Incremental elastoplastic FEM for simulating the deformation process of suction caissons subjected to cyclic loads in soft clays

This paper presents an incremental elastoplastic finite element method (FEM) to simulate the undrained deformation process of suction caisson foundations subjected to cyclic loads in soft clays. The method is developed by encoding the total-stress-based bounding surface model proposed by the authors in the ABAQUS software package. According to the model characteristics, elastoplastic stress states associated with the incremental strains of each iteration are determined using the sub-incremental explicit Euler algorithm, and the state parameters describing the cyclic accumulative rates of strains are updated by setting state variables during the calculations. The radial fallback method is also proposed to modify the stress states outside the bounding surface to the surface during determination of the elastoplastic stress states. The stress reversals of soil elements are judged by the angle between the incremental deviatoric stress and the exterior normal vector at the image stress point on the bounding surface to update the mapping centre and state variables during cyclic loading. To assess the general validity of the method, the reduced scale model tests and centrifuge tests of suction caissons subjected to cyclic loads are simulated using the method. Predictions are in relative good agreement with test results. Compared with the limit equilibrium and quasi-static methods, the method can not only determine the cyclic bearing capacity, but can also analyse the deformation process and the failure mechanisms of suction caisson under cyclic loads in soft clays.     

压实粉土非线性应力-应变关系的试验研究

对京九线路基粉土用GDS三轴仪进行固结不排水剪试验,研究不同围压、含水量、压实度下压实粉土样的应力-应变关系。结果表明:压实粉土在低围压下为应变软化,高围压下为应变硬化,存在一个屈服应力;含水量和压实度对粉土强度和应力-应变关系影响显著,随着含水量的减小、压实度的增大,压实粉土样强度增大,应力-应变曲线上升。对围压小于屈服应力的应变软化曲线,用常规的土的软化关系式进行拟和;对围压大于屈服应力的应变硬化曲线,用邓肯-张模型进行拟和;这二者的结合能描述压实粉土的应力-应变关系曲线,效果良好。     

The penetration experiment to predict liquefaction resistance of reclaimed soils

The liquefaction resistance of the soils used to be estimated through the in situ tests, such as standard penetration test and cone penetration test; or by means of cyclic triaxial test in laboratory. However, both in situ tests and cyclic triaxial test are time-consuming and costly; this study introduces a quick and cost-effective method to evaluate the liquefaction resistance of soils under certain confining pressure in laboratory. A particular device modified from the conventional triaxial compression test apparatus, namely “Triaxial Cone Penetration Test”, was developed to obtain the peak values of cone resistance in soils so as to correlate the liquefaction resistance of the reclaimed soils evaluated by cyclic triaxial tests. The test result indicates a good correlation between the peak value of cone resistance and the corresponding cyclic stress ratio (CSR) at the state of initial liquefaction, in which the correlation for loose samples is better than that for dense samples. Besides, both peak values of cone resistance and corresponding CSR increase with fine content of soils reaches 10% and decreased with fine content varying between 10% and 50%. By examining the compositions of the soils with scanning electron microscopy and X-ray diffraction, it is found that the proportion and characteristics of the fines plays an important role on the liquefaction resistance of the reclaimed soils.     

Effects of installation on the cyclic axial behaviour of suction buckets in sandy soils

Suction buckets differ with their easy and cost-efficient installation technique from other foundation types for offshore wind turbines. For successful completion of their installation process, suction is essential, but the imposed seepage leads to the changes in states of the soil in and around the bucket. Especially, a loosening of soil inside the bucket affects the load carrying behaviour of bucket subjected to repetitive loading resulting from environmental conditions. In this study, the behaviour of buckets under cyclic axial compressive loads with considering a possible loosening and related changes in permeability of soil inside the bucket is investigated numerically. In the framework of finite element analysis, a fully coupled two-phase model and a hypoplastic constitutive model are used to describe the saturated sandy soil behaviour under repetitive loading. The porosity-permeability variation is taken into account by Kozeny–Carman relationship. Special attention is dedicated to load carrying behaviour of bucket top plate, inner and outer skirt as well as base and their changes resulting from a loosening of soil inside the bucket with variable aspect ratio. For this purpose, cyclic axial compressive loads which cause an attenuation and progressive failure of soil-bucket system response are considered. The main findings on the changes in load carrying behaviour of bucket are presented and discussed.     

Drainage conditions around monopiles in sand

Large diameter monopiles are typical foundation solutions for offshore wind turbines. In design of the monopile foundations in sand, it is necessary to understand the drainage conditions of the foundation soil under the design loading conditions as the soil performance (strength and stiffness) is highly dependent on the drainage conditions. This paper presents a numerical investigation into this issue, with a purpose to develop a simple design criterion for assessing the soil drainage conditions around a monopile in sand. It is found that for typical monopile foundations in sand, the drainage condition during a single load cycle is generally expected to be undrained. However, the current state-of-practice uses p-y springs derived for drained soil responses for monopile design. The impact of this discrepancy on monopile foundation design was evaluated and found to be insignificant due to the relatively low level of loading as compared to the capacity of the soil.     

Development of the cyclic p–y curve for a single pile in sandy soil

Pile foundations that support transmission towers or offshore structures are dominantly subjected to cyclic lateral load induced by wind and waves. For a successful design, it is crucial to investigate the effect of cyclic lateral loads on the pile behavior that is loaded laterally. Although the p–y curve method is generally utilized to design the cyclic laterally loaded pile foundations, the effect of cyclic lateral loads on the pile has not been properly implemented with the p–y curve. This reflects a lack of consideration of the overall stiffness change in soil–pile interaction. To address this, a series of model pile tests were conducted in this study on a preinstalled aluminum flexible pile under various sandy soil conditions. The test results were used to investigate the effect of cyclic lateral loads on the p–y behavior. The cyclic p–y curve, which properly takes into account this effect, was developed as a hyperbolic function. Pseudo-static analysis was also conducted with the proposed cyclic p–y curve, which showed that it was able to properly simulate cyclic laterally loaded pile behavior in sandy soil.     

Lateral cyclic response of an aluminum model pile in sand

Lateral cyclic load tests were performed on an aluminum model pile in dry sand. Two levels of loading were adopted to represent different service load conditions. The maximum number of loading cycles was 1,000. From the test results, it was found that the even though in the service load condition, the pile response was still affected by cyclic effects and a larger load level would produce more significant influence. In a global point of view, the lateral displacement and maximum moment increased with loading cycles, while the secant stiffness within a cycle decreased with cycles. The cyclic effect was more significant on the lateral displacement than on the moment. In a local point of view, cyclic loading would degrade the equivalent subgrade stiffness for the soil shallower than about seven times diameter. In addition, the secant subgrade stiffness within a cycle increased with loading cycles. Some experimental relationships of lateral pile response and loading cycles were built and compared with those in the literature.     

Cyclic sedimentation and climatically caused sea-level changes in the Late Palaeozoic of Central Europe

Significant short-term fluctuations are characteristic of geological history since Precambrian times. Only the younger Quaternary climatic fluctuations are known in more detail as a result of a high grade time resolution. Climatic change can also be postulated with respect to older, cold periods during which polar inland ice sheets developed. From a discussion of endogene and exogene interpretations it is shown that global climatic changes, and the sea-level changes induced by them, as well as changes in the position and extent of climatic zones throughout the world provide a control mechanism for sedimentation which is consistent with cyclic sedimentation in Late Palaeozoic times, and also if the basin subsides non-cyclically. The model allows an explanation of the development of the Permo-Carboniferous sedimentary cycles without numerous short-term vertical oscillations of the earth's crust. In reality, exogene and endogene controls on sedimentation act together in great variety of combinations.     

Suction-controlled triaxial testing: Laboratory procedures in relation to resistance envelope methods

In certain tropical slopes it appears possible that soil suction may play a significant role in maintaining stability. This communication outlines a laboratory suction-controlled triaxial test that can be undertaken to validate the threshold suction predicted by resistance envelope methods. It is shown that for two sites examined in St. Lucia, West Indies, the results from such a test confirm results obtained by use of resistance envelopes.