An electrochemical study of pyrite oxidation in the presence of carbon coatings in cyanide medium

The anodic and cathodic behaviour of pyrite with clay and different carbon coatings of activated carbon, graphite and carbonaceous matter in cyanide medium was investigated using the potentiodynamic method. The presence of clay coating did not change the polarisation curve appearance for either the anodic oxidation of pyrite or the cathodic reduction of oxygen or the potential of the current plateau, but only decreased the plateau current especially at a higher coating thickness. The presence of the carbon coatings marginally shifted the rest potential for pyrite to a more anodic position and slightly changed the polarisation curve appearance for pyrite oxidation. The current density for pyrite oxidation largely increased in the presence of the carbon coatings, the potential at the plateau shifted to more cathodic positions, and the plateau width became smaller. These effects became more noticeable at a higher coating thickness. The activated carbon, graphite and carbonaceous matter coatings performed similarly in affecting pyrite oxidation at a similar thickness. The carbon coatings significantly increased the limiting current densities for oxygen reduction on pyrite, and the limiting current plateau became steeper at a higher coating thickness. The carbon coatings increased the limiting current density for oxygen reduction to a similar extent at a low coating thickness, but increased to varied extents at a higher coating thickness. The carbon coatings also greatly increased the cathodic current density for gold reduction on pyrite. The enhancement of pyrite oxidation and oxygen or gold reduction on pyrite by the carbon coatings was likely attributed to the electrochemical interaction between pyrite and the carbon materials with electron-rich surfaces and high conductivity. The presence of the carbon coatings significantly increased the oxidation of pyrite in aerated cyanide solutions and the preg-robbing of pyrite especially at a higher coating thickness.     

The effects of carbon dioxide leakage on fractures, and water quality of potable aquifers during geological sequestration of CO2

Since industrial revolution, the ＂greenhouse effect＂ is one of the most important global environmental issues. Of all the greenhouse gases, CO2 is responsible for about 64% of the enhanced ＂greenhouse effect＂, making it the target for mitigation, so reducing anthropogenic discharge of carbon dioxide attracts more and more attention. Geological sequestration of CO2 in deep saline aquifers is one of the most promising options. But because unknown fractures and faults may exist in the caprock layers which can prevent the leakage of CO2, CO2 will leak upward into upper potable aquifers, and lead to adverse impacts on the shallow potable aquifers. In order to assess the potential effect of CO2 leakage from underground storage reservoirs on fractures and water quality of potable aquifers, this study used the non-isothermal reactive geochemical transport code TOUGHREACT developed by Xu et al to establish a simplified 2-D model of CO2 underground sequestration system, which includes deep saline aquifers, caprock layers, and shallow potable aquifers, and study and analyze the changes of mineral and aqueous components. The simulation results indicated that the minerals of deep saline aquifers and fractures should be mainly composed of aluminosilicate and silicate minerals, which not only enhance the mass of CO2 sequestrated by mineral trapping, but also decrease the porosity and permeability of caprock layers and fractures to prevent and reduce CO2 leakage. The results from deep saline aquifers showed that the mass of carbon dioxide trapped by minerals and solution phases is limited, the rest remained as a supercritical phase, and so once the caprock aquifers have some unknown fractures, the free carbon dioxide phase may leak from CO2 geologic sequestration reservoirs by buoyancy.     

Associations and mobility of uranium in soils near a depleted uranium （DU） weapons testing site, SW Scotland

Natural uranium has three isotopes, ^238U, ^235U and ^234U, with natural abundances of 99.27 atom %, 0.72% and 0.0055%, respectively. Only ^235U is fissile and the production of nuclear fuel and nuclear weapons involves enrichment of uranium in ^235U. This process also results in separation of ^234U from ^238U, leaving depleted uranium （DU）, with typical ^234U/^238U and ^235U/^238U activity ratios of about 0.19 and 0.013, respectively, as a waste product. The high density, high melting and boiling points and chemical stability of uranium and the availability of DU in relatively pure form mean that DU has many uses, including armour-piercing munitions. Such munitions have been developed in the UK since the 1960s and testing has been carried out by the Ministry of Defence （MoD） at firing ranges such as Dundrennan, SW Scotland and Eskmeals, NW England. The firing of DU munitions can result in the dispersion of DU and its combustion products （oxides） as aerosols or as larger fragments, with the potential for human exposure either directly at the site of detonation or via post-depositional migration in the environment. The aim of this work was to investigate the potential environmental mobility of DU by characterizing the associations of U in soil porewaters with increasing distance from a firing site. To this end, several soil cores located down-wind of the firing site at Dundrennan, near Kirkcudbright, SW Scotland, were collected in May 2006. These were sectioned on-site into 1- or 2-cm depth intervals and porewaters were isolated by centfifugation （10 minutes; 8873 g） on return to the laboratory. Following filtration through 0.2-micron cellulose nitrate filters, the porewaters were analyzed by ICP-QMS （U concentration） and ICP-OES （Fe, Al, Ca, Mg, Mn concentrations）. Sub-samples were also subjected to centrifugal ultrafiltration （100, 30, and 3 kD） and to gel electrophoretic fractionation （agarose; 0.045 M Tris-borate; 20 mA, 30 minutes）. Results showed that U was present at up to 4 μg/L in the soil porewater and that the associations of U varied with sample location and soil depth.     

Effects of low molecular weight organic acids on sorption and desorption behavior of p-chlorophenol by yellow earth

Low molecular weight organic acids （LMWOAs） are important components of root exudates. They play an important role in immobilizing and remobilizing contaminants in rhizospheric soil. Effects of four LMWOAs on the sorption and desorption behavior of p-chlorophenol by yellow earth was studied in batch mode. The results showed that the previous application of LMWOAs to enhanced adsorption capacity of p-chlorophenol of the soil in the order of maleic acid〉malic acid〉oxalic acid〉citric acid. However, when LMWOAs were applied to soil where p-chlorophenol had been previously adsorbed, substantial p-chlorophenol was desorbed from soil by oxalic acid, whereas citric acid, malic acid and maleic acid didn＇t desorb as much p-chlorophenol from soil as deionized water.     

Origin and three-dimensional fluorescence spectrum of the chromophoric dissolved organic matter in Yangtze estuary, East China

Dissolved organic matter （DOM） is an important chemical component in natural water. Chromophoric dissolved organic matter （CDOM）, a fraction of optical properties, plays art important role in the biogeochemical cycle of nutrients in aquatic environment. People realized that DOM cycle is crucial in the global carbon and nitrogen flux, and also is inherently related to nutrients and trace metal elements. Therefore, CDOM was concerned by scientists in global oceanography and limnology fields. Water samples were collected from three sections （North Channel, South Channel and Zhuyuan） of the Yangtze （Changjiang River） estuary in March 2006 Three-dimensional excitation emission matrix （3-DEEM） fluorescence spectra were analyzed for those filtrates through Whatman GF/F filters. Dissolved organic carbon （DOC） was also measured by TOC analyzer. The tidal variety was also taken into account. The 3-D EEM fluorescence scans suggested the fluorescence characteristics of humic acid （Ex=332-344 nm, Em=439-451 nm） and fulvic acid （Ex=250-254 nm, Em=472-478 nm） were obvious, and the fluorescence group of protein-like and tyrosine （Ex=230 nm, Em=283 nm） was also found. They are mainly composed of CDOM in the Yangtze estuary. Further data analysis, especially the fluorescence index （f 450/500）, showed that terrestrial signal was rather strong （1.41-1.65） in the surface water, however, some terrestrial CDOM signals of bottom water showed excursions （1.28-1.39）. On the other hand, anthropogenic sign was impressed in the waters of Zhuyuan, which is one of the main drain outlets of Shanghai Metropolis. DOC concentrations ranged from 2.2 mg/L to 3.4 mg/L in Zhuyuan and South Channel, and from 2.0 mg/L to 2.4 mg/L in North Channel. The tide effect played a role in the composition of the CDOM measured by 3-D fluorescence scan technology.     

森林碳汇决策与农村可持续发展研究(英文)

认为有必要在基于碳汇的土地利用和当地可持续发展之间建立一种更加明确的联系.依托一个中国-加拿大合作项目,以中国贵州省黎平县为例,阐述了一种将森林碳汇、森林资源管理以及如何促进当地可持续发展联系起来的综合评估方法,并且着重介绍了能帮助资源管理和规划部门实施这种综合评估的土地利用决策支持工具(LUDST) .     

湿地生态系统碳循环过程及碳动态模型

从地上、地下有机物质生产对湿地碳输入的贡献,湿地土壤碳库以及土地利用变化对湿地土壤碳库和碳排放的影响,甲烷排放和可溶性有机碳输出以及影响因子,湿地生态系统碳循环动态模型4个方面对湿地生态系统碳循环国内外研究进展和研究成果进行综述、分析,提出了我国亚热带区域天然湿地碳循环研究的主要热点和方向:⑴沿海湿地碳库估算及土地利用转化对土壤碳库和温室气体排放的影响;⑵酸沉降对于我国东南沿海低纬度地区湿地甲烷排放的影响;⑶沿海湿地生态系统碳循环动态模型的应用与开发;⑷湿地系统可溶性有机碳的输出机理探讨.     

大气CO2浓度升高对土壤中不同粒级碳的影响

不同粒级土壤中的碳有着不同的周转规律，在高CO2浓度条件下，它们含量的变化将在一定程度上反映土壤碳是累积还是减少，对明确土壤碳的变化趋势有重要意义．采用田间培养试验初步模拟研究在高CO2浓度条件下土壤不同粒级碳的分布．结果表明，加入秸秆培养1年，由于CO2浓度升高的原因导致在低氮（LN）、常规氮（NN）和高氮（HN）水平下土壤中碳分别增加0．01、1．10、1．22g／kg，表现为粒级〈53μm土壤颗粒中碳分别增加1．53、2．19、2．70g／kg．粒级〈53μmm土壤颗粒碳量的增加，主要是由于其重量分配百分数显著增加36．2％，碳浓度增加5．4％；粒级〉250μm和250～53μm土壤颗粒部分虽然其碳浓度分别增加20．8％和17．3％（P〈0．05），怛由于重量分配百分数分别显著降低22．8％和36．1％，结果碳量降低．试验表明高CO2浓度导致不同粒级土壤的分配及碳浓度的变化；高氮施肥水平下有增加土壤碳量特别是小粒级土壤碳量的趋势．