Experimental evidence of a unique flow rule of non-cohesive soils under high-cyclic loading

The presented results of cyclic triaxial tests on sand demonstrate that the cumulative effects due to small cycles obey a kind of flow rule. It mainly depends on the average stress ratio about which the cycles are performed. This so-called “cyclic flow rule” is unique and can be well approximated by flow rules for monotonic loading. Amongst others it is shown that the cyclic flow rule is only moderately influenced by the average mean pressure, by the strain loop (span, shape, polarization), the void ratio, the loading frequency, the static preloading and the grain size distribution curve. A slight increase of the compactive portion of the flow rule with increasing residual strain (due to the previous cycles) was observed. These experimental findings prove that the cyclic flow rule is an essential and indispensable concept in explicit (N-type) accumulation models.     

胶新铁路砂土液化区路基沉降规律研究

地震液化常给人们带来巨大损失,而剪切振动和循环荷载作用下的动力学效应常被认为是地震液化的主要原因,人们对剪切荷载作用下饱和砂土的液化问题进行了较多的研究,而对循环荷载作用下砂土液化的动力学效应研究较少。胶新铁路在DK39+000开始为高地震烈度区,DK283+550~DK283+770分布有地震可液化层,工程修建后列车动荷载的影响将会有诱发砂土液化的可能性。为了研究通车前自然沉降特征和通车后循环荷载作用下的路基沉降变形规律,本文在具体分析了砂土液化的概念和准则判别的基础上,重点分析了砂土液化区路基沉降特征,包括测试断面竖向分层沉降变形特征分析和路基水平位移特征分析。最后在试验的基础上,从理论上给出了循环荷载下砂土的本构关系。     

Modelling the stress-strain behaviour of saturated rocks undergoing triaxial deformation using complex electrical conductivity measurements

Measurement of complex electrical conductivity as a function of frequency is an extremely sensitive probe for changes in pore and crack volume, crack connectivity, and crack surface topography. Such measurements have been made as a function of pore fluid chemistry, hydrostatic confining pressure, as well as uniaxial and triaxial deformation. This paper will; (1) describe the effects of triaxial deformation on the complex electrical conductivity of saturated porous rocks, (2) use the electrical data to model the mechanical stress-strain behaviour, and (3) compare the modelled behaviour with the stress-strain behaviour measured during the deformation. Experimental conductivity data tracks how the rock undergoes compaction with progressive loss of crack volume, followed by dilatation due to new crack formation, growth of existing cracks, crack interlinkage, and finally failure, as axial strain is increased. We have used the complex electrical data to produce a direction-sensitive (anisotropic) crack damage parameter, and used it to calculate the effective Young's modulus by employing the models of Walsh and Bruner. Comparison of the synthetic stress-strain curves so produced, with the experimentally derived stress-strain curves shows good agreement, particularly for undrained tests. This modelling is an improvement on similar curves produced using isotropic crack damage parameters derived from acoustic emission data. The improvement is likely to be due to the directional sensitivity of the electrical conductivity measurement, and its ability to discriminate between the formation of isolated cracks, and those cracks that contribute to the inter-connected crack space i.e. those cracks upon which transport properties of the rock such as electrical conductivity, and mechanical properties depend most critically during triaxial deformation.     

Shear modulus and damping ratio of grouted sand

An experimental comparative study of three different grouted sands in terms of their effects on the values of two dynamic properties is presented. The dynamic properties studied are the shear modulus and the damping ratio which are determined with resonant column tests and cyclic triaxial tests. The behaviour of a pure Fontainebleau sand is compared with the behaviour of a Fontainebleau sand grouted with a silicate grout, a micro-fine cement grout and a mineral grout. The effects of the grouting treatment, the type of grout, the confining pressure, and the strains, on the shear modulus and the damping ratio are studied. The test results have shown that grouting improves the stiffness of the sand especially for small strains. Whatever the type of material, confining stress improves the shear modulus whereas it has a negligible effect on the damping ratio. When strain increases, the shear modulus decreases and the damping ratio increases.     

Current state of research on flow failure considering void redistribution in liquefied deposits

In liquefied ground, lateral flow is sometimes much larger than surface settlement and may exceed several meters even in a gentle slope of less than a few percent. It occurs not only during but also after earthquake shaking. Conventional laboratory soil tests using uniform sand cannot reproduce this phenomenon. Its mechanism is still poorly understood. In this paper, there is a major focus on the mechanism involving void redistribution or water film effects in layered sand deposits using recent findings obtained by different researchers on void redistribution and the associated lateral flow movement that potentially occurs in layered sand deposits. 1G shake table tests, 1D tube tests, torsional simple shear tests, in situ soil investigations, case history studies, etc. are used to develop an understanding of the lateral flow mechanism during liquefaction. Some of the major findings are; sand deposits in the field consist of sublayers with different particle sizes and permeability and readily develop water films by post-liquefaction void redistribution at sublayer boundaries. The water films may have served as sliding surfaces for large flow during the 1964 Niigata earthquake without the constraint of the dilatancy effect because the water films serve as shear stress isolators. The potential of this type of flow failure will be high for loose sand with relative density around 40% or less.     

东营凹陷旋回式深湖相烃源岩研究

对东营凹陷沙河街组烃源岩的研究发现:在灰褐色泥岩、纹层状褐色泥岩、钙质泥岩和油页岩中常常夹有泥质粉砂岩和少量浊积砂岩;对牛38井密集采样分析则指示有机碳含量等多项地球化学参数呈现出“波峰”、“波谷”状变化特征,沉积界面也清晰地记录了湖平面的旋回式(升降)变换过程。本文探讨了盆地的充填过程,建立了旋回式深湖相沉积的地层模式——平衡充填,并深入分析了该套烃源岩的地质地球化学特征和有机质的赋存状态,指出旋回式深湖相烃源岩与浊积砂和前三角洲砂体主要以交互式或包裹式构成最佳生储配置关系,有利于隐蔽油气藏的形成。     

Field measurements of shear strength of an underconsolidated marine clay

This paper presents the observations of cone penetration testing (CPT), in situ vane shear testing and undrained triaxial testing of underconsolidated marine clay in the Craney Island Dredged Material Management Area (CIDMMA), Norfolk, VA. Comparison of vane shear measurements, taken during 1981–1983, to CPT measurements, taken during 1993, indicates a change in undrained shear strength. Both the vane shear and cone penetration resistances are lowest at the mid-heights of the clay layers and the excess pore water pressures are highest at the mid-height of the clay layers, indicating that the clay layer is underconsolidated.     

A method analyzing deformation of anchor foundations in soft clay under static and cyclic loads

The paper presents a constitutive model to describe undrained cyclic stress-strain responses of soft clays based on the equivalent visco-elastic and creep theories. The hysteretic and nonlinear stress-strain responses of soft clays are described using the equivalent visco-elastic relationship and variations of the cyclic modulus and the damping ratio with the octahedral shear strain, respectively in the model. The cyclic accumulative strain is described using the Mises creeping potential function and the associated flow rule. The method determining the model parameters is given by static and cyclic triaxial tests. The finite element method to analyze deformation of anchor foundation in soft clay under static and cyclic loads is developed based on the model. For the method, a cyclic loading time history is divided into a series of incremental loading sub-processes which include one load cycle at least. The cyclic stress-strain responses of soil elements at any time are not tracked in detail and determined by the equivalent visco-elastic calculations for every loading sub-process. The accumulative deformation of anchor foundations is calculated using the initial strain algorithm. The method has been implemented in ABAQUS Software by developing interface programs. Model tests of the suction anchors are conducted and predicted using the method. Comparisons of predicted and model test results show that the method can be used to evaluate cyclic stability and reveal the failure process and mechanism of anchor foundations by analyzing deformation time-histories.     

Behavior of stratified sand–silt–gravel composites under seismic liquefaction conditions

Laboratory seismic liquefaction studies have generally dealt with homogeneous soil conditions only, although stratified soils exist for various soil deposits. The main objective of this research project was to compare the behavior of stratified and homogeneous sand–silt–gravel composites during seismic liquefaction conditions for various silt and gravel contents. An experimental program was undertaken in which a total of eighty stress-controlled undrained cyclic triaxial tests were performed. Two methods of sample preparation were used for each soil type. These methods included moist tamping (representing homogeneous soil conditions) and sedimentation (representing layered soil conditions). The silt contents ranged from 0 to 50%, and soils with 10 and 30% gravel contents were tested. The confining pressure in all test series was 100 kPa. The results indicate that the liquefaction resistances of layered and uniform soils are not significantly different, despite the fact that the soil fabric produced by the two methods of sample preparation is totally different. This finding justifies applying the laboratory tests results to the field conditions for the range of variable studied.     

魏岗油田二层系统周期注水地质模型

利用概率-统计方法建立了魏岗油田二层系统周期注水地质模型．