基于退火BP神经网络的GPS高程转换

阐述模拟退火算法的基本思想和原理,提出并介绍模拟退火算法优化的BP神经网络模型在GPS高程转换中的具体应用,同时编写相应的MATLAB处理程序,结合大量数据进行仿真实验,结果表明文中提出的退火BP神经网络模型具有收敛速度快、精度高、避免陷入局部最小的优良特性。     

小波技术在GPS基线解算数据预处理中的应用

采用小波技术对GPS观测数据进行处理。应用小波变换技术对GPS相位观测值进行周跳的探测和修复。GPS相位观测值可以作为时间序列来进行分析,作为时间函数,它所表现出来的是一条光滑度很好的曲线,一旦出现周跳,这种光滑性就被破坏,从发生周跳的历元开始,后继相位观测值序列发生等量阶跃,通过小波变换的信号特性检测原理,能够有效地探测出周跳的发生,这种方法对于缩小模糊度搜索空间及提高模糊度解的有效性有明显的作用,从而提高基线解算的精度。     

Bringing GPS into harsh environments for fully automated deformation monitoring

Engineering projects that require deformation monitoring frequently utilize geodetic sensors to measure displacements of target points located in the deformation zone. In situations where control stations and targets are separated by a kilometer or more, GPS can offer higher precision position updates at more frequent intervals than can normally be achieved using total station technology. For large-scale deformation projects requiring the highest precision, it is therefore advisable to use a combination of the two sensors. In response to the need for high precision, continuous GPS position updates in harsh deformation monitoring environments, a software has been developed that employs triple-differenced carrier-phase measurements in a delayed-state Kalman filter. Two data sets were analyzed to test the capabilities of the software. In the first test, a GPS antenna was displaced using a translation stage to mimic slow deformation. In the second test, data collected at a large open pit mine were processed. It was shown that the delayed-state Kalman filter developed could detect millimeter-level displacements of a GPS antenna. The actual precision attained depends upon the amount of process noise infused at each epoch to accommodate the antenna displacements. Higher process noise values result in quicker detection times, but at the same time increase the noise in the solutions. A slow, 25 mm displacement was detected within 30 min of the full displacement with sigma values in E, N and U of ±10 mm or better. The same displacement could also be detected in less than 5 h with sigma values in E, N and U of ±5 mm or better. The software works best for detecting long period deformations (e.g., 20 mm per day or less) for which sigma values of 1–2 mm are attained in all three solution components. It was also shown that the triple-differenced carrier-phase observation can be used to significantly reduce the effects of residual tropospheric delay that would normally plague double-differenced observations in harsh GPS environments.

Spin rate estimation of sounding rockets using GPS wind-up

Carrier phase wind-up is a well-known effect that arises from the relative rotation between a transmitting and receiving antenna. In GPS measurements at L1 frequency, this effect translates into an error of 19.029 cm per full relative rotation of antennas. Since this effect is independent of the satellite elevation for pure rotation about the antenna boresight axis, it is usually absorbed by the clock estimation in navigation algorithms. Therefore, the impact of wind-up is usually neglected for applications that do not require accuracies to the cm level like RTK. However, in receiving platforms with high rotation rate, the accumulated wind-up value can be important and actually be larger than receiver noise or even ionospheric variations. Therefore, in such scenarios, the wind-up contribution can be isolated and used as a source of information to compute the spin rate of such platforms using an appropriate combination of GPS observables. This work shows some results of a coarse, yet simple, approach to monitor the rotation angle and spin-rate of spin stabilized sounding rockets flown by DLR.     

GPS signal acquisition using the repeatability of successive code phase measurements

This paper introduces a new method for GPS signal acquisition, which is based on the repeatability of successive code phase measurements and the M-of-N search algorithm. The performance of the proposed method in terms of probability of signal detection is similar to that of traditional methods, except that the calculation of the probability of detection does not rely on the noise distribution or the Carrier-to-Noise ratio (C/N₀). The code phase repeatability-based method is presented along with equations for probability of detection and probability of false detection. If the distribution of the noise is known, it also provides an estimate of the C/N₀. The proposed method is illustrated for coherent and non-coherent acquisition and C/N₀ estimation.     

公交车站台智能显示牌系统设计与实现——以南充市的一个站台为例

介绍了一种基于GIS/GPS/GSM技术的实时显示公交车运动状态和时间的电子显示牌设计方案。以南充市为例,在利用GPS系统对车辆精确定位的基础上,采用GSM无线通讯网关实现消息的传输,并在电子地图上实时的显示出公交车辆的位置、状态和各路公交车到达客人所在目的站点所需用的时间,方便人们更有效快捷地选择交通工具。本文重点分析了系统的各组成部分的功能和实现方式,最后采用VC++6.0和MapXtreme2004开发实现了该系统。     

GPS伪卫星的组合定位技术及其误差分析

介绍了GPS伪卫星组合定位的观测模型,详细论述了GPS伪卫星组合定位中存在的误差源,并对各误差源的消除方法进行了分析。     

连续运行GPS定位服务系统的探讨

介绍了连续运行GPS定位服务的概念、实现模式及其在测绘行业中的应用。     

坐标转换中公共点选取对于转换精度的影响

采用7参数布尔莎模型转换GPS坐标时,由于公共点情况复杂会对坐标转换精度产生影响。本文简述了采用布尔莎模型进行坐标转换的一般过程,结合工程算例考虑了公共点分布的几种情况对坐标转换精度的影响,提出了坐标转换分区进行的思想,得到了一些有益的结论。