Pre-eruptive and syn-eruptive conditions in the Black Butte, California dacite: Insight into crystallization kinetics in a silicic magma system

A series of experiments and petrographic analyses have been run to determine the pre-eruption phase equilibria and ascent dynamics of dacitic lavas composing Black Butte, a dome complex on the flank of Mount Shasta, California. Major and trace element analyses indicate that the Black Butte magma shared a common parent with contemporaneously erupted magmas at the Shasta summit. The Black Butte lava phenocryst phase assemblage (20 v.%) consists of amphibole, plagioclase (core An_77.5), and Fe–Ti oxides in a fine-grained (< 0.5 mm) groundmass of plagioclase, pyroxene, Fe–Ti oxides, amphibole, and cristobalite. The phenocryst assemblage and crystal compositions are reproduced experimentally between 890 °C and 910 °C, ≥ 300 MPa, X_H2O = 1, and oxygen fugacity = NNO + 1. This study has quantified the extent of three crystallization processes occurring in the Black Butte dacite that can be used to discern ascent processes. Magma ascent rate was quantified using the widths of amphibole breakdown rims in natural samples, using an experimental calibration of rim development in a similar magma at relevant conditions. The majority of rims are 34 ± 10 μm thick, suggesting a time-integrated magma ascent rate of 0.004–0.006 m/s among all four dome lobes. This is comparable to values for effusive samples from the 1980 Mount St. Helens eruption and slightly faster than those estimated at Montserrat. A gap between the compositions of plagioclase phenocryst cores and microlites suggests that while phenocryst growth was continuous throughout ascent, microlite formation did not occur until significantly into ascent. The duration of crystallization is estimated using the magma reservoir depth and ascent rate, as determined from phase equilibria and amphibole rim widths, respectively. Textural analysis of the natural plagioclase crystals yields maximum growth rates of plagioclase phenocryst rims and groundmass microlites of 8.7 × 10^− 8 and 2.5 × 10^− 8 mm/s, respectively. These rates are comparable to values determined from time-sequenced samples of dacite erupted effusively from Mount St. Helens during 1980 and indicate that syneruptive crystallization processes were important during the Black Butte eruptive cycle.     

Continuous,Direct Gas-Geochemical Monitoring in Hydrothermal Vents: Installation and Long-Term Operation on Nisyros Island (Greece)

In this paper the installation and long-term operation of a system for continuous monitoring of fumarolic gases is described. Several physicochemical and gas-geochemical parameters such as the concentration of CO₂, H₂S and CO in the fumarolic emissions, as well as the temperatures of the hydrothermal steam and soil in close vicinity of the fumarole and steam pressure are measured in short-time intervals (typically 15 seconds). Data are logged on-site and in parallel transferred to a remote station by digital telemetry. Specially developed software enables the real-time observation of the local conditions in the crater and full bidirectional control of the monitoring system. Fluctuations in the monitored parameters are also reported. From the data presented it can be concluded that environmental conditions (direction and strength of wind, precipitation) will interact with some of the parameters monitored. These influences can only be revealed by continuously operated monitoring systems.     

辽东半鸟南部寒武系与奥陶系的界线

在辽南瓦房店市长兴岛镇二龙山、长岭子等地的寒武纪—奥陶纪冶里组上部首次发现Saukia,Calvinella等属种的化石,确定了Saukia—Calvinella组合带,为晚寒武世凤山阶最顶部的化石带。此外在该带之上采到了微体化石Ulahconusbeimadaoensis,该化石属种为奥陶纪早期的标准分子。据此重新厘定了辽南地区寒武系与奥陶系的界线。     

甘肃北山造山带类型及基本特征

北山造山带经历多期次、多阶段的板块裂解－俯冲－碰撞－拼合的复杂地质演化历程，具多旋回复合造山的特色。通过对造山带构造单元的建立、古板块重建、原型盆地恢复、造山带结构、构造特征及造山机制和模式的研究，确定北山造山带类型为陆－增生弧碰撞造山带。     

圆弧形凹陷地形表面覆盖层对入射平面SV波的影响

利用Fourier Bessel级数展开法，给出了表面具有覆盖层的圆弧形凹陷地形对入射平面SV波散射问题的一个解析解，并利用该解分析了不同深宽比凹陷地形表面覆盖层刚度和厚度对入射SV波的影响．结果表明，凹陷地形表面覆盖层的存在，即使厚度很薄，也会显著增加对入射SV波的放大作用，该放大作用可达到单一凹陷地形的2.5倍以上．覆盖层刚度和厚度的变化对入射平面SV波也具有很大影响．      

子午线弧长公式的简化及通用高斯投影计算程序介绍

通过简化子午线弧长公式，给出适用于各种椭球的通用高斯投影实用公式，并简单介绍依此编制的通用高斯投影计算程序。     

Quantitative models for reconstructing catchment ice-extent using physical-chemical characteristics of lake sediments

The physical characteristics of surface sediments from a suite of pristine lakes on Signy Island, maritime Antarctic, were used to develop a quantitative link between catchment ice-extent and lake-sediment response. Percentage dry weight, median particle size, percentage loss-on-ignition and wet density of the lakes' surface sediments were the most significant variables explaining contemporary catchment ice-extent. Two independent reconstruction models – Partial Least Squares (PLS) and a Modern Analog Technique (MAT) – were applied to dated sediment cores at two sites on Signy Island. The validity of the reconstructions was tested against historical information on catchment ice-extent. With sufficiently high sedimentation rates and sampling resolution, the models can predict sub-decadal changes in ice-extent. The model results are best regarded as indicators of erosion resulting from meltwater activity in the catchment. Comparison of results with Twentieth Century climate records affirms the hypothesis that climatic warming is the most likely cause for the ice retreat observed on Signy Island during the last 40 yrs. Similar reconstruction models using these simple sedimentary measures could be developed for analogous locations in the Antarctic and in Arctic and Alpine regions.     

Quaternary vertical offset and average slip rate of the Nojima Fault on Awaji Island, Japan

Abstract Drilling was carried out to penetrate the Nojima Fault where the surface rupture occurred associated with the 1995 Hyogo-ken Nanbu earthquake. Two 500 m boreholes were successfully drilled through the fault zone at a depth of 389.4 m. The drilling data show that the relative uplift of the south-east side of the Nojima Fault (south-west segment) was approximately 230 m. The Nojima branch fault, which branches from the Nojima Fault, is inferred to extend to the Asano Fault. From the structural contour map of basal unconformity of the Kobe Group, the vertical component of displacement of the Nojima branch–Asano Fault is estimated to be 260–310 m. Because the vertical component of displacement on the Nojima Fault of the north-east segment is a total of those of the Nojima Fault of the south-west segment and of the Nojima branch–Asano Fault, it is estimated to total to 490–540 m. From this, the average vertical component of the slip rate on the Nojima Fault is estimated to be 0.4–0.45 m/10³ years for the past 1.2 million years.     

Collision orogeny at arc-arc junctions in the Japanese Islands

Abstract In the Japanese Islands, collision tectonics are operating at arc-arc junctions in three regions: Hokkaido, Central Japan and Kyushu. Hokkaido is situated at the junction of the Kuril and Northeast Japan Arcs. The Kuril fore arc sliver collides with the Northeast Japan Arc, and the lower crust of the Kuril Arc thrusts upon the fore arc of the Northeast Japan Arc in Hokkaido. Outcrops of the lower crust are observed in the Hidaka Mountains in the fore arc of the junction area. Central Japan is in the juncture area among the Northeast Japan, Izu-Bonin, and Southwest Japan Arcs. The Izu-Bonin arc is colliding against the Honshu mainland, which has been bent by the collision. Kyushu is a juvenile collision area between the Southwest Japan and Ryukyu Arcs. The fore arc of the Southwest Japan Arc is starting to underthrust beneath the Kyushu islands along the Bungo Strait, where shallow seismicity within the crust is active in terms of the collision. Collision tectonics are observed at most of the arc-arc junctions in the circum-Pacific orogenic belts and may be an important process contributing to the relatively rapid growth of new continental crust in subduction zones.     

Recent sedimentation in a high arctic lake, northern Ellesmere Island, Canada

A multiple core study was conducted on laminated minerogenic sediments from Lake C2, Northern Ellesmere Island, Canadian High Arctic. Lateral persistence, distal thinning, variation in grain size of these laminations as well as present-day processes of highly seasonal sediment transfer into the lake basin suggest that clastic varves have been formed. Sedimentation rates based on ²¹⁰Pb dating agree well with sedimentation rates based on lamination counts giving further evidence that laminations are annual. Errors in varve counting were reduced from 12% to < 2% using the multi-core approach of cross-correlating all records. Varved sediments are occasionally interrupted by thick coarse-grained layers, which are interpreted as deposits of turbidity currents and may be related to extremely high discharge events and slope failures of the delta front. Micro-laminated sediments spanning the last two centuries were studied in detail. Suspension settling is the dominant process of deposition depending upon stream discharge which is controlled by nival melt and summer temperatures. Application of varve chronology thus allows to use lamination thickness measurements as source of high resolution proxy data for palaeoclimatic reconstruction.This is the fifth in a series of papers published in this issue on the Taconite Inlet Lakes Project. These papers were collected by Dr R. S. Bradley.