国产热浸锌锚链的耐蚀性研究(Ⅰ):热浸锌锚链的海港试验

本文记叙了国内外首次以大型商品化热浸锌锚链为研究对象的海港试验结果,跟踪记录了其4年的腐蚀与生物污损发展过程。分别于2013年7月、2014年7月、2015年7月和2016年7月将试验锚链提出海面,对出现在锚链上的全部附着生物进行刮取、分类、鉴定、称重,清洗锚链的表面,检查锈点,并对热浸锌锚链表面测厚,照相记录跟踪全过程。试验结果表明：裸钢腐蚀严重,锈层在2~3mm,腐蚀产物易成片脱落,形成大小不等的腐蚀坑,最大坑深3mm左右;热浸锌锚链未出现明显腐蚀点,大气区锌层腐蚀速率约10μm/a,水下区锌层腐蚀速率约20~70μm/a,但在两个链环连接处出现磨蚀锈斑;耐蚀性在不同区带中表现为水上链>水下链;热浸锌锚链表面的污损生物数量少于未浸锌锚链,随着时间延长,热浸锌锚链表面污损生物逐年增多,其中优势生物为海鞘（Ascidians）、苔藓虫（Bryozoans）,其次是贻贝（Mytilus sp.）、牡蛎（Ostreidae sp.）、石莼（Ulva sp.）,曾出现南方污损生物种,如翡翠贻贝（Perna viridis）。2013~2014、2014~2015、2015~2016三年锚链单位面积上污损生物的重量分别为1257.6、1454.6和21304.0g/m²。污损生物重量的增加大大增加了锚链的磨蚀程度,为锚链腐蚀失效埋下了隐患。本研究为海洋工程锚链设计或应用提供了宝贵的科学依据。     

山西代县中心地震台形变动态特征浅析

文章介绍了代县中心地震台各形变观测手段的基本情况,通过对各测项资料的分析,进一步研究其动态特征和映震能力,总结地震前兆短临异常,为地震预测研究提供参考依据。     

Experimental investigation of spatially varying effect of ground motions on bridge pounding

Pounding between adjacent bridge structures with insufficient separation distance has been identified as one of the primary causes of damage in many major earthquakes. It takes place because the closing relative movement is larger than the structural gap provided between the structures. This relative structural response is controlled not only by the dynamic properties of the participating structures but also by the characteristics of the ground excitations. The consequence of the spatial variation of ground motions has been studied by researchers; however, most of these studies were performed numerically. The objective of the present research is to experimentally evaluate the influence of spatial variation of ground motions on the pounding behaviour of three adjacent bridge segments. The investigation is performed using three shake tables. The input spatially varying ground excitations are simulated based on the New Zealand design spectra for soft soil, shallow soil and strong rock using an empirical coherency loss function. Results confirm that the spatially nonniform ground motions increase the relative displacement of adjacent bridge girders and pounding forces. Copyright © 2012 John Wiley & Sons, Ltd.     

圆形空心钢管混凝土柱的耐火性能实验研究

关于实心钢管混凝土的耐火性能已有大量的实验研究,而空心钢管混凝土的耐火实验目前还非常少见。针对这一不足,对空心钢管混凝土进行了耐火实验研究,其中考虑了不同的空心率,并对中空注水对构件耐火性能的影响也进行了实验研究。实验结果表明：在相同的荷栽比下,构件的耐火时间随空心率先增大后减小。当空心率较小时,中空注水对构件耐火时间的提高作用不明显;当空心率较大时,注水对耐火时间的提高才体现出来。     

钢管混凝土柱带钢板耗能键组合剪力墙抗震研究

提出了连排钢管混凝土柱带钢板耗能键组合剪力墙,它由钢管混凝土连排柱、柱间钢板耗能键、钢板耗能键外包混凝土条带三种单元组合而成。进行了4个不同设计参数试件的低周反复荷载试验研究。分析了各试件的承载力、刚度及其退化过程、滞回特性、延性和破坏特征,探讨了分灾耗能机制。研究表明:连排钢管混凝土柱带钢板耗能键组合剪力墙,承载力较大,后期刚度较稳定;混凝土条带在开裂与闭合过程中消耗地震能量,钢板耗能键通过弯剪变形消耗地震能量,钢管与混凝土条带共同工作协同耗能,具有良好的抗震耗能机制;这种新型组合剪力墙具有较强综合抗震耗能能力。     

AN EXPERIMENTAL STUDY ON THE PROCESS OF INTERGRANULAR PRESSURE SOLUTION OF PLAGIOCLASE GOUGE UNDER HIGH TEMPERATURE AND PRESSURE: METHOD AND PRELIMINARY RESULTS

To understand the mechanism of lower-crust earthquake and slow slips, it is necessary to study the frictional properties of mafic rocks and their major rock-forming minerals. Previous studies have performed a series of experimental researches on gabbro, basalt and their major constituents. According to the results of previous experiments, frictional sliding of plagioclase under hydrothermal conditions(100~600℃)shows a property of velocity weakening, and the experimental results show that both the direct rate effect parameter(a)and the healing effect parameter(b)increase with temperature, a typical feature for thermally-activated processes. Velocity weakening means property of a shear band that has a stronger friction healing effect than the direct rate effect in the rate and state friction constitutive framework, and the healing effect(b value)in constitutive relation mainly reflects the increase in contact area with time under hydrothermal conditions, with some minor effect of structural changes. Since the microphysical mechanism of feldspar minerals at the contacts is mainly brittle cataclasis for temperatures below 600℃, the significant frictional healing effect in this case can only be explained by the mechanism of pressure solution. In order to determine if the dissolution process of plagioclase actually occurs on the laboratory time scale, we conducted hydrostatic experiments on plagioclase powder samples under hydrothermal conditions whereby frequent contact switch between particles seen in frictional sliding experiments can be avoided, making the observation on the dissolution sites possible. Experimental temperatures were 400℃ and 500℃, with confining pressure of 90~150MPa, pore pressure of 30MPa, with 2mm initial thickness of fault gouge. The mechanical data show that a creep process occurred in the plagioclase fault gouge in the experimental temperature and pressure range; and the microstructures of the experiment show that precipitation of new grains is prevalent as the product of pressure solution process between plagioclase particles. At the same time, it is observed that the contact points have an appearance similar to fused, fuzzy structure as signatures of dissolution. The results of our experiments provide a definite experimental evidence for the healing mechanism in friction of plagioclase and for the theoretical relation between unstable slip and the pressure solution process. The results of the experiments are summarized as follows: (1)Drainage rate of pore water in plagioclase gouge was high in the first few hours of experiment, but gradually decreases over time for both temperature and pressure series of experiments slowing down to a steady state. This feature indicates that there is a creep process that evolves inside the plagioclase gouge. In the temperature-series experiments, the drainage rate of the pore water in the plagioclase gouge at 400℃ is relatively low than the cases for higher temperatures. Thus, the applied temperature is positively correlated with the creep of plagioclase gouge. (2)Scanning electron microscopy(SEM)observations of the experimentally deformed samples were performed on thin sections cut along the sample axis. Firstly, from the images of microstructure, it was found that the degree of particle fracture became more significant at a higher effective pressure, with smaller pore volume between particles. In the temperature-series experiments it was found that the degree of compaction of plagioclase gouge increased with increasing temperature. Precipitation of plagioclase grains in layered structures was generally observed in high-magnification images, indicating the presence of pressure solution processes. Contact points were also found to be in a state of ambiguity that seems to be a fused morphology, but the details of the structure remain to be determined by further observations. The above results indicate that the pressure solution process of plagioclase particles can occur on a typical laboratory time scale, and the results of this study provide robust experimental evidences for the theory that links between pressure solution and the mechanism of frictional healing and unstable slips for plagioclase.     

山西近期形变短期异常的调查和分析

2002年7月开始，山西省地形变观测项目陆续出现了5项异常，其中2项异常(定襄台地倾斜、临汾台地倾斜)到2003年2月已经结束，分析认为，这些异常与2002年9月3日太原5．0级地震有关，其余3项异常仍在发展，调查了周围环境及干扰因素，认为异常较为可信，需密切跟踪监视。     

Iterative implicit integration procedure for hybrid simulation of large nonlinear structures

A fully implicit iterative integration procedure is presented for local and geographically distributed hybrid simulation of the seismic response of complex structural systems with distributed nonlinear behavior. The purpose of this procedure is to seamlessly incorporate experimental elements in simulations using existing fully implicit integration algorithms designed for pure numerical simulations. The difficulties of implementing implicit integrators in a hybrid simulation are addressed at the element level by introducing a safe iteration strategy and using an efficient procedure for online estimation of the experimental tangent stiffness matrix. In order to avoid physical application of iterative displacements, the required experimental restoring force at each iteration is estimated from polynomial curve fitting of recent experimental measurements. The experimental tangent stiffness matrix is estimated by using readily available experimental measurements and by a classical diagonalization approach that reduces the number of unknowns in the matrix. Numerical and hybrid simulations are used to demonstrate that the proposed procedure provides an efficient method for implementation of fully implicit numerical integration in hybrid simulations of complex nonlinear structures. The hybrid simulations presented include distributed nonlinear behavior in both the numerical and experimental substructures. Copyright © 2010 John Wiley & Sons, Ltd.     

流速对浮游藻类生长和种群变化影响的模拟试验

采集夏季崇明岛中心湖原水,在环形有机玻璃水槽开展了不同流速对浮游藻类生长和种群变化影响的研究.相对于静止水槽,实验前期不同的流速条件均对浮游藻类的生长产生了一定的抑制作用,实验后期浮游藻类叶绿素a含量均稳定在一定水平,且流动水槽中叶绿素a含量略大于静止水槽,这可能与静止围隔中出现大量枝角类浮游动物有关,而流动条件则抑制了浮游动物的生长,减轻了对浮游藻类的捕食压力.水体流动导致了浮游藻类种群的变化,蓝藻的迅速消失、绿藻和硅藻形成生长优势是主要特征,表明持续的流动条件是导致浮游植物种属减少和群落结构变化的直接原因.该研究可为调水引流在河道、湖泊和水库中的富营养化控制和水华防治提供基础依据.     

The manufacture of a three-dimensional transducer used in laboratory

Ｔｈｅｍａｎｕｆａｃｔｕｒｅｏｆａｔｈｒｅｅ－ｄｉｍｅｎｓｉｏｎａｌｔｒａｎｓｄｕｃｅｒｕｓｅｄｉｎｌａｂｏｒａｔｏｒｙＸＩＡＯ－ＨＯＮＧＬＩＵ（刘晓红）（ＩｎｓｔｉｔｕｔｅｏｆＧｅｏｐｈｙｓｉｃｓ，ＳｔａｔｅＳｅｉｓｍｏｌｏｇｉｃａｌＢｕｒｅａｕ，...