International Journal of Sediment Research(IJSR)-Order Form(2015)(ISSN 1001-6279)

正Editing Board address:IRTCES,20 West Chegongzhuang Rd.,Beijing 100048,China IJSR is the journal of THE WORLD ASSOCIATION FOR SEDIMENTATION AND EROSION RESEARCH(WASER)and is edited by the International Research and Training Center on Erosion and Sedimentation(IRTCES).Main topics:Fluvial and estuarine processes Mechanics of sediment transport Soil erosion and sediment yield in upland Soil conservation,including socio-economic aspects     

近断层地震作用下基础隔震层组合限位振动台实验研究

近断层脉冲型地震作用下,基础隔震结构隔震层会产生过大变形,导致隔震支座侧倾失稳,隔震体系破坏。设计制作了3层基础隔震钢框架实验模型和11种U型钢板I型铅棒组合限位器,进行了U型钢板静力加载实验和近断层脉冲型地震作用下基础隔震层软碰撞限位振动台模型实验。实验表明：①静力加载时,U型钢板具有很好的弹性性能;②动力作用下,组合限位器残余变形较小,仍具有良好限位复位能力;③近断层地震作用下,基础隔震层软限位效果良好,同时控制上部结构层间变形在允许范围内。     

加筋土石坝小型振动台模型试验分析

土石坝振动台模型试验是认识坝体地震破坏过程和检验抗震措施效果的重要手段之一。针对2种坝体材料,利用小型振动台,开展了一系列不同加载工况、不同加筋方式的土石坝小型振动台模型试验。试验结果表明：①2种坝体材料的初始破坏都首先从坝顶开始,表明坝顶是抗震的关键部位,与已有研究成果基本一致;②相同加载条件下,级配较差的碎石料模型坝的抗震性能优于砂砾石料,表明相对于级配,堆石料自身的性质对土石坝抗震性能的影响更大;③由细铁丝网和纱布组成并在坝坡采取包裹处理的复合加筋的抗震措施,抗震效果优于平铺纱布、平铺纱布且在坝坡包裹处理、平铺细铁丝网等的抗震措施。研究成果可供进一步开展土石坝大型振动台模型试验的材料选择、抗震措施设计等参考。     

板式支座与铅芯支座连续梁桥振动台试验对比分析

通过对分别采用板式支座和铅芯支座的2座3跨连续梁桥模型进行振动台试验,对比分析了这2类桥梁的动力特性、破坏过程及2种支座对连续梁桥地震反应的影响。研究结果表明：地震波特性对桥梁结构的地震反应有较大影响,在对桥梁结构进行抗震设计时,需选择合理的地震动输入;在地震强度较小时,板式支座的滑动能够起到一定的隔震效果,铅芯支座的隔震性能能得到较好的发挥;在地震强度较大时,铅芯支座的隔震性能不能得到很好的发挥,采用铅芯支座的桥梁地震反应不一定小于普通桥梁;通过合理的设计,2类桥梁都完全可以实现大震不倒的设防目标。     

带粘弹性阻尼器结构振动台试验设计——基于OpenSees的阻尼器尺寸选择

基于带粘弹性阻尼器钢框架结构振动台试验,提出了基于OpenSees的阻尼器尺寸选择方法。首先,通过试验获得一种特定尺寸阻尼器的滞回曲线,根据粘弹性阻尼器相似理论,将其转换为一系列不同尺寸的阻尼器滞回曲线。使用Bouc-Wen模型对它们进行参数识别并添加到结构分析模型中,利用OpenSees软件对添加阻尼器结构和纯框架结构进行不同水准的3条地震波下动力时程分析。最后,通过综合考查阻尼器的减震效果和最大应变来确定合适的用于振动台试验当中的阻尼器尺寸。结果表明,本方法可避免对不同尺寸阻尼器逐个进行性能试验,Bouc-Wen模型可较准确地模拟阻尼器力学性能,OpenSees非线性动力时程分析可准确模拟试验过程,根据提出的选择指标能简单方便地确定阻尼器的尺寸。     

Substructure shake table test method using a controlled mass: formulation and numerical simulation

This study proposes a new substructure shake table test method that allows for experimental investigation of the lower portion of structures while the upper part is numerically analyzed. Compatibility conditions are derived to ensure that the dynamic characteristics of the substructured system are equivalent to the reference entire structure. This method utilizes controlled masses to incorporate interface forces from the computational substructure to the experimental substructure. A feasible implementation procedure for the interface force compatibility is developed using a series of conversions and signal processing. For validation of the capabilities and limitations of the proposed substructure method, numerical simulations are performed using detailed models including dynamics of the controlled mass systems. Results from the numerical simulations showed that the proposed substructure method produced comparable results to the reference entire simulations. The average error between top floor displacements produced by substructured and entire responses for earthquake inputs was 7.1%. Numerical studies showed that the substructure method has potential to serve as an alternative to shaking table tests of entire structures. Copyright © 2012 John Wiley & Sons, Ltd.     

Boundary effects of a laminar container in centrifuge shaking table tests

Two dynamic centrifuge model tests were performed to simulate dry or saturated sand deposits subjected to 1 Hz base shaking. This experimental study investigated the boundary effects of a laminar container on the seismic response acquired from accelerometers and from pore pressure transducers, both of which were embedded in the sand bed at various depths and distances from the end walls. Under the tested configurations and the employed input motion used in the study, the test results revealed minimal boundary effects on the seismic responses. The measured maximum amplitude, main frequencies, phase lags of acceleration, and the profiles of the calculated RMS acceleration amplification factor were not affected by the boundaries if the instruments were positioned at a distance of more than one-twentieth of the model length from the end walls and were not positioned on the ground surface. No obvious discrepancies were observed in the time histories of excess pore water pressure, measured at a distance of one-fourth of the model length from the end walls. These results infer that variations in the seismic response at the end walls were minimal; hence the laminar container used in the study may be used effectively to simulate 1D shear wave propagation in centrifuge shaking table tests. However, for other testing configurations, a similar study should be undertaken for evaluating the boundary effect of the laminar container on the seismic responses.     

软弱场地地铁车站结构地震反应的数值模拟与模型试验对比分析

根据软弱场地土上地铁车站结构大型振动台模型试验结果,以软件ABAQU S为平台,采用记忆型嵌套面黏塑性动力本构模型和动塑性损伤模型,分别模拟土体和车站结构混凝土的动力特性,建立了土-地铁车站结构非线性动力相互作用二维和三维有限元分析模型,对各种试验工况下地基土-地铁车站结构体系的地震反应进行了数值模拟,并与试验结果进行了对比。结果表明：二维、三维数值模拟与振动台模型试验结果基本一致,三维模型可更好地模拟软弱场地与地铁车站结构的动力相互作用及模型结构的动力反应。数值模拟结果和振动台试验结果可相互验证其可靠性。     

Effect of viscous damping devices on the response of seismically isolated structures

Viscous and other damping devices are often used as elements of seismic isolation systems. Despite the widespread application of nonlinear viscous systems particularly in Japan (with fewer applications in the USA and Taiwan), the application of viscous damping devices in isolation systems in the USA progressed intentionally toward the use of supplementary linear viscous devices due to the advantages offered by these devices. This paper presents experimental results on the behavior of seismically isolated structures with low damping elastomeric (LDE) and single friction pendulum (SFP) bearings with and without linear and nonlinear viscous dampers. The isolation systems are tested within a six‐story structure configured as moment frame and then again as braced frame. Emphasis is placed both on the acquisition of data related to the structural system (drifts, story shear forces, and isolator displacements) and on non‐structural systems (floor accelerations, floor spectral accelerations, and floor velocities). Moreover, the accuracy of analytical prediction of response is investigated based on the results of a total of 227 experiments, using 14 historic ground motions of far‐fault and near‐fault characteristics, on flexible moment frame and stiff braced frame structures isolated with LDE or SFP bearings and linear or nonlinear viscous dampers. It is concluded that when damping is needed to reduce displacement demands in the isolation system, linear viscous damping results in the least detrimental effect on the isolated structure. Moreover, the study concludes that the analytical prediction of peak floor accelerations and floor response spectra may contain errors that need to be considered when designing secondary systems. Copyright © 2014 John Wiley & Sons, Ltd.     

松嫩平原地下水位动态影响因素分析

通过对实测数据进行统计、对比并绘制相关曲线,分析研究松嫩平原气候、水文、地形地貌、地质与水文地质条件、土壤与植被等自然因素以及地下水开采与回灌等人为因素对地下水位动态的影响,认为：除降水量减少等自然因素外,人类治水工程和开采地下水等因素是造成松嫩平原水资源减少的重要原因,是影响松嫩平原地下水位动态变化的主要因素.