福建戴云山隧道断层性质与稳定性研究

隧道断层（F2）为张性正断层,破坏原岩中较为对称的应力平衡,加之带内岩石破碎,节理裂隙发育,使得断层更加容易坍塌和涌水。建议采用稳定掌子面法和专门支护保证硐室稳定。     

郑州市城区深部基岩层热储特征分析

通过对郑州市城区深部基岩层热储的岩性、构造、热源及盖层条件分析研究,总结了该区热储特征,并首次提出了断裂循环型带状热储构造网络体系的构思,这对该区今后深部基岩层热储的研究具有一定的参考意义。     

Surface renewal analysis for sensible and latent heat flux density

High frequency temperature measurements were recorded at five heights and surface renewal (SR) analysis was used to estimate sensible heat flux density (H) over 0.1 m tall grass. Traces of the temperature data showed ramp-like structures, and the mean amplitude and duration of these ramps were used to calculate H using structure functions. Data were compared with H values measured with a sonic anemometer. Latent heat flux density (E) was calculated using an energy balance and the results were compared with E computed from the sonic anemometer data. SR analysis provided good estimates of H for data recorded at all heights but the canopy top and at the highest measurement level, which was above the fully adjusted boundary layer.     

Possible creep-related tilt precursors obtained in the Central Apennines (Italy) and in the Southern Caucasus (Georgia)

Daily averaged tilt component data from two sites of the Central Apennines (Italy) and of the Southern Caucasus (Georgia), respectively, revealed intermediate-term tilts as possible precursors to earthquakes (M=3.0÷4.7) which occurred in the above-mentioned seismic areas within a distance of 50 km from the sites. A good temporal correlation as well as a fair spatial correspondence between these residual tilts (with amplitude and duration of some microradians and months, respectively) and main shocks were pointed out, by removing both secular trends and seasonal thermoelastic effects from the raw tilts. An attempt was made to justify the above-mentioned results, based on the assumption that the observed intermediate-term preseismic tilts are the manifestation of aseismic creep episodes of comparable duration in the fault materials of thrust faults close to the tilt sites. The mechanism refers to a strain field slowly propagating from the preparation focal area to the tilt site, through crustal blocks separated by weak transition zones. This propagation is thought to be the cause of the local aseismic fault slip recorded by the tiltmeters. Previously, both discrete structures and strain propagation effects were revealed in the Central Apennines and are thought also to exist in the Southern Caucasus. As in the past, the rheological properties of fault materials are revealed as viscoelastic ones. In fact, creep equations obtained by applying several viscoelastic models on our data, proved to fit quite well some of the observed tilt precursors, producing viscosity and rigidity values very similar to those reported in literature.Professor Petr Viktorovich Manjgaladze died during the writing of this paper     

饱和软土压缩曲线的“反常”现象

饱和软土压缩试验时,经常出现压缩曲线“反常”、压缩系数“倒大”的现象。它是土的原始结构发生破坏前后的不同压缩性的客观反映。饱和软土的结构力很微弱,唯质量好的原状土才能见到这种“反常”。应从成孔、取样、测试及资料整理等多个环节保证其工程意义。     

Fault zone geometry of a mature active normal fault: A potential high permeability channel (Pirgaki fault, Corinth rift, Greece)

We present results from petrophysical analysis of a normal fault zone with the aim of defining the flow pathways and their behavior during seismic and interseismic periods. Data are obtained on porosity geometry, strain structure and mineralogy of different domains of a normal fault zone in the Corinth rift. Data point out a close relationship between mineralogy of the clayey minerals, porosity network and strain structures and allow definition of a macroscopic anisotropy of the flow parameters with a strong control by microscopic ultracataclasite structures. The Pirgaki fault zone, developed within pelagic limestone, has a sharp asymmetric porosity profile, with a high porosity volume in the fault core and in the damage zone of the hanging wall. From porosity volumes and threshold measurements, a matrix permeability variation of 6 orders of magnitude could be expected between the protolith and the fault core. Modifications of this pathway during seismic and interseismic phases are depicted. Healing of cracks formed during seismic slip events occurred in the fault core zone and the porous network in the damage zone is sealed in a second step. The lens geometry of the fault core zone is associated with dissolution surfaces and open conduits where dissolved matter could move out of the fault core zone. These elementary processes are developed in particular along Riedel's structures and depend on the orientation of the strain surfaces relative to the local stress and depend also on the roughness of each surface type. P-surfaces are smooth and control shearing process. R-surfaces are rough and present two wavelengths of roughness. The long one controls localization of dissolution surfaces and conduits; the short one is characteristic of dissolution surfaces. The dissolved matter can precipitate in the open structures of the hanging wall damage zone, decreasing the connectivity of the macroscopic conduit developed within this part of the fault zone.     

Fracture analysis in the south-western Corinth rift (Greece) and implications on fault hydraulic behavior

This paper reviews the data concerning the fracture network and the hydraulic characteristics of faults in an active zone of the Gulf of Corinth. Pressure gap measured through fault planes shows that in this area the active normal faults (Aigion, Helike) act, at least temporarily and locally, as transversal seal. The analysis of the carbonate cements in the fractures on both the hangingwall and the footwall of the faults also suggests that they have acted as local seals during the whole fault zone evolution. However, the pressure and the characteristics of the water samples measured in the wells indicate that meteoric water circulates from the highest part of the relief to the coast, which means it goes through the fault zones. Field quantitative analysis and core studies from the AIG-10 well have been performed to define both regional and fault-related fracture networks. Then laboratory thin section observations have been done to recognize the different fault rocks characterizing the fault zone components. These two kinds of approach give information on the permeability characteristics of the fault zone. To synthesize the data, a schematic conceptual 3D fluid flow modeling has been performed taking into account fault zone permeability architecture, sedimentation, fluid flow, fault vertical offset and meteoric water influx, as well as compaction water flow. This modeling allows us to fit all the data with a model where the fault segments act as a seal whereas the relays between these segments allow for the regional flow from the Peloponnese topographic highs to the coast.     

Fault slip analysis of Quaternary faults in southeastern Korea

The Quaternary stress field has been reconstructed for southeast Korea using sets of fault data. The subhorizontal direction of the maximum principal stress (σ₁) trended ENE and the direction of the minimum principal stress (σ₃) was nearly vertical. The stress ratio (Φ = (σ₂ − σ₃) / (σ₁ − σ₃)) value was 0.65. Two possible interpretations for the stress field can be made in the framework of eastern Asian tectonics; (1) The σ_Hmax trajectory for southeast Korea fits well with the fan-shaped radial pattern of maximum principal stress induced by the India–Eurasia collision. Thus, we suggest that the main source for this recent stress field in southeast Korea is related to the remote India–Eurasia continental collision. (2) The stress field in Korea shows a pattern similar to that in southwestern Japan. The origin for the E–W trending σ_Hmax in Japan is known to be related to the mantle upwelling in the East China Sea. Thus, it is possible that Quaternary stress field in Korea has evolved synchronously with that in Japan. We suggest further studies (GPS and in situ stress measurement) to test these hypotheses.     

Early Jurassic rift structures associated with the Soapaga and Boyacá faults of the Eastern Cordillera, Colombia: Sedimentological inferences and regional implications

The NW-trending Bucaramanga fault links, at its southern termination, with the Soapaga and Boyacá faults, which by their NW trend define an ample horsetail structure. As a result of their Neogene reactivation as reverse faults, they bound fault-related anticlines that expose the sedimentary fill of two Early Jurassic rift basins. These sediments exhibit the wedge-like geometry of rift fills related to west-facing normal faults. Their structural setting was controlled further by segmentation of the bounding faults at approximately 10 km intervals, in which each segment is separated by a transverse basement high. Isopach contours and different facies associations suggest these transverse anticlines may have separated depocenters of their adjacent subbasins, which were shaped by a slightly different subsidence history and thereby decoupled. The basin fill of the relatively narrow basin associated with the Soapaga fault is dominated by fanglomeratic successions organized in two coarsening-upward cycles. In the larger basin linked to the Boyacá fault, the sedimentary fill consists of two coarsening-upward sequences that, when fully developed, vary from floodplain to alluvial fan deposits. These Early Jurassic rift fills temporally constrain the evolution of the Bucaramanga fault, which accommodated right-lateral displacement during the early Mesozoic rift event.