沉积物粒度对水合物形成的制约：来自IODP 311航次证据

对取自IODP 311航次（东北太平洋Cascadia大陆边缘）所有5个站位、采样间距约为1.5 m的614件沉积物样品，利用Beckman Coulter LS 230激光粒度仪进行了沉积物粒度分析，获得了沉积物粒度随深度变化特征，进而与水合物层位的替代指标进行了位置对比，这些指标包括特殊沉积构造（soupy和mousse like构造）、测井数据（LWD）推算出来的水合物饱和度（Sh）、岩芯红外图像和实际钻取的含水合物沉积物等。发现沉积物粒度分别为31~63 μm和63~125 μm的2组较粗粒径的沉积物数量变化增多的位置与水合物出现层位之间存在较好的位置对应关系。如在U1326站位海底以下5~8 m、21~26 m、50~123 m、132~140 m、167~180 m、195~206 m、220~240 m深度位置出现了沉积物粒度明显偏向粗粒的趋势，而这些位置正好对应于大多数特殊沉积构造出现的深度，也对应于水合物饱和度（Sh）值相对较高的深度，并与一些实际钻取的赋含水合物的浊积沙层观察结果一致。因此，初步研究后认为，沉积物粒度在水合物形成过程中扮演了重要角色，天然气水合物可能偏向形成于粒度大于31 μm的粗粒沉积物中。       

Determining the size of spatial clusters in focused tests: Comparing two methods by means of simulation in a GIS

 Based on a four-point evaluation system consisting of accuracy, consistency, power, and chance to commit type I errors, this study compares Tango's minimum p (MinP) and Stone's maximum relative risk (MaxRR) methods for detecting focused cluster size through simulations in GIS. It reveals that the MinP method is more effective than the MaxRR method. The MinP method exhibits higher levels of accuracy and consistency; and its power and chance to commit type I errors are similar to the MinP method. The MaxRR method has a tendency to underestimate the cluster size, while the MinP method tends to overestimate the cluster size, particularly when the clusters are relatively big and have high relative risk levels. In addition, the MinP method seems to be most effective in revealing the size of clusters when clusters are neither too strong nor too weak. The lowest detection rates for clustering occur when the clustering signal is relatively weak, which is easily understandable. In practice, it might be useful to use both the methods to estimate a range of possible cluster sizes, where the MaxRR method indicates the lower estimate, while the MinP method gives the higher estimate of the cluster size. Received: 24 August 2002 / Accepted: 20 December 2002     

Predicting channel patterns

The proposed distinction between meandering and braided river channel patterns, on the basis of bankfull specific stream power and bed material size, is analysed and rejected. Only by using regime-based estimates of channel widths (rather than actual widths) has discrimination been achieved, and it is argued that this procedure is unacceptable.An alternative is to explore the patterning processes underlying the marked pattern scatter on bankfull stream power/bed material size plots. Of the five sets of patterning processes, large-scale bedform development and stability is seen as especially important for meandering and braiding. For gravel-bed rivers, bedforms developed at around or above bankfull stage appear important for pattern generation, with braiding relating to higher excess shear stress and Froude number. There seems to be an upper threshold to both meandering and braiding which is achieved at extreme discharges and steep gradients, as on steep alluvial fans, rather than for the rivers with available flow data here considered. For sand-bed rivers with greater excess shear stress, the equivalent upper plane bed threshold may occur below bankfull, with bed material mobility and bedform modification occurring over a wider range of sub-bankfull discharges. Sand-bed channel margin outlines appear to be less perturbed by bedform effects than gravel bed planforms, and they may have naturally straight or sinuous planforms. Bedform relief may nevertheless lead to some being designated as braided when viewed at low flows.It is concluded that the use of a single-stage stream power measure and bed material size alone is unlikely to achieve meandering/braiding discrimination.     

我国人均粮食变化的地理研究

人均粮食占有量是反映粮食供给水平的重要指标，本文分析了我国人均粮食占有量变化的阶段和地理特征，并探讨了其与粮食增产的关系，对因地制宜调控人粮关系有一定参考价值。     

Textural analysis and modelling of a flood deposit: River severn,U.K.

Samples of sediment collected from the Severn floodplain between Worcester and Gloucester following the severe flooding in January and February 1990, were analysed for their grain size distribution. The results show that most sand was deposited within 20 m of the channel bank, but that fine sand may contribute to flood sediment across the width of the floodplain. James' (1985) numerical model of overbank sedimentation attempts to predict the transfer of sediment to the floodplain during flooding. Geometrical and hydraulic data relating to the Severn flood are used as input for a computer program of James' (1985) model. The pattern of sediment concentrations predicted by the model was compared with that obtained from statistical analysis of the flood sediment. The patterns were found to be similar, so James' (1985) model was considered to predict in a relative sense the distribution of flood sediment.     

Coupled changes in sand grain size and sand transport driven by changes in the upstream supply of sand in the Colorado River: Relative importance of changes in bed-sand grain size and bed-sand area

Sand transport in the Colorado River in Marble and Grand canyons was naturally limited by the upstream supply of sand. Prior to the 1963 closure of Glen Canyon Dam, the river exhibited the following four effects of sand supply limitation: (1) hysteresis in sediment concentration, (2) hysteresis in sediment grain size coupled to the hysteresis in sediment concentration, (3) production of inversely graded flood deposits, and (4) development or modification of a lag between the time of a flood peak and the time of either maximum or minimum (depending on reach geometry) bed elevation. Construction and operation of the dam has enhanced the degree to which the first two of these four effects are evident, and has not affected the degree to which the last two effects of sand supply limitation are evident in the Colorado River in Marble and Grand canyons. The first three of the effects involve coupled changes in suspended-sand concentration and grain size that are controlled by changes in the upstream supply of sand. During tributary floods, sand on the bed of the Colorado River fines; this causes the suspended sand to fine and the suspended-sand concentration to increase, even when the discharge of water remains constant. Subsequently, the bed is winnowed of finer sand, the suspended sand coarsens, and the suspended-sand concentration decreases independently of discharge. Also associated with these changes in sand supply are changes in the fraction of the bed that is covered by sand. Thus, suspended-sand concentration in the Colorado River is likely regulated by both changes in the bed-sand grain size and changes in the bed-sand area. A physically based flow and suspended-sediment transport model is developed, tested, and applied to data from the Colorado River to evaluate the relative importance of changes in the bed-sand grain size and changes in the bed-sand area in regulating suspended-sand concentration. Although the model was developed using approximations for steady, uniform flow, and other simplifications that are not met in the Colorado River, the results nevertheless support the idea that changes in bed-sand grain size are much more important than changes in bed-sand area in regulating the concentration of suspended sand.     

The strength and fractal dimension characteristics of alum–kaolin flocs

Flocs generated by various shear forces exhibit different characteristics of size, strength and structure. These properties were investigated by employing a continuous optical monitoring and a microscope with CCD camera to directly monitor aggregation under six different shear intensities. The floc structure was characterized by the fractal dimension. The results showed that the flocculation index (FI) decreased from 1.16 at 20 rpm to 0.25 at 250 rpm and the floc size decreased from 550 μm to 150 μm, meantime, the FI value showed a good correlation with floc size. In order to determine the floc strength, two methods were used. One was the strength factor, ranging from 18.3% to 62.5%, calculated from FI curve, and the other was a theoretical value between 0.005 N/m² and 0.240 N/m², estimated by calculation. The floc strength increased with the G value in both cases. Furthermore, the fractal dimension increased with G and its value was between 1.30 and 1.63. The relation between fractal dimension and strength was also obtained.     

New method for in situ characterization of loose material for landslide mapping purpose

The assessment of grain size distribution and plasticity of loose geological material, during in situ geological investigations, is not obvious. Visual appreciation allows an approximative quantification of the coarse granulometric fractions, but not of the fine ones. Field soils determination methods suggested until now, are visual and tactile tests leading to a very rough estimate, which is only qualitative and not very reproducible. The new proposed field test (GEOLEP method) allows a quick quantification of the fine fraction of loose material. It allows the determination of the sand fraction (fine and medium grained sands) as well as the methylene blue value of the samples. The necessary equipment to perform this test is light and compact and the time needed to analyze one sample is approximately 15 min. Thus it is also possible to carry out numerous measurements in one day. The calibrations were carried out on a selection of 13 natural samples, chosen for their representativeness of the typical alpine quaternary deposits. The results obtained with GEOLEP method are relevant compared with standardized laboratory tests; the obtained correlation indexes are of 73% for the comparison with laboratory stain test results and of 89% with a laboratory method using a similar procedure than the field test. The correlation we performed with Atterberg's limits tests shows that a rough approximation of plasticity index can also be obtained (R² = 75%). This method thus brings a new tool which should allow taking into account the lithological factor (by some quantitative and representative variables) in a reliable way for the evaluation of landslide hazards.     

Utilisation of the image analysis method for the detection of the morphological anisotropy of calcite grains in marble

This paper presents the development and utilisation of an automated image processing algorithm for detection and analysis of grains. Using optical polarising microscopy, a set of colored images are collected from an area on a thin section. A filtering operation, using rotation of a morphological alternating sequence filter (based on a structuring element), is used to remove twinning features within individual grains. Filtering is followed by the watershed segmentation technique to determine grain boundaries. The method is used for the identification of calcite grains in marble and the subsequent analysis of morphological anisotropy.     

Influence of surface roughness of dune bedforms on flow and turbulence characteristics

The current paper investigates the flow and turbulence characteristics over dune bedforms by means of laboratory experiments, where spatially dense and temporally high frequency velocity measurements were done. Although similar studies are available in the literature, the focus and novelty of the current study is to assess the influence of surface roughness of the dune bedforms on the nearbed flow. For direct comparison, two different surface roughness heights over idealized, fixed-shaped, high-angled dune bedforms were tested; one with a hydraulically-smooth surface, and the other with a fully-rough surface. Spatial variation of time-averaged flow as well as turbulence statistics were examined, which was complemented by streamline plots and spectral analyses. The results are interpreted from sediment entrainment and sediment transport points of view. The results show that increased dune surface roughness reduces the nearbed flow velocity, but increases the flow velocities at upper regions. The upward directed flow near the dune crests becomes stronger in the case of smooth surface, while the re-attachment point moves further downstream compared to the rough wall case. It is concluded that the roughness of the dune surface affects the nearbed flow and turbulence characteristics qualitatively and quantitatively, which is shown to have direct consequences on sediment entrainment characteristics.