若羌县阿北银铅矿地质特征与成因初探

阿北银铅矿位于阿尔金北缘断裂南侧,矿体产于石炭纪二长花岗岩中的偏脆性断裂破碎带中,呈脉状、透镜状、带状沿断裂构造及裂隙产出.硫同位素组成特征显示,硫源可能为海相沉积岩来源硫与岩浆来源硫的混合,铅同位素组成显示其来源于上地壳.该矿床为受断裂裂隙控制、与石炭纪中酸性岩浆活动有关的岩浆热液型矿床.     

斑岩铜矿床研究进展

斑岩铜矿不但形成于环太平洋成矿域,还形成于特提斯成矿域和中亚成矿域（古亚洲洋成矿域）。成矿物质来源于深部,经过“洋壳一地幔熔岩流”、“原始岩浆”、“浅部富矿岩浆”和“岩浆结晶一成矿”4个阶段,其中在“原始弧岩浆”阶段,通过MASH过程,有大量成矿物质和能量的聚集。成矿流体为富H2O、高温、高压、高盐度、强氧化性、高氧逸度的富矿气液相流体,这些特点有利于成矿物质在岩浆一热液分离过程中向流体富集,并以氯络合物的形式运移。随着成矿流体的上侵,温度和压力的降低是成矿物质沉淀的主要影响因素。磁铁矿的结晶为成矿流体提供了大量的S2-离子,也是导致成矿物质沉淀的主要因素。斑岩型蚀变带从里向外为石英内核、钾化带、SCC带和泥化带,铜矿化主要发育在矿化带外围以及SCC带。目前,斑岩铜矿成矿模型主要有经典模型、系统模型和多阶段叠加模型。     

歧口凹陷沙三段成岩作用对储层物性贡献率研究

为定量描述各种成岩作用对储层物性变化的影响,提出成岩综合系数(C),该系数由压实作用(α)、胶结作用(β)、溶蚀作用(γ)等3个成岩要素贡献率之和构成。通过对研究区大量岩芯薄片分析统计,经多元回归,建立各种成岩作用与孔隙度之间的关系式,得出它们对储层物性的贡献率,认为胶结作用是储层物性的主控因素。     

河北省承德县磴西—烟筒山一带银铅锌多金属矿地质特征及矿床成因

河北省承德县磴西—烟筒山一带银铅锌多金属矿位于温家沟—东山断裂带内,区内已知有姑子沟银铅锌矿、富豪银矿,以及新发现的富含金银的锌多金属矿.矿体多为隐伏矿体,受断裂破碎带的控制;矿体呈单脉、复脉状产出,有分支复合特点,银-铅锌-金等多金属矿共生;同位素地球化学特征和包裹体地球化学特征显示,成矿元素、硫和热液主要为地壳深部...     

查干凹陷早白垩世碎屑岩储层成岩作用及孔隙演化

在对大量薄片和岩心观察分析基础上,结合扫描电镜和全岩分析、 X衍射粘土分析、 包裹体测温等手段,对查干凹陷碎屑岩储层的成岩作用和孔隙演化进行了研究。结果表明: 研究区碎屑岩储层主要为低成分成熟度、 低结构成熟度的长石岩屑砂岩,成岩作用呈现“强压实、 强胶结、 弱交代、 弱溶蚀“的“两强两弱”特征;成岩阶段主要处于中成岩A期,局部达中成岩B期至晚成岩期。两期胶结主要发生在苏二早期和乌兰苏海时期,中浅层（<2 500 m）较低孔隙度主要由于强压实和早期致密胶结所致;较高孔隙度是由于原生孔隙保存较好,长石及碳酸盐胶结物的溶蚀作用导致孔隙度增大。深层碎屑岩储层（>2 500 m）较低孔隙度除压实作用外,碳酸盐致密胶结是主因;较高孔隙度则为早期酸性溶蚀叠加晚期碱性溶蚀产生次生孔隙为主。晚期碱性溶蚀发生在油气充注之后,为无效溶孔。     

Fluvial deposits within the Pleistocene Crag at Thorpe St Andrew,Norwich, England

This paper records the findings at a temporary exposure at Thorpe St Andrew near Norwich, Norfolk, UK in Early and early Middle Pleistocene Crag deposits. The British Geological Survey (BGS) describes the particular formation exposed as Norwich Crag consisting of Early Pleistocene shallow marine sediments. The section shows a succession of sorted sands and gravels overlain by a sandy diamicton. Based on field evidence and clast analysis, the sands and gravels are interpreted as the product of point bar and overbank sedimentation and represent the product of a river cutting into and aggrading within the more widespread shallow marine deposits. Composition of the sediments indicates derivation, primarily from Wroxham Crag Formation, with a contribution from Norwich Crag. The sandy diamicton is interpreted as late Middle Pleistocene Corton Till that is recorded in the area. A distinct pattern of colour changes at the top of the sands and gravels is interpreted as a soil that developed on the fluvial sediments before being overridden by the glacier that deposited the Corton Till. The existence of the fluvial sediments within the regional shallow marine deposits suggests that a fall of sea-level, possibly due to climate cooling, while the elevation of the sediments and the adjacent Crag implies that the site has been uplifted since sedimentation. This is the first observation of terrestrial sediments within the shallow marine Crag. The paper also makes a contribution to understanding the diagenetic processes that give deposits within this region some distinctive colour and sediment patterns.     

Fracture-aperture size—frequency,spatial distribution,and growth processes in strata-bounded and non-strata-bounded fractures,Cambrian Mesón Group,NW Argentina

In Cambrian Mesón Group, NW Argentina, small faults and three opening-mode fracture sets defined by orientation and cement texture (Sets 1–3) formed sequentially in sandstone that most likely had constant mechanical properties throughout deformation. Yet the opening-mode sets display contrasting fracture-aperture-size distributions, spacing patterns, and tendency to be bed bounded. Set 1 fractures are quartz-filled or -lined opening-mode fractures with crack-seal texture, having a wide range of opening-displacement (kinematic aperture) sizes; they are irregularly spaced and non-strata-bounded fractures. Set 1 macro and microfracture-opening-displacement sizes are well described by a power law with slope −0.8. Set 2 fractures are microscopic, mostly quartz filled and have characteristic aperture sizes, are probably not bed bounded and have either a near-random or clustered spatial distribution. Set 3 fractures are quartz-lined, opening-mode fractures with extensive open pore space, having a narrow (characteristic) opening-displacement size distribution; they are regularly spaced and stratabounded. Differences between Sets 1 and 3 can be accounted for by quartz deposition resisting fracture reopening to a greater extent for Set 1 during repeated, episodic growth, where crack-seal texture is present in fracture-spanning quartz. In contrast Set 3 fractures are nearly barren with only trace-cement deposits that did not resist opening. Power-law opening-displacement size distributions may be favored in cases where fracture growth is unequally partitioned amongst variably cemented fractures, whereas a characteristic size is favored where growth is unaffected by cementation. Results imply that thermal history and diagenesis are important for fracture-size-distribution patterning.     

页岩孔隙演化及其与残留烃量的耦合关系：来自地质过程约束模拟实验的证据

加强页岩孔隙演化规律研究,特别是定量评价其与残留烃之间的关系对页岩油的勘探具有重要意义。采集鄂尔多斯盆地低成熟度湖相Ⅰ型富有机质页岩,通过地质条件约束(埋藏史、地层压力、地层水矿化度等)成岩物理模拟实验模拟页岩演化,利用压汞法、氮气吸附法和二氧化碳吸附法获得不同温压段页岩的比孔容、比表面积和孔径分布,结合氯仿沥青A抽提定量结果,确定孔隙演化规律及其与残留烃的关系。结果表明页岩大孔比孔容与残留烃含量先增加后减小,微孔和中孔的比孔容随着模拟实验温度的增加呈现先减小后增大。XRD分析显示黄铁矿含量控制大孔,有机质丰度和粘土含量控制微孔和中孔。微孔和中孔的比孔容增加为高—过成熟度阶段页岩气提供储集空间,大孔比孔容与残留烃含量变化一致,生油窗阶段大孔增加是页岩油的有利储集带。     

The Ge/Si ratio as a tool to recognize biogenic silica in chert

Germanium and silicon, dissolved in seawater, are considered to be incorporated into biogenic opal with no or little fractionation, which permitted to use diatoms as reliable recorders of seawater Ge/Si. Does some fractionation occur during diagenesis, preventing the use of Ge/Si in ancient sediments? We examined the Ge/Si ratio of fossil sponges and flint nodules of the Cretaceous Chalk Formation of northern France. Though disputed, silica in this formation is considered to originate from sponges. No fractionation is observed between sponges and diagenetic flints, which allows us to observe whether Ge/Si bears a biogenic or detrital signature. We may thus confirm that sponges were the main silica supplier during the chalk deposition. The Ge/Si ratio may be used to identify a biogenic signature in cherts where the origin of silica is dubious.     

Relating background fractures to diagenesis and rock physical properties in a platform–slope transect. Example of the Maiella Mountain (central Italy)

Fractured reservoirs are of prime interest as fracture networks control most of the fluid flow and/or accumulation. However, characterizing 3D fracture patterns from subsurface data remains challenging. Studying fractures on outcrops is a good substitution to 1D data from subsurface exploration tools. In addition, outcrops allow deciphering the nature, origin and conditions for fracture formation through the geodynamic history. In this paper, we aim at characterizing the true 3D fracture patterns and determining the genetic role of facies, diagenesis and rock physical properties. We targeted a platform–slope transect within a carbonate reservoir analog, the Maiella Mountain in central Italy, where implications for analog hydrocarbon reservoir can be discussed.Fracture patterns are sorted based on geometric and kinematic criteria from field measurements and petrographic analyzes on thin-sections. Sedimentary facies, pore types and rock physical properties have been characterized in order to establish the impact of early diagenesis on rock evolution. Diagenetic sequences have been unraveled and correlated to the fractures. Fracture sequences have been determined considering the cross-cutting relationships and compared with burial–uplift history. In the two studied formations (platform and slope carbonates), we interpret a stage of fracturing perpendicular to bedding, formed at shallow depth and occurring prior to major regional tectonic events. The studied carbonates have undergone early diagenesis during fast and shallow burial, conferring early brittle behavior. The amount of stylolites is not correlated to burial depth but to fracture density, porosity and free air P–wave velocity. It means that fracture development, mechanical and petrophysical properties are acquired during early diagenesis.Both studied formations have undergone the same geodynamic history and their brittle response is different and not related to folding but to burial and early cementation. Deciphering the close relationship between sedimentary facies, diagenetic and geodynamic history has allowed unraveling the controling factors on rock properties and therefore on fracture pattern.