Vertical seismic compressional- and shear-wave (P-and S-wave) profiles were collected from three shallow boreholes in sediment of the upper Mississippi embayment. The site of the 60-m hole at Shelby Forest, Tennessee, is on bluffs forming the eastern edge of the Mississippi alluvial plain. The bluffs are composed of Pleistocene loess, Pliocene-Pleistocene alluvial clay and sand deposits, and Tertiary deltaic-marine sediment. The 36-m hole at Marked Tree, Arkansas, and the 27-m hole at Risco, Missouri, are in Holocene Mississippi river floodplain sand, silt, and gravel deposits. At each site, impulsive P- and S-waves were generated by man-made sources at the surface while a three-component geophone was locked downhole at 0.91-m intervals.
Consistent with their very similar geology, the two floodplain locations have nearly identical S-wave velocity (VS) profiles. The lowest VS values are about 130 m s−1, and the highest values are about 300 m s−1 at these sites. The shear-wave velocity profile at Shelby Forest is very similar within the Pleistocene loess (12 m thick); in deeper, older material, VS exceeds 400 m s−1.
At Marked Tree, and at Risco, the compressional-wave velocity (VP) values above the water table are as low as about 230 m s−1, and rise to about 1.9 km s−1 below the water table. At Shelby Forest, VP values in the unsaturated loess are as low as 302 m s−1. VP values below the water table are about 1.8 km s−1. For the two floodplain sites, the VP/VS ratio increases rapidly across the water table depth. For the Shelby Forest site, the largest increase in the VP/VS ratio occurs at 20-m depth, the boundary between the Pliocene-Pleistocene clay and sand deposits and the Eocene shallow-marine clay and silt deposits.
Until recently, seismic velocity data for the embayment basin came from eartquake studies, crustal-scale seismic refraction and reflection profiles, sonic logs, and from analysis of dispersed earthquake surface waves. Since 1991, seismic data for shallow sediment obtained from reflection, refraction, crosshole and downhole techniques have been obtained for sites at the northern end of the embayment basin. The present borehole data, however, are measured from sites representative of large areas in the Mississippi embayment. Therefore, they fill a gap in information needed for modeling the response of the embayment to destructive seismic shaking. 相似文献
This paper presents the results of an experimental investigation which studied the feasibility of using the electrokinetic process to remediate contaminated clays of glacial origin, otherwise known as glacial tills. An overview of the electrokinetic phenomena, as well as previously performed laboratory and field investigations, is first presented. The methodology of the electrokinetic experiments which were conducted to investigate the removal of metals from a glacial till is then described. A total of 16 experiments were conducted using glacial till samples obtained from a project site near Chicago. Sodium and calcium were used as the surrogate cationic metallic contaminants. These experiments demonstrated that ion transport during the electrokinetic process occurs due to both electro-osmosis and electromigration, but that due to electromigration is significantly higher than that due to electro-osmosis. Unlike other clays such as kaolinite, the glacial till used for this investigation possessed high buffering capacity because of its high carbonate content which prevented the acid front migration from the anode to the cathode during the electrokinetic process. The ion removal efficiency of the electrokinetic process was found to increase when: (1) the voltage gradient applied to the soil was increased, (2) the initial concentration of the contaminants was increased, and (3) the duration of the treatment process was increased. The ion removal efficiency was also greater for smaller ions which possess less ionic charge and when the ions existed independently in the soil as compared to when they coexisted. This investigation suggests that the electrokinetic process has significant potential for remediating glacial tills contaminated with metals. However, the properties of Na and Ca are not representative of contaminants, such as heavy metals, so further investigations are needed. 相似文献