基于水电比拟方法的山东南四湖上级湖流场研究

利用水电比拟方法模拟了南四湖流场结构。同时,基于HAMSOM模式,对其流场进行了数值模拟,所得结果与水电比拟结果一致,两者平均相关系数在0.94以上,表明水电比拟实验技术路线可行,流场基本结构准确。该方法适用于低流速大流场的模拟。流场结构分析表明,湖区流速在汛期为cm/s量级,非汛期仅为mm/s量级。其中,在南阳湖北部...     

VIV and galloping of single circular cylinder with surface roughness at 3.0×10≤Re≤1.2×10

Passive Turbulence Control (PTC) in the form of selectively distributed surface roughness is used to alter Flow Induced Motion (FIM) of a circular cylinder in a steady flow. The objective is to enhance FIM's synchronization range and amplitude, thus maximizing conversion of hydrokinetic energy into mechanical energy by oscillator in vortex-induced vibration and/or galloping. Through additional viscous damping, mechanical energy is converted to electrical harnessing clean and renewable energy from ocean/river currents. High Reynolds numbers (Re) are required to reach the high-lift TrSL3 (Transition-Shear-Layer-3) flow regime. PTC trips flow separation and energizes the boundary layer, thus inducing higher vorticity and consequently lift. Roughness location, surface coverage, and size are studied using systematic model tests with broad-field laser visualization at 3.0×10⁴<Re<1.2×10⁵ in the low-turbulence free-surface water-channel of the Marine Renewable Energy Laboratory of the University of Michigan. Test results show that 16° roughness coverage is effective in the range (10°-80°) inducing reduced vortex-induced vibration (VIV), enhanced VIV, or galloping. Range of synchronization may increase or decrease, galloping amplitude of oscillation reaches three diameters; wake structures change dramatically reaching up to ten vortices per cycle. Conversion of hydrokinetic energy to mechanical is enhanced strongly with proper PTC.     

New model to determine forces at on-bottom slender pipelines

The present paper proposes a numerical model to determine horizontal and vertical components of the hydrodynamic forces on a slender submarine pipeline lying at the sea bed and exposed to non-linear waves plus a current. The new model is an extension of the Wake II type model, originally proposed for sinusoidal waves (Soedigdo et al., 1999) and for combined sinusoidal waves and currents (Sabag et al., 2000), to the case of periodic or random waves, even with a superimposed current. The Wake II type model takes into account the wake effects on the kinematic field and the time variation of drag and lift hydrodynamic coefficients. The proposed extension is based on an evolutional analysis carried out for each half period of the free stream horizontal velocity at the pipeline. An analytical expression of the wake velocity is developed starting from the Navier–Stokes and the boundary layer equations. The time variation of the drag and lift hydrodynamic coefficients is obtained using a Gaussian integration of the start-up function. A reduced scale laboratory investigation in a large wave flume has been conducted in order to calibrate the empirical parameters involved in the proposed model. Different wave and current conditions have been considered and measurements of free stream horizontal velocities and dynamic pressures on a bottom-mounted pipeline have been conducted. The comparison between experimental and numerical hydrodynamic forces shows the accuracy of the new model in evaluating the time variation of peaks and phase shifts of the horizontal and vertical wave and current induced forces.     

龙门山北段九龙山构造几何学运动学分析

九龙山构造是川西北地区的重点勘探构造。据地震剖面分析,解析了九龙山的构造几何学特征。研究表明,九龙山背斜受到米仓山构造和龙门山构造的双重影响,主要经历了三期次构造叠加,其叠加组合形成了现今九龙山的复杂构造。通过合理的构造建模,对九龙山构造运动过程、多期构造叠加及油气运移与分布规律等有了新的认识。     

Flow and deformation failure of sandy slopes

The effects of earthquake induced pore pressure on seismic and post seismic stability conditions of cohesionless slopes are investigated with reference to the infinite slope scheme. In cohesionless slopes the shear strength reduction caused by pore pressure build-up may lead the slope to a deformation failure or to a flow failure if liquefaction conditions are approached. Two critical values of the seismic induced pore pressure ratio are introduced to evaluate the effect of shear strength reduction on the slope failure mechanism. The results are given in the form of stability charts and a procedure for the evaluation of the seismic stability condition is described. The procedure gives useful information about the failure mechanism that slopes may exhibit and the displacement analysis which should be carried out.     

高温高压岩石力学—历史,现状,展望

高温高压岩石力学是岩石力学的分支学科，它以固体地球介质（材料）的变形行为和机制为研究对象，与一般变形固体力学相比较，具有高温、高压、强约束、宽时域、大变形、以及固－液相互作用、物理效应－化学效应并存等特点。高温高压岩石力学是在经典连续介质力学的基础上，针对自身的特殊性，运用破裂学、摩擦学和流变学的研究成果，经过相当长时期的酝酿和积累，大致于本世纪七十年代建立并逐步发展起来的。它在岩石破裂、摩质力学     

Response and recovery of the Eel River, California, and its tributaries to floods in 1955, 1964, and 1997

Northwestern California is prone to regional, high magnitude winter rainstorms, which repeatedly produce catastrophic floods in the basins of the northern Coast Ranges. Major floods on the Eel River in 1955 and 1964 resulted in substantial geomorphic changes to the channel, adjacent terraces, and tributaries. This study evaluated the changes and the effects of a moderate flood in 1997 through field observations and examination of aerial photographs that spanned from 1954 to 1996. The purpose was to document the nature and magnitude of geomorphic responses to these three floods and assess the rates and controls on the recovery of the Eel River and its tributaries. Channel widening from extensive bank erosion was the dominant geomorphic change along the lower Eel River during major floods. As a result of the 1964 flood, the largest amount of widening was 195 m and represented an 80% change in channel width. Channel narrowing characterized the periods after the 1955 and 1964 floods. More than 30 years after the 1964 flood, however, the river had not returned to pre-flood width, which suggests that channel recovery required decades to complete. A long recovery time is unusual given that the Eel River is located in an area with a “superhumid” climate and has an exceptionally high sediment yield. This long recovery time may reflect highly seasonal precipitation and runoff, which are concentrated in 3–5 months each winter. In contrast to the main stem of the Eel River, the dominant effects of floods on the tributaries of the Eel River were rapid aggradation of channel bed and valley floor followed by immediate downcutting. Dendrogeomorphic data, aerial photographs, and field observations indicate that thick wedges of gravel, derived largely from hillslope failures in upper reaches of the tributaries, are deposited at and immediately upstream of the mouths of tributaries as the stage of the Eel River exceeded that of the tributaries during major floods. In the waning stages of the flood, the tributaries cut through the gravel at a rate equal to the lowering of the Eel and generated unpaired terraces and nickpoints. The complete process of deposition and incision can occur within a few days of peak discharge. Although reworking of some sediment on the valley floor may continue for years after large floods, channel morphology in the tributaries appears to be a product of infrequent, high magnitude events. The morphology of the tributary channel also appears to be greatly influenced by the frequency and magnitude of mass wasting in headwater areas of small basins.     

An evaluation of the health status of the Lavaca Bay, Texas ecosystem using Crassostrea virginica as the sentinel species

Locational risks for compromised ecosystem health for the eastern oysters (Crassostrea virginica) harvested from Lavaca Bay, Texas were estimated. Flow cytometric evaluation of variations in DNA content and the lysosomal destabilization assay were used for evaluation of genotoxicity and stress, respectively. Bayesian geo-statistical methods were utilized to estimate and evaluate spatial effects. For models with spatial risks, continuous surface maps of predicted parameter values were created to evaluate risk location. Lysosomal destabilization assay results were spatially oriented whereas flow cytometry results were fit best with the random effects model. While not spatially oriented, the highest levels of variations in DNA content were also present near industrial facilities. Locational risks of increased biomarkers of genotoxicity and stress in the eastern oyster (Crassostrea virginica) were increased with proximity to industrial facilities     

A heat perturbation flow meter for application in soft sediments

A prototype flow meter has been developed, based upon the heat perturbation principle, to monitor groundwater specific discharge in soft sediments. The device is designed for use in spatially intensive, long-term monitoring campaigns in remote or inconvenient locations, and is cheap, robust and capable of being logged automatically. The results of the laboratory tests indicate that the heat perturbation principle is suitable for determining the magnitude of specific discharge to a degree of accuracy that would be useful in practical applications in dynamic groundwater systems with rapidly changing flows of approximately 1 md⁻¹ or more and that the groundwater flow direction can generally be determined to a high level of precision. The accuracy and reliability of the estimates of specific discharge have been shown to depend strongly upon the geometrical precision of manufacture and the quality of the temperature monitoring system. These factors become most significant in the estimation of lower flows and further investigation is required to determine the detection limit of the device. Specific discharge estimates have been shown to be insensitive to dispersivity values appropriate to the scale of the device. Unlike the majority of heat perturbation devices, calibration is unnecessary.     

A scaled experiment for the verification of the SeaBed Logging method

SeaBed Logging (SBL) is an application of the marine controlled source electromagnetic (CSEM) method that is used to directly detect and characterize possible hydrocarbon-bearing prospects. Although the CSEM method has been used by academia for more than three decades, the application as a direct hydrocarbon indicator was first introduced about five years ago. The central idea of SBL is the guiding of electromagnetic energy in thin resistive layers within conductive sediments. Even if it has been well known for a long time that electromagnetic signals can propagate from a conductive region to another via resistive regions such as air or resistive parts of the lithosphere, the application to hydrocarbon exploration has not been developed until recently. This might be due to the uncertainty of getting any significant response from thin resistive layers such as hydrocarbon reservoirs since electromagnetic energy is highly attenuated in conductive sediments. Thus, during the early development phase of the SBL technique, a scaled laboratory experiment was performed to validate if a thin resistive layer (e.g. hydrocarbons) buried within conductive media (e.g. sediments) could be remotely detected by using electric dipoles as sources and receivers. Data from this experiment were compared to a forward modelling code for layered media, and the comparison showed good agreement between experimental and theoretical results. This suggested that thin resistive layers buried in conductive media are detectable due to the guiding of the electromagnetic field within the resistor. The successful results were vital for realizing the application of marine CSEM as a hydrocarbon exploration technique. We here present the results of the first scaled SBL experiment.