further reduce the influence of undetected outliers, an outlier detection algorithm is implemented inside the gravity field solver (the Quick-Look Gravity Field Analysis tool was used). This results in spherical harmonic coefficient estimates that are of similar quality to those obtained without outliers in the input data.     

World-wide synthetic tide parameters for gravity and vertical and horizontal displacements

The response of the Earth’s crust to the direct effect of lunisolar gravitational forcing is known as the body tide. The body tide is superimposed by surface-loading forces due to the pressure of the periodically varying ocean tide acting on the Earth, called ocean tide loading (OTL). Both body tide and OTL can be decomposed into components of the same frequency known as tidal parameters. However, OTL is more complicated than body tides because of the dynamic effects of the ocean. Estimating OTL requires a model of the ocean tides and knowledge of the elastic properties of the solid Earth. Thus, synthetic tide parameters (amplitude factors and phase leads) have been developed here on a world-wide grid for gravity and positional displacements. The body tide contributions were added to the oceanic contribution to provide the Earth tide response. The accuracy and reliability of the synthetic tidal parameters have been estimated by comparing observed gravity and vertical-displacement tide parameters with those interpolated from our synthetic model, which shows good agreement. Tests also indicate that the synthetic tide parameters provide realistic gravimetric and displacements for practical use in tidal prediction.     

近百年中国东部夏季降水的时空变率

利用中国东部25°N以北28个站1880-1999年夏季季降水序列,用旋转复经验正交函数（RCEOF）方法,研究了中国东部地区百年干湿的时空演变规律。结果表明,夏季降水空间变率大值区依次为:长江中下游地区、淮河流域、江南、华北、西南及东北。除西南外的5个关键区大体上反映了从6月到8月夏季雨带自南向北椎进所滞留的地区。旋转空间位相分布揭示了长江中下游地区、江南、东北的旱涝异常主要表现为驻波振动特征;而淮河流域、华北、西南地区显示出降水异常信号具有部分的行波特征。尤其第4空间模显示出旱涝异常信号从东北南部可沿着黄淮下游传到长江下游地区。对于近百年中国东部地区夏季于湿变化,长江中下游地区、淮河流域、华北及东北四个地区都存在20-25年时间尺度的周期振荡;长江中下游地区及华北地区都存在准60年时间尺度的振荡周期;东北地区主要表现出36年时间尺度的振荡周期;淮河流域存在明显的70-80年时间尺度的振荡周期;华北地区存在的11年时间尺度的振荡周期恰好与太阳黑子活动的11年周期相一致。在年代际时间尺度（包括次年代际时间尺度）上,长江中下游、淮河流域及华北地区的夏季降水的变化与太阳活动有显著的正相关。     

油田污水中Fe2+,S2-,DO及pH值对HPAM-酚醛CDG成胶性能影响的研究

在对河南油田双河矿区油田污水进行全分析的基础上，研究了污水中Fe^2 ,S^2-，溶解氧（DO）及污水的pH值对有机交联体系聚丙烯酰胺（HPAM）－酚醛胶态分散凝胶（CDG）成胶性能的影响。研究结果表明，Fe^2 ,S^2－，DO及污水的pH值对HPAM－酚醛体系的成胶性能都有影响当ρ（Fe^2 )=1.6mg/L,ρ（S^2-)=0.1mg/L,ρ（DO）=1.6mg/L，HPAM－酚醛体系就不能成胶；随着污水pH值的增大，CDG强度变弱。     

安庆铜矿综合治水工程及其评价

介绍安庆铜矿矿山的生产及水文地质概况，指出矿山生产中存在的水文地质、环境地质等问题，提出总体治理方案和实施措施，对治水工程进行了综合评价。     

基于GM(1,1)优化模型的岩石边坡变形预报

岩石边坡系统是一典型灰色系统，其变形发展过程可以用灰色预测模型完成。尽管传统GM（1，1）模型预测有很多成功的实例，但是也存在一些预测偏差过大的情况，必须对其进行优化。逐步迭代法GM（1，1）模型不仅收敛速度快，而且与原始数据库序列的凹凸性保护一致。利用自编的计算程序对马步坎边坡预测测点G1沉降和开裂进行预测分析，结果表明逐步迭代法GM（1，1）优化模型计算精度较传统GM（1，1）模型和背景构造法GM（1，1）优化模型高，较好地反映了岩石边坡的变形趋势。     

Multi‐objective optimal design of FLC driven hybrid mass damper for seismically excited structures

Structural vibration control using active or passive control strategy is a viable technology for enhancing structural functionality and safety against natural hazards such as strong earthquakes and high wind gusts. Both the active and passive control systems have their limitations. The passive control system has limited capability to control the structural response whereas the active control system depends on external power. The power requirement for active control of civil engineering structures is usually quite high. Thus, a hybrid control system is a viable solution to alleviate some of the limitations. In this paper a multi‐objective optimal design of a hybrid control system for seismically excited building structures has been proposed. A tuned mass damper (TMD) and an active mass driver (AMD) have been used as the passive and active control components of the hybrid control system, respectively. A fuzzy logic controller (FLC) has been used to drive the AMD as the FLC has inherent robustness and ability to handle the non‐linearities and uncertainties. The genetic algorithm has been used for the optimization of the control system. Peak acceleration and displacement responses non‐dimensionalized with respect to the uncontrolled peak acceleration and displacement responses, respectively, have been used as the two objectives of the multi‐objective optimization problem. The proposed design approach for an optimum hybrid mass damper (HMD) system, driven by FLC has been demonstrated with the help of a numerical example. It is shown that the optimum values of the design parameters of the hybrid control system can be determined without specifying the modes to be controlled. The proposed FLC driven HMD has been found to be very effective for vibration control of seismically excited buildings in comparison with the available results for the same example structure but with a different optimal absorber. Copyright © 2002 John Wiley & Sons, Ltd.     

滇西北地区富碱岩体(脉)地质学及岩石化学特征

喜山期富碱岩体广布于滇西北地区 ,通过对其地质学和岩石化学特征的研究 ,认为富碱岩体 (脉 )由正长 (斑 )岩、二长斑岩、花岗斑岩及相关的火山岩组成 ,具有多次活动的特征 ,并形成区内富有特色的岩浆岩系列 ;该系列岩浆岩以富碱高钾为突出特点 ,具有正常的岩浆演化趋势 ,不同岩带岩石地质学和岩石化学方面有区域性变化规律。     

A multi-scale study on land use and land cover quality change: The case of the Yellow River Delta in China

This paper presents a case study of the Yellow River Delta in China, to trace land use and land cover changes during the past 20 years, with an emphasis on land quality changes. Three sets of data are used in this case study: remote sensing data derived from satellite images; crop yield data from statistics; and soil data collected by the researchers in the field. Our study reveals that at the regional scale, LUCC has taken place in a positive direction: vegetation cover has been expanding and crop yields per hectare have been on rise. However, while the overall eco-environment has improved, the improvement is uneven across the Delta region. At local levels, some areas show signs of increased salinization and declining organic content. Both natural forces and human activities are responsible for the LUCC, but human activities play a more important role. While some impacts of human activities are positive, the damages are often long-lasting and irreversible. We also conclude that it is necessary to use both macro data (such as remote sensing data) and micro data (data collected in the field) to study land quality change. The former are efficient in examining land quality changes at the regional scale, the latter can serve to verify ground patterns revealed from macro data and help to identify local variations, so as to get a comprehensive understanding of LUCC and promote sustainable land use and land management. This revised version was published online in July 2006 with corrections to the Cover Date.