大陆地震的动力学模型研究

应用非线性动力学模型，以大陆构造构体为参照对象，对大陆地震的成组孕育和发生过程进行模拟研究，通过对６×８弹簧－滑块－阻尼器组合单元非线性动力学模型的理论计算及其结果的分析，得到了一系列与实际地震较类似的人工地震图像，如模型中的地震活动在时间上有轮回怀，在地点上有条带性，并在不同轮回中有条过移的现象。模型中应力变化十分复杂，但仍能为预测地震提供概略性的信息。     

试论陆壳增生的两种基本模式及其对比

大陆地壳是地球形成演化的必然产物。大陆地壳由不同时代、不同类型、不同规模地体的拼贴而增生；同时已形成的大陆地壳沿着新的断裂分裂、离散而碱小。因此大陆地壳是地体拼贴增生与分裂离散的综合结果。太古代早期，原始陆壳形成后，主要通过环太平洋型与天山型两种基本模式达到陆壳的增生。环太平洋型陆壳增生模式出现于陆块的边缘，由古大陆向大洋方向单向增生，增生年代由老到新，增生地体一般都有较大距离的移置，其增生与板块的俯冲作用密切有关。天山型陆壳增生模式出现在陆块的内部，其形成与陆块的开台作用密切有关，可以但不一定伴随有俯冲作用。当古大陆沿一定方向断裂带分裂、离散。其间形成新的海槽接受碳酸盐岩和正常陆源碎屑沉积物与来自地壳深部或地幔的火山物质。由于壳下应力条件改变，两侧古陆相向运动，海槽中物质受两侧古陆碰撞挤压，形成褶皱造山带，并把两侧的古大陆“焊接”成新的、范围更大的大陆地壳。     

构造层次与大陆壳动力学机制转变关系

针对构造层次研究现状和存在的问题，把大陆壳划分为深部，中部，浅部和浅－表部四个构造层次。依据各自所处特定的构造位置、组成构造岩类型、形成的制约因素和地质时代等方面的区别，各构造层次分别是壳－幔间滑动，大陆张裂、隆－滑构造和变质核杂岩构造等多种大陆壳动力学机制转变过程中的产物。构造层次与大陆壳动力学机制转变关系的确定，更有利于古老板构造连续性、整体性的研究以及多期、多层次、多旋回大陆地壳演化模式的建     

Attenuation differences in layer 2A in intermediate- and slow-spreading oceanic crust

In situ seismic attenuationQ⁻¹logs are derived from borehole velocity profiles and reveal sharp boundaries between morphologies of the extrusive volcanic layers in intermediate- and slow-spreading oceanic crust.Q⁻¹logs are calculated from the scattering attenuation associated with vertical velocity heterogeneity in Ocean Drilling Program Holes 504B and 896A and in Hole 395A, located in 5.9–7.3 Ma crust on the Pacific and Atlantic plates, respectively. Our results strongly tie crustal properties to seismic measurables and observed geological structures: we find that the scattering attenuation can be used to identify the extrusive volcanic sequence because it is closely related to changes in the degree of vertical heterogeneity. We interpret a distinct decrease in the Q⁻¹log at the transition below the extrusive volcanic layer to correspond with the seismic layer 2A/2B boundary. The boundary is located at 465 m depth below the sea floor in both Hole 395A and 504B, although this is likely to be a coincidence of the sediment thickness at these sites. Layer 2A is estimated to be approximately 150 m thick in Hole 504B and > 300 m thick in Hole 395A. Cyclic sequences of high-porosity pillows and low-porosity massive units in the uppermost 100 m of volcanics in Hole 395A result in large velocity heterogeneities which cause > 5 times more attenuation in this layer than in Hole 504B. In Hole 896A, by contrast, fewer pillows, more massive flows, and a greater volume of carbonate veins decrease the velocity heterogeneity and attenuation significantly over only 1 km distance from Hole 504B. We conclude that the attenuation in the extrusive volcanics of the ocean crust is largely controlled by variation in local heterogeneity and morphology as well as by subsequent hydrothermal alteration. The observed differences inQ⁻¹profiles and layer 2A thickness at these sites may be attributed to variations in the volume and duration of volcanic activity at mid-ocean spreading centers for these Pacific and Atlantic ridge segments.     

世纪之交我国震源物理研究的进展与展望

从大陆地震震源的观测研究、震源力学的理论研究和震源物理实验三个方面，评述了90年代以来中国震源物理研究的进展.这些进展包括：大陆地震的震源参数测定；利用数字地震资料进行的“现代”震源参数的反演；地震断裂力学的应用和发展；非线性物理学在震源研究中的应用；岩石破裂实验的发展；地震前兆的物理机制的实验研究等.指出了新技术的发展和现代物理科学的发展对90年代以来震源物理研究的重要影响．展望了跨世纪的我国震源物理研究的发展方向，指出震源物理研究的进展必将在大陆地震预测和减轻地震灾害方面发挥积极的作用．     

联合办刊是科技期刊走出困境的重要途径--以《灾害学》杂志为例

以《灾害学》杂志为例，论述了联合办刊的问题。实践证明，联合办刊是解决科技期刊办刊经费不足、发行量有限、稿源短缺等问题并使其走出困境、寻求发展的重要途径。     

浅议中国地震科技期刊

对地震系统科技期刊普遍存在的问题进行了梳理．分析了形成的原因。指出，只有摆脱传统办刊的束缚．树立全行业、全社会办刊的意识．进行管理模式的改革、对系统内期刊进行整合、与系统外期刊进行联合．才能使地震科技期刊走出困境。     

Physical disturbance creates bacterial dominance of benthic biological communities in tropical deltaic environments of the Gulf of Papua

Unlike many reactive continental shelf mud deposits in temperate regions, bacteria and microfauna rather than macrofauna typically dominate benthic biomass and activities over large areas of the Gulf of Papua (GoP) deltaic complex, Papua New Guinea. During mid NW monsoon periods (Jan–Feb), macrofaunal densities at Gulf stations were relatively low (), large macroinfauna were absent (upper 25 cm), and small (), surface deposit-feeding polychaetes and tubiculous amphipods were dominant, reflecting a frequently destabilized seabed and high sedimentation/erosion rates. Although frequent physical disturbance generally inhibits development of macrobenthic communities, some regions of the Gulf deposits are periodically colonized and extensively bioturbated during quiescent periods, as shown by preserved biogenic sedimentary structures. Bacterial inventories integrated over the top 20 cm were extremely variable within each sub region of the clinoform complex. A possible bimodal pattern with bathymetric depth and distance offshore may occur: lowest-inventories within the sandy, proximal Fly River delta, an open Gulf inner topset zone (10–20 m) having sites of relatively high inventories, an open Gulf mid-topset region with intermediate values and less extreme variation, and the outer topset—upper foreset zone (40–50 m) where highest values are attained (). Various measures of microbial activity, including measures proportional to the cellular rRNA content and the proportion of dividing cells, indicate extremely productive populations over the upper 1-m of the seabed throughout the Gulf of Papua region. Bacterial biomass (0–20 cm) including data of Alongi et al. (1991, 1992, 1995) varied from a low of in intertidal mud banks to a high of in the topset—foreset zone. Macrofaunal biomass did not exceed in any sampled region, ranging from 0.009±0 to with no obvious correlation with bathymetric depth (1–63 m). Meiofaunal biomass was generally an order of magnitude lower than macrofaunal biomass. Relatively elevated bacterial biomass and high turnover rates are consistent with high measured rates of benthic remineralization, presumably reflecting the rapid response time of bacteria to physical reworking, the associated entrainment of organic substrate, and flushing of metabolites. Solute exchange is also enhanced below the directly mixed surface region, possibly producing ‘far field’ stimulation of microbes in underlying deposits. Physical reworking and reoxidation of sediments between 10 and 50 m water depth maintain suboxic, nonsulfidic conditions in the upper 0.5–1 m despite active microbial communities and high benthic remineralization rates.     

A brief comparison of lava flows from the Deccan Volcanic Province and the Columbia-Oregon Plateau Flood Basalts: Implications for models of flood basalt emplacement

The nature and style of emplacement of Continental Flood Basalt (CFB) lava flows has been a matter of great interest as well as considerable controversy in the recent past. However, even a cursory review of published literature reveals that the Columbia River Basalt Group (CRBG) and Hawaiian volcanoes provide most of the data relevant to this topic. It is interesting to note, however, that the CRBG lava flows and their palaeotopographic control is atypical of other CFB provinces in the world. In this paper, we first present a short overview of important studies pertaining to the emplacement of flood basalt flows. We then briefly review the morphology of lava flows from the Deccan Volcanic Province (DVP) and the Columbia-Oregon Plateau flood basalts. The review underscores the existence of significant variations in lava flow morphology between different provinces, and even within the same province. It is quite likely that there were more than one way of emplacing the voluminous and extensive CFB lava flows. We argue that the establishment of general models of emplacement must be based on a comprehensive documentation of lava flow morphology from all CFB provinces.     

Centrifuge modelling of the influence of crustal fabrics on the development of transfer zones: insights into the mechanics of continental rifting architecture

Centrifuge analogue experiments are used to model the reactivation of pre-existing crustal fabrics during extension. The models reproduced a weakness zone in the lower crust whose geometry was varied in order to investigate its role in controlling the architecture of rift segments and related transfer zones. The typical rift system geometry was characterised by two offset rift segments connected by a major transfer zone in which boundary faults were oblique to the extension vector and displayed a significant transcurrent component of movement. The transfer zone was also characterised by cross-basin faults with both trend and strike-slip component of movement opposite to that displayed by the master faults. Typically, different structural patterns were obtained by changing the offset angle φ between the rift segments, supporting that the structural pattern at transfer zones is strongly influenced by the orientation of pre-existing discontinuities with respect to the stretching vector. In the models, the aspect ratio (ratio of length vs. width) of the transfer zone shows a positive correlation with the offset angle (i.e., the more the inherited fabric is parallel to the extension direction, the longer and narrower the transfer zones). In case of staircase offset of the rift segments (φ=90°), the structural pattern was characterised by two isolated rift depressions linked by a narrow transfer zone in which border faults with alternating polarity overlapped. Prominent rise of the ductile lower crust was also observed at the transfer zone. Many of these geometrical features display striking similarities with natural rift systems. The results of the current experiments provide useful insights into the mechanics of continental rift architecture, supporting that rift propagation, width and along-axis segmentation may be strongly controlled by the reactivation of pre-existing pervasive crustal fabrics.